This paper describes a technique for identifying hydrometeor particle types using airborne HIAPER Cloud Radar (HCR) and High Spectral Resolution Lidar (HSRL) observations. HCR operates at a frequency of 94 GHz (3 mm wavelength), while HSRL is an eye‐safe lidar system operating at a wavelength of 532 nm. Both instruments are deployed on the NSF‐NCAR HIAPER aircraft. HCR is designed to fly in an underwing pod and HSRL is situated in the cabin. The HCR and HSRL data used in this study were collected during the Southern Ocean Clouds, Radiation, Aerosol Transport Experimental Study (SOCRATES). Comprehensive observations of the vertical distributions of liquid and mixed‐phase clouds were obtained using in situ probes on the aircraft and remote sensing instruments. Hydrometeor particle types were retrieved from HCR, HSRL, and temperature fields with a newly developed fuzzy logic particle identification (PID) algorithm. The PID results were validated with in situ measurements collected onboard the HIAPER aircraft by a 2D‐Stereo (2D‐S) cloud probe. Particle phases derived from the PID results compare well with those obtained from the 2D‐S observations and agree in over 70% of cases. Size distributions are also consistent between the two methods of observation. Knowledge of the particle type distribution gained from the PID results can be used to constrain microphysical parameterizations and improve the representation of cloud radiative effects in weather and climate models.
- Award ID(s):
- 1841215
- NSF-PAR ID:
- 10215118
- Date Published:
- Journal Name:
- Geoscientific Model Development
- Volume:
- 13
- Issue:
- 4
- ISSN:
- 1991-9603
- Page Range / eLocation ID:
- 1975 to 1998
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
more » « less
Abstract. Satellite cloud observations have become an indispensable tool for evaluatinggeneral circulation models (GCMs). To facilitate the satellite and GCMcomparisons, the CFMIP (Cloud Feedback Model Inter-comparison Project)Observation Simulator Package (COSP) has been developed and is nowincreasingly used in GCM evaluations. Real-world clouds and precipitation canhave significant sub-grid variations, which, however, are often ignored oroversimplified in the COSP simulation. In this study, we use COSP cloudsimulations from the Super-Parameterized Community Atmosphere Model (SPCAM5)and satellite observations from the Moderate Resolution ImagingSpectroradiometer (MODIS) and CloudSat to demonstrate the importance ofconsidering the sub-grid variability of cloud and precipitation when usingthe COSP to evaluate GCM simulations. We carry out two sensitivity tests:SPCAM5 COSP and SPCAM5-Homogeneous COSP. In the SPCAM5 COSP run, the sub-gridcloud and precipitation properties from the embeddedcloud-resolving model (CRM) of SPCAM5 are used to drive the COSP simulation, while inthe SPCAM5-Homogeneous COSP run only grid-mean cloud and precipitationproperties (i.e., no sub-grid variations) are given to the COSP. We find thatthe warm rain signatures in the SPCAM5 COSP run agree with the MODIS andCloudSat observations quite well. In contrast, the SPCAM5-Homogeneous COSPrun which ignores the sub-grid cloud variations substantially overestimatesthe radar reflectivity and probability of precipitation compared to thesatellite observations, as well as the results from the SPCAM5 COSP run. Thesignificant differences between the two COSP runs demonstrate that it isimportant to take into account the sub-grid variations of cloud andprecipitation when using COSP to evaluate the GCM to avoid confusing andmisleading results.
-
Abstract. Optimizing radar observation strategies is one of the mostimportant considerations in pre-field campaign periods. This is especiallytrue for isolated convective clouds that typically evolve faster than theobservations captured by operational radar networks. This study investigatesuncertainties in radar observations of the evolution of the microphysicaland dynamical properties of isolated deep convective clouds developing inclean and polluted environments. It aims to optimize the radar observationstrategy for deep convection through the use of high-spatiotemporalcloud-resolving model simulations, which resolve the evolution of individualconvective cells every 1 min, coupled with a radar simulator and a celltracking algorithm. The radar simulation settings are based on the TrackingAerosol Convection Interactions ExpeRiment (TRACER) and Experiment of SeaBreeze Convection, Aerosols, Precipitation and Environment (ESCAPE) fieldcampaigns held in the Houston, TX, area but are generalizable to other fieldcampaigns focusing on isolated deep convection. Our analysis produces thefollowing four outcomes. First, a 5–7 m s−1 median difference inmaximum updrafts of tracked cells is shown between the clean and pollutedsimulations in the early stages of the cloud lifetimes. This demonstratesthe importance of obtaining accurate estimates of vertical velocity fromobservations if aerosol impacts are to be properly resolved. Second,tracking of individual cells and using vertical cross section scanning every minute capture the evolution of precipitation particle number concentration and size represented by polarimetric observables better than the operational radar observations that update the volume scan every 5 min. This approach also improves multi-Doppler radar updraft retrievals above 5 km above ground level for regions with updraft velocities greater than 10 m s−1. Third, we propose an optimized strategy composed of cell tracking by quick (1–2 min) vertical cross section scans from more than oneradar in addition to the operational volume scans. We also propose the useof a single-RHI (range height indicator) updraft retrieval technique for cellsclose to the radars, for which multi-Doppler radar retrievals are stillchallenging. Finally, increasing the number of deep convective cells sampledby such observations better represents the median maximum updraft evolutionwith sample sizes of more than 10 deep cells, which decreases the errorassociated with sampling the true population to less than 3 m s−1.more » « less
-
more » « less
Abstract The evolution of anvil clouds detrained from deep convective systems has important implications for the tropical energy balance and is thought to be shaped by radiative heating. We use combined radar‐lidar observations and a radiative transfer model to investigate the influence of radiative heating on anvil cloud altitude, thickness, and microphysical structure. We find that high clouds with an optical depth between 1 and 2 are prevalent in tropical convective regions and can persist far from any convective source. These clouds are generally located at higher altitudes than optically thicker clouds, experience strong radiative heating, and contain high concentrations of ice crystals indicative of turbulence. These findings support the hypothesis that anvil clouds are driven toward and maintained at a preferred optical thickness that corresponds to a positive cloud radiative effect. Comparison of daytime and nighttime observations suggests that anvil thinning proceeds more rapidly at night, when net radiative cooling promotes the sinking of cloud top. It is hypothesized that the properties of aged anvil clouds and their susceptibility to radiative destabilization are shaped by the time of day at which the cloud was detrained. These results underscore the importance of small‐scale processes in determining the radiative effect of tropical convection.
-
more » « less
During the Cloud System Evolution in the Trades (CSET) field study, 14 research flights of the National Science Foundation G-V sampled the stratocumulus–cumulus transition between Northern California and Hawaii and its synoptic variability. The G-V made vertically resolved measurements of turbulence, cloud microphysics, aerosol characteristics, and trace gases. It also carried dropsondes and a vertically pointing W-band radar and lidar. This paper summarizes these observations with the goals of fostering novel comparisons with theory, models and reanalyses, and satellite-derived products. A longitude–height binning and compositing strategy mitigates limitations of sparse sampling and spatiotemporal variability. Typically, a 1-km-deep decoupled stratocumulus-capped boundary layer near California evolved into 2-km-deep precipitating cumulus clusters surrounded by patches of thin stratus that dissipated toward Hawaii. Low cloud cover was correlated with estimated inversion strength more than with cloud droplet number, even though the thickest clouds were generally precipitating and ultraclean layers indicative of aerosol–cloud–precipitation interaction were common west of 140°W. Accumulation-mode aerosol concentration correlated well with collocated cloud droplet number concentration and was typically largest near the surface. Aitken mode aerosol concentration was typically larger in the free troposphere. Wildfire smoke produced spikes of aerosol and trace gases on some flights. CSET data are compared with space–time collocated output from MERRA-2 reanalysis and from the CAM6 climate model run with winds and temperature nudged toward this reanalysis. The reanalysis compares better with the observed relative humidity than does nudged CAM6. Both vertically diffuse the stratocumulus cloud layer versus observations. MERRA-2 slightly underestimates in situ carbon monoxide measurements and underestimates ozone depletion within the boundary layer.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.5194/gmd-13-1975-2020
