An official website of the United States government
Abstract In this paper, the forced response of a two degrees-of-freedom (DOF) bilinear oscillator with initial gaps involving inelastic collision is discussed. In particular, a focus is placed upon the experimental verification of the generalized bilinear amplitude approximation (BAA) method, which can be used for the accurate estimation of forced responses for bilinear systems with initial gaps. Both experimental and numerical investigations on the system have been carried out. An experimental setup that is capable of representing the dynamics of a 2DOF oscillator has been developed, and forced response tests have been conducted under swept-sine base excitation for different initial gap sizes. The steady-state response of the system under base excitation was computed by both traditional time integration and BAA. It is shown that the results of experiments and numerical predictions are in good agreement especially at resonance. However, slight differences in the responses obtained from both numerical methods are observed. It was found that the time duration where the DOFs are in contact with each other predicted by BAA is longer than that predicted by time integration. Spectral analyses have also been conducted on both experimental and numerical results. It was observed that in a frequency range where intermittent contact between the masses occurs, super-harmonic components of the excitation frequency are present in the spectra. Moreover, as the initial gap size increases, the frequency band where the super-harmonic components are observed decreases.
more »
« less
Experimental Forced Response Analysis of Two-Degree-of-Freedom Piecewise-Linear Systems With a Gap
Abstract In this paper, an experimental forced response analysis for a two degree of freedom piecewise-linear oscillator is discussed. First, a mathematical model of the piecewise linear oscillator is presented. Second, the experimental setup developed for the forced response study is presented. The experimental setup is capable of investigating a two degree of freedom piecewise linear oscillator model. The piecewise linearity is achieved by attaching mechanical stops between two masses that move along common shafts. Forced response tests have been conducted, and the results are presented. Discussion of characteristics of the oscillators are provided based on frequency response, spectrogram, time histories, phase portraits, and Poincaré sections. Period doubling bifurcation has been observed when the excitation frequency changes from a frequency with multiple contacts between the masses to a frequency with single contact between the masses occurs.
more »
« less
- Award ID(s):
- 1902408
- PAR ID:
- 10219615
- Date Published:
- Journal Name:
- ASME 2020 International Design Engineering Technical Conferences and Computers and Information in Engineering Conference
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Quasi-periodic motions can be numerically found in piecewise-linear systems, however, their characteristics have not been well understood. To illustrate this, an incremental harmonic balance (IHB) method with two timescales is extended in this work to analyze quasi-periodic motions of a non-smooth dynamic system, i.e., a gear transmission system with piecewise linearity stiffness. The gear transmission system is simplified to a four degree-of-freedom nonlinear dynamic model by using a lumped mass method. Nonlinear governing equations of the gear transmission system are formulated by utilizing the Newton’s second law. The IHB method with two timescales applicable to piecewise-linear systems is employed to examine quasi-periodic motions of the gear transmission system whose Fourier spectra display uniformly spaced sideband frequencies around carrier frequencies. The Floquet theory is extended to analyze quasi-periodic solutions of piecewise-linear systems based on introduction of a small perturbation on a steady-state quasi-periodic solution of the gear transmission system with piecewise linearities. Comparison with numerical results calculated using the fourth-order Runge-Kutta method confirms that excellent accuracy of the IHB method with two timescales can be achieved with an appropriate number of harmonic terms.more » « less
-
Vibration energy harvesting is increasingly being seen as a viable energy source to provide for our energy-dependent society. There has been great interest in scavenging previously unused or wasted energy in a large variety of systems including vibrating machinery, ocean waves and human motion. In this work, a bench-top system of a piecewise-linear nonlinear vibration energy harvester is studied. A similar idealized model of the system had previously been studied numerically, and in this work the method is adjusted to better account for the physical system. This new design is able to actively tune the system’s resonant frequency to match the current excitation through the adjustment of the gap size between the oscillator and mechanical stopper; thus maximizing the system response over a broad frequency range. This design shows an increased effective frequency bandwidth compared with traditional linear systems and improves upon current nonlinear designs that are less effective than linear harvesters at resonance. In this paper, the physical system is tested at various excitation conditions and gap sizes to showcase the new harvester design’s effectiveness.more » « less
-
Abstract The impact of the vibration absorber on the synchronization region during vortex-induced vibration of turbine blades is investigated. This work is based on a 3DOF model, including a coupled plunge-pitch airfoil motion and a van der Pol oscillator to the fluid-structure interaction caused by the vortex shedding of the incoming flow. The aeroelastic system is increased by a degree of freedom, namely, the vibration absorber. Linear and nonlinear vibration absorbers are used in this investigation to analyze the effectiveness of the vibration absorber. To demonstrate the effect of the resonator on the lock-in, the coupled natural frequencies, numerical frequency responses, and time histories are plotted. The study reveals the promising capability of the absorber to reduce the lock-in region and mitigate the VIV amplitudes within these regions. For the current application, however, the nonlinear absorber response was indifferent compared to its linear counterpart for the given values of coupling coefficients. This observation indicates that a linear absorber efficiently shrinks the lock-in regions and mitigates the VIV in turbomachinery.more » « less
-
The chief objective of this paper is to explore energy transfer mechanism between the sub-systems that are coupled by a nonlinear elastic path. In the proposed model (via a minimal order, two degree of freedom system), both sub-systems are defined as damped harmonic oscillators with linear springs and dampers. The first sub-system is attached to the ground on one side but connected to the second sub-system on the other side. In addition, linear elastic and dissipative characteristics of both oscillators are assumed to be identical, and a harmonic force excitation is applied only on the mass element of second oscillator. The nonlinear spring (placed in between the two sub-systems) is assumed to exhibit cubic, hardening type nonlinearity. First, the governing equations of the two degree of freedom system with a nonlinear elastic path are obtained. Second, the nonlinear differential equations are solved with a semi-analytical (multi-term harmonic balance) method, and nonlinear frequency responses of the system are calculated for different path coupling cases. As such, the nonlinear path stiffness is gradually increased so that the stiffness ratio of nonlinear element to the linear element is 0.01, 0.05, 0.1, 0.5 and 1.0 while the absolute value of linear spring stiffness is kept intact. In all solutions, it is observed that the frequency response curves at the vicinity of resonant frequencies bend towards higher frequencies as expected due to the hardening effect. However, at moderate or higher levels of path coupling (say 0.1, 0.5 and 1.0), additional branches emerge in the frequency response curves but only at the first resonant frequency. This is due to higher displacement amplitudes at the first resonant frequency as compared to the second one. Even though the oscillators move in-phase around the first natural frequency, high amplitudes increase the contribution of the stored potential energy in the nonlinear spring to the total mechanical energy. The out-of-phase motion around the second natural frequency cannot significantly contribute due to very low motion amplitudes. Finally, the governing equations are numerically solved for the same levels of nonlinearity, and the motion responses of both sub-systems are calculated. Both in-phase and out-of-phase motion responses are successfully shown in numerical solutions, and phase portraits of the system are generated in order to illustrate its nonlinear dynamics. In conclusion, a better understanding of the effect of nonlinear elastic path on two damped harmonic oscillators is gained.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Conference Paper:
- https://doi.org/10.1115/DETC2020-22289
