skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


  • NSF Public Access
  • Search Results
  • Inorganic salts and organic matter effects on nanorod, nanowire, and nanoplate MoO 3 aggregation, dissolution, and photocatalysis
Title: Inorganic salts and organic matter effects on nanorod, nanowire, and nanoplate MoO 3 aggregation, dissolution, and photocatalysis
Use of visible light photocatalytic nanomaterials in water treatment can be promising in treating contaminants. However, little research has been conducted examining the effects of more complex chemistries in the nanomaterial's performance. In this work, the effects of inorganic salts (NaCl and CaCl 2 ) and natural organic matter (NOM) such as humic acid (HA) and extracellular polymeric substances (EPS) on nanoparticle aggregation, dissolution, and ultimately on the photocatalytic properties of molybdenum trioxide (MoO 3 ), i.e. nanorods, nanowires, and nanoplates were examined. In the presence of NaCl, nanorod, nanowire, and nanoplate MoO 3 had similar critical coagulation concentrations, while the nanorods showed higher instability in CaCl 2 . Overall, the presence of inorganic salts caused high colloidal instability in the MoO 3 nanostructures in terms of aggregation behavior, but greatly aided in the reduction of MoO 3 dissolution. NOM presence decreased aggregation rates, albeit dissolution was not similarly affected in all three structures. Only the dissolution of the nanowire structures was reduced in the presence of HA or EPS. Furthermore, the photocatalytic activity of the nanowires and nanoplates was overall reduced when inorganic salts or natural organic matter were present. While the presence of natural organic matter alone did reduce photocatalytic effectiveness of the nanorod MoO 3 , the presence of salts seemed to negate the effects from the organic compounds. Furthermore, the presence of CaCl 2 resulted in a highly enhanced photocatalytic activity regardless of the presence of natural organic matter. The structural and chemical differences of the nanomaterials played a significant role in their aggregation, dissolution, and ability to photocatalytically degrade methylene blue in solution. This study demonstrates that a better understanding of water chemistry effects on nanomaterials is essential prior to their intended applications.  more » « less
Award ID(s):
1705511
PAR ID:
10226836
Author(s) / Creator(s):
; ;
Date Published:
Journal Name:
Environmental Science: Nano
Volume:
7
Issue:
12
ISSN:
2051-8153
Page Range / eLocation ID:
3794 to 3804
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; (, Angewandte Chemie International Edition)
    Silicon is an extremely important technological material, but the current industrial production of silicon by carbothermic reduction of SiO₂ is energy intensive and generates CO₂ emission. Here we developed a new and more sustainable method to produce silicon nanowires in bulk quantities via direct electrochemical reduction of CaSiO₃, an abundant and inexpensive silicon source soluble in molten salts, at a low temperature of 650 ⁰C by using low melting point ternary molten salts CaCl₂-MgCl₂-NaCl, which still retains high CaSiO₃ solubility, and a supporting electrolyte of CaO, which facilitates the transport of O²¯ anions, drastically improves the reaction kinetics and enables the electrolysis at low temperatures. The Si nanowire product can be used as high-capacity Li-ion battery anode materials with excellent cycling performance. This practical strategy at lower temperatures can be applied to other molten salt systems and also promising for waste glass and coal ash recycling. 
    more » « less
  2. ; ; ; ; ; (, Nanoscale)
    The present study compares for the first time the effects of h-MoO 3 and α-MoO 3 against two fungal strains: Aspergillus niger and Aspergillus flavus . The h-MoO 3 nanoparticles were more toxic to both fungi than α-MoO 3 . The toxic effects of h-MoO 3 were more pronounced toward A. flavus , which presented a growth inhibition of 67.4% at 200 mg L −1 . The presence of the nanoparticles affected drastically the hyphae morphology by triggering nuclear condensation and compromising the hyphae membrane. Further analysis of the volatile organic compounds (VOCs) produced by both fungi in the presence of the nanomaterials indicated important metabolic changes related to programmed cell death. These nanomaterials induced the production of specific antifungal VOCs, such as β-Elemene and t-Cadinol, by the fungi. The production of essential enzymes involved in fungal metabolism, such as acid phosphatase, naphthol-As-BI-phosphohydrolase, β-galactosidase, β-glucosidase and N -acetyl-β-glucosaminidase, reduced significantly in the presence of the nanomaterials. The changes in enzymatic production and VOCs corroborate the fact that these nanoparticles, especially h-MoO 3 , exert changes in the fungal metabolism, triggering apoptotic-like cell death responses in these fungi. 
    more » « less
  3. ; (, Environmental Science: Water Research & Technology)
    Lead( iv ) oxide PbO 2 is one dominant solid phase in lead corrosion scales of drinking water distribution systems. Understanding the colloidal dispersion of PbO 2 is important for lead control in drinking water, especially under scenarios of switching the residual disinfectant from chlorine to chloramine. This study investigated the changes in lead release and colloidal dispersion from PbO 2(s) associated with the presence of natural organic matter (NOM), the introduction of chloramine, and the addition of a phosphate corrosion inhibitor in drinking water distribution systems. Experimental data showed that when NOM was present, the surface charges of PbO 2 exhibited a prominent negative shift, leading to colloidal dispersion of Pb( iv ) particles. The presence of chloramine did not significantly change the detrimental effects of NOM on the colloidal behavior of PbO 2 . In contrast, the addition of phosphate greatly reduced colloidal lead release in the size range between 0.1 and 0.45 μm, and limited lead release with colloidal sizes less than 0.1 μm to below 15 μg L −1 , i.e. , the U.S. EPA regulatory standard. The beneficial effects of phosphate addition are mainly attributed to the suppression in colloidal dispersion of Pb( iv ) particles. Meanwhile, the presence of phosphate also limits the reductive dissolution of PbO 2 via the formation of hydroxypyromorphite Pb 5 (PO 4 ) 3 OH particles. Results from this study suggest that phosphate limits the dispersion of PbO 2(s) by NOM and prevented the release of Pb( iv ) colloids into drinking water. 
    more » « less
  4. ; (, Physical Chemistry Chemical Physics)
    Determination of the surface hydrophobicity or wettability of nanomaterials and nanoparticles (NPs) is often challenged by the heterogeneous properties of NPs that vary with particle size, shape, surface charge, aggregation states, and surface sorption or coating. This study first summarized inherent limitations of the water contact angle, octanol–water partition coefficient ( K ow ) and surface adsorption of probe molecules in probing nanomaterial hydrophobicity. Then, we demonstrated the principle of a scanning probe method based on atomic force microscopy (AFM) for the local surface hydrophobicity measurement. Specifically, we measured the adhesion forces between functionalized AFM tips and self-assembled monolayers (SAMs) to establish a linear relationship between the adhesion forces and water contact angles based on the continuum thermodynamic approach (CTA). This relationship was used to determine the local surface hydrophobicity of seven different NPs ( i.e. , TiO 2 , ZnO, SiO 2 , CuO, CeO 2 , α-Fe 2 O 3 , and Ag), which agreed well with bulk contact angles of these NPs. Some discrepancies were observed for Fe 2 O 3 , CeO 2 and SiO 2 NPs, probably because of surface hydration and roughness effects. Moreover, the solution pH and ionic strength had negligible effects on the adhesion forces between the AFM tip and MWCNTs or C 60 , indicating that the hydrophobicity of carbonaceous nanomaterials is not influenced by pH or ionic strength (IS). By contrast, natural organic matter (NOM) appreciably decreased the hydrophobicity of MWCNTs and C 60 due to surface coating of hydrophilic NOM. This scanning probe method has been proved to be reliable and robust toward the accurate measurement of the nanoscale hydrophobicity of individual NPs or nanomaterials in liquid environments. 
    more » « less
  5. ; ; ; ; (, Environmental Science: Nano)
    null (Ed.)
    Engineered nanoparticle (NP) size and natural organic matter (NOM) composition play important roles in determining NP environmental behaviors. The aim of this work was to investigate how NP size and NOM composition influence the colloidal stability of polyvinylpyrrolidone coated platinum engineered nanoparticles (PVP-PtNPs). We evaluated PVP-PtNP aggregation as a function of the NP size (20, 30, 50, 75, and 95 nm, denoted as PVP-PtNP 20–95 ) in moderately hard water (MHW). Further, we quantified the effect of the hydrophobic organic acid (HPOA) fraction of NOM on the aggregation of PVP-PtNP 20 and PVP-PtNP 95 using 6 NOM samples from various surface waters, representing a range of NOM compositions and properties. NOM samples were characterized for bulk elemental composition ( e.g. , C, H, O, N, and S), specific ultraviolet absorbance at 254 nm (SUVA 254 ), and molecular level composition ( e.g. , compound classes) using ultrahigh resolution mass spectrometry. Single particle-inductively coupled plasma-mass spectrometry (sp-ICP-MS) was employed to monitor the aggregation of PVP-PtNPs at 1 μg PVP-PtNP per L and 1 mg NOM per L concentrations. PVP-PtNP aggregate size increased with decreasing primary PVP-PtNP size, likely due to the lower zeta potential, the higher number concentration, and the higher specific surface area of smaller NPs compared to larger NPs at the same mass concentration. No aggregation was observed for PVP-PtNP 95 in MHW in the presence and absence of the different NOM samples. PVP-PtNP 20 formed aggregates in MHW in the presence and absence of the six NOM samples, and aggregate size increased in the presence of NOM likely due to interparticle bridging of NOM-coated PVP-PtNPs by divalent counterions. PVP-PtNP 20 aggregate size increased with the increase in NOM elemental ratio of H to C and the relative abundance of lignin-like/carboxyl rich-alicyclic molecules (CRAM)-like compounds. However, the aggregate size of PVP-PtNP 20 decreased with the increase in NOM molecular weight, NOM SUVA 254 , elemental ratio of O to C, and the relative abundance of condensed hydrocarbons and tannin-like compounds. Overall, the results of this study suggest that the composition and sources of NOM are key factors that contribute to the stability of PVP-PtNPs in the aquatic environment. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email