skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


  • NSF Public Access
  • Search Results
  • Disruption Behavior of Aggregates in a Rotating/Oscillating Cylindrical Tank and Implications for Particle Transport in the Ocean
Title: Disruption Behavior of Aggregates in a Rotating/Oscillating Cylindrical Tank and Implications for Particle Transport in the Ocean
Particle size and settling speed determine the rate of particulate mass transfer from the ocean surface to the sea bed. Turbulent shear in the ocean can act on large, faster-settling flocculated particles to break them into slower-settling primary particles or sub-aggregates. However, it is difficult to understand the disruption behavior of aggregates and their response to varying shear forces due to the complex ocean environment. A study was conducted to simulate the disruption behavior of marine aggregates in the mixed layer of the ocean. The breakup process was investigated by aggregating and disrupting flocs of bentonite clay particles in a rotating and oscillating cylindrical tank 10 cm in diameter filled with salt water. This laboratory tank, which operated based on an extension of Stokes’ second problem inside a cylinder, created laminar oscillating flow superimposed on a constant rotation. This motion allowed the bentonite particles to aggregate near the center of the tank but also exposed large aggregates to high shear forces near the wall. A high-speed camera system was used, along with particle tracking measurements and image processing techniques, to capture the breakup of the large particle aggregates and locate their radial position. The breakup response of large aggregates and the sizes of their daughter particles after breakup were quantified using the facility. The disruption strength of the aggregated particles is presented and discussed relative to their exposure to varying amounts of laminar shear.  more » « less
Award ID(s):
1948283
PAR ID:
10227332
Author(s) / Creator(s):
;
Date Published:
Journal Name:
Proceedings of the ASME 2020 Fluids Engineering Division Summer Meeting
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; (, Proceedings of the ASME-JSME-KSME 2019 8th Joint Fluids Engineering Conference)
    null (Ed.)
    The fate of particulate matter in the ocean is determined in large part by its size and settling rate. Disaggregation, caused by turbulence-induced shear, acts to fracture or erode large particles into slower-settling sub-aggregates and primary particles. The strength and breakup response of organic marine aggregates (i.e. marine snow particles consisting of phytoplankton) is poorly understood, limiting our ability to accurately predict marine particle transport effects on the global carbon cycle. A study was conducted to enable the investigation of disaggregation effects on these organic marine particle aggregates. Due to the fragile nature of the Phytoplankton cells and their resulting aggregates, test facilities that do not rely on external sampling or pumps are required. A novel rolling aggregation tank was developed that can both aggregate phytoplankton cells under varying hydrodynamic conditions and then expose them to calibrated shear forces using laminar oscillating flow. The theory behind the operation of this tank is presented along with the necessary operating conditions to create stable regions within the tank where particle settling effects are minimal but shear is still representative of values expected in the open ocean. Phytoplankton was cultured in the laboratory to create simulated marine snow particles in the open ocean for disaggregation experiments. The procedure to calculate and track the shear-history of each aggregate is described and how the data generated from this facility will be used to quantify disaggregation parameters relevant for population balance modeling is discussed. 
    more » « less
  2. ; ; (, Frontiers in Marine Science)
    Understanding the effect of hydrodynamics on aggregate size and structure is key to predicting mass transport in the aquatic environment. Aggregation theory of particles is well established but our knowledge of deformation processes, biological bonding forces, and their effects on fragmentation of aquatic aggregates is still limited. To better comprehend fragmentation processes and adhesion forces we implemented breakup experiments with diatom and microplastic aggregates made in the laboratory. We captured a substantial number of events showing deformation and subsequent fragmentation of these aggregates in an oscillatory shear flow. Polystyrene and polyethylene aggregates showed distinct fragmentation strengths and provided comparative upper and lower limits to the biological bonding strength of the diatom aggregates. Additionally, we employed a force balance model to evaluate attractive interactions within clusters of particles using the Lagrangian stress history and morphology. We found that the fractal structures of aggregates led to a power law of breakup strength with size and that time-integrated stress governed the overall fragmentation process. We also found that the weakening of the aggregates through deformation with shear exposure enabled their disaggregation at very low shear rates typical of the ocean environment. 
    more » « less
  3. ; ; (, SPE Journal)
    Controlling the downhole pressure is an important parameter for successful and safe drilling operations. Several types of weighting agents (i.e., high-density particles), traditionally barite particles, are added to maintain the desired density of the drilling fluid (DF). The DF density is an important design parameter for preventing multiple drilling complications. These issues are caused by the settling of the dense particles, an undesired phenomenon also referred to as sagging. Therefore, there is a need to understand the settling characteristics of heavy particles in such scenarios. To this end, simultaneous measurements of liquid phase flow patterns and particle settling velocities have been conducted in a Taylor-Couette (TC) cell with a rotating inner cylinder and stationary outer cylinder separated by an annular gap of 9.0 mm. Liquid flow patterns and particle settling velocities have been measured using particle image velocimetry (PIV) and particle tracking velocimetry (PTV) techniques, respectively. Experiments have been performed by varying the rotational speed of the inner cylinder up to 200 rev/min, which is used in normal drilling operations. Spherical particles with diameters of 3.0 mm or 4.0 mm and densities between 1.2 g/cm3 and 3.95 g/cm3 were used. The liquid phases studied included deionized (DI) water and mineral oil, which are the basic components of a non-Newtonian DF with a shear-thinning viscosity. The DF is a mud-like emulsion of opaque appearance, which impedes the ability to observe the liquid flow field and particle settling in the TC cell. To address this issue, a solution of carboxymethyl cellulose (CMC) with a 6% weight concentration in DI water was used. This non-Newtonian solution displays shear-thinning rheological behavior and was used as a transparent alternative to the opaque DF. For water, PIV results have shown wavy vortex flow (WVF) to turbulent Taylor vortex flow (TTVF), which agrees with the flow patterns reported in the literature. For mineral oil, circular Couette flow (CCF) was observed at up to 100 rev/min and vortex formation at 200 rev/min. For CMC, no vortex formation was observed up to 200 rev/min, only CCF. The settling velocities for all particles in water matched with the particle settling velocities predicted using the Basset-Boussinesq-Oseen (BBO) equation of motion. For mineral oil and CMC, the results did not match well with the predicted settling velocities, especially for heavy particles due possibly to the radial particle migration and interactions with the outer cylinder wall. 
    more » « less
  4. ; ; ; (, Journal of Marine Science and Engineering)
    Marine snow aggregates often dominate carbon export from the surface layer to the deep ocean. Therefore, understanding the formation and properties of aggregates is essential to the study of the biological pump. Previous studies have observed a relationship between phytoplankton growth phase and the production of transparent exopolymer particles (TEP), the sticky particles secreted by phytoplankton that act as the glue during aggregate formation. In this experimental study, we aim to determine the effect of phytoplankton growth phase on properties related to aggregate settling. Cultures of the diatom Thalassiosira weissflogii were grown to four different growth phases and incubated in rotating cylindrical tanks to form aggregates. Aggregate excess density and delayed settling time through a sharp density gradient were quantified for the aggregates that were formed, and relative TEP concentration was measured for cultures before aggregate formation. Compared to the first growth phase, later phytoplankton growth phases were found to have higher relative TEP concentration and aggregates with lower excess densities and longer delayed settling times. These findings may suggest that, although particle concentrations are higher at later stages of phytoplankton blooms, aggregates may be less dense and sink slower, thus affecting carbon export. 
    more » « less
  5. ; ; ; ; (, Frontiers in Earth Science)
    The flocculation behavior of clay minerals in aquatic environments is an important process in estuarine and riverine dynamics, where strong gradients in salinity can locally occur. Various contradicting observations have been reported in the literature on the impact of salt concentration on the settling process of cohesive sediments. To address this issue in a systematic manner, we investigate the settling behavior of clay minerals as a function of the salt concentration of the ambient water. Specifically, we focus on montmorillonite as a prototype clay mineral with a high cation exchange capacity (CEC). To this end, we study suspensions of Wyoming bentonite (Volclay SPV) as a very important constituent for many constructional and industrial purposes. We perform an experimental campaign to study the settling behavior of moderately turbid montmorillonite concentrations in monovalent salt solutions with different salinities (sodium chloride) to represent different environments ranging from deionized to ocean water, respectively. The subsequent settling process was monitored by taking pictures by a camera in regular time intervals over a total observation time up to 48 h. In addition, a modified hydrometer analysis is conducted to determine the grain size distribution (in terms of an equivalent diameter) of the flocculated clay suspension in salt water. Despite the rather high cation exchange capacity of the investigated clay (CEC=88.1), our results show that the settling speed drastically increases within a range of 0.6–1.0 PSU and stays approximately constant for higher salinities. This critical salt concentration is defined here as the critical coagulation concentration (CCC) and lies well below the salinity of natural open water bodies. The hydrometer analysis revealed that 60% of the agglomerates exceed the equivalent grain size of 20 μm. Finally, the findings of this study are supplemented with experiments studying the effect of Extracellular Polymeric Substances (EPS) on the flocculation behavior of bentonite in salt water. Our results demonstrate that salinity is the original trigger for flocculation, whereas EPS allows for even larger floc size but it does not play a significant role for the settling processes of bentonite in estuarine environments. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email