An official website of the United States government
The effects of nanoscale silver (nAg) particles on subsurface microbial communities can be influenced by the presence of biosurfactants, which have been shown to alter nanoparticle surface properties. Batch and column studies were conducted to investigate the influence of rhamnolipid biosurfactant (1–50 mg L −1 ) on the stability and mobility of silver nanoparticles (16 ± 4 nm) in batch reactors and water-saturated columns with three solution chemistries: pH = 4 and dissolved oxygen concentration (DO) = 8.8 mg L −1 , pH = 7 and DO = 8.8 mg L −1 , pH = 7 and DO = 2.0 mg L −1 . In batch studies, the presence of rhamnolipid (2–50 mg L −1 ) reduced nAg dissolution by 83.3–99.1% under all pH and DO conditions. Improved nAg stability was observed when rhamnolipid was present in batch reactors at pH = 7 ± 0.2, where the hydrodynamic diameter remained constant (∼50 nm) relative to rhamnolipid-free controls (increased to >230 nm) in 48 hours. Column experiments conducted at pH 4.0 ± 0.2 demonstrated that co-injection of nAg with rhamnolipid (2, 5 and 50 mg L −1 ) decreased Ag + breakthrough from ∼22% of total applied mass in rhamnolipid-free columns to less than 8.1% in the presence of rhamnolipid and altered the shape of the nAg retention profile from a hyper-exponential to a uniform distribution. Column experiments performed at pH 7.0 ± 0.2 and DO levels of either ∼2.0 or ∼8.8 mg L −1 showed that co-injection of 5 mg L −1 and 50 mg L −1 rhamnolipid increased nAg mass breakthrough by 25–40% and ∼80%, respectively, enhancements in nAg stability and mobility were attributed to rhamnolipid adsorption on nAg surfaces, which effectively slowed the oxidation and thus release of Ag + , and adsorption of rhamnolipid on the porous medium, which competed for nAg attachment sites. These results indicate that the presence of rhamnolipid significantly influenced nAg dissolution and mobility under dynamic flow conditions. A mathematical model based on modified filtration theory (MFT) accurately reproduced nAg transport and retention behavior when aggregation and reaction processes were minimal and when rhamnolipid was present, providing a tool to predict the effects of biosurfactants on nAg transport in porous media.
more »
« less
Effect of rhamnolipid biosurfactant on transport and retention of iron oxide nanoparticles in water-saturated quartz sand
Although prior studies have investigated the effects of solution constituents, including dissolved organic matter and synthetic polymers, on nanoparticle mobility in porous media, far less attention has been directed toward evaluating the impacts of biosurfactants secreted by microorganisms on the transport and retention behavior of nanomaterials. The objective of this study was to explore the influence of rhamnolipid, a biosurfactant associated with biofilms, on the transport and retention of iron oxide nanoparticles (IONPs) in a water-saturated quartz sand. Column experiments were conducted using aerobic medium (ionic strength = 50.4 mM) or 10 mM NaCl as background electrolyte at a pore velocity of 0.43 m per day and pH 6.8 ± 0.2. In aerobic medium columns, nearly all introduced nanoparticles were retained when IONPs were injected alone, whereas the presence of 10 mg L −1 or 50 mg L −1 rhamnolipid resulted in ∼25% and ∼50% breakthrough of the injected IONP mass, respectively. Moreover, preflushing media with 50 mg L −1 rhamnolipid further increased IONP mass breakthrough by ∼30%. Similar enhancement of nanoparticle mobility by 50 mg L −1 rhamnolipid was also measured in lower ionic strength (10 mM NaCl) columns. Mathematical models that incorporated nanoparticle filter ripening and biosurfactant competitive adsorption successfully reproduced experimental observations. Modeling results predicted an order-of-magnitude decrease in IONP filter ripening rate coefficient and a three-fold drop in average IONP retention capacity in the presence of rhamnolipid, consistent with a stabilizing effect and competition for surface sites. These findings demonstrate that rhamnolipid biosurfactant can potentially enhance nanomaterial stability and mobility in subsurface environments and that these effects should be considered when evaluating the impact of biological process on nanoparticle fate and transport in porous media.
more »
« less
- Award ID(s):
- 1704326
- PAR ID:
- 10228122
- Date Published:
- Journal Name:
- Environmental Science: Nano
- Volume:
- 8
- Issue:
- 1
- ISSN:
- 2051-8153
- Page Range / eLocation ID:
- 311 to 327
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)The spread of pathogenic bacteria in unsaturated porous media, where air and liquid coexist in pore spaces, is the major cause of soil contamination by pathogens, soft rot in plants, food spoilage, and many pulmonary diseases. However, visualization and fundamental understanding of bacterial transport in unsaturated porous media are currently lacking, limiting the ability to address the above contamination and disease related issues. Here, we demonstrate a previously unreported mechanism by which bacterial cells are transported in unsaturated porous media. We discover that surfactant-producing bacteria can generate flows along corners through surfactant production that changes the wettability of the solid surface. The corner flow velocity is on the order of several mm/h, which is the same order of magnitude as bacterial swarming, one of the fastest known modes of bacterial surface translocation. We successfully predict the critical corner angle for bacterial corner flow to occur based on the biosurfactant-induced change in the contact angle of the bacterial solution on the solid surface. Furthermore, we demonstrate that bacteria can indeed spread by producing biosurfactants in a model soil, which consists of packed angular grains. In addition, we demonstrate that bacterial corner flow is controlled by quorum sensing, the cell-cell communication process that regulates biosurfactant production. Understanding this previously unappreciated bacterial transport mechanism will enable more accurate predictions of bacterial spreading in soil and other unsaturated porous media.more » « less
-
Predicting the transport of toxic metals in dolomite saline aquifers where petroleum produced water (PW) is commonly injected is important to prevent underground sources of drinking water contamination. This study presents new experimental results on the degree and impact of precipitation and sorption reactions on the transport of high concentrations of toxic metals (80-100 mg-Ba/L, 80-100 mg-Sr/L, 70-100 mg-Cd/L, 2-100 mg-Pb/L, and 80-100 mg-As/L) in dolomite injected with PW of variable alkalinity (0–200 mg/L), total dissolved solids (1700–77,000 mg/L), and pH (2–7). Changes in the elemental and mineral composition of dolomite surface were measured by BSEs SEM, SEM-EDS, and high-resolution XRD analyses. The results reveal a key role of alkalinity generated from the dissolution of dolomite. We show that a short initial stage where the removal of toxic metals is driven by the initial pH and alkalinity of PW is followed by a prolonged stage where the removal of toxic metals by sorption and precipitation reactions is driven by the alkalinity and pH that results from the kinetic dissolution of dolomite. Precipitated/coprecipitated metals were carbonate minerals reflecting the metal composition of PW. Attained removal levels of tested toxic metals from 1 L of PW using a dolomite core made of 200 g were >90% for Pb, >50% for As, >30% for Cd, and >5% for Ba and Sr. Apparently, the in-situ generation of alkalinity (carbonate ions) and sorption reactions of metals on dolomite catalyzes the precipitation of toxic metals as carbonate minerals. This catalytic effect of dolomite is different with PW and fresh water (FW) of low salinity (NaCl). Precipitation reactions are more prominent with FW than with PW, whereas sorption reactions are more prominent with PW than with FW.more » « less
-
Engineered nanomaterials interfaced with plant seeds can improve stress tolerance during the vulnerable seedling stage. Herein, we investigated how priming seeds with antioxidant poly(acrylic acid)-coated cerium oxide nanoparticles (PNC) impacts cotton ( Gossypium hirsutum L.) seedling morphological, physiological, biochemical, and transcriptomic traits under salinity stress. Seeds primed with 500 mg L −1 PNC in water (24 h) and germinated under salinity stress (200 mM NaCl) retained nanoparticles in the seed coat inner tegmen, cotyledon, and root apical meristem. Seed priming with PNC significantly ( P < 0.05) increased seedling root length (56%), fresh weight (41%), and dry weight (38%), modified root anatomical structure, and increased root vitality (114%) under salt stress compared with controls (water). PNC seed priming led to a decrease in reactive oxygen species (ROS) accumulation in seedling roots (46%) and alleviated root morphological and physiological changes induced by salinity stress. Roots from exposed seeds exhibited similar Na content, significantly decreased K (6%), greater Ca (22%) and Mg content (60%) compared to controls. A total of 4779 root transcripts were differentially expressed by PNC seed priming alone relative to controls with no nanoparticles under non-saline conditions. Under salinity stress, differentially expressed genes (DEGs) in PNC seed priming treatments relative to non-nanoparticle controls were associated with ROS pathways (13) and ion homeostasis (10), indicating that ROS and conserved Ca 2+ plant signaling pathways likely play pivotal roles in PNC-induced improvement of salinity tolerance. These results provide potential unifying molecular mechanisms of nanoparticle-seed priming enhancement of plant salinity tolerance.more » « less
-
Dissolution of CuO nanoparticles, releasing Cu ions, is a primary mechanism of Cu interaction in the rooting zone of plants. CuO dissolution is sometimes incorrectly considered negligible at high pH, since complexation of Cu with dissolved organic matter may enhance nanoparticle dissolution. Therefore data on the effects of plant-microbial-soil interactions on nanoparticle dissolution, particularly in alkaline soils, are needed. Dissolution of CuO nanoparticles (100 mg kg −1 Cu) was studied in sand supplemented with factorial combinations of wheat growth, a root-colonizing bacterium, and saturated paste extracts (SPEs) from three alkaline, calcareous soils. In control sand systems with 3.34 mM Ca(NO 3 ) 2 solution, dissolved Cu was low (266 μg L −1 Cu). Addition of dissolved organic matter via wheat root metabolites and/or soil SPEs increased dissolved Cu to 795–6250 μg L −1 Cu. Dissolution was correlated with dissolved organic carbon ( R = 0.916, p < 0.0001). Ligands >3 kDa, presumably fulvic acid from the SPEs, complexed Cu driving solubility; the addition of plant exudates further increased solubility 1.5–3.5×. The root-colonizing bacterium decreased dissolved Cu in sand pore waters from planted systems due to metabolism of root exudates. Batch solubility studies (10 mg L −1 Cu) with the soil SPEs and defined solutions containing bicarbonate or fulvic acid confirmed elevated CuO nanoparticle solubility at >7.5 pH. Nanoparticle dissolution was suppressed in batch experiments compared to sand, via nanoparticle organic matter coating or homoconjugation of dissolved organic matter. Alterations of CuO nanoparticles by soil organic matter, plant exudates, and bacteria will affect dissolution and bioavailability of the CuO nanoparticles in alkaline soils.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/d0en01033b
