skip to main content


Title: Data report: revised Pleistocene sediment splice for Site U1457, IODP Expedition 355
Sediment cores from adjacent holes at a drill site are typically spliced to make a continuous sediment record that spans sediment gaps that occur between sediment cores within each hole. The splice also provides a template for later sampling. During International Ocean Discovery Program Expedition 355, we made such a splice for both Sites U1456 and U1457 using shipboard Whole-Round Multisensor Logger and Section Half Multisensor Logger data. The shipboard-spliced sediment section at Site U1457 was constructed for the advanced piston corer interval to an age of about 1.5 Ma. Additional postexpedition planktonic foraminifer stable isotope data (Globigerinoides ruber δ18O) show that the shipboard stratigraphic tie between Cores 355-U1457B-1H and 355-U1457A-1H was wrong. This paper describes a revised splice that appends Core 355-U1457A-1H to the base of Core 355-U1457B-1H. The core composite depth below seafloor depths of the remaining splice have been revised because of this change. The revised splice interval is also longer by 1.2 m to accommodate the lower part of Core 355-U1457B-1H. In addition, a break of unknown thickness is present between Cores 355-U1457B-1H and 355-U1457A-1H. The revised splice interval table is included in this report.  more » « less
Award ID(s):
1326927
NSF-PAR ID:
10229637
Author(s) / Creator(s):
;
Date Published:
Journal Name:
Proceedings of the International Ocean Discovery Program
Volume:
355
ISSN:
2377-3189
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. null (Ed.)
    Bulk sediment chemistry was measured at 2 cm resolution along cores from International Ocean Discovery Program (IODP) Site U1457 using the X-ray fluorescence (XRF) core scanner at the IODP Gulf Coast Repository. The Pleistocene splice section assembled from Holes U1457A and U1457B was scanned in its entirety, and nearly continuous sediment bulk chemistry profiles were constructed to a depth of 125 m core composite depth below seafloor (CCSF). Some sections of Hole U1457C were also scanned: (1) an upper Miocene hemipelagic section and (2) a 30 m lower Paleocene section directly overlying basalt. In the Pleistocene spliced sections, 2 cm spacing represents a sampling resolution of 150–300 y, whereas in the upper Miocene section this spacing represents about 500 y between samples. We report data and acquisition conditions for major and many minor elements. We find large variability in CaCO3 content in the Pleistocene section, from around 14 to 89 wt%. We used discrete shipboard CaCO3 measurements to calibrate the XRF Ca data. CaCO3 has cyclic variability and correlates with light sediment colors. Variation in aluminosilicate elements is largely caused by changes in dilution by CaCO3. The lower part of the spliced section, presumably representing distal Indus Fan deposits, has a distinctive but more uniform composition than the upper part. 
    more » « less
  2. null (Ed.)
    The Indian (southwest) summer monsoon is one of the most intense climatic phenomena on Earth. Its long-term development has been linked to the growth of high topography in South and Central Asia. The Indian continental margin, adjoining the Arabian Sea, offers a unique opportunity to investigate tectonic–climatic interactions and the net impact of these processes on weathering and erosion of the western Himalaya. During International Ocean Discovery Program Expedition 355, two sites (U1456 and U1457) were drilled in Laxmi Basin in the eastern Arabian Sea to document the coevolution of mountain building, weathering, erosion, and climate over a range of timescales. In addition, recovering basement from the eastern Arabian Sea provides constraints on the early rifting history of the western continental margin of India with special emphasis on continental breakup between India and the Seychelles and its relationship to the plume-related volcanism of the Deccan Plateau. Drilling and coring operations during Expedition 355 recovered sediment from Sites U1456 and U1457 in the Laxmi Basin, penetrating 1109.4 and 1108.6 m below seafloor (mbsf), respectively. Drilling reached sediment dated to 13.5–17.7 Ma (late early to early middle Miocene) at Site U1456, although with a large hiatus between the lowermost sediment and overlying deposits dated to <10.9 Ma. At Site U1457, a much longer hiatus occurs near the base of the cored section, spanning from 10.9 to ~62 Ma. At both sites, hiatuses span ~8.2–9.2 and ~3.6–5.6 Ma, with a possible condensed section spanning ~2.0–2.6 Ma, although the total duration for each hiatus is slightly different between the two sites. A major submarine fan draining the western Himalaya and Karakoram must have been supplying sediment to the eastern Arabian Sea since at least ~17 Ma. Sand mineral assemblages indicate that the Greater Himalayan Crystalline Sequence was fully exposed to the surface by this time. Most of the recovered sediment appears to be derived from the Indus River and includes minerals that are unique to the Indus Suture Zone, in particular glaucophane and hypersthene, most likely originating from the structural base of the Kohistan arc. Pliocene sandy intervals at Site U1456 were deposited in lower fan “sheet lobe” settings, with intervals of basin plain turbidites separated by hemipelagic muddy sections deposited during the Miocene. Site U1457 is more distal in facies, reflecting its more marginal setting. No major active lobe appears to have affected the Laxmi Basin since the Middle Pleistocene (~1.2 Ma). We succeeded in recovering sections spanning the 8 Ma climatic transition, when monsoon intensity is believed to have changed strongly, although the nature of this change awaits postcruise analysis. We also recovered sediment from a large mass transport deposit measuring ~330 and ~190 m thick at Sites U1456 and U1457, respectively. This section includes an upper sequence of slump-folded muddy and silty rocks, as well as underlying calcarenites and limestone breccias, together with smaller amounts of volcanic clasts, all of which are likely derived from the western Indian continental shelf. Identification of similar facies on the regional seismic lines in Laxmi Basin suggests that these deposits form parts of one of the world’s largest mass transport deposits. Coring of igneous basement was successful at Site U1457. Recovery of massive basalt and associated volcaniclastic sediment at this site should address the key questions related to rifting and volcanism associated with formation of Laxmi Basin. Geochemical analysis is required to understand the petrogenesis and thus the tectonic setting of volcanism that will reveal whether it is oceanic basalt or volcanic rock contaminated by underlying continental crust or continental flood basalt. However, the fact that the lavas are massive and have few vesicles implies water depths of eruption likely deeper than 2000 m. This precludes opening of the basin in the presence of a major mantle thermal anomaly, such as that associated with the Deccan Large Igneous Province. Other observations made at the two sites during Expedition 355 provide vital constraints on the rift history of this margin. Heat flow measurements at the two drill sites were calculated to be ~57 and ~60 mW/m2. Such heat flow values are compatible with those observed in average oceanic crust of 63–84 Ma age, as well as with the presence of highly extended continental crust. Postcruise analyses of the more than ~1722 m of core will provide further information about the nature of tectonic–climatic interactions in this global type area for such studies. 
    more » « less
  3. null (Ed.)
    The shipboard sediment splice of International Ocean Discovery Program Expedition 363 Site U1483, drilled in 1733 m water depth on the Scott Plateau off Northwest Australia, was primarily based on a composite of the magnetic susceptibility records at 2.5 cm resolution from three holes drilled at this site. We performed X-ray fluorescence (XRF) core scanning at 2 cm intervals with overlaps of ~1–2 m at splice tie points and used these new data to verify the tie points along the original splice from 0 to 211.53 m core composite depth below seafloor (CCSF). Based on the XRF records, we revised the position of three original tie points and present a revised composite depth scale for Site U1483. These revisions resulted in shifts of up to 94 cm relative to the original shipboard offsets and a continuous section extending down to 211.62 m revised core composite depth below seafloor (r-CCSF). 
    more » « less
  4. A near-complete sedimentary sequence was spliced together for the upper part of International Ocean Discovery Program (IODP) Holes U1553A, U1553B, and U1553E. Poor core recovery precluded a complete splice for the deeper section cored in Holes U1553C and U1553D. The history of Deep Sea Drilling Project Site 277, which was cored nearby, suggests that the Site U1553 splice will be heavily sampled and that eventually samples will be taken from intervals of core that are not included in the splice (i.e., off-splice). Although the depths of all cores have been shifted to a common scale during the splicing process by aligning significant features shared by cores from the different holes, core disturbance and natural variability often lead to misalignment between features in the splice and the same features in off-splice data. To remedy this problem for future sampling, data from off-splice intervals are squeezed or stretched to match spliced intervals using a set of tie points between the splice and off-splice data. The difference in depths can be significant when considering sedimentation rates and orbital periods of precession, obliquity, and eccentricity and sometimes even change the phase relationship compared to the splice. Results are presented as tables of tie points between each hole and the splice that can be used to interpolate the proper splice depth of off-splice samples. 
    more » « less
  5. Contribution of melting Antarctic Ice Sheets (AIS) to rising sea level remains one of the least quantified inputs to predictive models for the future. To improve these estimates, International Ocean Discovery Program Expedition 374 cored five sites in the Ross Sea, Antarctica, to examine the stability of the AIS to past intervals of global warmth. Site U1523 proved difficult to core because of the presence of gravel lags and indurated intervals; thus, we cored three holes with overlapping stratigraphy at that site to recover a more complete stratigraphic section. Given these challenges, no attempt was made to create a composite depth scale or stratigraphic splice during the expedition. Here we use a combination of physical property data (primarily magnetic susceptibility and natural gamma radiation), X-ray fluorescence core scanning, and visual core description to construct a core composite depth below seafloor (CCSF) depth scale to the base of Hole U1523B. This composite depth scale is discontinuous because of challenging coring conditions and variable core recovery, although there are several intervals of reasonably good stratigraphic continuity between 0 and 26 m CCSF and 82 and 96 m CCSF. We also created a stratigraphic splice from 0 to 93.95 m CCSF, although the splice is only continuous to 15.82 m CCSF. Additionally, we mapped the off-splice interval of Core 374-U1523E-1H to the composite depth scale over several intervals with significant core disturbance by stretching and squeezing to obtain a best fit. Development of the composite depth scale and stratigraphic splice will improve postcruise research results by allowing scientists to compare samples from different holes on the same depth scale. 
    more » « less