Steamboat Geyser in Yellowstone National Park is the tallest active geyser on Earth and is believed to have hydrologic connection to Cistern Spring, a hydrothermal pool ∼100 m southwest from the geyser vent. Despite broad scientific interest, rare episodic Steamboat eruptions have made it difficult to study its eruption dynamics and underground plumbing architecture. In response to the recent reactivation of Steamboat, which has produced more than 130 eruptions since March 2018, we deployed a dense seismic nodal array surrounding the enigmatic geyser in the summer of 2019. The array recorded abundant 1–5 Hz hydrothermal tremor originating from phase‐transition events within both Steamboat Geyser and Cistern Spring. To constrain the spatiotemporal distribution of the tremor sources, an interferometric‐based polarization analysis was developed. The observed tremor locations indicate that the conduit beneath Steamboat is vertical and extends down to ∼120 m depth and the plumbing of Cistern includes a shallow vertical conduit connecting with a deep, large, and laterally offset reservoir ∼60 m southeast of the surface pool. No direct connection between Steamboat and Cistern plumbing structures is found. The temporal variation of tremor combined with
- Award ID(s):
- 1724986
- NSF-PAR ID:
- 10239547
- Date Published:
- Journal Name:
- Proceedings of the National Academy of Sciences
- Volume:
- 118
- Issue:
- 2
- ISSN:
- 0027-8424
- Page Range / eLocation ID:
- e2020943118
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract in situ temperature and water depth measurements of Cistern reveals interaction between Steamboat and Cistern throughout the eruption/recharge cycles. The observed delayed responses of Cistern Spring in reaction to Steamboat eruptions and recharge suggest that the two plumbing structures may be connected through a fractured/porous medium instead of a direct open channel, consistent with our inferred plumbing structure. -
more » « less
Abstract In the past century, most eruptions of Steamboat Geyser in Yellowstone National Park's Norris Geyser Basin were mainly clustered in three episodes: 1961–1969, 1982–1984, and ongoing since 2018. These eruptive episodes resulted in extensive disturbance to surrounding trees. To characterize tree response over time as an indicator of geyser activity adjustments to climate variability, aerial and ground images were analyzed to document changes in tree coverage around the geyser since 1954. Radiocarbon dating of silicified tree remnants from within 14 m of the geyser vent was used to examine geyser response to possible variations in decadal to centennial precipitation patterns. We searched for atypical or absent growth rings in cores from live trees in years associated with large geyser eruptions. Photographs indicate that active eruptive phases have adversely affected trees up to 30 m from the vent, primarily in the dominant downwind direction. Radiocarbon dates indicate that the geyser formed before 1878, in contrast to the birthdate reported in historical documents. Further, the ages of the silicified trees cluster within three episodes that are temporally correlated with periods of relative drought in the Yellowstone region during the 15th–17th centuries. The discontinuous growth of trees around the geyser suggests that changes in eruptive patterns occur in response to decadal to multidecadal droughts. This inference is supported by the lack of silicified specimens with more than 20 annual rings and by the existence of atypical or missing rings in live trees during periods of extended geyser activity.
-
more » « less
Abstract Geyser and volcano monitoring suffer from temporal, geographic, and instrumental biases. We present a recording bias identified through multiyear monitoring of Steamboat Geyser in Yellowstone National Park, USA. Eruptions of Steamboat are the tallest of any geyser in the world and they produce broadband signals at two nearby stations in the Yellowstone National Park Seismograph Network. In winter, we observe lower eruption signal amplitudes at these seismometers. Instead of a source effect, we find that environmental conditions affect the recorded signals. Lower amplitudes for 23–45 Hz frequencies are correlated with greater snow depths at the station 340 m away from Steamboat, and we calculate an energy attenuation coefficient of 0.21 ± 0.01 dB per cm of snow. More long‐term monitoring is needed at geysers to track changes over time and identify recording biases that may be missed during short, sporadic studies.
-
more » « less
Abstract Geysers are rare geologic features that intermittently discharge liquid water and steam driven by heating and decompression boiling. The cause of variability in eruptive styles and the associated seismic signals are not well understood. Data collected from five broadband seismometers at Lone Star Geyser, Yellowstone National Park are used to determine the properties, location, and temporal patterns of hydrothermal tremor. The tremor is harmonic at some stages of the eruption cycle and is caused by near‐periodic repetition of discrete seismic events. Using the polarization of ground motion, we identify the location of tremor sources throughout several eruption cycles. During preplay episodes (smaller eruptions preceding the more vigorous major eruption), tremor occurs at depths of 7–10 m and is laterally offset from the geyser's cone by ~5 m. At the onset of the main eruption, tremor sources migrate laterally and become shallower. As the eruption progresses, tremor sources migrate along the same path but in the opposite direction, ending where preplay tremor originates. The upward and then downward migration of tremor sources during eruptions are consistent with warming of the conduit followed by evacuation of water during the main eruption. We identify systematic relations among the two types of preplays, discharge, and the main eruption. A point‐source moment tensor fit to low‐frequency waveforms of an individual tremor event using half‐space velocity models indicates average
V S ≳ 0.8 km/s, source depths ~4–20 m, and moment tensors with primarily positive isotropic and compensated linear vector dipole moments. -
more » « less
Abstract Water injection and Enhanced Geothermal System (EGS) technologies have been used to exploit heat resources from geothermal reservoirs. Detecting spatial and temporal changes in reservoir physical properties is important for monitoring reservoir condition changes due to water injection and EGS. Here, we determine high‐resolution models of the temporal changes in the three‐dimensional
P wave velocity and attenuation (Vp and Qp) structures between the years 2005 and 2011 in the northwestern part of The Geysers geothermal field, California, using double‐difference seismic velocity and attenuation tomography. The northwest Geysers has a shallow normal temperature reservoir (NTR) underlain by a high temperature reservoir (HTR) that has substantial underutilized heat resources but may be more fully utilized in the future through EGS. In the southeastern part of the northwest Geysers, however, EGS has been successfully but unintentionally applied for at least 50 years because the waters injected into the NTR have been flowing into the HTR. Our models are well resolved in this area and show that the NTR and HTR have different seismic responses (seismicity, Vp, and Qp) to water injection, which can be explained by the injection‐induced differences in fracturing and saturation that are likely related to their geological properties. Our results indicate that the joint analysis of changes in seismicity, velocity, and attenuation is valuable for characterizing changes in reservoir fracturing and saturation conditions. Our results suggest that high‐permeability zones and/or pre‐existing permeable fault zones are important for the success of EGS at The Geysers and potentially other geothermal systems.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1073/pnas.2020943118
