An official website of the United States government
Abstract Old Faithful Geyser in Yellowstone is one of the most well‐known hydrothermal features in the world. Despite abundant geophysical studies, the structure of Old Faithful's plumbing system beneath ~20‐m depth remained largely elusive. By deploying a temporary dense three‐component geophone array, we observe 1–5 Hz low‐frequency hydrothermal tremor originating from Old Faithful's deeper conduit. By applying seismic interferometry and polarization analyses, we track seismic tremor source migration throughout the eruption/recharge cycle. The tremor source drops rapidly to ~80‐m depth right after the eruption and gradually ascends vertically back to ~20‐m depth, coinciding with the previously inferred bubble trap location. Likely excited by the liquid/steam phase transition, the observed tremor source migration can provide new constraints on the recharge process and deeper conduit geometry. Combined with the shallow conduit structure from previous studies, these results provide constraints on the major fluid pathway down to 80‐m depth.
more »
« less
Imaging the Subsurface Plumbing Complex of Steamboat Geyser and Cistern Spring With Hydrothermal Tremor Migration Using Seismic Interferometry
Abstract Steamboat Geyser in Yellowstone National Park is the tallest active geyser on Earth and is believed to have hydrologic connection to Cistern Spring, a hydrothermal pool ∼100 m southwest from the geyser vent. Despite broad scientific interest, rare episodic Steamboat eruptions have made it difficult to study its eruption dynamics and underground plumbing architecture. In response to the recent reactivation of Steamboat, which has produced more than 130 eruptions since March 2018, we deployed a dense seismic nodal array surrounding the enigmatic geyser in the summer of 2019. The array recorded abundant 1–5 Hz hydrothermal tremor originating from phase‐transition events within both Steamboat Geyser and Cistern Spring. To constrain the spatiotemporal distribution of the tremor sources, an interferometric‐based polarization analysis was developed. The observed tremor locations indicate that the conduit beneath Steamboat is vertical and extends down to ∼120 m depth and the plumbing of Cistern includes a shallow vertical conduit connecting with a deep, large, and laterally offset reservoir ∼60 m southeast of the surface pool. No direct connection between Steamboat and Cistern plumbing structures is found. The temporal variation of tremor combined within situtemperature and water depth measurements of Cistern reveals interaction between Steamboat and Cistern throughout the eruption/recharge cycles. The observed delayed responses of Cistern Spring in reaction to Steamboat eruptions and recharge suggest that the two plumbing structures may be connected through a fractured/porous medium instead of a direct open channel, consistent with our inferred plumbing structure.
more »
« less
- Award ID(s):
- 1753362
- PAR ID:
- 10359831
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Solid Earth
- Volume:
- 126
- Issue:
- 4
- ISSN:
- 2169-9313
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Geysers are rare geologic features that intermittently discharge liquid water and steam driven by heating and decompression boiling. The cause of variability in eruptive styles and the associated seismic signals are not well understood. Data collected from five broadband seismometers at Lone Star Geyser, Yellowstone National Park are used to determine the properties, location, and temporal patterns of hydrothermal tremor. The tremor is harmonic at some stages of the eruption cycle and is caused by near‐periodic repetition of discrete seismic events. Using the polarization of ground motion, we identify the location of tremor sources throughout several eruption cycles. During preplay episodes (smaller eruptions preceding the more vigorous major eruption), tremor occurs at depths of 7–10 m and is laterally offset from the geyser's cone by ~5 m. At the onset of the main eruption, tremor sources migrate laterally and become shallower. As the eruption progresses, tremor sources migrate along the same path but in the opposite direction, ending where preplay tremor originates. The upward and then downward migration of tremor sources during eruptions are consistent with warming of the conduit followed by evacuation of water during the main eruption. We identify systematic relations among the two types of preplays, discharge, and the main eruption. A point‐source moment tensor fit to low‐frequency waveforms of an individual tremor event using half‐space velocity models indicates averageVS ≳ 0.8 km/s, source depths ~4–20 m, and moment tensors with primarily positive isotropic and compensated linear vector dipole moments.more » « less
-
null (Ed.)Steamboat Geyser in Yellowstone National Park’s Norris Geyser Basin began a prolific sequence of eruptions in March 2018 after 34 y of sporadic activity. We analyze a wide range of datasets to explore triggering mechanisms for Steamboat’s reactivation and controls on eruption intervals and height. Prior to Steamboat’s renewed activity, Norris Geyser Basin experienced uplift, a slight increase in radiant temperature, and increased regional seismicity, which may indicate that magmatic processes promoted reactivation. However, because the geothermal reservoir temperature did not change, no other dormant geysers became active, and previous periods with greater seismic moment release did not reawaken Steamboat, the reason for reactivation remains ambiguous. Eruption intervals since 2018 (3.16 to 35.45 d) modulate seasonally, with shorter intervals in the summer. Abnormally long intervals coincide with weakening of a shallow seismic source in the geyser basin’s hydrothermal system. We find no relation between interval and erupted volume, implying unsteady heat and mass discharge. Finally, using data from geysers worldwide, we find a correlation between eruption height and inferred depth to the shallow reservoir supplying water to eruptions. Steamboat is taller because water is stored deeper there than at other geysers, and, hence, more energy is available to power the eruptions.more » « less
-
When and why earthquakes trigger volcano and geyser eruptions remains unclear. In September 2022, Steamboat Geyser in Yellowstone, USA erupted 8.25 hours after a local M3.9 earthquake—an improbable coincidence based on the geyser’s eruption intervals. We leverage monitoring data from the surrounding geyser basin to determine if the earthquake triggered this eruption. We calculate a peak ground velocity of 1.2 cm s−1, which is the largest ground motion in the area since Steamboat reactivated in March 2018 and exceeds a threshold associated with past earthquake-triggered geyser eruptions in Yellowstone. Despite no changes in other surface hydrothermal activity, we found abrupt, short-lived shifts in ambient seismic noise amplitude and relative seismic velocity in narrow frequency bands related to the subsurface hydrothermal system. Our analysis indicates that Steamboat’s eruption was likely earthquake-triggered. The hours-long delay suggests that dynamic strains from seismic waves altered subsurface permeability and flow which enabled eruption.more » « less
-
The intensity of explosive volcanic eruptions is correlated with the amplitude of eruption tremor, a ubiquitously observed seismic signal during eruptions. Here we expand upon a recently introduced theoretical model that attributes eruption tremor to particle impacts and dynamic pressure changes in the turbulent flow above fragmentation (Gestrich et al., 2020). We replace their point source model with Rayleigh wave Green's functions with full Green's functions and account for depth variation of input fields using conduit flow models. The latter self-consistently capture covariation of input fields like particle velocity, particle volume fraction, and density. Body wave contributions become significant above 2-3 Hz, bringing the power spectral density (PSD) closer to observations. Conditions at the vent are not representative of flow throughout the tremor source region and using these values overestimates tremor amplitude. Particle size and its depth distribution alter the PSD and where dominant source contributions arise within the conduit. Solutions with decreasing mass eruption rate, representing a waning eruption, reveal a shift in the dominant tremor contribution from turbulence to particle impacts. Our work demonstrates the ability to integrate conduit flow modeling with volcano seismology studies of eruption tremor, providing an opportunity to link observations to eruptive processes.more » « less
