An official website of the United States government
Crowdyet al.(2023Phys. Rev. Fluids, vol. 8, 094201), recently showed that liquid suspended in the Cassie state over an asymmetrically spaced periodic array of alternating cold and hot ridges such that the menisci spanning the ridges are of unequal length will be pumped in the direction of the thermocapillary stress along the longer menisci. Their solution, applicable in the Stokes flow limit for a vanishingly small thermal Péclet number, provides the steady-state temperature and velocity fields in a semi-infinite domain above the superhydrophobic surface, including the uniform far-field velocity, i.e. pumping speed, the key engineering parameter. Here, a related problem in a finite domain is considered where, opposing the superhydrophobic surface, a flow of liquid through a microchannel is bounded by a horizontally mobile smooth wall of finite mass subjected to an external load. A key assumption underlying the analysis is that, on a unit area basis, the mass of the liquid is small compared with that of the wall. Thus, as shown, rather than the heat equation and the transient Stokes equations governing the temperature and flow fields, respectively, they are quasi-steady and, as a result, governed by the Laplace and Stokes equations, respectively. Under the further assumption that the ridge period is small compared with the height of the microchannel, these equations are resolved using matched asymptotic expansions which yield solutions with exponentially small asymptotic errors. Consequently, the transient problem of determining the velocity of the smooth wall is reduced to an ordinary differential equation. This approach is used to provide a theoretical demonstration of the conversion of thermal energy to mechanical work via the thermocapillary stresses along the menisci.
more »
« less
Two-Dimensional Numerical Analysis of Gas Diffusion-Induced Cassie to Wenzel State Transition
Abstract We develop a two-dimensional model for the transient diffusion of gas from the cavities in ridge-type structured surfaces to a quiescent liquid suspended above them in the Cassie state to predict the location of the liquid vapor-interface (meniscus) as a function of time. The transient diffusion equation is numerically solved by a Chebyshev collocation (spectral) method coupled to the Young-Laplace equation and the ideal gas law. We capture the effects of variable meniscus curvature and, subsequently, when applicable, movement of triple contact lines. Results are presented for the evolution of the dissolved gas concentration field in the liquid and, when applicable, the time it takes for a meniscus to depin and that for longevity, i.e., the onset of the Cassie to Wenzel state transition. Two configurations are examined; viz., one where an impermeable membrane pressurizes the liquid above the ridges and one where hydrostatic pressure is considered and the top of the liquid is exposed to non-condensable gas.
more »
« less
- Award ID(s):
- 1805179
- PAR ID:
- 10293837
- Date Published:
- Journal Name:
- Journal of Heat Transfer
- ISSN:
- 0022-1481
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Effective separation of two immiscible liquids with filters requires a difference in the pressures to permeate between the two liquids, and setting the applied pressure between these two pressures. To help design such filters, we present an equation that enables the calculation of the pressure for a liquid phase to permeate through a smooth pore in the shape of a truncated cone as a function of (a) the contact angle of the liquid on the filters and (b) the angle of the pore wall. The equation was derived by considering the interfacial energy required to push a liquid meniscus from the top of the pore to the bottom, and then to exceed the maximum curvature required at the exit. This equation was tested experimentally by adding a hydrostatic head with water on the 3Dprinted filters of acrylate polymer while systematically varying the pore radii and contact angle with water. Experimental results showed an increased pressure to permeate with higher contact angles while the equation predicted the opposite. We hypothesized that the reason for the disagreement was the assumption of a smooth pore. For a liquid on a rough pore wall, the curvature of the meniscus is not solely determined from the microscopic contact angle and the pore wall angle, but the liquid would adopt a lower curvature meniscus. Therefore, the developed equation was modified after reflecting the lower curvature, which showed much better agreement with the experimental results. The remaining discrepancy from the theory was attributed to the pressure fluctuation from the fluid flow occurring while adding water.more » « less
-
As a liquid approaches the gas state, the properties of the potential energy landscape (PEL) sampled by the system become anomalous. Specifically, (i) the mechanically stable local minima of the PEL [inherent structures (IS)] can exhibit cavitation above the so-called Sastry volume, v S , before the liquid enters the gas phase. In addition, (ii) the pressure of the liquid at the sampled IS [i.e., the PEL equation of state, P IS ( v)] develops a spinodal-like minimum at v S . We perform molecular dynamics simulations of a monatomic water-like liquid and verify that points (i) and (ii) hold at high temperatures. However, at low temperatures, cavitation in the liquid and the corresponding IS occurs simultaneously and a Sastry volume cannot be defined. Remarkably, at intermediate/high temperatures, the IS of the liquid can exhibit crystallization, i.e., the liquid regularly visits the regions of the PEL that belong to the crystal state. The model liquid considered also exhibits a liquid–liquid phase transition (LLPT) between a low-density and a high-density liquid (LDL and HDL). By studying the behavior of P IS ( v) during the LLPT, we identify a Sastry volume for both LDL and HDL. The HDL Sastry volume marks the onset above which IS are heterogeneous (composed of LDL and HDL particles), analogous to points (i) and (ii) above. However, the relationship between the LDL Sastry volume and the onset of heterogeneous IS is less evident. We conclude by presenting a thermodynamic argument that can explain the behavior of the PEL equation of state P IS ( v) across both the liquid–gas phase transition and LLPT.more » « less
-
Surfaces that exhibit both superhydrophobic and superoleophobic properties have recently been demonstrated. Specifically, remarkable designs based on overhanging/inverse-trapezoidal microstructures enable water droplets to contact these surfaces only at the tips of the micro-pillars, in a state known as the Cassie state. However, the Cassie state may transition into the undesirable Wenzel state under certain conditions. Herein, we show from large-scale molecular dynamics simulations that the transition between the Cassie and Wenzel states can be controlled via precisely designed trapezoidal nanostructures on a surface. Both the base angle of the trapezoids and the intrinsic contact angle of the surface can be exploited to control the transition. For a given base angle, three regimes can be achieved: the Wenzel regime, in which water droplets can exist only in the Wenzel state when the intrinsic contact angle is less than a certain critical value; the Cassie regime, in which water droplets can exist only in the Cassie state when the intrinsic contact angle is greater than another critical value; and the bistable Wenzel–Cassie regime, in which both the Wenzel and Cassie states can exist when the intrinsic contact angle is between the two critical values. A strong base-angle dependence of the first critical value is revealed, whereas the second critical value shows much less dependence on the base angle. The stability of the Cassie state for various base angles (and intrinsic contact angles) is quantitatively evaluated by computing the free-energy barrier for the Cassie-to-Wenzel state transition.more » « less
-
Computational fluid dynamics models often employ the free shear boundary condition at free surfaces, a result from the continuity of the stress and the large viscosity contrast at liquid–gas interfaces. This study leverages nonequilibrium molecular dynamics simulations to investigate the validity of the free shear boundary condition on the exposed surface of a liquid meniscus at the nanoscale. The primary objective is elucidating the fundamental mechanisms and behavior of fluid interactions within a capillary meniscus formed between two carbon nanotubes (CNTs) in shear-driven flow. Shear-driven flow simulations were conducted by varying the velocity of a solid slab to induce different shear rates in the adjacent water molecules. The results demonstrate, for the first time, negligible shear at the free surface, supporting the free shear assumption from the nanoscale point of view. A force balance analysis reveals that capillary and surface tension forces dominate within the meniscus, dictating its shape and stability. Meniscus deformation was observed and primarily attributed to interatomic interactions between water molecules and CNTs, driven by a combination of short-range repulsive forces and van der Waals attractions. The minimal contribution from shear forces suggests that interatomic forces, rather than applied shear stress, are the primary drivers of the meniscus deformation. These findings offer valuable insights into fluid behavior and a sound fundamental analysis of the free shear boundary condition at the nanoscale.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1115/1.4051320
