An official website of the United States government
The growing demand of society for gas sensors for energy-efficient environmental sensing stimulates studies of new electronic materials. Here, we investigated quasi-one-dimensional titanium trisulfide (TiS3) crystals for possible applications in chemiresistors and on-chip multisensor arrays. TiS3 nanoribbons were placed as a mat over a multielectrode chip to form an array of chemiresistive gas sensors. These sensors were exposed to isopropanol as a model analyte, which was mixed with air at low concentrations of 1–100 ppm that are below the Occupational Safety and Health Administration (OSHA) permissible exposure limit. The tests were performed at room temperature (RT), as well as with heating up to 110 °C, and under an ultraviolet (UV) radiation at λ = 345 nm. We found that the RT/UV conditions result in a n-type chemiresistive response to isopropanol, which seems to be governed by its redox reactions with chemisorbed oxygen species. In contrast, the RT conditions without a UV exposure produced a p-type response that is possibly caused by the enhancement of the electron transport scattering due to the analyte adsorption. By analyzing the vector signal from the entire on-chip multisensor array, we could distinguish isopropanol from benzene, both of which produced similar responses on individual sensors. We found that the heating up to 110 °C reduces both the sensitivity and selectivity of the sensor array.
more »
« less
The Ultraviolet Index Is Well Estimated by the Terrestrial Irradiance at 310 nm
Ultraviolet (UV) exposure significantly contributes to non-melanoma skin cancer. In the context of health, UV exposure is the product of time and the UV Index (UVI), a weighted sum of the irradiance I(λ) over all wavelengths from λ = 250 to 400 nm. In our analysis of the United States Environmental Protection Agency’s UV-Net database of over 400,000 spectral irradiance measurements taken over several years, we found that the UVI is well estimated by 77 I310. To further understand this result, we applied an optical atmospheric model to generate terrestrial irradiance spectra and found that it applies across a wide range of conditions. An accurate UVI radiometer can be built from a photodiode covered by a bandpass filter centered at 310 nm.
more »
« less
- Award ID(s):
- 1951189
- PAR ID:
- 10309236
- Date Published:
- Journal Name:
- Sensors
- Volume:
- 21
- Issue:
- 16
- ISSN:
- 1424-8220
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Monitoring personal ultraviolet (UV) exposure facilitates risk mitigation against UV‐induced skin aging and skin cancer, the most common malignancy in North America, Europe, and Australia. UV radiometers convey real‐time information on local UV irradiance, while UV dosimeters count accumulated UV exposure over time. These devices can help users manage exposure levels in order to reach a healthy daily dose of UV light required for vitamin D production without exceeding erythemal limits that would increase skin cancer risk. However, personal UV detectors still suffer from several limitations. Wearable electronic UV sensors are relatively bulky, heavy, and expensive, while the more commonly used on‐skin disposable colorimetric UV sensors suffer from short service life, skin discomfort, and high accumulated costs when used daily as recommended. Intradermal colorimetric UV nanosensors can overcome these limitations, offering long‐term, comfortable, and inexpensive naked‐eye colorimetric indication of intradermal UV irradiance. Now, a new generation of UV‐sensing intradermal pigments with an improved design offers better tunability, stability, and biocompatibility. These UV‐photochromic nanosensors may be operated as UV dosimeters or simple sunscreen efficacy monitors, depending on the formulation, and can remain functional and re‐usable in the dermis for years.more » « less
-
null (Ed.)Abstract. Organic aerosol (OA) emissions from biomass burning havebeen the subject of intense research in recent years, involving acombination of field campaigns and laboratory studies. These efforts haveaimed at improving our limited understanding of the diverse processes andpathways involved in the atmospheric processing and evolution of OAproperties, culminating in their accurate parameterizations in climate andchemical transport models. To bring closure between laboratory and fieldstudies, wildfire plumes in the western United States were sampled andcharacterized for their chemical and optical properties during theground-based segment of the 2019 Fire Influence on Regional to GlobalEnvironments and Air Quality (FIREX-AQ) field campaign. Using acustom-developed multiwavelength integrated photoacoustic-nephelometerspectrometer in conjunction with a suite of instruments, including anoxidation flow reactor equipped to generate hydroxyl (OH⚫) ornitrate (NO3⚫) radicals to mimic daytime or nighttimeoxidative aging processes, we investigated the effects of multipleequivalent hours of OH⚫ or NO3⚫ exposure onthe chemical composition and mass absorption cross-sections (MAC(λ)) at 488 and 561 nm of OA emitted from wildfires in Arizona and Oregon. Wefound that OH⚫ exposure induced a slight initial increase inabsorption corresponding to short timescales; however, at longer timescales, the wavelength-dependent MAC(λ) decreased by a factor of0.72 ± 0.08, consistent with previous laboratory studies and reportsof photobleaching. On the other hand, NO3⚫ exposure increasedMAC(λ) by a factor of up to 1.69 ± 0.38. We also noted somesensitivity of aerosol aging to different fire conditions between Arizonaand Oregon. The MAC(λ) enhancement following NO3⚫ exposure was found to correlate with an enhancement in CHO1N andCHOgt1N ion families measured by an Aerodyne aerosol mass spectrometer.more » « less
-
Abstract Wildfire smoke is frequently present over the U.S. during the agricultural growing season and will likely increase with climate change. Studies of smoke impacts have largely focused on air quality and human health; however, understanding smoke's impact on photosynthetically active radiation (PAR) is essential for predicting how smoke affects plant growth. We compare surface shortwave irradiance and diffuse fraction (DF) on smoke‐impacted and smoke‐free days from 2006 to 2020 using data from multifilter rotating shadowband radiometers at 10 U.S. Department of Agriculture UV‐B Monitoring and Research Program stations and smoke plume locations from operational satellite products. On average, 20% of growing season days are smoke‐impacted, but smoke prevalence increases over time (r = 0.60,p < 0.05). Smoke presence peaks in the mid to late growing season (i.e., July, August), particularly over the northern Rocky Mountains, Great Plains, and Midwest. We find an increase in the distribution of PAR DF on smoke‐impacted days, with larger increases at lower cloud fractions. On clear‐sky days, daily average PAR DF increases by 10 percentage points when smoke is present. Spectral analysis of clear‐sky days shows smoke increases DF (average: +45%) and decreases total irradiance (average: −6%) across all six wavelengths measured from 368 to 870 nm. Optical depth measurements from ground and satellite observations both indicate that spectral DF increases and total spectral irradiance decreases with increasing smoke plume optical depth. Our analysis provides a foundation for understanding smoke's impact on PAR, which carries implications for agricultural crop productivity under a changing climate.more » « less
-
Abstract The ongoing COVID-19 global pandemic has necessitated evaluating various disinfection technologies for reducing viral transmission in public settings. Ultraviolet (UV) radiation can inactivate pathogens and viruses but more insight is needed into the performance of different UV wavelengths and their applications. We observed greater than a 3-log reduction of SARS-CoV-2 infectivity with a dose of 12.5 mJ/cm 2 of 254 nm UV light when the viruses were suspended in PBS, while a dose of 25 mJ/cm 2 was necessary to achieve a similar reduction when they were in an EMEM culture medium containing 2%(v/v) FBS, highlighting the critical effect of media in which the virus is suspended, given that SARS-CoV-2 is always aerosolized when airborne or deposited on a surface. It was found that SARS-CoV-2 susceptibility (a measure of the effectiveness of the UV light) in a buffer such as PBS was 4.4-fold greater than that in a cell culture medium. Furthermore, we discovered the attenuation of UVC disinfection by amino acids, vitamins, and niacinamide, highlighting the importance of determining UVC dosages under a condition close to aerosols that wrap the viruses. We developed a disinfection model to determine the effect of the environment on UVC effectiveness with three different wavelengths, 222 nm, 254 nm, and 265 nm. An inverse correlation between the liquid absorbance and the viral susceptibility was observed. We found that 222 nm light was most effective at reducing viral infectivity in low absorbing liquids such as PBS, whereas 265 nm light was most effective in high absorbing liquids such as cell culture medium. Viral susceptibility was further decreased in N95 masks with 222 nm light being the most effective. The safety of 222 nm was also studied. We detected changes to the mechanical properties of the stratum corneum of human skins when the 222 nm accumulative exposure exceeded 50 J/cm 2 .The findings highlight the need to evaluate each UV for a given application, as well as limiting the dose to the lowest dose necessary to avoid unnecessary exposure to the public.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/s21165528
