An official website of the United States government
Abstract To better constrain meltwater transport and ice viscosity in temperate glaciers, particularly in ice stream shear margins, we use a custom permeameter to study the untested model relationship between the permeability of temperate ice and its liquid water content. The permeability of lab-made ice of two mean grain diameters (1.8 and 4.2 mm) is measured, and water content is controlled with the ice salinity and measured calorimetrically. Fluorescein dye is added to through-flowing, chilled water to highlight flow pathways through the ice after experiments. As predicted by a simple model, permeability increases with approximately the square of the water content and by about three orders of magnitude across water contents of 0.1–4.4%. However, permeability values are less than those of the model by average factors of 2.6 and 4.1 for the finer and coarser ice, respectively. This discrepancy is likely due to tortuous, truncated or air-clogged veins. The order-of-magnitude agreement between measured and modeled values may indicate that reduced permeability from these factors is nearly compensated by preferential flow in oversized veins that are isolated or arborescent. Both kinds of preferred flow pathways are observed but the latter only in fine-grained ice at water contents > 2%.
more »
« less
A permeameter for temperate ice: first results on permeability sensitivity to grain size
Abstract Results of ice-stream models that treat temperate ice deformation as a two-phase flow are sensitive to the ice permeability. We have constructed and begun using a custom, falling-head permeameter for measuring the permeability of temperate, polycrystalline ice. Chilled water is passed through an ice disk that is kept at the pressure-melting temperature while the rate of head decrease indicates the permeability. Fluorescein dye in the water allows water-vein geometry to be studied using fluorescence microscopy. Water flow over durations of seconds to hours is Darcian, and for grain diameter d increasing from 1.7 to 8.9 mm, average permeability decreases from 2 × 10 −12 to 4 × 10−15 m 2. In tests with dye on fine ( d= 2 mm) and coarse (d = 7 mm) ice, average area-weighted vein radii are nearly equal, 41 and 34 μm, respectively. These average radii, if included in a theory slightly modified from Nye and Frank (1973), yield permeability values within a factor of 2.0 of best-fit values based on regression of the data. Permeability values depend on d −3.4, rather than d−2 as predicted by models if vein radii are considered independent of d. In future experiments, the dependence of permeability on liquid water content will be measured.
more »
« less
- Award ID(s):
- 1643120
- PAR ID:
- 10316217
- Date Published:
- Journal Name:
- Journal of Glaciology
- ISSN:
- 0022-1430
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Within the temperate ice of ice stream shear margins, high strain and accompanying recrystallization likely result in longitudinal foliation characterized by thin, steeply dipping ice layers with distinct variations in grain size and bubble content. The sensitivity of ice permeability to these factors, particularly grain size, implies that foliation causes shear‐margin ice to be hydraulically anisotropic. In this study, the permeability of foliated ice is measured in disks cut from cores from Athabasca Glacier, allowing permeability anisotropy to be assessed. We collected cores oriented normal and parallel to foliation from beneath the weathered crust of the glacier. Permeability values range from approximately m2and correlate with the textures and orientations of foliation layers. Results indicate that the anisotropic permeability of foliated ice can be approximated using a model that incorporates an empirical grain‐size/permeability relationship and a model of vein clogging by air bubbles. For water flow parallel to foliation, the arithmetic mean of the area‐weighted permeability closely approximates the bulk permeability; for flow perpendicular to foliation, measurements agree with the harmonic mean permeability, weighted to the thickness of each layer. These findings imply hydraulic anisotropy spanning several orders of magnitude in temperate glacier ice, with water flux governed by the most and least permeable layers in the flow‐parallel and flow‐perpendicular cases, respectively.more » « less
-
Ice at depth in ice-stream shear margins is thought to commonly be temperate, with interstitial meltwater that softens ice. Models that include this softening extrapolate results of a single experimental study in which ice effective viscosity decreased by a factor of ∼3 over water contents of ∼0.01–0.8%. Modeling indicates this softening by water localizes strain in shear margins and through shear heating increases meltwater at the bed, enhancing basal slip. To extend data to higher water contents, we shear lab-made ice in confined compression with a large ring-shear device. Ice rings with initial mean grain sizes of 2–4 mm are kept at the pressure-melting temperature and sheared at controlled rates with peak stresses of ∼0.06–0.20 MPa, spanning most of the estimated shear-stress range in West Antarctic shear margins. Final mean grain sizes are 8–13 mm. Water content is measured by inducing a freezing front at the ice-ring edges, tracking its movement inward with thermistors, and fitting the data with solutions of the relevant Stefan problem. Results indicate two creep regimes, below and above a water content of ∼0.6%. Comparison of effective viscosity values in secondary creep with those of tertiary creep from the earlier experimental study indicate that for water contents of 0.2–0.6%, viscosity in secondary creep is about twice as sensitive to water content than for ice sheared to tertiary creep. Above water contents of 0.6%, viscosity values in secondary creep are within 25% of those of tertiary creep, suggesting a stress-limiting mechanism at water contents greater than 0.6% that is insensitive to ice fabric development in tertiary creep. At water contents of ∼0.6–1.7%, effective viscosity is independent of water content, and ice is nearly linear-viscous. Minimization of intercrystalline stress heterogeneity by grain-scale melting and refreezing at rates that approach an upper bound as grain-boundary water films thicken might account for the two regimes.more » « less
-
Abstract. Flocculation controls mud sedimentation and organic carbon burial rates by increasing mud settling velocity. However, calibration and validation of floc settling velocity models in freshwater are lacking. We used a camera, in situ laser diffraction particle sizing, and suspended sediment concentration–depth profiles to measure flocs in Wax Lake Delta, Louisiana. We developed a new workflow that combines our multiple floc data sources to distinguish between flocs and unflocculated sediment and measure floc attributes that were previously difficult to constrain. Sediment finer than ∼10 to 55 µm was flocculated with median floc diameter of 30 to 90 µm, bulk solid fraction of 0.05 to 0.3, fractal dimension of ∼2.1, and floc settling velocity of ∼0.1 to 1 mm s−1, with little variation along water depth. Results are consistent with a semi-empirical model indicating that sediment concentration and mineralogy, organics, water chemistry, and, above all, turbulence control floc settling velocity. Effective primary particle diameter is ∼2 µm, about 2 to 6 times smaller than the median primary particle diameter, and is better described using a fractal theory. Flow through the floc increases settling velocity by an average factor of 2 and up to a factor of 7 and can be described by a modified permeability model that accounts for the effect of many primary particle sizes on flow paths. These findings help explain discrepancies between observations and an explicit settling model based on Stokes' law that depends on floc diameter, permeability, and fractal properties.more » « less
-
Understanding subsurface heterogeneity is critical for predicting groundwater flow, pollutant transport, and managing water resources. While traditional methods often rely on sparse borehole or geophysical data, this study explores a spectral analysis approach to infer aquifer structure from groundwater level fluctuations. We use a coupled surface–subsurface flow model to simulate hydraulic head time series in synthetic aquifers with bimodal hydraulic conductivity distributions. The frequency characteristics of these head fluctuations are analyzed to compute the scaling exponent (defined as the slope of the log-power spectral density of head fluctuations versus log-frequency) and its spatial gradient magnitude. Results show that areas with significant heterogeneity, such as transitions between high- and low-permeability zones, exhibit strong spatial gradients in the scaling exponent. These features can be used to delineate unsaturated zones, groundwater flow systems, and aquifer heterogeneity. By testing four scenarios with different hydraulic conductivity contrasts, we demonstrate that this method is sensitive to aquifer configuration. Our findings suggest that the gradient magnitude of the scaling exponent may serve as a diagnostic tool for characterizing heterogeneity in groundwater models and has the potential for future applications in estimating permeability distributions from monitored groundwater level data.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1017/jog.2021.136
