An official website of the United States government
Abstract. Sedimentary records indicate that atmospheric dust has increased substantially since preindustrial times. However, state-of-the-art global Earth system models (ESMs) are unable to capture this historical increase, posing challenges in assessing the impacts of desert dust on Earth's climate. To address this issue, we construct a globally gridded dust emission dataset (DustCOMMv1) spanning 1841–2000. We do so by combining 19 sedimentary records of dust deposition with observational and modeling constraints on the modern-day dust cycle. The derived emission dataset contains interdecadal variability of dust emissions as forced by the deposition flux records, which increased by approximately 50 % from 1851–1870 to 1981–2000. We further provide future dust emission datasets for 2000–2100 by assuming three possible scenarios for how future dust emissions will evolve. We evaluate the historical dust emission dataset and illustrate its effectiveness in enforcing a historical dust increase in ESMs by conducting a long-term (1851–2000) dust cycle simulation with the Community Earth System Model (CESM2). The simulated dust depositions are in reasonable agreement with the long-term increase in most sedimentary dust deposition records and with measured long-term trends in dust concentration at sites in Miami and Barbados. This contrasts with the CESM2 simulations using a process-based dust emission scheme and with simulations from the Coupled Model Intercomparison Project (CMIP6), which show little to no secular trends in dust deposition, concentration, and optical depth. The DustCOMM emissions thus enable ESMs to account for the historical radiative forcings (RFs), including due to dust direct interactions with radiation (direct RF). Our CESM2 simulations estimate a 1981–2000 minus 1851–1870 direct RF of −0.10 W m−2 by dust aerosols up to 10 µm in diameter (PM10) at the top of atmosphere (TOA). This global dust emission dataset thus enables models to more accurately account for historical aerosol forcings, thereby improving climate change projections such as those in the Intergovernmental Panel on Climate Change (IPCC) assessment reports.
more »
« less
Mineral dust cycle in the Multiscale Online Nonhydrostatic AtmospheRe CHemistry model (MONARCH) Version 2.0
Abstract. We present the dust module in the Multiscale Online Non-hydrostatic AtmospheRe CHemistry model (MONARCH) version 2.0, a chemical weather prediction system that can be used for regional and global modeling at a range of resolutions. The representations of dust processes in MONARCH were upgraded with a focus on dust emission (emission parameterizations, entrainment thresholds, considerations of soil moisture and surface cover), lower boundary conditions (roughness, potential dust sources), and dust–radiation interactions. MONARCH now allows modeling of global and regional mineral dust cycles using fundamentally different paradigms, ranging from strongly simplified to physics-based parameterizations. We present a detailed description of these updates along with four global benchmark simulations, which use conceptually different dust emission parameterizations, and we evaluate the simulations against observations of dust optical depth. We determine key dust parameters, such as global annual emission/deposition flux, dust loading, dust optical depth, mass-extinction efficiency, single-scattering albedo, and direct radiative effects. For dust-particle diameters up to 20 µm, the total annual dust emission and deposition fluxes obtained with our four experiments range between about 3500 and 6000 Tg, which largely depend upon differences in the emitted size distribution. Considering ellipsoidal particle shapes and dust refractive indices that account for size-resolved mineralogy, we estimate the global total (longwave and shortwave) dust direct radiative effect (DRE) at the surface to range between about −0.90 and −0.63 W m−2 and at the top of the atmosphere between −0.20 and −0.28 W m−2. Our evaluation demonstrates that MONARCH is able to reproduce key features of the spatiotemporal variability of the global dust cycle with important and insightful differences between the different configurations.
more »
« less
- PAR ID:
- 10327923
- Date Published:
- Journal Name:
- Geoscientific Model Development
- Volume:
- 14
- Issue:
- 10
- ISSN:
- 1991-9603
- Page Range / eLocation ID:
- 6403 to 6444
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract. Mineral dust aerosols cool and warm the atmosphere byscattering and absorbing solar (shortwave: SW) and thermal (longwave: LW)radiation. However, significant uncertainties remain in dust radiativeeffects, largely due to differences in the dust size distribution andspectral optical properties simulated in Earth system models. Dust modelstypically underestimate the coarse dust load (more than 2.5 µm indiameter) and assume a spherical shape, which leads to an overestimate ofthe fine dust load (less than 2.5 µm) after the dust emissions in themodels are scaled to match observed dust aerosol optical depth at 550 nm(DAOD550). Here, we improve the simulated dust properties with data setsthat leverage measurements of size-resolved dust concentration, asphericityfactor, and refractive index in a coupled global chemical transport modelwith a radiative transfer module. After the adjustment of size-resolved dustconcentration and spectral optical properties, the global and annual averageof DAOD550 from the simulation increases from 0.023 to 0.029 and fallswithin the range of a semi-observationally based estimate (0.030 ± 0.005). The reduction of fine dust load after the adjustment leads to areduction of the SW cooling at the top of the atmosphere (TOA). To improveagreement against a semi-observationally based estimate of the radiativeeffect efficiency at TOA, we find that a less absorptive SW dust refractiveindex is required for coarser aspherical dust. Thus, only a minor differenceis estimated for the net global dust radiative effect at TOA (−0.08 vs.−0.00 W m−2 on a global scale). Conversely, our sensitivitysimulations reveal that the surface warming is substantially enhanced nearthe strong dust source regions (less cooling to −0.23 from −0.60 W m−2 on a global scale). Thus, less atmospheric radiativeheating is estimated near the major source regions (less heating to 0.15from 0.59 W m−2 on a global scale), because of enhanced LWwarming at the surface by the synergy of coarser size and aspherical shape.more » « less
-
Abstract. Nitrate (NO3-) aerosol is projected to increase dramatically in the coming decades and may become the dominant inorganic particle species. This is due to the continued strong decrease in SO2 emissions, which is not accompanied by a corresponding decrease in NOx and especially NH3 emissions. Thus, the radiative effect (RE) of NO3- aerosol may become more important than that of SO42- aerosol in the future. The physicochemical interactions of mineral dust particles with gas and aerosol tracers play an important role in influencing the overall RE of dust and non-dust aerosols but can be a major source of uncertainty due to their lack of representation in many global climate models. Therefore, this study investigates how and to what extent dust affects the current global NO3- aerosol radiative effect through both radiation (REari) and cloud interactions (REaci) at the top of the atmosphere (TOA). For this purpose, multiyear simulations nudged towards the observed atmospheric circulation were performed with the global atmospheric chemistry and climate model EMAC, while the thermodynamics of the interactions between inorganic aerosols and mineral dust were simulated with the thermodynamic equilibrium model ISORROPIA-lite. The emission flux of the mineral cations Na+, Ca2+, K+, and Mg2+ is calculated as a fraction of the total aeolian dust emission based on the unique chemical composition of the major deserts worldwide. Our results reveal positive and negative shortwave and longwave radiative effects in different regions of the world via aerosol–radiation interactions and cloud adjustments. Overall, the NO3- aerosol direct effect contributes a global cooling of −0.11 W m−2, driven by fine-mode particle cooling at short wavelengths. Regarding the indirect effect, it is noteworthy that NO3- aerosol exerts a global mean warming of +0.17 W m−2. While the presence of NO3- aerosol enhances the ability of mineral dust particles to act as cloud condensation nuclei (CCN), it simultaneously inhibits the formation of cloud droplets from the smaller anthropogenic particles. This is due to the coagulation of fine anthropogenic CCN particles with the larger nitrate-coated mineral dust particles, which leads to a reduction in total aerosol number concentration. This mechanism results in an overall reduced cloud albedo effect and is thus attributed as warming.more » « less
-
null (Ed.)Abstract. Even though desert dust is the most abundant aerosol bymass in Earth's atmosphere, atmospheric models struggle to accuratelyrepresent its spatial and temporal distribution. These model errors arepartially caused by fundamental difficulties in simulating dust emission incoarse-resolution models and in accurately representing dust microphysicalproperties. Here we mitigate these problems by developing a new methodologythat yields an improved representation of the global dust cycle. We presentan analytical framework that uses inverse modeling to integrate an ensembleof global model simulations with observational constraints on the dust sizedistribution, extinction efficiency, and regional dust aerosol opticaldepth. We then compare the inverse model results against independentmeasurements of dust surface concentration and deposition flux and find thaterrors are reduced by approximately a factor of 2 relative to currentmodel simulations of the Northern Hemisphere dust cycle. The inverse modelresults show smaller improvements in the less dusty Southern Hemisphere,most likely because both the model simulations and the observationalconstraints used in the inverse model are less accurate. On a global basis,we find that the emission flux of dust with a geometric diameter up to 20 µm (PM20) is approximately 5000 Tg yr−1, which is greater than mostmodels account for. This larger PM20 dust flux is needed to matchobservational constraints showing a large atmospheric loading of coarsedust. We obtain gridded datasets of dust emission, vertically integratedloading, dust aerosol optical depth, (surface) concentration, and wet anddry deposition fluxes that are resolved by season and particle size. As ourresults indicate that this dataset is more accurate than current modelsimulations and the MERRA-2 dust reanalysis product, it can be used toimprove quantifications of dust impacts on the Earth system.more » « less
-
Abstract The shortwave direct radiative effect of dust, the difference between net shortwave radiative flux in a cloud free and cloud and aerosol free atmosphere, is typically estimated using forward calculations made with a radiative transfer model. However, estimates of the direct radiative effect made via this initial method can be highly uncertain due to difficultly in accurately describing the relevant optical and physical properties of dust used in these calculations. An alternative approach to estimate this effect is to determine the forcing efficiency, or the direct radiative effect normalized by aerosol optical depth. While this approach avoids the uncertainties associated with the initial method for calculating the direct effect, random errors and biases associated with this approach have not been thoroughly examined in literature. Here we explore biases in this observation‐based approach that are related to atmospheric water vapor. We use observations to show that over the Sahara Desert dust optical depth and column‐integrated atmospheric water vapor are positively correlated. We use three idealized radiative models of varying complexity to demonstrate that a positive correlation between dust and water vapor produces a positive bias in the dust forcing efficiency estimated via the observation‐based method. We describe a simple modification to the observation‐based method that correctly accounts for the correlation between dust and water vapor when estimating the forcing efficiency and use this method to estimate the instantaneous forcing efficiency of dust over the Sahara Desert using satellite data, obtaining −12.3 ± 6.68 to 20.9 ± 11.9 W m−2per unit optical depth.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.5194/gmd-14-6403-2021
