An official website of the United States government
Excess electrons in liquid acetonitrile are of particular interest because they exist in two different forms in equilibrium: they can be present as traditional solvated electrons in a cavity, and they can form some type of solvated molecular anion. Studies of small acetonitrile cluster anions in the gas phase show two isomers with distinct vertical detachment energies, and it is tempting to presume that the two gas-phase cluster anion isomers are precursors of the two excess electron species present in bulk solution. In this paper, we perform DFT-based ab initio molecular dynamics simulations of acetonitrile cluster anions to understand the electronic species that are present and why they have different binding energies. Using a long-range-corrected density functional that was optimally tuned to describe acetonitrile cluster anion structures, we have theoretically explored the chemistry of (CH3CN)n¯ cluster anions with sizes n=5,7 and 10. Since the temperature of the experimental cluster anions is not known, we performed two sets of simulations that investigated how the way in which the cluster anions are prepared affects the excess electron binding motif: one set of simulations simply attached excess electrons to neutral (CH3CN)n clusters, providing little opportunity for the clusters to relax in the presence of the excess electron, while the other set allowed the cluster anions to thermally equilibrate near room temperature. We find that both sets of simulations show three distinct electron binding motifs: electrons can attach to the surface of the cluster (dipole-bound) or be present as either solvated monomer anions, CH3CN¯, or as solvated molecular dimer anions, (CH3CN)2¯. All three species have higher binding energies at larger cluster sizes. Thermal equilibration strongly favors the formation of the valence-bound molecular anions relative to surface-bound excess electrons, and the dimer anion becomes more stable than the monomer anion and surface-bound species as the cluster size increases. The calculated photoelectron spectra from our simulations in which there was poor thermal equilibration are in good agreement with experiment, suggesting assignment of the two experimental cluster anion isomers as the surface-bound electron and the solvated molecular dimer anion. The simulations also suggest that the shoulder seen experimentally on the low-energy isomer's detachment peak is not part of a vibronic progression but instead results from molecular monomer anions. Nowhere in the size range that we explore do we see evidence for a non-valence, cavity-bound interior-solvated electron, indicating that this species is likely only accessible at larger sizes with good thermal equilibration.
more »
« less
Influence of geometry on positron binding to molecules
Abstract Annihilation studies have established that positrons bind to most molecules. They also provide measurements of the positron-molecule binding energies, which are found to vary widely and depend upon molecular size and composition. Trends of binding energy with global parameters such as molecular polarizability and dipole moment have been discussed previously. In this paper, the dependence of binding energy on molecular geometry is investigated by studying resonant positron annihilation on selected pairs of isomers. It is found that molecular geometry can play a significant role in determining the binding energies even for isomers with very similar polarizabilities and dipole moments. The possible origins of this dependence are discussed.
more »
« less
- Award ID(s):
- 2010699
- PAR ID:
- 10333590
- Date Published:
- Journal Name:
- Journal of Physics B: Atomic, Molecular and Optical Physics
- Volume:
- 54
- Issue:
- 22
- ISSN:
- 0953-4075
- Page Range / eLocation ID:
- 225201
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The use of Coincidence Doppler-Broadened (CDB) positron annihilation spectra for surface analysis requires ensuring that a significant fraction of the annihilation signal originates from positrons annihilating at the surface. We present measurements of CDB spectra obtained using a high-purity germanium (HPGe) detector in coincidence with a sodium iodide (NaI) detector for a series of incident positron beam energies ranging from 2 eV to 20 keV on multilayer graphene (6–8 layers) on copper. The CDB data were analyzed by fitting the Doppler spectra using a linear combination of spectra derived from measured data obtained at the incident beam energies mentioned together with a Gaussian function representing the spectrum associated with para-positronium decay. These fits were used to determine the fraction of incident positrons that annihilate at the surface and in the bulk. We compare the results obtained from fitting the full Doppler-broadened spectra with those derived from a VEPFIT analysis of the S parameters as a function of beam energy, using the same set of Doppler spectra. Both approaches indicate that most annihilation events occur at the surface for beam energies below 5 keV. However, the results from full spectrum fitting suggest a significantly larger bulk annihilation fraction than VEPFIT in the 100 eV to 5 keV range, highlighting the importance of accounting for bulk contributions when using CDB for surface analysis at beam energies above 100 eV.more » « less
-
Slow positrons are generated from a 22Na source and cone-shaped solid neon moderator and extracted as a magnetically guided beam. Measurements are presented for the mean parallel and perpendicular energies and the radial distribution of the beam particles. Over a distance of 7 m, where the magnetic field B varies from 0.005 to 0.12 T, the beam transport is found to be adiabatic for mean energies up to 50 eV. Non-adiabatic effects, evidenced by an increase in energy in motion perpendicular to B, are observed at larger transport energies. The implications of these observations for buffer-gas positron traps and other positron-transport beamlines are discussed.more » « less
-
We present the design of a pair spectrometer for use at FACET-II, where there is a need for spectroscopy of photons having energies up to 10 GeV. Incoming gammas are converted to high-energy positron-electron pairs, which are then subsequently analyzed in a dipole magnet. These charged particles are then recorded in arrays of acrylic Cherenkov counters, which are significantly less sensitive to background x-rays than scintillator counters in this case. To reconstruct energies of single high-energy photons, the spectrometer has a sensitivity to single positron-electron pairs. Even in this single-photon limit, there is always some low-energy continuum present, so spectral deconvolution is not trivial, for which we demonstrate a maximum likelihood reconstruction. Finally, end-to-end simulations of experimental scenarios, together with anticipated backgrounds, are presented.more » « less
-
The preparation, isolation, and identification of dinitro, trinitro, and tetranitro metalloporphyrins bearing nitro groups on pyrrole rings—desirable intermediates that enable fundamental changes in the chemico‐physical properties of the porphyrin core—are studied. All six possible dinitro‐Ni‐TPP isomers are formed; three are isolated as pure substances using column chromatography, while the remaining three are inseparable. All possible trinitro‐Ni‐TPP isomers are prepared and isolated, except for the 2,7,13 isomer. Attempts to synthesize tetranitro‐Ni‐TPP either through direct nitration of metalloporphyrin or via direct condensation of the nitropyrrole building blocks are unsuccessful. The molecular structures are unambiguously identified using 2D NMR experiments. Some experimental observations, though not all, are consistent with quantum chemical calculations performed on the geometry, energy, Fukui indices, dipole moments of nitroporphyrins, and the energy of nitration intermediates.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1088/1361-6455/ac3e78
