An official website of the United States government
In July 2019, approximately 217 km of 2-D multichannel seismic reflection data were collected along 27 profiles on Oneida Lake, New York using a 120 channel Seamux™ solid-towed array marine streamer with a 3.125 m group interval and a maximum offset of ~400 meters. Data were originally recorded in SEG-D format on a NTRS2 recording system. Navigational data and ancillary data (ship speed, depth, etc.) were fed into the external header of each field file. The seismic source was a 4x10 in3 Bolt 2800 LLX airgun array and was towed at ~1 meter depth to allow for venting of seismic source air bubbles. Gun pressures varied from 1500 to 2000 PSI. Air guns were fired every 6.25 m distance using two high resolution (Trimble) GPS receivers for navigation. This geometry provided 30-fold seismic coverage with a common midpoint (CMP) interval of 1.56 m. Record length is 2 seconds and the sample rate is 0.25 ms. The following processing steps were applied to the dataset using SeisSpace/ProMAX Software. Data were initially reviewed in shot mode and noisy traces were edited. Geometry was applied using source and receiver offsets with group and shot intervals, and data were sorted into the CMP domain. Stacking velocities were picked using a combination of velocity semblance plots and constant velocity stacks applied to CMP supergathers. For the constant velocity stacks, supergathers were constructed from 51 CMPs and analyzed in increments of 100 CMPs. Once time-velocity pairs were selected, normal moveout was applied to the full profile data set and the data were stacked.Nested Ormsby bandpass filters of 110-135-1500-1700 Hz and 40-70-1100-1300 Hz were applied to the stacked datasets. Ormsby filter frequencies were picked by executing a careful parameter test where frequencies were altered incrementally until the ideal filter was produced. A post-stack F-K filter was applied to remove steeply dipping noise, and a careful comparison of F-K filtered profiles and raw profiles was conducted. A post-stack Kirchhoff time migration with a 200 ms bottom taper was applied using the RMS stacking velocities picked for each seismic profile. The data files are in SEG-Y format and were generated as part of a project called P2C2: A High Resolution Paleoclimate Archive of Termination I in Oneida Lake and Glacial Lake Iroquois Sediments. Funding was provided through NSF grant EAR18-04460 to Syracuse University.
more »
« less
Raw 2-D multichannel seismic reflection SEG-D shot data from Oneida Lake, New York (2019)
In July 2019, approximately 217 km of 2-D multichannel seismic reflection data were collected along 27 profiles on Oneida Lake, New York using a 120 channel Seamux™ solid-towed array marine streamer with a 3.125 m group interval and a maximum offset of ~400 meters. Data were recorded in SEG-D format on a NTRS2 recording system. The seismic source was a 4x10 in3 Bolt 2800 LLX airgun array and was towed at ~1 meter depth to allow for venting of seismic source air bubbles. Gun pressures varied from 1500 to 2000 PSI. Air guns were fired every 6.25 m distance using two high resolution (Trimble) GPS receivers for navigation. This geometry provided 30-fold seismic coverage with a common midpoint (CMP) interval of 1.56 m. Record length is 2 seconds and the sample rate is 0.25 ms. These raw field shot data files are in SEG-D format, bundled by seismic line. The files were acquired as part of a project called P2C2: A High Resolution Paleoclimate Archive of Termination I in Oneida Lake and Glacial Lake Iroquois Sediments. Funding was provided through NSF grant EAR18-04460 to Syracuse University.
more »
« less
- Award ID(s):
- 1804460
- PAR ID:
- 10336289
- Publisher / Repository:
- Interdisciplinary Earth Data Alliance (IEDA)
- Date Published:
- Edition / Version:
- 1
- Subject(s) / Keyword(s):
- Seismic:Reflection:MCS
- Format(s):
- Medium: X Other: application/seismic-segd
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This data set consists of raw multi-channel seismic reflection (MCS) data in SEG-Y format, collected in July 2022 along the continental slope of the Campeche Bank aboard R/V Justo Sierra. The research objective was to map the detailed stratigraphy of sediment drift deposits to explore the history of the Loop Current and its climatic implications. We used the portable high-resolution seismic acquisition system operated by Scripps Institution of Oceanography, which comprised a source array of two 45 cubic inches G.I. air-guns and a GeoEel streamer with 120 channels at a spacing of 6.25 m. The air-gun array was fired every 12.5 m and was towed at a depth of 3 m. Data was recorded using the Geometrics seismic recording system with sample rate of 0.5 ms and recording length of 4 ms. A 50-ms delay was created during each shot as a buffer between the timing pulse that starts the recording and the trigger pulse that fires the air-guns. A total of 11 seismic lines were acquired including two long strike lines, five dip lines, two tilted dip lines and two short transition lines. The shot spacing was not exactly 12.5 m during the first three lines (1001-1003) due to system glitches, therefore, it is necessary to merge navigation with SEG-Y headers to ensure accurate processing of these lines. Detailed acquisition parameters and cruise incidents are described in the associated documents. Funding for this work was provided through NSF awards OCE-1928888 and OCE-1450528, and CONTEX award 2018-38A.more » « less
-
The deglaciation record of the Ontario Lowland and Mohawk Valley of North America is important for constraining the retreat history of the Laurentide Ice Sheet, end-Pleistocene paleoclimate, and ice-sheet processes. The Mohawk Valley was an important meltwater drainage route during the last deglaciation, with the area around modern Oneida Lake acting as a valve for meltwater discharge into the North Atlantic Ocean. The Mohawk Valley was occupied by the Oneida Lobe and Oneida Ice Stream during the last deglacial period. Multichannel seismic reflection data can be used to generate images of preglacial surfaces and internal structures of glacial bedforms and proglacial lake deposits, thus contributing to studies of deglaciation. This paper uses 217 km of offshore multichannel seismic reflection data to image the entire Quaternary section of the Oneida basin. A proglacial lake and paleo-calving margin is interpreted, which likely accelerated the Oneida Ice Stream, resulting in elongated bedforms observed west of the lake. The glacial bedforms identified in this study are buried by proglacial lake deposits, indicating the Oneida basin contains a record of glacial meltwater processes, including a 60-m-thick proglacial interval in eastern Oneida Lake.more » « less
-
Abstract Ice streams are sites of ice-sheet drainage and together with other processes, such as calving, have an impact on deglaciation rates and ice-sheet mass balance. Proglacial lake deposits provide records of ice-sheet deglaciation and have the potential to supplement other paleoclimate records. Oneida Lake, northeastern USA, contains a thick proglacial lake sequence that buries evidence of ice streaming and a paleo-calving margin that developed during retreat of the Laurentide Ice Sheet. Previous high-resolution digital elevation models identified the Oneida Ice Stream from glacial landforms northwest of the lake. In this study, we utilize seismic refractions from a multichannel seismic (MCS) reflection dataset to estimate the thickness of glacial deposits using seismic tomography. With this method we constrain the depth to top of Paleozoic strata, especially in areas where the reflection data yielded poor outcomes and validate our reflection data in regions of good coverage. We demonstrate that where long offset seismic data are available, the first-arrival tomography method is useful in studies of formerly glaciated basins. Our study identifies a ~108 m thick sedimentary section and potentially long paleoclimate record in Oneida Lake, and identifies a paleotopographic low that likely encouraged formation of the Oneida Ice Stream.more » « less
-
Oneida Lake, New York, is the remnant of Glacial Lake Iroquois, a large proglacial lake that delivered fresh water to the Atlantic Ocean during the last deglaciation. The formation of Glacial Lake Iroquois and its subsequent drainage into the Atlantic Ocean via the Mohawk Valley was a significant shift in the routing of Laurentide Ice Sheet meltwater to the east instead of south via the Allegheny or Susquehanna Rivers. Catastrophic drainage of Glacial Lake Iroquois into the Atlantic Ocean via the Champlain Valley is interpreted as the meltwater pulse responsible for the Intra-Allerod cold stadial. Therefore, understanding the evolution of Glacial Lake Iroquois has significant implications for understanding late Pleistocene paleoclimate. High-resolution CHIRP seismic reflection data provides insight into the evolution of Glacial Lake Iroquois and Oneida Lake. Three seismic units image distinct stages of the Oneida Basin. Unit 1 is interpreted as proglacial lake deposits that overlie glacial till. Unit 2 is interpreted as sediments deposited when the Oneida Basin became isolated from Glacial Lake Iroquois and Unit 3 is interpreted as lacustrine sediments of the modern lake. Distally sourced turbidites possibly triggered by seismic activity or ice sheet meltwater pulses are represented as reflection- free acoustic facies that infill topographic lows and range in thickness from ~1–5m within otherwise conformable proglacial lake deposits. Local slump deposits imaged at the boundary between Unit 1 and 2 were likely triggered by the drainage of Glacial Lake Iroquois. Wave cut terraces indicative of a low stand on the upper bounding surface of Unit 2 are likely the result of drier conditions during the Holocene Hypsithermal. Furthermore, preservation of this low stand suggests a rapid rise in lake level, possibly the result of the same transition to a wetter climate responsible for the Nipissing transgression observed in the Laurentian Great lakes.more » « less
