An official website of the United States government
Abstract Oxygen and hydrogen stable isotope analyses of quartz and muscovite veins from the footwall of the Raft River detachment shear zone (Utah) provide insight into the hydrology and fluid‐rock interactions during ductile deformation. Samples were collected from veins containing 90%–100% quartz with orientations either at a high angle or sub‐parallel to the surrounding quartzite mylonite foliation. Stable isotope analysis was performed on 10 samples and compared with previous quartzite mylonite isotope data sets. The results indicate that the fluid present during deformation of the shear zone was meteoric in origin, with a δ2H value of approximately −100‰ and a δ18O value of approximately −13.7‰. Oxygen stable isotope O18O depletion correlates with the muscovite content of the analyzed rocks. Many of the analyzed samples in this and other studies show an apparent lack of equilibrium between the oxygen and hydrogen isotope systems, which can be explained by hydrogen and oxygen isotope exchange at varying fluid‐rock ratios. Our results suggest that the Raft River detachment shear zone had a low static fluid‐rock ratio (<0.1), yet experienced episodic influxes of fluids through semi‐brittle structures. This fluid was then expelled out into the surrounding mylonite following progressive shearing, causing further18O‐depletion and fluid‐related embrittlement.
more »
« less
Role of fluids on deformation in mid-crustal shear zones, Raft River Mountains, Utah
Abstract Fluids are commonly invoked as the primary cause for weakening of detachment shear zones. However, fluid-related mechanisms such as pressure-solution, reaction-enhanced ductility, reaction softening and precipitation of phyllosilicates are not fully understood. Fluid-facilitated reaction and mass transport cause rheological weakening and strain localization, eventually leading to departure from failure laws derived in laboratory experiments. This study focuses on the Miocene Raft River detachment shear zone in northwestern Utah. The shear zone is localized in the Proterozoic Elba Quartzite, which unconformably overlies the Archaean basement, and consists of an alternating sequence of quartzite and muscovite-quartzite schist. In this study, we characterize fluid-related microstructures to constrain conditions that promoted brittle failure in a plastically deforming shear zone. Thin-section analyses reveal the presence of healed microcracks, transgranular fluid inclusion planes and grain boundary fluid inclusion clusters. Healed microcracks occur in three sets, one sub-perpendicular to the mylonitic foliation, and a set of two conjugate microcracks oriented at ∼40–60° to the mylonitic foliation. Healed microfractures are filled with quartz, which has a distinct fabric, suggesting that microcracks healed while the shear zone was still at conditions favourable for quartz crystal plasticity. Transgranular fluid inclusion planes also occur in three sets, similar in orientation to the healed microfractures. Fluid inclusions commonly decorate grain and subgrain boundaries as inter- and intragranular clusters. Our results document ductile overprint of brittle microstructures, suggesting that, during exhumation, the Raft River detachment shear zone crossed the brittle–ductile transition repeatedly, providing pathways for fluids to permeate through this shear zone.
more »
« less
- Award ID(s):
- 1849812
- PAR ID:
- 10337863
- Date Published:
- Journal Name:
- Geological Magazine
- ISSN:
- 0016-7568
- Page Range / eLocation ID:
- 1 to 13
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Quartz deformation fabrics reflect stress and strain conditions in mylonites, and their interpretation has become a mainstay of kinematic and structural analysis. Quantification of grain size and shape and interpretation of textures reflecting deformation mechanisms can provide estimates of flow stress, strain rate, kinematic vorticity, and deformation temperatures. Empirical calibration and determination of quartz flow laws is based on laboratory experiments of pure samples; however, pure quartzite mylonites are relatively uncommon. In particular, phyllosilicates may localize and partition strain that can inhibit or enhance different deformation mechanisms. Experimental results demonstrate that even minor phyllosilicate content (<15 vol%) can dramatically alter the strain behavior of quartz; however, few field studies have demonstrated these effects in a natural setting. To investigate the role of phyllosilicates on quartz strain fabrics, we quantify phyllosilicate content and distribution in quartzite mylonites from the Miocene Raft River detachment shear zone (NW Utah, USA). We use microstructural analysis and electron backscatter diffraction to quantify quartz deformation fabrics and muscovite spatial distribution, and X-ray computed tomography to quantify muscovite content in samples with varying amounts of muscovite collected across the detachment shear zone. Phyllosilicate content has a direct control on quartz deformation mechanisms, and application of piezometers and flow laws based on quartz deformation fabrics yield strain rates and flow stresses that vary by up to two orders of magnitude across our samples. These findings have important implications for the application of flow laws in quartzite mylonites and strain localization mechanisms in mid-crustal shear zones.more » « less
-
We investigate the deformation conditions of coeval mylonites and pseudotachylytes (pst) exposed in the brittle-ductile transition (BDT) in the Black Belt Shear Zone (BBSZ) in the Southern California Batholith using SEM (Scanning Electron Microscope) imaging, and Electron Backscatter Diffraction (EBSD) analysis. We selected four representative samples along a strain gradient of the BBSZ. The BBSZ is a transpressional shear zone developed within hornblende and biotite tonalites and diorites. The shear zone is discontinuous over a ~ 1.5 - 2 km wide zone, and kinematic indicators show oblique top-to-SW, sinistral-reverse to thrust-sense motion. Metamorphic titanite grains aligned within the mylonitic fabric date the deformation to ~ 83 Ma. SEM and EBSD data show mm-thick seams of pst contained within and parallel to mylonitic foliation, and mutually overprinting relationships between brittle and plastic deformation. We observe a brittle overprint of mylonitic fabric in sample 46 and fractured porphyroclasts reworked into mylonitic fabric in samples 45 and 47. EBSD maps from sample 45 and 47 show decreasing modal percentages of hydrous mafic minerals (biotite and hornblende) in the mylonites with proximity to pst seams, suggesting these melted to form pst. In pst seams, there are embayed and rounded/elliptical plagioclase survivor clasts and acicular and aligned biotite microlites parallel to mylonitic fabric (45 & 47). EBSD maps show pst survivor clasts with the same shear sense as the mylonitic fabric, suggesting co-development. Pole figures show weak CPO in hornblende and plagioclase of sample 46. Samples 45 and 47 have no CPO present in plagioclase, however samples 45, 46, and 47 show strong CPO patterns for quartz that are consistent with prism slip. We interpret dislocation creep as the deformation mechanism accommodating plastic deformation in host mylonites. Quartz CPO patterns provide evidence of mylonitic deformation at temperatures ~ 600o C, and the presence of plagioclase survivor clasts as evidence of pst temperatures of ~1100oC. The kinematically consistent sense of shear between pst and host mylonitic fabrics suggests coeval development that indicate shifts from brittle to ductile deformation. Our results suggest periodic pst-generating events involving melting of hydrous mafic minerals aided the development of coeval mylonites and pst in the BDT.more » « less
-
Abstract Oceanic transform faults represent abundant yet relatively unexplored components of the hydrologic cycle in the mantle lithosphere. Current models limit fluid circulation to 600 °C, the thermal limit of earthquakes recorded by teleseismic surveys. However, recent ocean‐bottom seismic surveys have located earthquakes at depths corresponding to >1000 °C in modeled thermal structure. To constrain the depth extent of brittle deformation and fluid infiltration, we analyzed peridotite mylonites dredged from the Shaka Transform Fault, Southwest Indian Ridge. Samples range from high strain mylonites that preserve ductile microstructures to lower strain mylonites that are fractured and overprinted by hydrothermal alteration. Microstructural analysis of the high strain samples reveals brittle deformation of pyroxene concomitant with ductile deformation of olivine and growth of amphibole. Porphyroclasts preserve healed fractures filled with fluid inclusions, implying repeated episodes of fracture, fluid infiltration, and healing. The association of hydration features with brittle structures points to seawater, rather than melt, as the fluid source. Textural analysis indicates that strain localization was initiated by grain boundary pinning and that olivine grain size was reduced to ~1 μm in the presence of amphibole. Comparing the amphibole stability field to thermometry estimates for the limit of recrystallization suggests that fluid flow extended to ~650–850 °C. Our results indicate that the hydrologic cycle extends past the brittle‐ductile transition and promotes strain localization via hydrolytic weakening and hydration reactions. We propose that seawater infiltration on oceanic transform faults is driven by the seismic cycle and represents a first order control on the rheology of the oceanic lithosphere.more » « less
-
Abstract Many low-angle normal faults (dip ≤30°) accommodate tens of kilometers of crustal extension, but their mechanics remain contentious. Most models for low-angle normal fault slip assume vertical maximum principal stress σ1, leading many authors to conclude that low-angle normal faults are poorly oriented in the stress field (≥60° from σ1) and weak (low friction). In contrast, models for low-angle normal fault formation in isotropic rocks typically assume Coulomb failure and require inclined σ1 (no misorientation). Here, a data-based, mechanical-tectonic model is presented for formation of the Whipple detachment fault, southeastern California. The model honors local and regional geologic and tectonic history and laboratory friction measurements. The Whipple detachment fault formed progressively in the brittle-plastic transition by linking of “minidetachments,” which are small-scale analogs (meters to kilometers in length) in the upper footwall. Minidetachments followed mylonitic anisotropy along planes of maximum shear stress (45° from the maximum principal stress), not Coulomb fractures. They evolved from mylonitic flow to cataclasis and frictional slip at 300–400 °C and ∼9.5 km depth, while fluid pressure fell from lithostatic to hydrostatic levels. Minidetachment friction was presumably high (0.6–0.85), based upon formation of quartzofeldspathic cataclasite and pseudotachylyte. Similar mechanics are inferred for both the minidetachments and the Whipple detachment fault, driven by high differential stress (∼150–160 MPa). A Mohr construction is presented with the fault dip as the main free parameter. Using “Byerlee friction” (0.6–0.85) on the minidetachments and the Whipple detachment fault, and internal friction (1.0–1.7) on newly formed Reidel shears, the initial fault dips are calculated at 16°–26°, with σ1 plunging ∼61°–71° northeast. Linked minidetachments probably were not well aligned, and slip on the evolving Whipple detachment fault probably contributed to fault smoothing, by off-fault fracturing and cataclasis, and to formation of the fault core and fractured damage zone. Stress rotation may have occurred only within the mylonitic shear zone, but asymmetric tectonic forces applied to the brittle crust probably caused gradual rotation of σ1 above it as a result of: (1) the upward force applied to the base of marginal North America by buoyant asthenosphere upwelling into an opening slab-free window and/or (2) basal, top-to-the-NE shear traction due to midcrustal mylonitic flow during tectonic exhumation of the Orocopia Schist. The mechanical-tectonic model probably applies directly to low-angle normal faults of the lower Colorado River extensional corridor, and aspects of the model (e.g., significance of anisotropy, stress rotation) likely apply to formation of other strong low-angle normal faults.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1017/S0016756822000231
