The 3.65 Å phase [MgSi(OH)6] is a hydrous phase that is predicted to be stable in a simplified MgO-SiO2-H2O (MSH) ternary system at pressures exceeding 9 GPa. Along cold subduction zones, it is likely to transport water, bound in its crystalline lattice, into the Earth’s interior. The 3.65 Å phase consists of Mg and Si octahedral sites attached to the hydroxyl group that forms a hydrogen bond and is predicted to undergo pressure-induced symmetrization of the hydrogen bond. Therefore, in this study, we investigate the high-pressure behavior of the 3.65 Å phase using Raman spectroscopy. We have conducted five distinct compressions up to ~60 GPa using two different pressure-transmitting media—alcohol mixture and neon. At ambient conditions, we identified vibrational modes using complementary first-principles simulations based on density functional perturbation theory. Upon compression, we note that the first derivative of the vibrational modes in the lattice region stiffens, i.e., b1lattice > 0. In contrast, the hydroxyl region softens, i.e., b1OH > 0. This is indicative of the strengthening of hydrogen bonding upon compression. We noticed a significant broadening of vibrational modes related to hydroxyl groups that are indicative of proton disorder. However, within the maximum pressures explored in this study, we did not find evidence for pressure-induced symmetrization of the hydrogen bonds. We used the pressure derivative of the vibrational modes to determine the ratio of the bulk moduli and their pressure derivative. We note that the smaller bulk moduli of hydrous phases compared to the major mantle phases are compensated by significantly larger pressure derivatives of the bulk moduli for the hydrous phases. This leads to a significant reduction in the elasticity contrast between hydrous and major mantle phases. Consequently, the detection of the degree of mantle hydration is likely to be challenging at greater depths.
Hydration-driven stabilization and volume collapse of grain boundaries in Mg2SiO4 forsterite predicted by first-principles simulations
Abstract Grain boundaries in mantle minerals are of critical importance to geophysical and geochemical processes of the Earth’s interior. One of the fundamental issues is to understand how the water (H2O) component influences the properties of grain boundaries in silicate materials. Here, we report the results of the structure and stability of several tilt grain boundaries in Mg2SiO4 forsterite over the pressure range 0 to 15 GPa using density functional theory-based first-principles simulations. The results suggest greater energetic stability and hydration-driven volume collapse (negative excess volume) at zero pressure for the majority of hydrous grain boundaries relative to the anhydrous (dry) ones. All the hydrous grain boundaries become increasingly favorable at elevated pressures as the calculated hydration enthalpy systematically decreases with increasing pressure. The hydrous components at the interfacial regions are predominantly in the hydroxyl form and, to a lesser extent, in the molecular H2O form. Their calculated ratio ranges from 1.6 to 8.7 among the different grain boundary configurations. Our structural analysis also reveals that the hydroxyls are bound to either both Mg and Si or to Mg only. In comparison, the molecular species are bound only to Mg sites. Besides direct oxygen-hydrogen bonding, intermolecular hydrogen bonding becomes important with compression. On the basis of our results, we suggest that local atomic rearrangements caused by dissociative adsorption of water facilitate efficient compaction of the boundary interfaces, which, in turn, results in greater relative stability of hydrous grain boundaries. This means that water prefers to be incorporated within the grain boundaries over the bulk of silicate materials.
more »
« less
- PAR ID:
- 10347046
- Date Published:
- Journal Name:
- American Mineralogist
- Volume:
- 107
- Issue:
- 4
- ISSN:
- 0003-004X
- Page Range / eLocation ID:
- 744 to 753
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract -
null (Ed.)Water (H2O) as one of the most abundant fluids present in Earth plays crucial role in the generation and transport of magmas in the interior. Though hydrous silicate melts have been studied extensively, the experimental data are confined to relatively low pressures and the computational results are still rare. Moreover, these studies imply large differences in the way water influences the physical properties of silicate magmas, such as density and electrical conductivity. Here, we investigate the equation of state, speciation, and transport properties of water dissolved in Mg1-xFexSiO3 and Mg2(1-x)Fe2xSiO4 melts (for x = 0 and 0.25) as well as in its bulk (pure) fluid state over the entire mantle pressure regime at 2000 to 4000 K using first-principles molecular dynamics. The simulation results allow us to constrain the partial molar volume of the water component in melts along with the molar volume of pure water. The predicted volume of silicate melt+water solution is negative at low pressures and becomes zero above 15 GPa. Consequently, the hydrous component tends to lower the melt density to similar extent over much of the mantle pressure regime irrespective of composition. Our results also show that hydrogen diffuses fast in silicate melts and enhances the melt electrical conductivity in a way that differs from electrical conduction in the bulk water. The speciation of the water component varies considerably from the bulk water structure as well. Water is dissolved in melts mostly as hydroxyls at low pressure and as -O-H-O-, -O-H-O-H- and other extended species with increasing pressure. On the other hand, the pure water behaves as a molecular fluid below 15 GPa, gradually becoming a dissociated fluid with further compression. On the basis of modeled density and conductivity results, we suggest that partial melts containing a few percent of water may be gravitationally trapped both above and below the upper mantle-transition region. Moreover, such hydrous melts can give rise to detectable electrical conductance by means of electromagnetic sounding observations.more » « less
-
more » « less
Abstract A comprehensive analysis of experimental data and theoretical simulations on the partial molar volume of water in silicate melt indicates that finite strain theory successfully describes the compression of the H2O component dissolved in silicate melt at high pressures and temperatures. However, because of the high compressibility of the water component, a fourth order equation of state fit is required to accurately simulate experimental results on water's volume in silicate melts at a deep upper mantle, transition zone, and lower mantle pressures. Data from previous shock compression experiments on hydrous minerals in which melting occurs along the Hugoniot are used to provide an experimental constraint on the partial molar volume of water in silicate melt at deep mantle temperatures and pressures. The equation of state of the water component indicates that, depending on elastic averaging technique, the amount of water that could be present in neutrally or negatively buoyant mafic/ultramafic melts above the 410 km seismic discontinuity is upper‐bounded at 5.6 wt%: smaller than previously inferred, and consistent with melt being confined to a narrow depth range above the 410 km discontinuity. If melt is predominantly distributed along grain boundaries in low aspect ratio films, extents of melting as low as 2% could produce observed seismic velocity reductions. The ability of the lowermost mantle to contain negatively buoyant hydrous liquids hinges on the trade‐off between iron content and hydration: at these depths, substantially higher degrees of hydration could be present within partial melts.
-
Abstract While the water storage capacities of the upper 700 km depths of the mantle have been constrained by high-pressure experiments and diamond inclusion studies, the storage capacity of the lower mantle remains controversial. A recent high-pressure experimental study on CaSiO3 perovskite, which is the third most abundant mineral in the lower mantle, reported possible storage of H2O up to a few weight percent. However, the substitution mechanism for H in this phase remains unknown. We have conducted a series of density functional theory calculations under static-lattice conditions and high pressures to elucidate hydration mechanisms at the atomic scale. All of the possible dodecahedral (Ca2+ → 2H+) and octahedral (Si4+ → 4H+) substitution configurations for a tetragonal perovskite lattice have very small energy differences, suggesting the coexistence of multiples of H configurations in CaSiO3 perovskite at mantle pressures and temperatures. The dodecahedral substitutions decrease the bulk modulus, resulting in a smaller unit-cell volume of hydrous CaSiO3 perovskite under pressure, consistent with the experimental observations. Although the octahedral substitutions also decrease the bulk modulus, they increase the unit-cell volume at 1 bar. The H atoms substituted in the dodecahedral sites develop much less hydrogen bonding with O atoms, leading to a large distortion in the neighboring SiO6 octahedra. Such distortion may be responsible for the non-cubic peak splittings observed in experiments on hydrous CaSiO3 perovskite. Our calculated infrared spectra suggest that the observed broad OH modes in CaSiO3 perovskite can result from the existence of multiples of H configurations in the phase. Combined with the recent experimental results, our study suggests that CaSiO3 can be an important mineral phase to consider for the H2O storage in the lower mantle.more » « less
-
null (Ed.)Volatiles including carbon and hydrogen are generally considered to be more soluble in silicate melts than in mantle rocks. How these melts contribute to the storage and distribution of key volatiles in Earth's interior today and during its early evolution, however, remains largely unknown. It is essential to improve our knowledge about volatiles-bearing silicate magmas over the entire mantle pressure regime. Here we investigate molten Mg FexSiO3 ( , 0.25) containing both carbon and hydrogen using first-principles molecular dynamics simulations. Our results show that the dissolution mechanism of the binary volatiles in melts varies considerably under different conditions of pressure and redox. When incorporated as CO2 and H2O components (corresponding to oxidizing conditions) almost all carbon and hydrogen form bonds with oxygen. Their speciation at low pressure consists of predominantly isolated molecular CO2, carbonates, and hydroxyls. More oxygenated species, including tetrahedrally coordinated carbons, hydrogen (O-H-O) bridges, various oxygen-joined complexes appear as melt is further compressed. When two volatiles are incorporated as hydrocarbons CH4 and C2H6 (corresponding to reducing conditions), hydroxyls are prevalent with notable presence of molecular hydrogen. Carbon-oxygen bonding is almost completely suppressed. Instead carbon is directly correlated with itself, hydrogen, and silicon. Both volatiles also show strong affinity to iron. Reduced volatile speciation thus involves polymerized complexes comprising of carbon, hydrogen, silicon, and iron, which can be mostly represented by two forms: C1−4H1−5Si0−5O0−2 (iron-free) and C5−8H1−8Si0−6Fe5−8O0−2. The calculated partial molar volumes of binary volatiles in their oxidized and reduced incorporation decrease rapidly initially with pressure and then gradually at higher pressures, thereby systematically lowering silicate melt density. Our assessment of the calculated opposite effects of the volatile components and iron on melt density indicates that melt-crystal density crossovers are possible in the present-day mantle and also could have occurred in early magma ocean environments. Melts at upper mantle and transition zone conditions likely dissolve carbon and hydrogen in a wide variety of oxidized and non-oxygenated forms. Deep-seated partial melts and magma ocean remnants at lower mantle conditions may exsolve carbon as complex reduced species possibly to the core during core-mantle differentiation while retaining a majority of hydrogen as hydroxyls-associated species.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.2138/am-2021-7732
