An official website of the United States government
Measurement of viscoelastic characteristics of cells cultured in 3D is critical to study many biological processes including tissue and organ growth. In this article, we present a unique electrical aspiration method to measure the viscoelastic properties of cell spheroids. A microfluidic sensor was created to demonstrate this method. Unlike the traditional optical aspiration method, the aspiration of the cell spheroids is monitored via monitoring the dynamic electrical resistance change of a symmetrical microfluidic aspiration channel. We first used the microfluidic device to measure the viscoelastic properties of two types of biological tissues derived from calfskin and porcine left ventricular myocardium. The equilibrium elastic modulus and creep time con-stants were measured to be 148.1±24.1 kPa and 76.7±3.5seconds and 64.5±7.7 kPa and 31.4±2.7 seconds respectively, which matched well with reported data. The test validated the principle of the electrical aspiration method. Next, we applied the method for measuring cell spheroids made of human mesenchymal stem cells at different culture stages. The equilibrium elastic modulus and apparent viscosity decreased with increasing culture time. Compared to optical aspiration methods, this microfluidic electrical aspiration method has no reliance on transparent materials and image processing, which thus allows simple set-up, fast data acquisition and analysis. The use of a symmetric aspiration channel and the linear half-space model enable measurements of a large number of viscoelastic properties via a single measurement with higher accuracy. This method will enable high throughput, continuous viscoelastic measurement of cell spheroids as well as other 3D cell culture models in flow conditions without the need for any optical measurements
more »
« less
A portable pen-sized instrumentation to measure stiffness of soft tissues in vivo
Abstract Quantitative assessment of soft tissue elasticity is crucial to a broad range of applications, such as biomechanical modeling, physiological monitoring, and tissue diseases diagnosing. However, the modulus measurement of soft tissues, particularly in vivo, has proved challenging since the instrument has to reach the site of soft tissue and be able to measure in a very short time. Here, we present a simple method to measure the elastic modulus of soft tissues on site by exploiting buckling of a long slender bar to quantify the applied force and a spherical indentation to extract the elastic modulus. The method is realized by developing a portable pen-sized instrument (EPen: Elastic modulus pen). The measurement accuracies are verified by independent modulus measures using commercial nanoindenter. Quantitative measurements of the elastic modulus of mouse pancreas, healthy and cancerous, surgically exposed but attached to the body further confirm the potential clinical utility of the EPen.
more »
« less
- Award ID(s):
- 1934991
- PAR ID:
- 10356603
- Date Published:
- Journal Name:
- Scientific Reports
- Volume:
- 11
- Issue:
- 1
- ISSN:
- 2045-2322
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract A method motivated by the eye’s aqueous veins is described for the imaging and strain calculation within soft biological tissues. A challenge to the investigation of the biomechanics of the aqueous vein—perilimbal sclera tissue complex is resolution of tissue deformations as a function of intraocular pressure and the subsequent calculation of strain (a normalized measure of deformation). The method involves perfusion of the eye with a contrast agent during conduction of non-invasive, optical resolution photoacoustic microscopy. This imaging technique permits three-dimensional displacement measurements of tracked points on the inner walls of the veins which are used in a finite element model to determine the corresponding strains. The methods are validated against two standard strain measurement methods. Representative porcine globe perfusion experiments are presented that demonstrate the power of the method to determine complex strain fields in the veins dependent on intraocular pressure as well as vein anatomy. In these cases, veins are observed to move radially outward during increases in intraocular pressure and to possess significant spatial strain variation, possibly influenced by their branching patterns. To the authors’ knowledge, these are the only such quantitative, data driven, calculations of the aqueous vein strains available in the open literature.more » « less
-
ABSTRACT There is growing evidence that minimizing the mechanical mismatch between neural implants and brain tissue mitigates inflammatory, biological responses at the interface under long-term implant conditions. The goal of this study is to develop a brain-like soft, conductive neural interface and use an improvised, penetrating microindentation technique reported by us earlier to quantitatively assess the (a) elastic modulus of the neural interface after implantation, (b) mechanical stresses during penetration of the probe, and (c) periodic stresses at steady-state due to tissue micromotion around the probe. We fabricated poly- dimethylsiloxane (PDMS) matrices with multi-walled carbon nanotubes (MWCNTs) using two distinct but carefully calibrated cross-linking ratios, resulting in hard (elastic modulus∼484 kPa) or soft, brain-like (elastic modulus∼5.7 kPa) matrices, the latter being at least 2 orders of magnitude softer than soft neural interfaces reported so far. Subsequent loading of the hard and soft silicone based matrices with (100% w/w) low-molecular weight PDMS siloxanes resulted in further decrease in the elastic modulus of both matrices. Carbon probes with soft PDMS coating show significantly less maximum axial forces (-587 ± 51.5 µN) imposed on the brain than hard PDMS coated probes (-1,253 ± 252 µN) during and after insertion. Steady-state, physiological micromotion related stresses were also significantly less for soft- PDMS coated probes (55.5 ± 17.4 Pa) compared to hard-PDMS coated probes (141.0 ± 21.7 Pa). The penetrating microindentation technique is valuable to quantitatively assess the mechanical properties of neural interfaces in both acute and chronic conditions.more » « less
-
Abstract BackgroundModern computational modeling could provide the key to obtaining new insights into the mechanisms of maize stalk failure as well as suggesting new ways to improve stalk strength. However, a complete set of mechanical properties of maize tissues is required to enable computational modeling of maize stems. This study developed two compression test methods for obtaining the longitudinal modulus of elasticity of both rind and pith tissues, assessed the influence of water content on tissue properties, and investigated the relationship between rind modulus and pith modulus. These methods involved uniform 5–7 cm segments of maize stems which were scanned using a flatbed scanner then tested in compression using a universal testing machine in both intact and dissected (rind-only and pith-only) states. ResultsThe modulus of elasticity of pith tissues was highest for fully turgid specimens and decreased as water was removed from the specimens. Water content was negatively correlated with the modulus of elasticity of the rind. Rind and pith tissues were found to be weakly correlated. The median ratio of rind modulus to pith modulus was found to be 17. Of the two methods investigated, the pith-only specimen preparation was found to be simple reliable while the rind-only method was found to be adversely affected by lateral bowing of the specimen. ConclusionsResearchers can use the information in this paper to improve computational models of maize stems in three ways: (1) by incorporating realistic values of the longitudinal modulus of elasticity of pith and rind tissues; (2) by selecting pith and rind properties that match empirically observed ratios; and (3) by incorporating appropriate dependencies between these material properties and water content. From an experimental perspective, the intact/pith-only experimental method outlined in this paper is simpler than previously reported methods and provides reliable estimates of both pith and rind modulus of elasticity values. Further research using this measurement method is recommended to more clearly understand the influence of water content and turgor pressure on tissue properties.more » « less
-
The elastic moduli of tissues are connected to their states of health and function. The epithelial monolayer is a simple, minimal, tissue model that is often used to gain understanding of mechanical behavior at the cellular or multi-cellular scale. Here we investigate how the elastic modulus of Madin Darby Canine Kidney (MDCK) cells depends on their packing density. Rather than measuring elasticity at the sub-cellular scale with local probes, we characterize the monolayer at the multicellular scale, as one would a thin slab of elastic material. We use a micro-indentation system to apply gentle forces to the apical side of MDCK monolayers, applying a normal force to approximately 100 cells in each experiment. In low-density confluent monolayers, we find that the elastic modulus decreases with increasing cell density. At high densities, the modulus appears to plateau. This finding will help guide our understanding of known collective behaviors in epithelial monolayers and other tissues where variations in cell packing density are correlated with cell motion.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1038/s41598-020-79735-8
