An official website of the United States government
Geophysical investigations documenting enhanced magnetic susceptibility (MS) within the water table fluctuation zone at hydrocarbon contaminated sites suggest that MS can be used as a proxy for investigating microbial mediated iron reduction during intrinsic bioremediation. Here, we investigated the microbial community composition over a 5-year period at a hydrocarbon-contaminated site that exhibited transient elevated MS responses. Our objective was to determine the key microbial populations in zones of elevated MS. We retrieved sediment cores from the petroleum-contaminated site near Bemidji, MN, United States, and performed MS measurements on these cores. We also characterized the microbial community composition by high-throughput 16S rRNA gene amplicon sequencing from samples collected along the complete core length. Our spatial and temporal analysis revealed that the microbial community composition was generally stable throughout the period of investigation. In addition, we observed distinct vertical redox zonations extending from the upper vadose zone into the saturated zone. These distinct redox zonations were concomitant with the dominant microbial metabolic processes as follows: (1) the upper vadose zone was dominated by aerobic microbial populations; (2) the lower vadose zone was dominated by methanotrophic populations, iron reducers and iron oxidizers; (3) the smear zone was dominated by iron reducers; and (4) the free product zone was dominated by syntrophic and methanogenic populations. Although the common notion is that high MS values are caused by high magnetite concentrations that can be biotically formed through the activities of iron-reducing bacteria, here we show that the highest magnetic susceptibilities were measured in the free-phase petroleum zone, where a methanogenic community was predominant. This field study may contribute to the emerging knowledge that methanogens can switch their metabolism from methanogenesis to iron reduction with associated magnetite precipitation in hydrocarbon contaminated sediments. Thus, geophysical methods such as MS may help to identify zones where iron cycling/reduction by methanogens is occurring.
more »
« less
Microbially Induced Anaerobic Oxidation of Magnetite to Maghemite in a Hydrocarbon‐Contaminated Aquifer
Abstract Iron mineral transformations occurring in hydrocarbon‐contaminated sites are linked to the biodegradation of the hydrocarbons. At a hydrocarbon‐contaminated site near Bemidji, Minnesota, USA, measurements of magnetic susceptibility (MS) are useful for monitoring the natural attenuation of hydrocarbons related to iron cycling. However, a transient MS, previously observed at the site, remains poorly understood and the iron mineral phases acting as reactants and products associated with this MS perturbation remain largely unknown. To address these unknowns, we acquired mineral magnetism measurements, including hysteresis loops, backfield curves, and isothermal remanent magnetizations on sediment core samples retrieved from the site and magnetite‐filled mineral packets installed within the aquifer. Our data show that the core samples and magnetite packs display decreasing magnetization with time and that this loss in magnetization is accompanied by increasing bulk coercivity consistent with decreased average grain size and/or partial oxidation. Low‐temperature magnetometry on all samples displayed behavior consistent with magnetite, but samples within the plume also show evidence of maghemitization. This interpretation is supported by the occurrence of shrinkage cracks on the surface of the grains imaged via scanning electron microscopy. Magnetite transformation to maghemite typically occurs under oxic conditions, here, we propose that maghemitization occurs within the anoxic portions of the plume via microbially mediated anaerobic oxidation. Mineral dissolution also occurs within the plume. Microorganisms capable of such anaerobic oxidation have been identified within other areas at the Bemidji site, but additional microbiological studies are needed to link specific anaerobic iron oxidizers with this loss of magnetization.
more »
« less
- PAR ID:
- 10367792
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Biogeosciences
- Volume:
- 127
- Issue:
- 4
- ISSN:
- 2169-8953
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Summary Magnetic minerals form or alter in the presence of hydrocarbons, making them a potential magnetic proxy for identifying hydrocarbon migration pathways. In this paper we test this idea by magnetically measuring core samples from the Tay Fan in the Western Central Graben in the Central North Sea. In a companion paper, 3D petroleum systems modelling has been carried out to forward model migration pathways within the Tay Fan. Rock magnetic experiments identified a range of magnetite, maghemite, iron sulphides, siderite, goethite and titanohematite, some of which are part of the background signal, and some due to the presence of hydrocarbons. Typical concentrations of the magnetic minerals were ∼10–200 ppm. Importantly, we have identified an increasing presence of authigenic iron sulphides (likely pyrite and greigite) along the identified lateral hydrocarbon migration pathway (east to west). This is likely caused by biodegradation resulting in the precipitation of iron sulphides, however, though less likely, it could alternatively be caused by mature oil generation, which subsequently travelled with the migrating oil to the traps in the west. These observations suggest mineral magnetic techniques could be a rapid alternative method for identifying the severity of biodegradation or oil maturity in core sample, which can then be used to calibrate petroleum systems models.more » « less
-
Harmful levels of environmental contaminants, such as arsenic (As), persist readily in the environment, threatening safe drinking water supplies in many parts of the world. In this paper, we present a straightforward and cost-effective filtration technology for the removal of arsenate from potable water. Biocomposite filters comprised of nanocrystalline iron oxides or oxyhydroxides mineralized within lignocellulose scaffolds constitute a promising low cost, low-tech avenue for the removal of these contaminants. Two types of iron oxide mineral phases, 2-line ferrihydrite (Fh) and magnetite (Mt), were synthesized within highly porous balsa wood using an environmentally benign modification process and studied in view of their effective removal of As from contaminated water. The mineral deposition pattern, minerology, as well as crystallinity, were assessed using scanning electron microscopy, transmission electron microscopy, micro-computed X-ray tomography, confocal Raman microscopy, infrared spectroscopy, and X-ray powder diffraction. Our results indicate a preferential distribution of the Fh mineral phase within the micro-porous cell wall and radial parenchyma cells of rays, while Mt is formed primarily at the cell wall/lumen interface of vessels and fibers. Water samples of known As concentrations were subjected to composite filters in batch incubation and gravity-driven flow-through adsorption tests. Eluents were analyzed using microwave plasma optical emission spectroscopy (MPAES) and inductively coupled plasma mass spectrometry (ICP-MS). By subjecting the filters to a flow of contaminated water, the time for As uptake was reduced to minutes rather than hours, while immobilizing the same amount of As. The retention of As within the composite filter was further confirmed through energy-dispersive X-ray mappings. Apart from addressing dangerously high levels of arsenate in potable water, these versatile iron oxide lignocellulosic filters harbor tremendous potential for addressing current and emerging environmental contaminants that are known to adsorb on iron oxide mineral phases, such as phosphate, polycyclic aromatic hydrocarbons or heavy metals.more » « less
-
null (Ed.)The textures of outcrop and near-surface exposures of the massive magnetite orebodies (>90 vol % magnetite) at the Plio-Pleistocene El Laco iron oxide-apatite (IOA) deposit in northern Chile are similar to basaltic lava flows and have compositions that overlap high- and low-temperature hydrothermal magnetite. Existing models— liquid immiscibility and complete metasomatic replacement of andesitic lava flows—attempt to explain the genesis of the orebodies by entirely igneous or entirely hydrothermal processes. Importantly, those models were developed by studying only near-surface and outcrop samples. Here, we present the results of a comprehensive study of samples from outcrop and drill core that require a new model for the evolution of the El Laco ore deposit. Backscattered electron (BSE) imaging, electron probe microanalysis (EPMA), and laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) were used to investigate the textural and compositional variability of magnetite and apatite from surface and drill core samples in order to obtain a holistic understanding of textures and compositions laterally and vertically through the orebodies. Magnetite was analyzed from 39 surface samples from five orebodies (Cristales Grandes, Rodados Negros, San Vicente Alto, Laco Norte, and Laco Sur) and 47 drill core samples from three orebodies (Laco Norte, Laco Sur, and Extensión Laco Sur). The geochemistry of apatite from eight surface samples from three orebodies (Cristales Grandes, Rodados Negros, and Laco Sur) was investigated. Minor and trace element compositions of magnetite in these samples are similar to magnetite from igneous rocks and magmatic-hydrothermal systems. Magnetite grains from deeper zones of the orebodies contain >1 wt % titanium, as well as ilmenite oxyexsolution lamellae and interstitial ilmenite. The ilmenite oxyexsolution lamellae, interstitial ilmenite, and igneous-like trace element concentrations in titanomagnetite from the deeper parts of the orebodies are consistent with original crystallization of titanomagnetite from silicate melt or high-temperature magmatic-hydrothermal fluid. The systematic decrease of trace element concentrations in magnetite from intermediate to shallow depths is consistent with progressive growth of magnetite from a cooling magmatic-hydrothermal fluid. Apatite grains from surface outcrops are F rich (typically >3 wt %) and have compositions that overlap igneous and magmatic-hydrothermal apatite. Magnetite and fluorapatite grains contain mineral inclusions (e.g., monazite and thorite) that evince syn- or postmineralization metasomatic alteration. Magnetite grains commonly meet at triple junctions, which preserve evidence for reequilibration of the ore minerals with hydrothermal fluid during or after mineralization. The data presented here are consistent with genesis of the El Laco orebodies via shallow emplacement and eruption of magnetite-bearing magmatic-hydrothermal fluid suspensions that were mobilized by decompression- induced collapse of the volcanic edifice. The ore-forming magnetite-fluid suspension would have rheological properties similar to basaltic lava flows, which explains the textures and presence of cavities and gas escape tubes in surface outcrops.more » « less
-
Abstract Demagnetizing effects and internal stress are difficult to distinguish in natural magnetite samples, but quantitative stress estimates can provide valuable information about microstructure formation, surface oxidation, impacts, tectonic stresses, or interface properties in exsolution structures. Quantifying demagnetizing effects informs about magnetite particle shape, magnetostatic interaction, or anisotropic texture. Here, we establish an improved measurement workflow to separate demagnetizing effects from internal stress for natural magnetite. The method is based on temperature‐dependent hysteresis measurements, and for natural samples require accurate estimates of Curie temperature and temperature‐dependent saturation magnetization to ensure that near‐end‐member magnetite is the dominant magnetic mineral, and to calibrate the temperature‐dependent scaled reversible work (SRW). SRW is the fundamental quantity to determine stress and demagnetizing factor. The improved SRW method is applied to three natural samples with different stress histories where it proves that large magnetite crystals in the metamorphosed Modum complex (Norway) have low internal stress (<100 MPa), while in highly exsolved magnetite‐ilmenite intergrowths from Taberg (Sweden) and Bushveld (South Africa) the magnetite component is highly stressed (>230 MPa). This confirms experimentally that interface strain in complex microstructures due to spinodal decomposition and partial oxidation creates large average internal stress in the magnetite minerals. Because sister specimens have similar internal stress but noticeably (>20%) different demagnetizing factors, textural, and shape anisotropy contribute substantially to SRW in these samples.more » « less
