skip to main content


Title: Wildfire Smoke Observations in the Western United States from the Airborne Wyoming Cloud Lidar during the BB-FLUX Project. Part II: Vertical Structure and Plume Injection Height
Abstract

The western U.S. wildfire smoke plumes observed by the upward-pointing Wyoming Cloud Lidar (WCL) during the Biomass Burning Fluxes of Trace Gases and Aerosols (BB-FLUX) project are investigated in a two-part paper. Part II here presents the reconstructed vertical structures of seven plumes from airborne WCL measurements. The vertical structures evident in the fire plume cross sections, supported by in situ measurements, showed that the fire plumes had distinct macrophysical and microphysical properties, which are closely related to the plume transport, fire emission intensity, and thermodynamic structure in the boundary layer. All plumes had an injection layer between 2.8 and 4.0 km above mean sea level, which is generally below the identified boundary layer top height. Plumes that transported upward out of the boundary layer, such as the Rabbit Foot and Pole Creek fires, formed a higher plume at around 5.5 km. The largest and highest Pole Creek fire plume was transported farthest and was sampled by University of Wyoming King Air aircraft at 170 km, or 2.3 h, downwind. It was associated with the warmest, driest, deepest boundary layer and the highest wind speed and turbulence. The Watson Creek fire plume intensified in the afternoon with stronger CO emission and larger smoke plume height than in the morning, indicating a fire diurnal cycle, but some fire plumes did not intensify in the afternoon. There were pockets of relatively large irregular aerosol particles at the tops of plumes from active fires. In less-active fire plumes, the WCL depolarization ratio and passive cavity aerosol spectrometer probe mass mean diameter maximized at a height that was low in the plume.

 
more » « less
Award ID(s):
1754019
NSF-PAR ID:
10372944
Author(s) / Creator(s):
 ;  ;  ;  ;  ;  
Publisher / Repository:
American Meteorological Society
Date Published:
Journal Name:
Journal of Atmospheric and Oceanic Technology
Volume:
39
Issue:
5
ISSN:
0739-0572
Page Range / eLocation ID:
p. 559-572
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Abstract. Wildfire smoke is one of the most significant concerns ofhuman and environmental health, associated with its substantial impacts onair quality, weather, and climate. However, biomass burning emissions andsmoke remain among the largest sources of uncertainties in air qualityforecasts. In this study, we evaluate the smoke emissions and plumeforecasts from 12 state-of-the-art air quality forecasting systemsduring the Williams Flats fire in Washington State, US, August 2019, whichwas intensively observed during the Fire Influence on Regional to GlobalEnvironments and Air Quality (FIREX-AQ) field campaign. Model forecasts withlead times within 1 d are intercompared under the same framework basedon observations from multiple platforms to reveal their performanceregarding fire emissions, aerosol optical depth (AOD), surface PM2.5,plume injection, and surface PM2.5 to AOD ratio. The comparison ofsmoke organic carbon (OC) emissions suggests a large range of daily totalsamong the models, with a factor of 20 to 50. Limited representations of thediurnal patterns and day-to-day variations of emissions highlight the needto incorporate new methodologies to predict the temporal evolution andreduce uncertainty of smoke emission estimates. The evaluation of smoke AOD(sAOD) forecasts suggests overall underpredictions in both the magnitude andsmoke plume area for nearly all models, although the high-resolution modelshave a better representation of the fine-scale structures of smoke plumes.The models driven by fire radiativepower (FRP)-based fire emissions or assimilating satellite AODdata generally outperform the others. Additionally, limitations of thepersistence assumption used when predicting smoke emissions are revealed bysubstantial underpredictions of sAOD on 8 August 2019, mainly over thetransported smoke plumes, owing to the underestimated emissions on7 August. In contrast, the surface smoke PM2.5 (sPM2.5) forecastsshow both positive and negative overall biases for these models, with mostmembers presenting more considerable diurnal variations of sPM2.5.Overpredictions of sPM2.5 are found for the models driven by FRP-basedemissions during nighttime, suggesting the necessity to improve verticalemission allocation within and above the planetary boundary layer (PBL).Smoke injection heights are further evaluated using the NASA LangleyResearch Center's Differential Absorption High Spectral Resolution Lidar(DIAL-HSRL) data collected during the flight observations. As the firebecame stronger over 3–8 August, the plume height became deeper, with aday-to-day range of about 2–9 km a.g.l. However, narrower ranges arefound for all models, with a tendency of overpredicting the plume heights forthe shallower injection transects and underpredicting for the days showingdeeper injections. The misrepresented plume injection heights lead toinaccurate vertical plume allocations along the transects corresponding totransported smoke that is 1 d old. Discrepancies in model performance forsurface PM2.5 and AOD are further suggested by the evaluation of theirratio, which cannot be compensated for by solely adjusting the smoke emissionsbut are more attributable to model representations of plume injections,besides other possible factors including the evolution of PBL depths andaerosol optical property assumptions. By consolidating multiple forecastsystems, these results provide strategic insight on pathways to improvesmoke forecasts. 
    more » « less
  2. Abstract

    During the summer of 2018, the upward-pointing Wyoming Cloud Lidar (WCL) was deployed on board the University of Wyoming King Air (UWKA) research aircraft for the Biomass Burning Flux Measurements of Trace Gases and Aerosols (BB-FLUX) field campaign. This paper describes the generation of calibrated attenuated backscatter coefficients and aerosol extinction coefficients from the WCL measurements. The retrieved aerosol extinction coefficients at the flight level strongly correlate (correlation coefficient, rr > 0.8) with in situ aerosol concentration and carbon monoxide (CO) concentration, providing a first-order estimate for converting WCL extinction coefficients into vertically resolved CO and aerosol concentration within wildfire smoke plumes. The integrated CO column concentrations from the WCL data in nonextinguished profiles also correlate (rr = 0.7) with column measurements by the University of Colorado Airborne Solar Occultation Flux instrument, indicating the validity of WCL-derived extinction coefficients. During BB-FLUX, the UWKA sampled smoke plumes from more than 20 wildfires during 35 flights over the western United States. Seventy percent of flight time was spent below 3 km above ground level (AGL) altitude, although the UWKA ascended up to 6 km AGL to sample the top of some deep smoke plumes. The upward-pointing WCL observed a nearly equal amount of thin and dense smoke below 2 km and above 5 km due to the flight purpose of targeted fresh fire smoke. Between 2 and 5 km, where most of the wildfire smoke resided, the WCL observed slightly more thin smoke than dense smoke due to smoke spreading. Extinction coefficients in dense smoke were 2–10 times stronger, and dense smoke tended to have larger depolarization ratio, associated with irregular aerosol particles.

     
    more » « less
  3. Abstract

    Wildfire emissions are a key contributor of carbonaceous aerosols and trace gases to the atmosphere. Induced by buoyant lifting, smoke plumes can be injected into the free troposphere and lower stratosphere, which by consequence significantly affects the magnitude and distance of their influences on air quality and radiation budget. However, the vertical allocation of emissions when smoke escapes the planetary boundary layer (PBL) and the mechanism modulating it remain unclear. We present an inverse modeling framework to estimate the wildfire emissions, with their temporal and vertical evolution being constrained by assimilating aerosol extinction profiles observed from the airborne Differential Absorption Lidar‐High Spectral Resolution Lidar during the Fire Influence on Regional to Global Environments and Air Quality field campaign. Three fire events in the western U.S., which exhibit free‐tropospheric injections are examined. The constrained smoke emissions indicate considerably larger fractions of smoke injected above the PBL (f>PBL, 80%–94%) versus the column total, compared to those estimated by the WRF‐Chem model using the default plume rise option (12%–52%). The updated emission profiles yield improvements for the simulated vertical structures of the downwind transported smoke, but limited refinement of regional smoke aerosol optical depth distributions due to the spatiotemporal coverage of flight observations. These results highlight the significance of improving vertical allocation of fire emissions on advancing the modeling and forecasting of the environmental impacts of smoke.

     
    more » « less
  4. Abstract

    We analyze new aerosol products from NASA satellite retrievals over the western USA during August 2013, with special attention to locally generated wildfire smoke and downwind plume structures. Aerosol optical depth (AOD) at 550 nm from MODerate Resolution Imaging Spectroradiometer (MODIS) (Terra and Aqua Collections 6 and 6.1) and Visible Infrared Imaging Radiometer Suite (VIIRS) Deep Blue (DB) and MODIS (Terra and Aqua) Multi‐Angle Implementation of Atmospheric Correction (MAIAC) retrievals are evaluated against ground‐based AErosol RObotic NETwork (AERONET) observations. We find a significant improvement in correlation with AERONET and other metrics in the latest DB AOD (MODIS C6.1r2 = 0.75, VIIRSr2 = 0.79) compared to MODIS C6 (r2 = 0.62). In general, MAIAC (r2 = 0.84) and DB (MODIS C6.1 and VIIRS) present similar statistical evaluation metrics for the western USA and are useful tools to characterize aerosol loading associated with wildfire smoke. We also evaluate three novel NASA MODIS plume injection height (PIH) products, one from MAIAC and two from the Aerosol Single scattering albedo and layer Height Estimation (ASHE) (MODIS and VIIRS) algorithm. Both Terra and Aqua MAIAC PIHs statistically agree with ground‐based and satellite lidar observations near the fire source, as do ASHE, although the latter is sensitive to assumptions about aerosol absorption properties. We introduce a first‐order approximation Smoke Height Boundary Layer Ratio (SHBLR) to qualitatively distinguish between aerosol pollution within the planetary boundary layer and the free troposphere. We summarize the scope, limitations, and suggestions for scientific applications of surface level aerosol concentrations specific to wildfire emissions and smoke plumes using these novel NASA MODIS and VIIRS aerosol products.

     
    more » « less
  5. Abstract. We characterize the aerosol physical and optical properties of 13 transported biomass burning (BB) events. BB events included long-rangeinfluence from fires in Alaskan and Siberian boreal forests transported to Mt. Bachelor Observatory (MBO) in the free troposphere (FT) over 8–14+ d and regional wildfires in northern California and southwestern Oregon transported to MBO in the boundary layer (BL) over 10 h to 3 d. Intensive aerosol optical properties and normalized enhancement ratios for BB events were derived from measured aerosol light scattering coefficients (σscat), aerosol light-absorbing coefficients (σabs), fine particulate matter (PM1), and carbon monoxide (CO) measurements made from July to September 2019, with particle size distribution collected from August to September. The observations showed that the Siberian BB events had a lower scattering Ångström exponent (SAE), a higher mass scattering efficiency (MSE; Δσscat/ΔPM1), and a bimodal aerosol size distribution with a higher geometric mean diameter (Dg). We hypothesize that the larger particles and associated scatteringproperties were due to the transport of fine dust alongside smoke in addition to contributions from condensation of secondary aerosol, coagulation of smaller particles, and aqueous-phase processing duringtransport. Alaskan and Siberian boreal forest BB plumes were transported long distances in the FT and characterized by lower absorptionÅngström exponent (AAE) values indicative of black carbon (BC)dominance in the radiative budget. Significantly elevated AAE values wereonly observed for BB events with <1 d transport, which suggests strong production of brown carbon (BrC) in these plumes but limited radiative forcing impacts outside of the immediate region.

     
    more » « less