Structural analyses combined with new U-Pb zircon and titanite geochronology show how two Early Cretaceous transpressional shear zones initiated and grew through a nearly complete section of continental arc crust during oblique convergence. Both shear zones reactivated Carboniferous faults that penetrated the upper mantle below Zealandia's Median Batholith but show opposite growth patterns and dissimilar relationships with respect to arc magmatism. The Grebe-Indecision Creek shear zone was magma-starved and first reactivated at ∼136 Ma as an oblique-reverse fault, along which an outboard batholith partially subducted beneath Gondwana. This system nucleated at or above ∼20 km depth and propagated downward at 2–3 mm yr−1, accumulating at least 35–45 km of horizontal (arc-normal) shortening by ∼124 Ma. In contrast, the magma-rich George Sound shear zone first reactivated in the lower crust (∼55 km depth) at ∼124 Ma and grew upward at ∼3 mm yr−1, reaching the upper crust by ∼110 Ma. In this latter system, magmatism influenced shear zone architecture and drove its growth while subduction and oblique convergence ended. As magma entered the roots of the system and began to solidify, deformation was driven out of the lower crust and into the middle crust where the system widened by a factor of three when fold-thrust belts formed on either side of a steep, central transpressional shear zone. This study illustrates how the reactivation of structural weaknesses localizes deformation at all depths in the lithosphere and shows how magma-deformation feedbacks influence shear zone connectivity and built a batholith from the bottom up.
more »
« less
The Initiation and Growth of Transpressional Shear Zones Through Continental Arc Lithosphere, Southwest New Zealand
Structural analyses combined with new U‐Pb zircon and titanite geochronology show how two Early Cretaceous transpressional shear zones initiated and grew through a nearly complete section of continental arc crust during oblique convergence. Both shear zones reactivated Carboniferous faults that penetrated the upper mantle below Zealandia's Median Batholith but show opposite growth patterns and dissimilar relationships with respect to arc magmatism. The Grebe‐Indecision Creek shear zone was magma‐starved and first reactivated at ∼136 Ma as an oblique‐reverse fault, along which an outboard batholith partially subducted beneath Gondwana. This system nucleated at or above ∼20 km depth and propagated downward at 2–3 mm yr−1, accumulating at least 35–45 km of horizontal (arc‐normal) shortening by ∼124 Ma. In contrast, the magma‐rich George Sound shear zone first reactivated in the lower crust (∼55 km depth) at ∼124 Ma and grew upward at ∼3 mm yr−1, reaching the upper crust by ∼110 Ma. In this latter system, magmatism influenced shear zone architecture and drove its growth while subduction and oblique convergence ended. As magma entered the roots of the system and began to solidify, deformation was driven out of the lower crust and into the middle crust where the system widened by a factor of three when fold‐thrust belts formed on either side of a steep, central transpressional shear zone. This study illustrates how the reactivation of structural weaknesses localizes deformation at all depths in the lithosphere and shows how magma‐deformation feedbacks influence shear zone connectivity and built a batholith from the bottom up.
more » « less- Award ID(s):
- 1655152
- NSF-PAR ID:
- 10373602
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Tectonics
- Volume:
- 41
- Issue:
- 9
- ISSN:
- 0278-7407
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Abstract Recovering the time-evolving relationship between arc magmatism and deformation, and the influence of anisotropies (inherited foliations, crustal-scale features, and thermal gradients), is critical for interpreting the location, timing, and geometry of transpressional structures in continental arcs. We investigated these themes of magma-deformation interactions and preexisting anisotropies within a middle- and lower-crustal section of Cretaceous arc crust coinciding with a Paleozoic boundary in central Fiordland, New Zealand. We present new structural mapping and results of Zr-in-titanite thermometry and U-Pb zircon and titanite geochronology from an Early Cretaceous batholith and its host rock. The data reveal how the expression of transpression in the middle and lower crust of a continental magmatic arc evolved during emplacement and crystallization of the ∼2300 km2 lower-crustal Western Fiordland Orthogneiss (WFO) batholith. Two structures within Fiordland’s architecture of transpressional shear zones are identified. The gently dipping Misty shear zone records syn-magmatic oblique-sinistral thrust motion between ca. 123 and ca. 118 Ma, along the lower-crustal WFO Misty Pluton margin. The subhorizontal South Adams Burn thrust records mid-crustal arc-normal shortening between ca. 114 and ca. 111 Ma. Both structures are localized within and reactivate a recently described >10 km-wide Paleozoic crustal boundary, and show that deformation migrated upwards between ca. 118 and ca. 114 Ma. WFO emplacement and crystallization (mainly 118–115 Ma) coincided with elevated (>750 °C) middle- and lower-crustal Zr-in-titanite temperatures and the onset of mid-crustal cooling at 5.9 ± 2.0 °C Ma−1 between ca. 118 and ca. 95 Ma. We suggest that reduced strength contrasts across lower-crustal pluton margins during crystallization caused deformation to migrate upwards into thermally weakened rocks of the mid-crust. The migration was accompanied by partitioning of deformation into domains of arc-normal shortening in Paleozoic metasedimentary rocks and domains that combined shortening and strike-slip deformation in crustal-scale subvertical, transpressional shear zones previously documented in Fiordland. U-Pb titanite dates indicate Carboniferous–Cretaceous (re)crystallization, consistent with reactivation of the inherited boundary. Our results show that spatio-temporal patterns of transpression are influenced by magma emplacement and crystallization and by the thermal structure of a reactivated boundary.more » « less
-
Abstract We investigated the interplay between deformation and pluton emplacement with the goal of providing insights into the role of transpression and arc magmatism in forming and modifying continental arc crust. We present 39 new laser-ablation–split-stream–inductively coupled plasma–mass spectrometry (LASS-ICP-MS) and secondary ion mass spectrometry (SIMS) 206Pb/238U zircon and titanite dates, together with titanite geochemistry and temperatures from the lower and middle crust of the Mesozoic Median Batholith, New Zealand, to (1) constrain the timing of Cretaceous arc magmatism in the Separation Point Suite, (2) document the timing of titanite growth in low- and high-strain deformational fabrics, and (3) link spatial and temporal patterns of lithospheric-scale transpressional shear zone development to the Cretaceous arc flare-up event. Our zircon results reveal that Separation Point Suite plutonism lasted from ca. 129 Ma to ca. 110 Ma in the middle crust of eastern and central Fiordland. Deformation during this time was focused into a 20-km-wide, arc-parallel zone of deformation that includes previously unreported segments of a complex shear zone that we term the Grebe shear zone. Early deformation in the Grebe shear zone involved development of low-strain fabrics with shallowly plunging mineral stretching lineations from ca. 129 to 125 Ma. Titanites in these rocks are euhedral, are generally aligned with weak subsolidus fabrics, and give rock-average temperatures ranging from 675 °C to 700 °C. We interpret them as relict magmatic titanites that grew prior to low-strain fabric development. In contrast, deformation from ca. 125 to 116 Ma involved movement along subvertical, mylonitic shear zones with moderately to steeply plunging mineral stretching lineations. Titanites in these shear zones are anhedral grains/aggregates that are aligned within mylonitic fabrics and have rock-average temperatures ranging from ∼610 °C to 700 °C. These titanites are most consistent with (re)crystallization in response to deformation and/or metamorphic reactions during amphibolite-facies metamorphism. At the orogen scale, spatial and temporal patterns indicate that the Separation Point Suite flare-up commenced during low-strain deformation in the middle crust (ca. 129–125 Ma) and peaked during high-strain, transpressional deformation (ca. 125–116 Ma), during which time the magmatic arc axis widened to 70 km or more. We suggest that transpressional deformation during the arc flare-up event was an important process in linking melt storage regions and controlling the distribution and geometry of plutons at mid-crustal levels.more » « less
-
more » « less
Abstract The Punta del Cobre district near Copiapó is a center of iron oxide-copper–gold (IOCG) mineralization spatially and temporally associated with regional sodic-calcic hydrothermal alteration, the Atacama fault system (AFS), and two phases of Early Cretaceous magmatism. Here, we investigate the spatiotemporal and geochemical relationships between magmatism, ductile deformation, and hydrothermal alteration along the ~ 200 to 300-m-thick steeply NW-dipping Sierra Chicharra shear zone, interpreted to be the major strand of the AFS. Mylonitic fabrics and oblique sinistral-reverse kinematic indicators together record coaxial flattening in a transpressional regime. Deformation on the AFS took place before, during, and after intrusion of the synkinematic Sierra Chicharra quartz diorite of the Coastal Cordillera arc at ~ 122 Ma and terminated before intrusion of the unstrained ~ 114 Ma Sierra Atacama diorite of the Copiapó batholith. Geochemical data show that the Copiapó batholith was more mafic and more K-rich than the calc-alkaline Coastal Cordillera arc. This time period thus overlaps IOCG mineralization in the Punta del Cobre district (~ 120 to 110 Ma). Multiple phases of sodic-calcic alteration in and around the AFS shear zone are recognized. Textures of altered rock in the shear zone show both synkinematic assemblages and post-kinematic hydrothermal oligoclase. A ~ 775-m-long andradite vein that cuts the shear zone formed broadly at the end of magmatism in the district (~ 95 Ma). Oxygen isotope ratios from the vein indicate that hydrothermal fluids were likely magmatically derived. Together, this work shows the AFS-related shear zone and nearby IOCG mineralization developed in a regional transpressional regime produced by SE-directed oblique convergence across a NE-striking shear zone. IOCG-related magmatic-hydrothermal fluids exploited this transcrustal shear zone to produce multiple episodes of regional sodic-calcic alteration formed from fluids exsolved from magmas or driven by the heat of the Coastal Cordillera arc and Copiapó batholith.
-
The Southern California Batholith is a ~500-km-wide segment of the Mesozoic California arc that lies between the northern Peninsular Ranges and the southern Sierra Nevada mountains. We use structural data and U-Pb zircon analyses from the eastern San Gabriel mountains to examine how the batholith responded to the onset of the Laramide orogeny during the Late Cretaceous. Zircon analyses show that the middle and lower crust of the batholith was hot and records a magmatic flareup from 90-77 Ma. From 90 to 86 Ma, tonalite of the San Sevaine Lookout intruded a thick package of metasedimentary rock that records a history of reverse displacements, crustal imbrication, and granulite metamorphism prior to tonalite intrusion. During the early stages of the magmatic flare-up, granodiorite dikes were emplaced and soon became tightly folded and disaggregated as younger sheets of comagmatic tonalite intruded. Deformation accompanied the magmatism, forming two parallel shear zones several 100 m thick. These two shear zones, which include the Black Belt Mylonite, are composed of thin (≤10 m) high-strain zones spaced several tens of meters apart. Each discrete high-strain zone contains subparallel layers of mylonite, ultramylonite, cataclasite and pseudotachylyte, all recording oblique sinistral-reverse displacements on gently and moderately dipping surfaces. This architecture, whereby individual high-strain zones are widely spaced and parallel the margins of intruding tonalite sheets, reveals the influence of magma emplacement on shear zone structure. U-Pb zircon geochronology on syn-tectonic dikes indicate that these different styles of deformation all formed within the same 89-85 Ma interval, suggesting that they reflect non-steady flow on deep seismogenic faults. Widespread (garnet) granulite-facies metamorphism and partial melting accompanied intrusion of the tonalites and sinistral- reverse displacements. The ages of undeformed dikes indicate that the deformation was over by 77-75 Ma. Together, these data show that arc magmatism and transpression within the Mesozoic California arc occurred from ~90 until ~75 Ma, implying that flat-slab subduction and the migration of the Laramide orogenic front into the North America interior occurred after ~75 Ma.more » « less
