skip to main content
US FlagAn official website of the United States government
dot gov icon
Official websites use .gov
A .gov website belongs to an official government organization in the United States.
https lock icon
Secure .gov websites use HTTPS
A lock ( lock ) or https:// means you've safely connected to the .gov website. Share sensitive information only on official, secure websites.

Explore Research Products in the PAR
It may take a few hours for recently added research products to appear in PAR search results.


Title: Performance testing and end-to-end mapping of the fiber cable on the SALT NIR integral field spectrograph
The optical fiber integral field unit (IFU) built to feed the near infrared (NIR) spectrograph for the 11-meter Southern African Large Telescope (SALT) has undergone prototyping and rigorous performance testing at Wash- burn Astronomical Laboratories of the University of Wisconsin-Madison Astronomy Department. The 43 m length of 256 fibers which make up the object and sky arrays and spares are routed from the SALT payload down into the spectrograph room in four separate cables. The IFU covers 344 arcsec2 on the sky, with the object array spanning a 552 arcsec2 near-rectangular area at roughly 56% fill-factor. Companion papers describe the mechanical design of the fiber cable that mitigates potential sources of mechanical strain on the optical fiber (Smith et al.) and details of the spectrograph (Wolf et al.). Here we present the results of the performance testing of various test cables as well as performance testing and end-to-end mapping of the fully-assembled science cable. The fiber optics experience an extreme temperature gradient at the ingress to the instrument enclosure held at -40 ◦C during operation. We find an increase in focal ratio degradation (FRD) when holding progressively longer lengths of test fiber at reduced temperature. However, we confirm that this temperature dependent FRD is negligible for our designed length of cold fiber. We also find negligible contributions to FRD from the rubber seal that breaches the room temperature strain relief box and the cold instrument enclosure. Our measure- ments characterize performance including the effects of internal fiber inhomogeneities, stress induced from fiber handling and termination, as well as any imperfections from end-polishing. We present the room-temperature laboratory performance measurements of the fully-assembled science cable; the effective total throughput the fiber cable delivers to the spectrograph collimator is 81±2.5% across all fibers accounting for all losses.  more » « less
Award ID(s):
1814682
PAR ID:
10374106
Author(s) / Creator(s):
; ; ; ; ; ; ; ; ;
Editor(s):
Geyl, Roland; Navarro, Ramón
Date Published:
Journal Name:
Performance testing and end-to-end mapping of the fiber cable on the SALT NIR integral field spectrograph
Volume:
12199
Page Range / eLocation ID:
17
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. ; ; ; ; ; ; ; ; ; ; et al (, Proceedings of the SPIE)
    Evans, Christopher J.; Bryant, Julia J.; Motohara, Kentaro (Ed.)
    PFS (Prime Focus Spectrograph), a next generation facility instrument on the Subaru telescope, is now being tested on the telescope. The instrument is equipped with very wide (1.3 degrees in diameter) field of view on the Subaru's prime focus, high multiplexity by 2394 reconfigurable fibers, and wide waveband spectrograph that covers from 380nm to 1260nm simultaneously in one exposure. Currently engineering observations are ongoing with Prime Focus Instrument (PFI), Metrology Camera System (MCS), the first spectrpgraph module (SM1) with visible cameras and the first fiber cable providing optical link between PFI and SM1. Among the rest of the hardware, the second fiber cable has been already installed on the telescope and in the dome building since April 2022, and the two others were also delivered in June 2022. The integration and test of next SMs including near-infrared cameras are ongoing for timely deliveries. The progress in the software development is also worth noting. The instrument control software delivered with the subsystems is being well integrated with its system-level layer, the telescope system, observation planning software and associated databases. The data reduction pipelines are also rapidly progressing especially since sky spectra started being taken in early 2021 using Subaru Nigh Sky Spectrograph (SuNSS), and more recently using PFI during the engineering observations. In parallel to these instrumentation activities, the PFS science team in the collaboration is timely formulating a plan of large-sky survey observation to be proposed and conducted as a Subaru Strategic Program (SSP) from 2024. In this article, we report these recent progresses, ongoing developments and future perspectives of the PFS instrumentation. 
    more » « less
  2. ; ; ; ; ; ; ; ; (, Earth and Space Science)
    Abstract Significant interest has developed in using optical fibers for seismology through Distributed Acoustic Sensing (DAS). However, converting DAS strain measurements to actual ground motions can result in errors and uncertainties due to imperfect coupling of the fiber to the earth and instrument response functions. To address this, we conducted a comparative analysis of strain data recorded by DAS, Optical Fiber Strainmeters (OFSs), and estimates derived from seismic data. This study used dark fibers in a commercial cable connecting two islands in Puget Sound, Washington, USA. The cable extends from a telecommunication substation on Whidbey Island, through an underground conduit, and across Saratoga Passage to Camano Island. The strain along the cable was recorded using OFS Michelson interferometers and a DAS interrogator, with a broadband seismometer positioned at one end. Comparing a teleseismic earthquake recording showed that summed DAS channels agreed well with OFS recordings. The amplitude discrepancies between the measurements and the seismometer's estimated strain indicated poor coupling between the cable and the earth. We also evaluated DAS amplitude response using a piezoelectric cylinder (PZT) to generate ground truth strain. The findings revealed a notable amplitude decrease in DAS recordings at lower frequencies, highlighting the need for amplitude calibration. Moreover, some underwater signals in the study area were strongly correlated with the velocity of the tidal current. These signals can be localized through coherence calculations between the DAS and OFS recordings. 
    more » « less
  3. ; ; ; ; ; ; ; ; ; ; et al (, 2024 IEEE Southeast Conference)
    Plastic optical fibers (POF) possess the potential to occupy a distinctive role in contemporary communication systems, bridging the gap between the attributes of copper cable and glass fiber. POF stands out as a more lightweight and cost-effective alternative to glass fiber, while concurrently offering significantly enhanced communication bandwidth compared to traditional copper cables of equivalent cost or weight. However, the novelty of this technology introduces a challenge, as there is limited understanding of how POF cables may behave under specific bending conditions, particularly in the case of the latest multi-core fibers. This paper outlines a research endeavor aimed at establishing a cost-effective and reproducible testing framework for assessing the light transmission properties of plastic optical fibers during various bending conditions. The methodology involves partial automation using National Instruments LabVIEW for servo motor control, and optical power measurements were taken using the Thorlabs PM100USB. The investigation encompassed measurements across diverse bending angles and radii for five distinct types of fibers: Eska MH, Eska BH, Eska GH, a Graded Index fiber, and a Multi Core Fiber. 
    more » « less
  4. ; ; ; ; ; ; ; ; (, Journal of Astronomical Instrumentation)
    Focal ratio degradation (FRD), the decrease of light’s focal ratio between the input into an optical fiber and the output, is important to characterize for astronomical spectrographs due to its effects on throughput and the point spread function. However, while FRD is a function of many fiber properties such as stresses, microbending, and surface imperfections, angular misalignments between the incoming light and the face of the fiber also affect the light profile and complicate this measurement. A compact experimental setup and a model separating FRD from angular misalignment was applied to a fiber subjected to varying stresses or angular misalignments to determine the magnitude of these effects. The FRD was then determined for a fiber in a fiber positioner that will be used in the Subaru Prime Focus Spectrograph (PFS). The analysis we carried out for the PFS positioner suggests that effects of angular misalignment dominate and no significant FRD increase due to stress should occur. 
    more » « less
  5. ; ; ; ; ; ; (, Geophysical Research Letters)
    Abstract Geophysical sensing in the open ocean is both costly and technically challenging. Here we developed a novel distributed fiber optic sensing technique that employs microwave modulation for phase measurement in signals returned from submarine repeaters. We transformed a trans‐Atlantic telecom cable into an 81‐sensor array and measured sub‐millihertz strains. The strains correlate with ocean tide height variations in phase, suggesting a dominant factor of the cable's Poisson's effect. Large strains observed at fiber spans located in the shallow water match the strong variations of simulated seafloor temperature. This study presents the first experimental confirmation of detecting sub‐millihertz signals using trans‐oceanic distributed sensing with submarine cables at span‐wise spatial resolution (∼80 km), opening the potential for cost‐efficient tsunami early warning and long‐term ocean temperature monitoring compatible with active data‐carrying fibers. 
    more » « less
  • Citation Formats
  • MLA
  • APA
  • Chicago
  • BibTeX
  • Save / Share this Record
  • Send to Email