An official website of the United States government
The fiber single-cavity dual-comb laser (SCDCL) is an emerging light-source architecture that opens up the possibility for low-complexity dual-comb pump-probe measurements. However, the fundamental trade-off between measurement speed and time resolution remains a hurdle for the widespread use of fiber SCDCLs in dual-comb pump-probe measurements. In this paper, we break this fundamental trade-off by devising an all-optical dynamic repetition rate difference (Δfrep) modulation technique. We demonstrate the dynamic Δfrepmodulation in a modified version of the recently developed counterpropagating all-normal dispersion (CANDi) fiber laser. We verify that our all-optical dynamic Δfrepmodulation technique does not introduce excessive relative timing jitter. In addition, the dynamic modulation mechanism is studied and validated both theoretically and experimentally. As a proof-of-principle experiment, we apply this so-called dynamic CANDi (DCANDi) fiber laser to measure the relaxation time of a semiconductor saturable absorber mirror, achieving a measurement speed and duty cycle enhancement factor of 143. DCANDi fiber laser is a promising light source for low-complexity, high-speed, high-sensitivity ultrafast dual-comb pump-probe measurements.
more »
« less
Relative timing jitter in a counterpropagating all-normal dispersion dual-comb fiber laser
The counterpropagating all-normal dispersion (CANDi) fiber laser is an emerging high-energy single-cavity dual-comb laser source. Its relative timing jitter (RTJ), a critical parameter for dual-comb timing precision and spectral resolution, has not been comprehensively investigated. In this paper, we enhance the state-of-the-art CANDi fiber laser pulse energy from 1 nJ to 8 nJ. We then introduce a reference-free RTJ characterization technique that provides shot-to-shot measurement capability at femtosecond precision. The measurement noise floor reaches 1.6 × 10 − 7 f s 2 / H z , and the corresponding integrated measurement precision is only 1.8 fs (1 kHz, 20 MHz). With this characterization tool, we are able to study the physical origin of the CANDi laser’s RTJ in detail. We first verify that the cavity length fluctuation does not contribute to the RTJ. Then we measure the integrated RTJ to be 39 fs (1 kHz, 20 MHz) and identify the pump relative intensity noise (RIN) to be the dominant factor responsible for it. In particular, pump RIN is coupled to the RTJ through the Gordon–Haus effect. Finally, solutions to reduce the free-running CANDi laser’s RTJ are discussed. This work provides a general guideline to improve the performance of compact single-cavity dual-comb systems such as the CANDi laser, benefitting various dual-comb applications.
more »
« less
- Award ID(s):
- 2048202
- PAR ID:
- 10393508
- Date Published:
- Journal Name:
- Optica
- Volume:
- 9
- Issue:
- 7
- ISSN:
- 2334-2536
- Page Range / eLocation ID:
- 717
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Performance of distributed Raman amplification (DRA) system with dual order forward (FW) pumping is analyzed with the consideration of both pump relative intensity noise (RIN) to signal phase noise transfer and signal nonlinear interference. The efficiencies of pump RIN to signal phase noise transfer are theoretically analyzed and experimentally verified by measuring signal phase noise introduced by small index intensity modulations applied on the pump lasers. The results indicate that the efficiency of 2nd order pump RIN to signal phase noise transfer can be more than 2 orders of magnitude higher than that from the 1st order pump. Although dual order FW Raman pumping corresponds to a slight increase of amplified spontaneous emission (ASE) compared to using only a 1st order pump, its major advantage comes from the reduction of nonlinear interference noise in a dense wavelength-division multiplexing (DWDM) system. Because pump RIN to signal phase noise transfer has lowpass characteristics, systems at high baud rates, such as 100 Gbaud, are less susceptible to the impact of pump laser RIN.more » « less
-
Optical frequency combs have enabled distinct advantages in broadband, high-resolution spectroscopy and precision interferometry. However, quantum mechanics ultimately limits the metrological precision achievable with laser frequency combs. Quantum squeezing has led to substantial measurement improvements with continuous wave lasers, but experiments demonstrating metrological advantage with squeezed combs are less developed. Using the Kerr effect in nonlinear optical fiber, a 1-gigahertz frequency comb centered at 1560 nanometers is amplitude-squeezed by >3 decibels (dB) over a 2.5-terahertz bandwidth. Dual-comb interferometry yields mode-resolved spectroscopy of hydrogen sulfide gas with a signal-to-noise ratio nearly 3 dB beyond the shot-noise limit. The quantum noise reduction leads to a twofold quantum speedup in the determination of gas concentration, with implications for high-speed measurements of multiple species in dynamic chemical environments.more » « less
-
Metrology experiments can be limited by the noise produced by the laser involved via small fluctuations in the laser’s power or frequency. Typically, active power stabilization schemes consisting of an in-loop sensor and a feedback control loop are employed. Those schemes are fundamentally limited by shot noise coupling at the in-loop sensor. In this Letter, we propose to use the optical spring effect to passively stabilize the classical power fluctuations of a laser beam. In a proof of principle experiment, we show that the relative power noise of the laser is stabilized from approximately 2 × 10 −5 Hz −1/2 to a minimum value of 1.6 × 10 −7 Hz −1/2 , corresponding to the power noise reduction by a factor of 125. The bandwidth at which stabilization occurs ranges from 400 Hz to 100 kHz. The work reported in this Letter further paves the way for high power laser stability techniques which could be implemented in optomechanical experiments and in gravitational wave detectors.more » « less
-
The integration of stabilized lasers, sources that generate spectrally pure light, will provide compact, low-cost solutions for applications including quantum information sciences, precision navigation and timing, metrology, and high-capacity fiber communications. We report a significant advancement in this field, demonstrating stabilization of an integrated waveguide Brillouin laser to an integrated waveguide reference cavity, where both resonators are fabricated using the same CMOS-compatible integration platform. We demonstrate reduction of the free running Brillouin laser linewidth to a 292 Hz integral linewidth and carrier stabilization to a 4.9 × 10 −13 fractional frequency at 8 ms reaching the cavity-intrinsic thermorefractive noise limit for frequencies down to 80 Hz. We achieve this level of performance using a pair of 56.4 × 10 6 quality factor Si 3 N 4 waveguide ring-resonators that reduce the high-frequency noise by the nonlinear Brillouin process and the low-frequency noise by Pound–Drever–Hall locking to the ultra-low loss resonator. These results represent an important step toward integrated stabilized lasers with reduced sensitivity to environmental disturbances for atomic, molecular, and optical physics (AMO), quantum information processing and sensing, and other precision scientific, sensing, and communications applications.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1364/OPTICA.458339
