An official website of the United States government
SUMMARY Long-period underside SS wave reflections have been widely used to furnish global constraints on the presence and depth of mantle discontinuities and to document evidence for their origins, for example, mineral phase-transformations in the transition zone, compositional changes in the mid-mantle and dehydration-induced melting above and below the transition zone. For higher-resolution imaging, it is necessary to separate the signature of the source wavelet (SS arrival) from that of the distortion caused by the mantle reflectivity (SS precursors). Classical solutions to the general deconvolution problem include frequency-domain or time-domain deconvolution. However, these algorithms do not easily generalize when (1) the reflectivity series is of a much shorter period compared to the source wavelet, (2) the bounce point sampling is sparse or (3) the source wavelet is noisy or hard to estimate. To address these problems, we propose a new technique called SHARP-SS: Sparse High-Resolution Algorithm for Reflection Profiling with SS waves. SHARP-SS is a Bayesian deconvolution algorithm that makes minimal a-priori assumptions on the noise model, source signature and reflectivity structure. We test SHARP-SS using real data examples beneath the NoMelt Pacific Ocean region. We recover a low-velocity discontinuity at a depth of $$\sim 69 \pm 4$$ km which marks the base of the oceanic lithosphere, consistent with previous work derived from surface waves, body wave conversions, and ScS reverberations. We anticipate high-resolution fine mantle stratification imaging using SHARP-SS at locations where seismic stations are sparsely distributed.
more »
« less
High-resolution mid-mantle imaging with multiple-taper SS -precursor estimates
SUMMARY SS-precursor imaging is used to image sharp interfaces within Earth’s mantle. Current SS-precursor techniques require tightly bandpassed signals (e.g. 0.02–0.05 Hz), limiting both vertical and horizontal resolutions. Higher frequency content would allow for the detection of finer structure in and around the mantle transition zone (MTZ). Here, we present a new SS-precursor deconvolution technique based on multiple-taper correlation (MTC). We show that applying MTC to SS-precursor deconvolution can increase the frequency cut-off up to 0.5 Hz, which potentially sharpens vertical resolution to ∼10 km. Furthermore, the high-pass frequency can be lowered (≪ 0.01 Hz), allowing more long-period energy to be included in the calculation, to better constrain the signal and reduce side lobes. Our method is benchmarked on full-waveform synthetic seismograms computed via AxiSEM3D for the PREM 1-D Earth model. We apply our novel MTC-SS-precursor deconvolution to ∼7000 seismograms recorded at broad-band borehole sensors of the Global Seismographic Network with source–receiver bounce points in the North-Central Pacific Ocean. The MTZ in this region appears to be thin, which agrees with previous results. We do not observe the 520-km discontinuity in our SS-precursor estimates. Additionally, we detect a low-velocity zone above the MTZ to the north of the Hawaiian Islands that has previously been inferred from asymmetry in side lobe amplitudes. Our high-frequency analysis demonstrates this feature to be a sharp interface (≤ 10-km thickness), rather than a thick wave speed gradient.
more »
« less
- Award ID(s):
- 1818792
- PAR ID:
- 10395534
- Publisher / Repository:
- Oxford University Press
- Date Published:
- Journal Name:
- Geophysical Journal International
- Volume:
- 233
- Issue:
- 2
- ISSN:
- 0956-540X
- Format(s):
- Medium: X Size: p. 1356-1371
- Size(s):
- p. 1356-1371
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
SUMMARY The Earth's mantle transition zone (MTZ) plays a key role in the thermal and compositional interactions between the upper and lower mantle. Seismic anisotropy provides useful information about mantle deformation and dynamics across the MTZ. However, seismic anisotropy in the MTZ is difficult to constrain from surface wave or shear wave splitting measurements. Here, we investigate the sensitivity to anisotropy of a body wave method, SS precursors, through 3-D synthetic modelling and apply it to real data. Our study shows that the SS precursors can distinguish the anisotropy originating from three depths: shallow upper mantle (80–220 km), deep upper mantle above 410 km, and MTZ (410–660 km). Synthetic resolution tests indicate that SS precursors can resolve $$\ge $$3 per cent azimuthal anisotropy where data have an average signal-to-noise ratio (SNR = 7) and sufficient azimuthal coverage. To investigate regional sensitivity, we apply the stacking and inversion methods to two densely sampled areas: the Japan subduction zone and a central Pacific region around the Hawaiian hotspot. We find evidence for significant VS anisotropy (15.3 ± 9.2 per cent) with a trench-perpendicular fast direction (93° ± 5°) in the MTZ near the Japan subduction zone. We attribute the azimuthal anisotropy to the grain-scale shape-preferred orientation of basaltic materials induced by the shear deformation within the subducting slab beneath NE China. In the central Pacific study region, there is a non-detection of MTZ anisotropy, although modelling suggests the data coverage should allow us to resolve at least 3 per cent anisotropy. Therefore, the Hawaiian mantle plume has not produced detectable azimuthal anisotropy in the MTZ.more » « less
-
SUMMARY Imaging seismic velocity discontinuities within the Earth's interior offers important insight into our understanding of the tectonic plate, associated mantle dynamics, and the evolution of the planet. However, imaging velocity discontinuities in locations where station coverage is sparse, is sometimes challenging. Here we demonstrate the effectiveness of a new imaging approach using deconvolved SS precursor phases. We demonstrate its effectiveness by applying it to synthetic seismograms. We also apply it to ∼1.6 M SS precursor waveforms from the global seismic database (1990–2018) for comparison with CRUST1.0. We migrate to depth and stack the data in circular 6° bins. The synthetic tests demonstrate that we can recover Moho depths as shallow as 20 km. Globally, the Moho is resolved at 21–67 km depth beneath continental regions. The Moho increases in depth from 21 km ± 4 km beneath the continental shelf to 45–50 km beneath the continental interiors and is as deep as 67 ± 4 km beneath Tibet. We resolve the Moho in 77 percent of all continental bins, within 10 km of CRUST1.0, with all outliers located in coastal regions. We also demonstrate the feasibility of using this method to image discontinuities associated with the mantle transition zone with both synthetic and real data. Overall, the approach shows broad promise for imaging mantle discontinuities.more » « less
-
SUMMARY The seismic quality factor (Q) of the Earth’s mantle is of great importance for the understanding of the physical and chemical properties that control mantle anelasticity. The radial structure of the Earth’s Q is less well resolved compared to its wave speed structure, and large discrepancies exist among global 1-D Q models. In this study, we build a global data set of amplitude measurements of S, SS, SSS and SSSS waves using earthquakes that occurred between 2009 and 2017 with moment magnitudes ranging from 6.5 to 8.0. Synthetic seismograms for those events are computed in a 1-D reference model PREM, and amplitude ratios between observed and synthetic seismograms are calculated in the frequency domain by spectra division, with measurement windows determined based on visual inspection of seismograms. We simulate wave propagation in a global velocity model S40RTS based on SPECFEM3D and show that the average amplitude ratio as a function of epicentral distance is not sensitive to 3-D focusing and defocusing for the source–receiver configuration of the data set. This data set includes about 5500 S and SS measurements that are not affected by mantle transition zone triplications (multiple ray paths), and those measurements are applied in linear inversions to obtain a preliminary 1-D Q model QMSI. This model reveals a high Q region in the uppermost lower mantle. While model QMSI improves the overall datafit of the entire data set, it does not fully explain SS amplitudes at short epicentral distances or the amplitudes of the SSS and SSSS waves. Using forward modelling, we modify the 1-D model QMSI iteratively to reduce the overall amplitude misfit of the entire data set. The final Q model QMSF requires a stronger and thicker high Q region at depths between 600 and 900 km. This anelastic structure indicates possible viscosity layering in the mid mantle.more » « less
-
SUMMARY Long-period (T > 10 s) shear wave reflections between the surface and reflecting boundaries below seismic stations are useful for studying phase transitions in the mantle transition zone (MTZ) but shear-velocity heterogeneity and finite-frequency effects complicate the interpretation of waveform stacks. We follow up on a recent study by Shearer & Buehler (hereafter SB19) of the top-side shear wave reflection Ssds as a probe for mapping the depths of the 410-km and 660-km discontinuities beneath the USArray. Like SB19, we observe that the recorded Ss410s-S and Ss660s-S traveltime differences are longer at stations in the western United States than in the central-eastern United States. The 410-km and 660-km discontinuities are about 40–50 km deeper beneath the western United States than the central-eastern United States if Ss410s-S and Ss660s-S traveltime differences are transformed to depth using a common-reflection point (CRP) mapping approach based on a 1-D seismic model (PREM in our case). However, the east-to-west deepening of the MTZ disappears in the CRP image if we account for 3-D shear wave velocity variations in the mantle according to global tomography. In addition, from spectral-element method synthetics, we find that ray theory overpredicts the traveltime delays of the reverberations. Undulations of the 410-km and 660-km discontinuities are underestimated when their wavelengths are smaller than the Fresnel zones of the wave reverberations in the MTZ. Therefore, modelling of layering in the upper mantle must be based on 3-D reference structures and accurate calculations of reverberation traveltimes.more » « less
