An official website of the United States government
Angle-sensitive photodetectors are a promising device technology for many advanced imaging functionalities, including lensless compound-eye vision, lightfield sensing, optical spatial filtering, and phase imaging. Here we demonstrate the use of plasmonic gradient metasurfaces to tailor the angular response of generic planar photodetectors. The resulting devices rely on the phase-matched coupling of light incident at select geometrically tunable angles into guided plasmonic modes, which are then scattered and absorbed in the underlying photodetector active layer. This approach naturally introduces sharp peaks in the angular response, with smaller footprint and reduced guided-mode radiative losses (and therefore improved spatial resolution and sensitivity) compared to analogous devices based on diffractive coupling. More broadly, these results highlight a promising new application space of flat optics, where gradient metasurfaces are integrated within image sensors to enable unconventional capabilities with enhanced system miniaturization and design flexibility.
more »
« less
Thickness bound for nonlocal wide-field-of-view metalenses
Abstract Metalenses—flat lenses made with optical metasurfaces—promise to enable thinner, cheaper, and better imaging systems. Achieving a sufficient angular field of view (FOV) is crucial toward that goal and requires a tailored incident-angle-dependent response. Here, we show that there is an intrinsic trade-off between achieving a desired broad-angle response and reducing the thickness of the device. Like the memory effect in disordered media, this thickness bound originates from the Fourier transform duality between space and angle. One can write down the transmission matrix describing the desired angle-dependent response, convert it to the spatial basis where its degree of nonlocality can be quantified through a lateral spreading, and determine the minimal device thickness based on such a required lateral spreading. This approach is general. When applied to wide-FOV lenses, it predicts the minimal thickness as a function of the FOV, lens diameter, and numerical aperture. The bound is tight, as some inverse-designed multi-layer metasurfaces can approach the minimal thickness we found. This work offers guidance for the design of nonlocal metasurfaces, proposes a new framework for establishing bounds, and reveals the relation between angular diversity and spatial footprint in multi-channel systems.
more »
« less
- Award ID(s):
- 2146021
- PAR ID:
- 10400221
- Date Published:
- Journal Name:
- Light: Science & Applications
- Volume:
- 11
- Issue:
- 1
- ISSN:
- 2047-7538
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Acoustic metasurfaces are two-dimensional architected materials designed to enable non-trivial control of waves, with a thickness that is either thinner than or comparable to the wavelength. However, most metasurfaces today have a fixed geometry and lack the ability to tune acoustic waves on command. This limits their ability to perform multiple functions, such as beam steering and dynamic focusing. This study introduces inflatable acoustic metasurface (IAM) lenses that enable tunable focusing. The IAMs feature two-dimensional diffractive focusing patterns embedded in a membrane that can be inflated nonplanarly through hydraulic control. It is experimentally demonstrated that inflation allows continuous focal length adjustment from –2.49λ to +3.17λ. To characterize the lens performance, changes in focal characteristics, including peak pressure, full width at half-maximum, and full length at half-maximum, are tracked at different levels of inflation. Furthermore, it is shown that IAMs can correct aberrations that occur as the angle of incidence increases in conventional planar lenses. To validate this, IAMs were tested in a concave configuration at a 20° oblique incidence angle. The results of this study may be applicable to fields requiring continuous and real-time response in tunable focusing, including acoustic imaging and communication, ultrasound surgery, and neuromodulation.more » « less
-
The one-bit spatial Sigma-Delta concept has recently been proposed as an approach for achieving low distortion and low power consumption for massive multi-input multi-output systems. The approach exploits users located in known angular sectors or spatial oversampling to shape the quantization noise away from desired directions of arrival. While reducing the antenna spacing alleviates the adverse impact of quantization noise, it can potentially deteriorate the performance of the massive array due to excessive mutual coupling. In this paper, we analyze the impact of mutual coupling on the uplink spectral efficiency of a spatial one-bit Sigma-Delta massive MIMO architecture, and compare the resulting performance degradation to standard one-bit quantization as well as the ideal case with infinite precision. Our simulations show that the one-bit Sigma-Delta array is particularly advantageous in space-constrained scenarios, can still provide significant gains even in the presence of mutual coupling when the antennas are closely spaced.more » « less
-
A direct-write configuration of microsphere photolithography (MPL) is investigated for the patterning of IR metasurfaces at large scales. MPL uses a self-assembled hexagonal close-packed array of microspheres as an optical element to generate photonic nanojets within a photoresist layer. The photonic jets can be positioned within the microsphere-defined unit cells by controlling the illumination’s angle of incidence (AOI). This allows the definition of complex antenna elements. A digital micromirror device is used to provide spatial modulation across the microsphere arrays and coordinated with a set of stages providing AOI control. This provides hierarchical patterning at the sub- and super-unit cell levels and is suitable for a range of metasurfaces. The constraints of this approach are analyzed and demonstrated with a polarization-dependent infrared perfect absorber/emitter, which agrees well with modeling.more » « less
-
We experimentally demonstrate imaging in the long-wave infrared (LWIR) spectral band (8 μm to 12 μm) using a single polymer flat lens based upon multilevel diffractive optics. The device thickness is only 10 μm, and chromatic aberrations are corrected over the entire LWIR band with one surface. Due to the drastic reduction in device thickness, we are able to utilize polymers with absorption in the LWIR, allowing for inexpensive manufacturing via imprint lithography. The weight of our lens is less than 100 times those of comparable refractive lenses. We fabricated and characterized 2 different flat lenses. Even with about 25% absorption losses, experiments show that our flat polymer lenses obtain good imaging with field of view of 35° and angular resolution less than 0.013°. The flat lenses were characterized with 2 different commercial LWIR image sensors. Finally, we show that, by using lossless, higher-refractive-index materials like silicon, focusing efficiencies in excess of 70% can be achieved over the entire LWIR band. Our results firmly establish the potential for lightweight, ultrathin, broadband lenses for high-quality imaging in the LWIR band.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1038/s41377-022-01038-6
