Solvents are the major source of chemical waste from synthetic chemistry labs. Growing attention to more environmentally friendly sustainable processes demands novel technologies to substitute toxic or hazardous solvents. If not always, sometimes, water can be a suitable substitute for organic solvents, if used appropriately. However, the sole use of water as a solvent remains non-practical due to its incompatibility with organic reagents. Nonetheless, over the past few years, new additives have been disclosed to achieve chemistry in water that also include aqueous micelles as nanoreactors. Although one cannot claim micellar catalysis to be a greener technology for every single transformation, it remains the sustainable or greener alternative for many reactions. Literature precedents support that micellar technology has much more potential than just as a reaction medium, i.e. , the role of the amphiphile as a ligand obviating phosphine ligands in catalysis, the shielding effect of micelles to protect water-sensitive reaction intermediates in catalysis, and the compartmentalization effect. While compiling the powerful impact of micellar catalysis, this article highlights two diverse recent technologies: (i) the design and employment of the surfactant PS-750-M in selective catalysis; (ii) the use of the semisynthetic HPMC polymer to enable ultrafast reactions in water.
more »
« less
Cascade Processes with Micellar Reaction Media: Recent Advances and Future Directions
Reducing the use of solvents is an important aim of green chemistry. Using micelles self-assembled from amphiphilic molecules dispersed in water (considered a green solvent) has facilitated reactions of organic compounds. When performing reactions in micelles, the hydrophobic effect can considerably accelerate apparent reaction rates, as well as enhance selectivity. Here, we review micellar reaction media and their potential role in sustainable chemical production. The focus of this review is applications of engineered amphiphilic systems for reactions (surface-active ionic liquids, designer surfactants, and block copolymers) as reaction media. Micelles are a versatile platform for performing a large array of organic chemistries using water as the bulk solvent. Building on this foundation, synthetic sequences combining several reaction steps in one pot have been developed. Telescoping multiple reactions can reduce solvent waste by limiting the volume of solvents, as well as eliminating purification processes. Thus, in particular, we review recent advances in “one-pot” multistep reactions achieved using micellar reaction media with potential applications in medicinal chemistry and agrochemistry. Photocatalyzed reactions in micellar reaction media are also discussed. In addition to the use of micelles, we emphasize the process (steps to isolate the product and reuse the catalyst).
more »
« less
- Award ID(s):
- 1651957
- NSF-PAR ID:
- 10403949
- Date Published:
- Journal Name:
- Molecules
- Volume:
- 27
- Issue:
- 17
- ISSN:
- 1420-3049
- Page Range / eLocation ID:
- 5611
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Performing multiple reaction steps in “one pot” to avoid the need to isolate intermediates is a promising approach for reducing solvent waste associated with liquid phase chemical processing. In this work, we incorporated gold nanoparticle catalysts into polymer nanoreactors via amphiphilic block copolymer directed self-assembly. With the polymer nanoreactors dispersed in water as the bulk solvent, we demonstrated the ability to facilitate two reaction steps in one pot with spontaneous precipitation of the product from the reaction mixture. Specifically, we achieved imide synthesis from 4-nitrophenol and benzaldehyde as a model reaction. The reaction occured in water at ambient conditions; the desired 4-benzylideneaminophenol product spontaneously precipitated from the reaction mixture while the nanoreactors remained stable in dispersion. A 65% isolated yield was achieved. In contrast, PEGylated gold nanoparticles and citrate stabilized gold nanoparticles precipitated with the reaction product, which would complicate both the isolation of the product as well as reuse of the catalyst. Thus, amphiphilic nanoreactors dispersed in water are a promising approach for reducing solvent waste associated with liquid phase chemical processing by using water as the bulk solvent, eliminating the need to isolate intermediates, achieving spontaneous product separation to facilitate the recycling of the reaction mixture, and simplifying the isolation of the desired product.more » « less
-
Water is an environmentally friendly medium for conducting reversible deactivation radical polymerizations. In this paper, we report the investigation of iodine-mediated photocontrolled atom transfer radical polymerization (photoATRP) in aqueous media. The iodine-based initiator was generated by an in situ halogen exchange from a commercially available bromine-based initiator, ethyl α-bromophenylacetate, using different iodide salts. Fast and well-controlled polymerization of a water-soluble methacrylate monomer was achieved in water under visible light irradiation, including blue, green and yellow lights. The nature of the reaction medium greatly affected the kinetics and control over the growth of polymers. Polymerizations in water resulted in a well-controlled reaction that provided high monomer conversion and polymers with low dispersities, whereas control over the polymerization was poor in bulk or in an organic solvent, N , N -dimethylformamide. Polymerizations were performed over a wide range of visible light in the absence of any photocatalyst. The selection of water as a reaction medium enabled use of iodide salts without the need for solubilizing agents. Moreover, iodine-mediated photoATRP was successfully performed in the presence of residual oxygen, signifying the potential of this polymerization system to tolerate oxygen without performing deoxygenation processes.more » « less
-
null (Ed.)Organic solvents have been the sought-after medium to achieve light initiated transformations in laboratories and industries. Given the current emphasis on green chemistry and rising awareness of environmental pollution it may be necessary for us to utilize abundantly freely available, non-toxic and environmentally friendly water as the medium to perform photoreactions. Although water has attracted the attention of organic synthetic chemists, it is yet to receive the indispensable attention of photochemists. In this article we present examples of photocycloaddition reactions of four molecules namely coumarin, indene, cinnamic acid and acenaphthylene that are sparingly soluble in water. Photodimerization of these molecules in water is much faster and occurs at much lower concentrations than in organic solvents. Aggregation probably forced by hydrophobic association is suggested to be the cause for the increased reactivity even at lower concentrations. The dimer distribution in water is different from that in organic solvents. Further work is required to fully understand the mechanism of photodimerization in water. Although the poor solubility of organic molecules in water requires one to irradiate large volumes to collect enough useful amounts, availability of flow reactors and LEDs as light sources should help one overcome the challenges.more » « less
-
Various membranes have been developed for the separation of oil/water mixtures; however, their fabrication requires toxic reagents, multiple processing steps, and advanced technologies. Nature not only precisely generates unique materials but also provides tremendous examples in the environment that can be used as inspiration for the development and creation of smart and green materials. In this study, we prepare multifunctional nanobiofibers (NBFs) from grape seeds by a one-pot reaction using green solvents that, when made into a smart layer, can switch between a state of underwater superoleophobic wetting to a state of underoil superhydrophobicity and back without any external stimuli. The several μm length and 50 nm width NBFs exhibit robust stability and provide a porous NBF layer, suggesting their potential for the simultaneous separation of various surfactant-stabilized water-in-oil and oil-in-water emulsions while showing high dye adsorption from water (100% for methylene blue). Furthermore, by rolling water droplets on the surface of NBF powder, an effective microreactor, known as a liquid marble, is prepared for the first time using a bio-originated, superamphiphilic material in air, rather than hydrophilic or hydrophobic materials, and it can be used to remove dye within 30 s. Moreover, based on the ability of NBFs to encapsulate a high volume of water (120 μL), we demonstrate another application of the NBF powder as an additive to soil for maintaining soil moisture under arid conditions, allowing us to successfully demonstrate the growth of a lentil seed. This multi-functional, low-cost, and green NBF material shows excellent sustainability and mechanical/chemical stability for multiple promising environmental remediation applications.more » « less