An official website of the United States government
We investigate the flow evolution of a linear and a branched wormlike micellar solution with matched rheology in a Taylor–Couette (TC) cell using a combination of particle-tracking velocimetry, birefringence, and turbidity measurements. Both solutions exhibit a stress plateau within a range of shear rates. Under startup of a steady shear rate flow within the stress plateau, both linear and branched samples exhibit strong transient shear thinning flow profiles. However, while the flow of the linear solution evolves to a banded structure at longer times, the flow of the branched solution transitions to a curved velocity profile with no evidence of shear banding. Flow-induced birefringence measurements indicate transient birefringence banding with strong micellar alignment in the high shear band for the linear solution. The transient flow-induced birefringence is stronger for the branched system at an otherwise identical Wi. At longer times, the birefringence bands are replaced by a chaotic flow reminiscent of elastic instabilities. Visualization of the flow-induced turbidity in the velocity gradient-vorticity plane reveals quasi-steady banding with a turbidity contrast between high and low shear bands in the linear solution. However, the turbidity evolves uniformly within the gap of the TC cell for the branched solution, corroborating the non-banded quasi-steady velocimetry results. Finally, we show that while elastic instabilities in the linear solution emerge in the high shear band, the flow of branched solution at high Wi becomes unstable due to end effects, with growing end regions that ultimately span the entire axial length of the TC cell.
more »
« less
Role of micellar entanglements on kinetics of shear banding flow formation
We investigate the effects of micellar entanglement number on the kinetics of shear banding flow formation in a Taylor–Couette flow. Three sets of wormlike micellar solutions, each set with a similar fluid elasticity and zero-shear-rate viscosity, but with varying entanglement densities, are studied under the startup of steady shear. Our experiments indicate that in the set with low fluid elasticity, the transient shear banding flow is characterized by the formation of a transient flow reversal in a range of entanglement densities. Outside of this range, the transient flow reversal is not observed. For the sets of medium and high elasticities, the transient flow reversals exist for relatively small entanglement densities and disappear for large entanglement densities. Our analysis shows that wall slip and elastic instabilities do not affect the transient flow feature. We identify a correlation between micellar entanglement number, the width of the stress plateau, and the extent of the transient flow reversal. As the micellar entanglement number increases, the width of the stress plateau first increases; then, at a higher micellar entanglement number, the plateau width decreases. Therefore, we hypothesize that the transient flow reversal is connected to the micellar entanglement number through the width of the stress plateau.
more »
« less
- Award ID(s):
- 1942150
- PAR ID:
- 10404164
- Date Published:
- Journal Name:
- Journal of Rheology
- Volume:
- 67
- Issue:
- 1
- ISSN:
- 0148-6055
- Page Range / eLocation ID:
- 169 to 181
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
The formation and evolution of a heterogeneous flow and flow reversal are examined in highly elastic, gel-like wormlike micelles (WLMs) formed from an amphiphilic triblock poloxamer P234 in 2M NaCl. A combination of linear viscoelastic, steady shear, and creep rheology demonstrate that these WLMs have a yield stress and exhibit viscoelastic aging, similar to some soft glassy materials. Nonlinear shear rheology and rheoparticle tracking velocimetry reveal that these poloxamer WLMs undergo a period of strong elastic recoil and flow reversal after the onset of shear startup. As flow reversal subsides, a fluidized high shear rate region and a nearly immobile low shear rate region of fluid form, accompanied by wall slip and elastic instabilities. The features of this flow heterogeneity are reminiscent of those for aging yield stress fluids, where the heterogeneous flow forms during the initial stress overshoot and is sensitive to the inherent stress gradient of the flow geometry. Additionally, macroscopic bands that form transiently above a critical shear rate become “trapped” due to viscoelastic aging in the nearly immobile region. This early onset of the heterogeneous flow during the rapidly decreasing portion of the stress overshoot differs from that typically observed in shear banding WLMs and is proposed to be necessary for observing significant flow reversal. Exploring the early-time, transient behavior of this WLM gel with rheology similar to both WLM solutions and soft glassy materials provides new insights into spatially heterogeneous flows in both of these complex fluids.more » « less
-
Rheo-NMR velocimetry was used to study shear banding of a 6 wt.% cetylpyridinium chloride (CPCl) worm-like micelle solution under shear startup conditions with and without pre-shear. 1D velocity profiles across the fluid gap of a concentric cylinder Couette shear cell were measured every 1 s following shear startup for four different applied shear rates within the stress plateau. Fitting of the velocity profiles allowed calculation of the shear banding characteristics (shear rates in the high and low shear band, the interface position and apparent slip at the inner rotating wall) as the flow transitioned from transient to steady state regimes. Characteristic timescales to reach steady state were obtained and found to be similar for all shear banding characteristics. Timescales decreased with increasing applied shear rate. Large temporal fluctuations with time were also observed and Fourier transform of the time and velocity autocorrelation functions quantified the fluctuation frequencies. Frequencies corresponded to the elastically driven hydrodynamic instabilities,i.e.vortices, that are known to occur in the unstable high shear band and were dependent upon both applied shear rate and the pre-shear protocol.more » « less
-
Nonlinear rheology of entangled wormlike micellar solutions predicted by a micelle-slip-spring modelWe examine linear and nonlinear shear and extensional rheological properties using a “micelle-slip-spring model” [T. Sato et al., J. Rheol. 64, 1045–1061 (2020)] that incorporates breakage and rejoining events into the slip-spring model originally developed by Likhtman [Macromolecules 38, 6128–6139 (2005)] for unbreakable polymers. We here employ the Fraenkel potential for main chain springs and slip-springs to address the effect of finite extensibility. Moreover, to improve extensional properties under a strong extensional flow, stress-induced micelle breakage (SIMB) is incorporated into the micelle-slip-spring model. Thus, this model is the first model that includes the entanglement constraint, Rouse modes, finite extensibility, breakage and rejoining events, and stress-induced micelle breakage. Computational expense currently limits the model to micellar solutions with moderate numbers of entanglements ([Formula: see text]), but for such solutions, nearly quantitative agreement is attained for the start-up of the shearing flow. The model in the extensional flow cannot yet be tested owing to the lack of data for this entanglement level. The transient and steady shear properties predicted by the micelle-slip-spring model for a moderate shear rate region without significant chain stretch are fit well by the Giesekus model but not by the Phan–Thien/Tanner (PTT) model, which is consistent with the ability of the Giesekus model to match experimental shear data. The extensional viscosities obtained by the micelle-slip-spring model with SIMB show thickening followed by thinning, which is in qualitative agreement with experimental trends. Additionally, the extensional rheological properties of the micelle-slip-spring model with or without SIMB are poorly predicted by both the Giesekus and the PTT models using a single nonlinear parameter. Thus, future work should seek a constitutive model able to capture the behavior of the slip-spring model in shear and extensional flows and so provide an accurate, efficient model of micellar solution rheology.more » « less
-
We explore the rheology during a startup flow of well-characterized polyelectrolyte microgel suspensions, which form soft glasses above the jamming concentration. We present and discuss results measured using different mechanical histories focusing on the variations of the static yield stress and yield strain. The behavior of the shear stress growth function is affected by long-lived residual stresses and strains that imprint a slowly decaying mechanical memory inside the materials. The startup flow response is not reversible upon flow reversal and the amplitude of the static yield stress increases with the time elapsed after rejuvenation. We propose an experimental protocol that minimizes the directional memory and we analyze the effect of aging. The static yield strain γ p and the reduced static yield stress σ p / σ y , where σ y is the dynamic yield stress measured from steady flow measurements, are in good agreement with our previous simulations [Khabaz et al., “Transient dynamics of soft particle glasses in startup shear flow. Part I: Microstructure and time scales,” J. Rheol. 65, 241 (2021)]. Our results demonstrate the need to consider memory and aging effects in transient measurements on soft particle glasses.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1122/8.0000436
