An official website of the United States government
We have carried out a combined theoretical and experimental investigation of both stoichiometric and nonstoichiometric CoFeVGe alloys. In particular, we have investigated CoFeVGe, Co 1.25 Fe 0.75 VGe, Co 0.75 Fe 1.25 VGe, and CoFe 0.75 VGe bulk alloys. Our first principles calculations suggest that all four alloys show ferromagnetic order, where CoFeVGe, Co 1.25 Fe 0.75 VGe, and Co 0.75 Fe 1.25 VGe are highly spin polarized with spin polarization values of over 80%. However, the spin polarization value of CoFe 0.75 VGe is only about 60%. We have synthesized all four samples using arc melting and high-vacuum annealing at 600 °C for 48 hours. The room temperature x-ray diffraction of these samples exhibits a cubic crystal structure with disorder. All the samples show single magnetic transitions at their Curie temperatures, where the Curie temperature and high field (3T) magnetization are 288 K and 42 emu/g; 305 K and 1.5 emu/g; 238 K and 39 emu/g; and 306 K and 35 emu/g for CoFeVGe, Co 1.25 Fe 0.75 VGe, Co 0.75 Fe 1.25 VGe, and CoFe 0.75 VGe, respectively.
more »
« less
High spin polarization and spin signal enhancement in non-local spin valves with Co–Fe alloy injectors and detectors
For applications such as spin accumulation sensors for next-generation hard disk drive read heads, and for fundamental research, it is desirable to increase the spin signal in metallic non-local spin valves, which are central devices in spintronics. To this end, here, we report on the integration of high-spin-polarization Co–Fe binary alloy ferromagnetic injectors and detectors in Al-based non-local spin valves. Room-temperature deposition on amorphous substrates from an alloy target is shown to generate smooth, polycrystalline (110-textured), solid-solution body-centered-cubic Co75Fe25 films, which we characterize by energy dispersive x-ray spectroscopy, x-ray diffraction, x-ray reflectivity, atomic force microscopy, and electronic transport. Simple integration into transparent-interface Al non-local spin valves is then shown to realize up to a factor of ∼5 enhancement of the spin signal relative to Co, with full quantitative analysis yielding strikingly temperature-independent current spin polarizations exceeding 60%. We make a detailed quantitative comparison of these values with prior literature, concluding that Co–Fe alloys present a remarkably facile route to higher spin polarization and spin signals in non-local spin valves, with minimal barrier to adoption.
more »
« less
- PAR ID:
- 10423618
- Date Published:
- Journal Name:
- APL Materials
- Volume:
- 11
- Issue:
- 5
- ISSN:
- 2166-532X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract We have carried out a combined theoretical and experimental investigation of FeCrVAl, and the effect of Mn and Co doping on its structural, magnetic, and electronic band properties. Our first principles calculations indicate that FeCrVAl, FeCr 0.5 Mn 0.5 VAl, and FeCr 0.5 Co 0.5 VAl exhibit nearly perfect spin polarization, which may be further enhanced by mechanical strain. At the same time, FeCrV 0.5 Mn 0.5 Al and FeCrV 0.5 Co 0.5 Al exhibit a relatively small value of spin polarization, making them less attractive for practical applications. Using arc melting and high vacuum annealing, we synthesized three compounds FeCrVAl, FeCr 0.5 Mn 0.5 VAl, and FeCr 0.5 Co 0.5 VAl, which are predicted to exhibit high spin polarization. The room temperature x-ray diffraction patterns of all samples are fitted with full B2 type disorder with a small amount of FeO 2 secondary phase. All samples show very small saturation magnetizations at room temperature. The thermomagnetic curves M(T) of FeCrVAl and FeCr 0.5 Co 0.5 VAl are similar to that of a paramagnetic material, whereas that of FeCr 0.5 Mn 0.5 VAl indicates ferrimagnetic behavior with the Curie temperature of 135 K. Our findings may be of interest for researchers working on Heusler compounds for spin-based electronic applications.more » « less
-
The X-ray-induced spin crossover transition of an Fe (II) molecular thin film in the presence and absence of a magnetic field has been investigated. The thermal activation energy barrier in the soft X-ray activation of the spin crossover transition for [Fe{H2B(pz)2}2(bipy)] molecular thin films is reduced in the presence of an applied magnetic field, as measured through X-ray absorption spectroscopy at various temperatures. The influence of a 1.8 T magnetic field is sufficient to cause deviations from the expected exponential spin state transition behavior which is measured in the field free case. We find that orbital moment diminishes with increasing temperature, relative to the spin moment in the vicinity of room temperature.more » « less
-
null (Ed.)For the spin crossover coordination polymer [Fe(L1)(bipy)] n (where L1 is a N 2 O 2 2− coordinating Schiff base-like ligand bearing a phenazine fluorophore and bipy = 4,4′-bipyridine), there is compelling additional evidence of a spin state transition. Both Fe 2p X-ray absorption and X-ray core level photoemission spectroscopies confirm that a spin crossover takes place, as observed by magnetometry. Yet the details of the temperature dependent changes of the spin state inferred from both X-ray absorption and X-ray core level photoemission, differ from magnetometry, particularly with regard to the apparent critical transition temperatures and the cooperative nature of the curve progression in general. Comparing the experimental spin crossover data to Ising model simulations, a transition activation energy in the region of 160 to 175 meV is indicated, along with a nonzero exchange J . Overall, the implication is that there may be perturbations to the bistability of spin states, that are measurement dependent or that the surface differs from the bulk with regard to the cooperative effects observed upon spin transition.more » « less
-
The non-local spin valve (NLSV) is a useful device for studying spin transport at nanoscopic dimensions, with potential technological applications. Despite this appeal, background signals, unrelated to spin diffusion, often hinder the interpretation of spin signals in NLSVs and could compromise performance in future devices. In this paper, we comprehensively investigate these background signals in all-metallic NLSVs fabricated from a variety of ferromagnetic (FM; , Fe, Co) and nonmagnetic (NM; Al, Cu) metals. We demonstrate that a background signal emerges in AC measurements, with contributions from both current spreading and thermoelectric effects, with a complex dependence on both temperature and FM injector-detector separation. Despite the complexity of these dependencies, we demonstrate excellent agreement with three-dimensional finite-element modelling that accounts for current-spreading and thermoelectric effects, across a wide range of temperatures, FM separations, and FM/NM pairings. This approach additionally offers a means to estimate the Seebeck coefficients for the tested FM/NM pairings, providing further insight into the charge and heat flow in such nanoscopic spintronic devices. Published by the American Physical Society2024more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript
- Journal Article:
- https://doi.org/10.1063/5.0147465
