An official website of the United States government
Abstract We present best-fit values of porosity—and the corresponding effective thermal inertiae—determined from three different depths in Europa’s near-subsurface (∼1–20 cm). The porosity of the upper ∼20 cm of Europa’s subsurface varies between 75% and 50% (Γeff≈ 50–140 J m−2K−1s−1/2) on the leading hemisphere and 50%–40% (Γeff≈ 140–180 J m−2K−1s−1/2) on the trailing hemisphere. Residual maps produced by comparison with these models reveal thermally anomalous features that cannot be reproduced by globally homogeneous porosity models. These regions are compared to Europa’s surface terrain and known compositional variations. We find that some instances of warm thermal anomalies are co-located with known geographical or compositional features on both the leading and trailing hemisphere; cool temperature anomalies are well correlated with surfaces previously observed to contain pure, crystalline water ice and the expansive rays of Pwyll crater. Anomalous regions correspond to locations with subsurface properties different from those of our best-fit models, such as potentially elevated thermal inertia, decreased emissivity, or more porous regolith. We also find that ALMA observations at ∼3 mm sound below the thermal skin depth of Europa (∼10–15 cm) for a range of porosity values, and thus do not exhibit features indicative of diurnal variability or residuals similar to other frequency bands. Future observations of Europa at higher angular resolution may reveal additional locations of variable subsurface thermophysical properties, while those at other wavelengths will inform our understanding of the regolith compaction length and the effects of external processes on the shallow subsurface.
more »
« less
Thermal Properties of the Leading Hemisphere of Callisto Inferred from ALMA Observations
Abstract We present a thermal observation of Callisto's leading hemisphere obtained using the Atacama Large Millimeter/submillimeter Array at 0.87 mm (343 GHz). The angular resolution achieved for this observation was ∼0.″16, which for Callisto at the time of this observation (D∼ 1.″05) was equivalent to ∼six elements across the surface. Our disk-integrated brightness temperature of 116 ± 5 K (8.03 ± 0.40 Jy) is consistent with prior disk-integrated observations. Global surface properties were derived from the observation using a thermophysical model constrained by spacecraft data. We find that models parameterized by two thermal inertia components more accurately fit the data than single thermal inertia models. Our best-fit global parameters adopt a lower thermal inertia of 15–50 J m−2K−1s−1/2and a higher thermal inertia component of 1200–2000 J m−2K−1s−1/2, with retrieved millimeter emissivities of 0.89–0.91. We identify several thermally anomalous regions, including spots ∼3 K colder than model predictions colocated with the Valhalla impact basin and a complex of craters in the southern hemisphere; this indicates the presence of materials possessing either a higher thermal inertia or a lower emissivity. A warm region confined to the midlatitudes in these leading hemisphere data may be indicative of regolith property changes due to exogenic sculpting.
more »
« less
- Award ID(s):
- 2308280
- PAR ID:
- 10441863
- Publisher / Repository:
- DOI PREFIX: 10.3847
- Date Published:
- Journal Name:
- The Planetary Science Journal
- Volume:
- 4
- Issue:
- 8
- ISSN:
- 2632-3338
- Format(s):
- Medium: X Size: Article No. 142
- Size(s):
- Article No. 142
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Grain sizes of Martian sand dunes are critical sedimentological data on sand provenance and transport pathways. Thermal inertia values are used to characterize the grain sizes of dune sand. Most early characterizations involved single dune fields. Recent work based on global data sets has provided more wide‐spread dune sand locations, though these data sets include the non‐sandy interdune areas. To provide a more accurate grain size characterization, we leverage a global thermal inertia data set, a global dune database and a global imaging mosaic to develop a freeware‐based methodology for deriving grain sizes. This methodology involves delineation of sand‐only areas within dune fields and collection of thermal inertia values from those areas. We consider a unimodal histogram of values with a mode <∼350 thermal inertia units (J m−2 K−1 s−1/2) to imply an effective exclusion of non‐sand surfaces. Application of this methodology to dune fields for which thermal inertia values have been previous derived shows our results fall within the envelope of those values. We apply our methodology to tropical dune fields on Mars for which Dust Cover Index data imply dust‐free surfaces. Conversion of these thermal inertia values to sand grain sizes yields a range of sand classifications of fine sand to granules. Comparison of sand size classifications with geographic location shows grain size ranges that are distinctive by location, consistent with local sourcing. This work points toward geographically diverse sand formation mechanisms yielding diverse grain sizes, while providing a freeware‐based and thus widely accessible method for expanding the derivation of these critical data.more » « less
-
Abstract We present a catalog of clouds identified from the12CO (1–0) data of M83, which was observed using the Atacama Large Millimeter/submillimeter Array with a spatial resolution of ∼46 pc and a mass sensitivity of ∼104M⊙(3σ). The almost full-disk coverage and high sensitivity of the data allowed us to sample 5724 molecular clouds with a median mass of ∼1.9 × 105M⊙, which is comparable to the most frequently sampled mass of giant molecular clouds by surveys in the Milky Way (MW). About 60% of the total CO luminosity in M83's disk arises from clouds more massive than 106M⊙. Such massive clouds comprise 16% of the total clouds in number and tend to concentrate toward the arm, bar, and center, while smaller clouds are more prevalent in interarm regions. Most >106M⊙clouds have peak brightness temperaturesTpeakabove 2 K with the current resolution. Comparing the observed cloud properties with the scaling relations determined by P. M. Solomon et al. (1987, hereafter S87),Tpeak> 2 K clouds follow the relations, butTpeak< 2 K clouds, which are dominant in number, deviate significantly. Without considering the effect of beam dilution, the deviations would suggest modestly high virial parameters (medianαvir∼ 2.7) and low surface mass densities (median Σ ∼ 22M⊙pc−2) for the entire cloud samples, which are similar to values found for the MW clouds by T. S. Rice et al. (2016) and M.-A Miville-Deschênes et al. (2017). However, once beam dilution is taken into account, the observedαvirand Σ for a majority of the clouds (mostlyTpeak<2 K) can be potentially explained with intrinsic Σ of ∼100M⊙pc−2andαvirof ∼1, which are similar to the clouds of S87.more » « less
-
Abstract We present Atacama Large Millimeter/submillimeter Array (ALMA) Cycle 2 observations of CO(2–1) emission from the circumnuclear disks in two early-type galaxies, NGC 1380 and NGC 6861. The disk in each galaxy is highly inclined (i∼ 75°), and the projected velocities of the molecular gas near the galaxy centers are ∼300 km s−1in NGC 1380 and ∼500 km s−1in NGC 6861. We fit thin disk dynamical models to the ALMA data cubes to constrain the masses of the central black holes (BHs). We created host galaxy models using Hubble Space Telescope images for the extended stellar mass distributions and incorporated a range of plausible central dust extinction values. For NGC 1380, our best-fit model yieldsMBH= 1.47 × 108M⊙with a ∼40% uncertainty. For NGC 6861, the lack of dynamical tracers within the BH’s sphere of influence due to a central hole in the gas distribution precludes a precise measurement ofMBH. However, our model fits require a value forMBHin the range of (1–3) × 109M⊙in NGC 6861 to reproduce the observations. The BH masses are generally consistent with predictions from local BH–host galaxy scaling relations. Systematic uncertainties associated with dust extinction of the host galaxy light and choice of host galaxy mass model dominate the error budget of both measurements. Despite these limitations, the measurements demonstrate ALMA’s ability to provide constraints on BH masses in cases where the BH’s projected radius of influence is marginally resolved or the gas distribution has a central hole.more » « less
-
Abstract We present Band 6 and Band 7 observations of 10 Lupus disks around M3-K6 stars from the Atacama Large Millimeter/submillimeter Array survey of Gas Evolution in PROtoplanetary disks (AGE-PRO) Large Program. In addition to continuum emission in both bands, our Band 6 setup covers the12CO,13CO, and C18OJ= 2–1 lines, while our Band 7 setup covers the N2H+J= 3–2 line. All of our sources are detected in12CO and13CO; seven out of ten are detected in C18O; and three are detected in N2H+. We find strong correlations between the CO isotopologue line fluxes and the continuum flux densities. With the exception of one disk, we also identify a strong correlation between the C18OJ= 2–1 and N2H+J= 3–2 fluxes, indicating similar CO abundances across this sample. For the two sources with well-resolved continuum and12COJ= 2–1 images, we find that their gas-to-dust size ratio is consistent with the median value of ∼2 inferred from a larger sample of Lupus disks. We derive dust disk masses from continuum flux densities. We estimate gas disk masses by comparing C18OJ= 2–1 line fluxes with those predicted by the limited grid of self-consistent disk models of M. Ruaud et al. A comparison of these mass estimates with those derived by L. Trapman et al., using a combination of CO isotopologue and N2H+line emission, shows that the masses are consistent with each other. Some discrepancies appear for small and faint disks, but they are still within the uncertainties. Both methods find gas disk masses increase with dust disk masses, and gas-to-dust mass ratios are between 10 and 100 in the AGE-PRO Lupus sample.more » « less
