An official website of the United States government
Abstract Domain wall nanoelectronics is a rapidly evolving field, which explores the diverse electronic properties of the ferroelectric domain walls for application in low‐dimensional electronic systems. One of the most prominent features of the ferroelectric domain walls is their electrical conductivity. Here, using a combination of scanning probe and scanning transmission electron microscopy, the mechanism of the tunable conducting behavior of the domain walls in the sub‐micrometer thick films of the technologically important ferroelectric LiNbO3is explored. It is found that the electric bias generates stable domains with strongly inclined domain boundaries with the inclination angle reaching 20° with respect to the polar axis. The head‐to‐head domain boundaries exhibit high conductance, which can be modulated by application of the sub‐coercive voltage. Electron microscopy visualization of the electrically written domains and piezoresponse force microscopy imaging of the very same domains reveals that the gradual and reversible transition between the conducting and insulating states of the domain walls results from the electrically induced wall bending near the sample surface. The observed modulation of the wall conductance is corroborated by the phase‐field modeling. The results open a possibility for exploiting the conducting domain walls as the electrically controllable functional elements in the multilevel logic nanoelectronics devices.
more »
« less
Ferroelectric Domain Wall Memristor
Abstract A domain wall‐enabled memristor is created, in thin film lithium niobate capacitors, which shows up to twelve orders of magnitude variation in resistance. Such dramatic changes are caused by the injection of strongly inclined conducting ferroelectric domain walls, which provide conduits for current flow between electrodes. Varying the magnitude of the applied electric‐field pulse, used to induce switching, alters the extent to which polarization reversal occurs; this systematically changes the density of the injected conducting domain walls in the ferroelectric layer and hence the resistivity of the capacitor structure as a whole. Hundreds of distinct conductance states can be produced, with current maxima achieved around the coercive voltage, where domain wall density is greatest, and minima associated with the almost fully switched ferroelectric (few domain walls). Significantly, this “domain wall memristor” demonstrates a plasticity effect: when a succession of voltage pulses of constant magnitude is applied, the resistance changes. Resistance plasticity opens the way for the domain wall memristor to be considered for artificial synapse applications in neuromorphic circuits.
more »
« less
- Award ID(s):
- 1709237
- PAR ID:
- 10449281
- Publisher / Repository:
- Wiley Blackwell (John Wiley & Sons)
- Date Published:
- Journal Name:
- Advanced Functional Materials
- Volume:
- 30
- Issue:
- 28
- ISSN:
- 1616-301X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Electrical modulation of magnetic states in single-phase multiferroic materials, using domain-wall magnetoelectric (ME) coupling, can be enhanced substantially by controlling the population density of the ferroelectric (FE) domain walls during polarization switching. In this work, we investigate the domain-wall ME coupling in multiferroic h-YbFeO3thin films, in which the FE domain walls induce clamped antiferromagnetic (AFM) domain walls with reduced magnetization magnitude. Simulation according to the phenomenological theory indicates that the domain-wall ME effect is dramatically enhanced when the separation between the FE domain walls shrinks below the characteristic width of the clamped AFM domain walls during the ferroelectric switching. Experimentally, we show that while the magnetization magnitude remains same for both the positive and the negative saturation polarization states, there is evidence of magnetization reduction at the coercive voltages. These results suggest that the domain-wall ME effect is viable for electrical control of magnetization.more » « less
-
Abstract A synaptic memristor using 2D ferroelectric junctions is a promising candidate for future neuromorphic computing with ultra‐low power consumption, parallel computing, and adaptive scalable computing technologies. However, its utilization is restricted due to the limited operational voltage memory window and low on/off current (ION/OFF) ratio of the memristor devices. Here, it is demonstrated that synaptic operations of 2D In2Se3ferroelectric junctions in a planar memristor architecture can reach a voltage memory window as high as 16 V (±8 V) and ION/OFFratio of 108, significantly higher than the current literature values. The power consumption is 10−5 W at the on state, demonstrating low power usage while maintaining a large ION/OFFratio of 108compared to other ferroelectric devices. Moreover, the developed ferroelectric junction mimicked synaptic plasticity through pulses in the pre‐synapse. The nonlinearity factors are obtained 1.25 for LTP, −0.25 for LTD, respectively. The single‐layer perceptron (SLP) and convolutional neural network (CNN) on‐chip training results in an accuracy of up to 90%, compared to the 91% in an ideal synapse device. Furthermore, the incorporation of a 3 nm thick SiO2interface between the α‐In2Se3and the Au electrode resulted in ultrahigh performance among other 2D ferroelectric junction devices to date.more » « less
-
Abstract Resonant tunneling is a quantum‐mechanical effect in which electron transport is controlled by the discrete energy levels within a quantum‐well (QW) structure. A ferroelectric resonant tunneling diode (RTD) exploits the switchable electric polarization state of the QW barrier to tune the device resistance. Here, the discovery of robust room‐temperature ferroelectric‐modulated resonant tunneling and negative differential resistance (NDR) behaviors in all‐perovskite‐oxide BaTiO3/SrRuO3/BaTiO3QW structures is reported. The resonant current amplitude and voltage are tunable by the switchable polarization of the BaTiO3ferroelectric with the NDR ratio modulated by ≈3 orders of magnitude and an OFF/ON resistance ratio exceeding a factor of 2 × 104. The observed NDR effect is explained an energy bandgap between Ru‐t2gand Ru‐egorbitals driven by electron–electron correlations, as follows from density functional theory calculations. This study paves the way for ferroelectric‐based quantum‐tunneling devices in future oxide electronics.more » « less
-
Abstract Field-free switching of perpendicular magnetization has been observed in an epitaxial L1$$_1$$-ordered CoPt/CuPt bilayer and attributed to spin-orbit torque (SOT) arising from the crystallographic $3m$ point group of the interface. Using a first-principles nonequilibrium Green’s function formalism combined with the Anderson disorder model, we calculate the angular dependence of the SOT in a CoPt/CuPt bilayer and find that the magnitude of the $3m$$ SOT is about 20\% of the conventional dampinglike SOT. We further study the magnetization dynamics in perpendicularly magnetized films in the presence of $$3m$ SOT and Dzyaloshinskii-Moriya interaction, using the equations of motion for domain wall dynamics and micromagnetic simulations. We find that for systems with strong interfacial DMI characterized by the N'eel character of domain walls, a very large current density is required to achieve deterministic switching because reorientation of the magnetization inside the domain wall is necessary to induce the switching asymmetry. For thicker films with relatively weak interfacial DMI and the Bloch character of domain walls the deterministic switching with much smaller currents is possible, which agrees with recent experimental findings.more » « less
