An official website of the United States government
Abstract Tropical islands, including many in island arcs, are subjected to recurring disturbances from extreme storms such as tropical cyclones. To test whether such storms influence cosmogenic nuclide concentrations such that they do not reflect long‐term rates of erosion, we measured meteoric andin situ10Be in river sediment samples from Dominica, an andesitic island in the Caribbean, before and after category five Hurricane Maria (in 2017). Populations of before‐ and after‐storm concentrations are statistically indistinguishable (n = 7 pairs forin‐situ10Be,n = 11 pairs for meteoric10Be).10Be concentrations vary from −138% to +73% within before–after sample pairs relative to the mean of the pair. These new data suggest that the effects of extreme storms on the depth and amount of near‐surface erosion on Dominica vary spatially. Our data support the calculations of Niemi et al. (2005) and Yanites et al. (2009) suggesting that basin‐by‐basin comparisons of erosion rates based on cosmogenic nuclides should be approached with caution in small (<~100 km2) watersheds affected by mass movements and extreme storms. Erosion rates determined fromin‐situ10Be on Dominica (geometric mean = 0.102 mm y−1,n = 12) are low compared to similarly steep and wet areas globally and correlate positively with the spatial density of mass movements.
more »
« less
Hillslope Morphology Drives Variability of Detrital 10 Be Erosion Rates in Steep Landscapes
Abstract The connection between topography and erosion rate is central to understanding landscape evolution and sediment hazards. However, investigation of this relationship in steep landscapes has been limited due to expectations of: (a) decoupling between erosion rate and “threshold” hillslope morphology; and (b) bias in detrital cosmogenic nuclide erosion rates due to deep‐seated landslides. Here we compile 120 new and published10Be erosion rates from catchments in the San Gabriel Mountains, California, and show that hillslope morphology and erosion rate are coupled for slopes approaching 50° due to progressive exposure of bare bedrock with increasing erosion rate. We find no evidence for drainage area dependence in10Be erosion rates in catchments as small as 0.09 km2, and we show that landslide deposits influence erosion rate estimates mainly by adding scatter. Our results highlight the potential and importance of sampling small catchments to better understand steep hillslope processes.
more »
« less
- Award ID(s):
- 1848321
- PAR ID:
- 10449719
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geophysical Research Letters
- Volume:
- 50
- Issue:
- 16
- ISSN:
- 0094-8276
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Direct measurements of erosional response to past climate change are scarce, but mid‐latitude landscapes can record how shifts between cold and warm periods altered erosion outside glacial margins. To study hillslope responses to periglaciation, we measured bulk geochemistry and cosmogenic10Be and26Al concentrations in colluvium and weathered bedrock in an 18 m regolith core from Bear Meadows, Pennsylvania, ∼100 km south of maximum glacial extent. Using core lithology, cosmogenic nuclide concentrations, and regional10Be‐derived erosion rates, we show the onset of 100‐Kyr glacial cycles at the Mid‐Pleistocene Transition (1.2–0.7 Ma) instigated multiple periglacial episodes in central Appalachia, increasing erosion rates compared to the relatively warmer Neogene. Our results show the higher efficiency of periglacial versus temperate erosion processes and highlight a pervasive Pleistocene periglacial erosion signal preserved in the10Be inventory of surface sediments in central Appalachia, where erosion rates are slow enough to integrate previous cold‐climate processes.more » « less
-
Abstract. Since the 1990s, analysis of cosmogenic nuclides, primarily 10Be, in quartz-bearing river sand, has allowed for quantitative determination of erosion rates at a basin scale. Paired measurements of in situ cosmogenic 26Al and 10Be in sediment are less common but offers insight into the history of riverine sediment moving down slopes and through drainage basins. Prolonged sediment burial (>105 years), a violation of assumptions underlying erosion rate calculations, is indicated by higher 26Al-based than 10Be-based erosion rates due to preferential loss of shorter-lived 26Al by decay when quartz is shielded from cosmic rays. Here, we use a global compilation of 26Al and 10Be data generated from quartz-bearing fluvial sediment samples (n = 624, including 121 new measurements) and calculate the discordance between erosion rates derived from each nuclide. We test for correlations between such discordance and topographic metrics for drainage basins, allowing us to infer the likelihood of sediment burial during transport in different geomorphic settings. We find that nearly half of samples (n = 276) exhibit discordance (> 1σ uncertainty) between erosion rates derived from 10Be and 26Al, indicating sediment histories that must include extended burial during residence on hillslopes and/or in the fluvial system after or during initial near-surface exposure. Physical basin parameters such as basin area, slope, and tectonic activity exhibit significant correlation with erosion rate discordance whereas climatic parameters have little correlation. Our analysis suggests that 26Al/10Be erosion rate discordance occurs more regularly in basins larger than 1,000 km2, particularly when such basins have low average slopes and are in tectonically quiescent terrains. Sediment sourced from smaller, steeper basins in tectonically active regions is more likely to have similar 10Be and 26Al erosion rates indicative of limited storage and limited burial during residence in the hillslope and fluvial sediment system. The data and analysis we present demonstrate that paired 26Al and 10Be analyses in detrital fluvial samples can provide a window into watershed processes, elucidating landscape behavior at different spatial scales and allowing a deeper understanding of both sediment routing systems and whether erosion rate assumptions are violated. Large lowland basins are more likely to transport detrital sediment that has experienced prolonged sediment storage and burial either on hillslopes and/or in fluvial networks; thus, erosion rates from such basins are lower limits due to nuclide decay during storage. Conversely, samples from smaller upland basins are more likely to provide reliable erosion rates.more » « less
-
null (Ed.)Abstract. Estimation of erosion rate is an important component of landscapeevolution studies, particularly in settings where transience or spatialvariability in uplift or erosion generates diverse landform morphologies.While bedrock rivers are often used to constrain the timing and magnitude of changes in baselevel lowering, hilltop curvature (or convexity), CHT, provides an additional opportunity to map variations in erosion rate given that average slope angle becomes insensitive to erosion rate owing to threshold slope processes. CHT measurement techniques applied in prior studies (e.g., polynomial functions), however, tend to be computationallyexpensive when they rely on high-resolution topographic data such as lidar,limiting the spatial extent of hillslope geomorphic studies to small studyregions. Alternative techniques such as spectral tools like continuouswavelet transforms present an opportunity to rapidly document trends inhilltop convexity across expansive areas. Here, we demonstrate howcontinuous wavelet transforms (CWTs) can be used to calculate the Laplacianof elevation, which we utilize to estimate erosion rate in three catchmentsof the Oregon Coast Range that exhibit varying slope angle, slope length,and hilltop convexity, implying differential erosion. We observe thatCHT values calculated with the CWT are similar to those obtained from2D polynomial functions. Consistent with recent studies, we find thaterosion rates estimated with CHT from both CWTs and 2D polynomialfunctions are consistent with erosion rates constrained with cosmogenicradionuclides from stream sediments. Importantly, our CWT approachcalculates curvature at least 103 times more quickly than 2Dpolynomials. This efficiency advantage of the CWT increases with domainsize. As such, continuous wavelet transforms provide a compelling approachto rapidly quantify regional variations in erosion rate as well aslithology, structure, and hillslope sediment transport processes, which areencoded in hillslope morphology. Finally, we test the accuracy of CWT and 2Dpolynomial techniques by constructing a series of synthetic hillslopesgenerated by a theoretical nonlinear transport model that exhibit a range oferosion rates and topographic noise characteristics. Notably, we find thatneither CWTs nor 2D polynomials reproduce the theoretically prescribedCHT value for hillslopes experiencing moderate to fast erosion rates,even when no topographic noise is added. Rather, CHT is systematicallyunderestimated, producing a power law relationship between erosion rate andCHT that can be attributed to the increasing prominence of planarhillslopes that narrow the zone of hilltop convexity as erosion rateincreases. As such, we recommend careful consideration of measurement lengthscale when applying CHT to estimate erosion rate in moderate tofast-eroding landscapes, where curvature measurement techniques may be prone to systematic underestimation.more » « less
-
Abstract Steep landscapes evolve largely by debris flows, in addition to fluvial and hillslope processes. Abundant field observations document that debris flows incise valley bottoms and transport substantial sediment volumes, yet their contributions to steepland morphology remain uncertain. This has, in turn, limited the development of debris‐flow incision rate formulations that produce morphology consistent with natural landscapes. In many landscapes, including the San Gabriel Mountains (SGM), California, steady‐state fluvial channel longitudinal profiles are concave‐up and exhibit a power‐law relationship between channel slope and drainage area. At low drainage areas, however, valley slopes become nearly constant. These topographic forms result in a characteristically curved slope‐area signature in log‐log space. Here, we use a one‐dimensional landform evolution model that incorporates debris‐flow erosion to reproduce the relationship between this curved slope‐area signature and erosion rate in the SGM. Topographic analysis indicates that the drainage area at which steepland valleys transition to fluvial channels correlates with measured erosion rates in the SGM, and our model results reproduce these relationships. Further, the model only produces realistic valley profiles when parameters that dictate the relationship between debris‐flow erosion, valley‐bottom slope, and debris‐flow depth are within a narrow range. This result helps place constraints on the mathematical form of a debris‐flow incision law. Finally, modeled fluvial incision outpaces debris‐flow erosion at drainage areas less than those at which valleys morphologically transition from near‐invariant slopes to concave profiles. This result emphasizes the critical role of debris‐flow incision for setting steepland form, even as fluvial incision becomes the dominant incisional process.more » « less
