skip to main content


Title: Hilltop curvature as a proxy for erosion rate: wavelets enable rapid computation and reveal systematic underestimation
Abstract. Estimation of erosion rate is an important component of landscapeevolution studies, particularly in settings where transience or spatialvariability in uplift or erosion generates diverse landform morphologies.While bedrock rivers are often used to constrain the timing and magnitude of changes in baselevel lowering, hilltop curvature (or convexity), CHT, provides an additional opportunity to map variations in erosion rate given that average slope angle becomes insensitive to erosion rate owing to threshold slope processes. CHT measurement techniques applied in prior studies (e.g., polynomial functions), however, tend to be computationallyexpensive when they rely on high-resolution topographic data such as lidar,limiting the spatial extent of hillslope geomorphic studies to small studyregions. Alternative techniques such as spectral tools like continuouswavelet transforms present an opportunity to rapidly document trends inhilltop convexity across expansive areas. Here, we demonstrate howcontinuous wavelet transforms (CWTs) can be used to calculate the Laplacianof elevation, which we utilize to estimate erosion rate in three catchmentsof the Oregon Coast Range that exhibit varying slope angle, slope length,and hilltop convexity, implying differential erosion. We observe thatCHT values calculated with the CWT are similar to those obtained from2D polynomial functions. Consistent with recent studies, we find thaterosion rates estimated with CHT from both CWTs and 2D polynomialfunctions are consistent with erosion rates constrained with cosmogenicradionuclides from stream sediments. Importantly, our CWT approachcalculates curvature at least 103 times more quickly than 2Dpolynomials. This efficiency advantage of the CWT increases with domainsize. As such, continuous wavelet transforms provide a compelling approachto rapidly quantify regional variations in erosion rate as well aslithology, structure, and hillslope sediment transport processes, which areencoded in hillslope morphology. Finally, we test the accuracy of CWT and 2Dpolynomial techniques by constructing a series of synthetic hillslopesgenerated by a theoretical nonlinear transport model that exhibit a range oferosion rates and topographic noise characteristics. Notably, we find thatneither CWTs nor 2D polynomials reproduce the theoretically prescribedCHT value for hillslopes experiencing moderate to fast erosion rates,even when no topographic noise is added. Rather, CHT is systematicallyunderestimated, producing a power law relationship between erosion rate andCHT that can be attributed to the increasing prominence of planarhillslopes that narrow the zone of hilltop convexity as erosion rateincreases. As such, we recommend careful consideration of measurement lengthscale when applying CHT to estimate erosion rate in moderate tofast-eroding landscapes, where curvature measurement techniques may be prone to systematic underestimation.  more » « less
Award ID(s):
1948961
NSF-PAR ID:
10299476
Author(s) / Creator(s):
;
Date Published:
Journal Name:
Earth Surface Dynamics
Volume:
9
Issue:
5
ISSN:
2196-632X
Page Range / eLocation ID:
1279 to 1300
Format(s):
Medium: X
Sponsoring Org:
National Science Foundation
More Like this
  1. Abstract

    Steep landscapes evolve largely by debris flows, in addition to fluvial and hillslope processes. Abundant field observations document that debris flows incise valley bottoms and transport substantial sediment volumes, yet their contributions to steepland morphology remain uncertain. This has, in turn, limited the development of debris‐flow incision rate formulations that produce morphology consistent with natural landscapes. In many landscapes, including the San Gabriel Mountains (SGM), California, steady‐state fluvial channel longitudinal profiles are concave‐up and exhibit a power‐law relationship between channel slope and drainage area. At low drainage areas, however, valley slopes become nearly constant. These topographic forms result in a characteristically curved slope‐area signature in log‐log space. Here, we use a one‐dimensional landform evolution model that incorporates debris‐flow erosion to reproduce the relationship between this curved slope‐area signature and erosion rate in the SGM. Topographic analysis indicates that the drainage area at which steepland valleys transition to fluvial channels correlates with measured erosion rates in the SGM, and our model results reproduce these relationships. Further, the model only produces realistic valley profiles when parameters that dictate the relationship between debris‐flow erosion, valley‐bottom slope, and debris‐flow depth are within a narrow range. This result helps place constraints on the mathematical form of a debris‐flow incision law. Finally, modeled fluvial incision outpaces debris‐flow erosion at drainage areas less than those at which valleys morphologically transition from near‐invariant slopes to concave profiles. This result emphasizes the critical role of debris‐flow incision for setting steepland form, even as fluvial incision becomes the dominant incisional process.

     
    more » « less
  2. Abstract. Carbonate rocks are highly reactive and can have higher ratios of chemical weathering to total denudation relative to most other rock types. Their chemical reactivity affects the first-order morphology of carbonate-dominated landscapes and their climate sensitivity to weathering.However, there have been few efforts to quantify the partitioning ofdenudation into mechanical erosion and chemical weathering in carbonatelandscapes such that their sensitivity to changing climatic and tectonicconditions remains elusive. Here, we compile bedrock and catchment-averagedcosmogenic calcite–36Cl denudation rates and compare them to weathering rates derived from stream water chemistry from the same regions. Local bedrock denudation and weathering rates are comparable, ∼20–40 mm ka−1, whereas catchment-averaged denudation rates are ∼2.7 times higher. The discrepancy between bedrock and catchment-averaged denudation is 5 times lower compared to silicate-rich rocks, illustrating that elevated weathering rates make denudation more spatially uniform in carbonate-dominated landscapes. Catchment-averaged denudation rates correlate well with topographic relief and hillslope gradients, and moderate correlations with runoff can be explained by concurrent increases in weathering rates. Comparing denudation rates with weathering rates shows that mechanical erosion processes contribute ∼50 % of denudation in southern France and ∼70 % in Greece and Israel. Our results indicate that the partitioning between largely slope-independent chemical weathering and slope-dependent mechanical erosion varies based on climate and tectonics and impacts the landscape morphology. This leads us to propose a conceptual model whereby in humid, slowly uplifting regions, carbonates are associated with low-lying, flat topography because slope-independent chemical weathering dominates denudation. In contrast, in arid climates with rapid rock uplift rates, carbonate rocks form steep mountains that facilitate rapid, slope-dependent mechanical erosion required to compensate for inefficient chemical weathering and runoff loss to groundwater systems. This result suggests that carbonates represent an end member for interactions between climate, tectonics, and lithology. 
    more » « less
  3. Abstract

    The connection between topography and erosion rate is central to understanding landscape evolution and sediment hazards. However, investigation of this relationship in steep landscapes has been limited due to expectations of: (a) decoupling between erosion rate and “threshold” hillslope morphology; and (b) bias in detrital cosmogenic nuclide erosion rates due to deep‐seated landslides. Here we compile 120 new and published10Be erosion rates from catchments in the San Gabriel Mountains, California, and show that hillslope morphology and erosion rate are coupled for slopes approaching 50° due to progressive exposure of bare bedrock with increasing erosion rate. We find no evidence for drainage area dependence in10Be erosion rates in catchments as small as 0.09 km2, and we show that landslide deposits influence erosion rate estimates mainly by adding scatter. Our results highlight the potential and importance of sampling small catchments to better understand steep hillslope processes.

     
    more » « less
  4. Temporal and spatial variations of tectonic rock uplift are generally thought to be the main controls on long-term erosion rates in various landscapes. However, rivers continuously lengthen and capture drainages in strike-slip fault systems due to ongoing motion across the fault, which can induce changes in landscape forms, drainage networks, and local erosion rates. Located along the restraining bend of the San Andreas Fault, the San Bernardino Mountains provide a suitable location for assessing the influence of topographic disequilibrium from perturbations by tectonic forcing and channel reorganization on measured erosion rates. In this study, we measured 17 new basin-averaged erosion rates using cosmogenic 10Be in river sands (hereafter, 10Be-derived erosion rates) and compiled 31 10Be-derived erosion rates from previous work. We quantify the degree of topographic disequilibrium using topographic analysis by examining hillslope and channel decoupling, the areal extent of pre-uplift surface, and drainage divide asymmetry across various landscapes. Similar to previous work, we find that erosion rates generally increase from north to south across the San Bernardino Mountains, reflecting a southward increase in tectonic activity. However, a comparison between 10Be-derived erosion rates and various topographic metrics in the southern San Bernardino Mountains suggests that the presence of transient landscape features such as relict topography and drainage-divide migration may explain local variations in 10Be-derived erosion rates. Our work shows that coupled analysis of erosion rates and topographic metrics provides tools for assessing the influence of tectonic uplift and channel reorganization on landscape evolution and 10Be-derived erosion rates in an evolving strike-slip restraining bend.

     
    more » « less
  5. Van Stan, John Toland (Ed.)
    Topography is commonly viewed as a passive backdrop on which vegetation grows. Yet, in certain circumstances, a bidirectional feedback may develop between the control of topography and the spatial distribution of vegetation and landform development, because vegetation modulates the erosion of the land surface. Therefore, if reinforcing feedbacks are established between erosion and land cover distribution over timescales relevant to landform development, then the interactions between vegetation and topography may create distinctive landforms, shaped by vegetation. We expose here a strong correlation between the spatial distribution of vegetation, erosion rates, and topography at a characteristic length scale of 10 2 -10 3 m (mesoscale topography) in the Luquillo Experimental forest (LEF) of Puerto Rico. We use high-resolution LiDAR topography to characterize landforms, satellite images to classify the vegetation into forest types, and in-situ produced cosmogenic 10 Be in the quartz extracted from soils and stream sediments to document spatial variations in soil erosion. The data document a strong correlation between forest type and topographic position (hilltop vs. valleys), and a correlation between topographic position and 10 Be-derived erosion rates over 10 3 −10 4 years. Erosion is faster in valleys, which are mostly covered by monocot Palm Forest, and slower on surrounding hills mostly covered by the dicot Palo Colorado Forest. Transition from one forest type to the next occurs across a break-in-slope that separates shallowly convex hilltops from deeply concave valleys (coves). The break-in-slope is the consequence of a longer-lasting erosional imbalance whereby coves erode faster than hills over landscape-shaping timescales. Such a deepening of the coves is usually spurred by external drivers, but such drivers are here absent. This implies that cove erosion is driven by a process originating within the coves themselves. We propose that vegetation is the primary driver of this imbalance, soil erosion being faster under Palm forest than under Palo Colorado forest. Concentration of the Palm forest in the deepening coves is reinforced by the better adaptation of Palm trees to the erosive processes that take place in the coves, once these develop steep slopes. At the current rate of landscape development, we find that the imbalance started within the past 0.1–1.5 My. The initiation of the process could correspond to time of settlement of these mountain slopes by the Palm and Palo Colorado forests. 
    more » « less