An official website of the United States government
Abstract Coral reef roughness produces turbulent boundary layers and bottom stresses that are important for reef metabolism monitoring and reef circulation modeling. However, there is some uncertainty as to whether field methods for estimating bottom stress are applicable in shallow canopy environments as found on coral reefs. Friction velocities () and drag coefficients () were estimated using five independent methods and compared across 14 sites on a shallow forereef (2–9 m deep) in Palau with large and spatially variable coral roughness elements (0.4–1 m tall). The methods included the following: (a) momentum balance closure, (b) log‐fitting to velocity profiles, (c) Reynolds stresses, (d) turbulence dissipation, and (e) roughness characterization from digital elevation models (DEMs). Both velocity profiles and point turbulence measurements indicated good agreement with log‐layer scaling, suggesting that measurements were taken within a well‐developed turbulent boundary layer and that canopy effects were minimal. However, estimated from the DEMs, momentum budget and log‐profile fitting were consistently larger than those estimated from direct turbulence measurements. Near‐bed Reynolds stresses only contributed about 1/3 of the total bottom stress and drag produced by the reef. Thus, effects of topographical heterogeneity that induce mean velocity fluxes, dispersive stresses, and form drag are expected to be important. This decoupling of total drag and local turbulence implies that both rates of mass transfer as well as values of fluxes inferred from concentration measurements may be proportional to smaller, turbulence‐derived values of rather than to those based on larger‐scale flow structure.
more »
« less
Flow and Drag in a Seagrass Bed
Abstract We report direct measurement of drag forces due to tidal flow over a submerged seagrass bed in Ngeseksau Reef, Koror State, Republic of Palau. In our study, drag is computed using an array of high‐resolution pressure measurements, from which values of the drag coefficients,CD, referenced to measured depth‐averaged velocities,V, were inferred. Reflecting the fact that seagrass blades deflect in the presence of flow, we find thatCDis O(1) when flows are weak and tends toward a value of 0.03 at the highest velocities, behavior that is consistent with existing theory for canopy flows with flexible canopy elements. A limited subset of velocity profiles obey the law of the wall, producing values of shear velocity that, while noisy, broadly agree with values inferred from the pressure measurements.
more »
« less
- Award ID(s):
- 1737096
- PAR ID:
- 10458989
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Journal of Geophysical Research: Oceans
- Volume:
- 124
- Issue:
- 3
- ISSN:
- 2169-9275
- Page Range / eLocation ID:
- p. 2153-2163
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract The effect of hydraulic resistance on the downstream evolution of the water surface profilehin a sloping channel covered by a uniform dense rod canopy following the instantaneous collapse of a dam was examined using flume experiments. Near the head of the advancing wavefront, wherehmeets the rods, the conventional picture of a turbulent boundary layer was contrasted to a distributed drag force representation. The details of the boundary layer around the rod and any interferences between rods were lumped into a drag coefficientCd. The study demonstrated the following: In the absence of a canopy, the Ritter solution agreed well with the measurements. When the canopy was represented by an equivalent wall friction as common when employing Manning's formula with constant roughness, it was possible to match the measured wavefront speed but not the precise shape of the water surface profile. However, upon adopting a distributed drag force with a constantCd, the agreement between measured and modeledhwas quite satisfactory at all positions and times. The measurements and model calculations suggested that the shape ofhnear the wavefront was quasilinear with longitudinal distance for a constantCd. The computed constantCd(≈0.4) was surprisingly much smaller than theCd(≈1) reported in uniform flow experiments with staggered cylinders for the same element Reynolds number. This finding suggested that drag reduction mechanisms associated with unsteadiness, nonuniformity, transient waves, and other flow disturbances were more likely to play a role when compared to conventional sheltering effects.more » « less
-
Abstract The need for operational models describing the friction factorfin streams remains undisputed given its utility across a plethora of hydrological and hydraulic applications concerned with shallow inertial flows. For small-scale roughness elements uniformly covering the wetted parameter of a wide channel, the Darcy-Weisbachf = 8(u*/Ub)2is widely used at very high Reynolds numbers, whereu*is friction velocity related to the surface kinematic stress,Ub = Q/Ais bulk velocity,Qis flow rate, andAis cross-sectional area orthogonal to the flow direction. In natural streams, the presence of vegetation introduces additional complications to quantifyingf, the subject of the present work. Turbulent flow through vegetation are characterized by a number of coherent vortical structures: (i) von Karman vortex streets in the lower layers of vegetated canopies, (ii) Kelvin-Helmholtz as well as attached eddies near the vegetation top, and (iii) attached eddies well above the vegetated layer. These vortical structures govern the canonical mixing lengths for momentum transfer and their influence onfis to be derived. The main novelty is that the friction factor of vegetated flow can be expressed asfv = 4Cd(Uv/Ub)2whereUvis the spatially averaged velocity within the canopy volume, andCdis a local drag coefficient per unit frontal area derived to include the aforemontioned layer-wise effects of vortical structures within and above the canopy along with key vegetation properties. The proposed expression is compared with a number of empirical relations derived for vegetation under emergent and submerged conditions as well as numerous data sets covering a wide range of canopy morphology, densities, and rigidity. It is envisaged that the proposed formulation be imminently employed in eco-hydraulics where the interaction between flow and vegetation is being sought.more » « less
-
In the coastal ocean, interactions of waves and currents with large roughness elements, similar in size to wave orbital excursions, generate drag and dissipate energy. These boundary layer dynamics differ significantly from well-studied small-scale roughness. To address this problem, we derived spatially and phase-averaged momentum equations for combined wave–current flows over rough bottoms, including the canopy layer containing obstacles. These equations were decomposed into steady and oscillatory parts to investigate the effects of waves on currents, and currents on waves. We applied this framework to analyse large-eddy simulations of combined oscillatory and steady flows over hemisphere arrays (diameter $$D$$ ), in which current ( $$U_c$$ ), wave velocity ( $$U_w$$ ) and period ( $$T$$ ) were varied. In the steady momentum budget, waves increase drag on the current, and this is balanced by the total stress at the canopy top. Dispersive stresses from oscillatory flow around obstacles are increasingly important as $$U_w/U_c$$ increases. In the oscillatory momentum budget, acceleration in the canopy is balanced by pressure gradient, added-mass and form drag forces; stress gradients are small compared to other terms. Form drag is increasingly important as the Keulegan–Carpenter number $$KC=U_wT/D$$ and $$U_c/U_w$$ increase. Decomposing the drag term illustrates that a quadratic relationship predicts the observed dependences of steady and oscillatory drag on $$U_c/U_w$$ and $KC$ . For large roughness elements, bottom friction is well represented by a friction factor ( $$f_w$$ ) defined using combined wave and current velocities in the canopy layer, which is proportional to drag coefficient and frontal area per unit plan area, and increases with $KC$ and $$U_c/U_w$$ .more » « less
-
Turbulence statistics and blade deformations of flexible emergent canopies impinged by water flows were experimentally investigated across a range of Reynolds numbers Reb=Ubb/ν (where Ub is the bulk incoming flow velocity, b is the blade width, and ν is the water kinematic viscosity) and blade aspect ratios AR=h/b (h is the blade length). Time-resolved particle image velocimetry was used to characterize both the deformation of flexible blades and the surrounding flow fields. Results showed that the blade deformation increased with the growth of both Reb and AR, with higher blade bending causing stronger variations in vertical profiles of streamwise velocities and Reynolds stresses. The drag produced by the presence of flexible canopies was identified as the dominant fluid loading balancing the pressure gradient. This term exhibited distinctive reduction near the water surface region with high blade deformation due to the large local blade inclination angle. Interestingly, in contrast to fully submerged flexible blades where the flow-induced drag increases monotonously with flow speed, a critical Reynolds number Reb,cri was observed, beyond which drag decreased with increasing flow speed until the blade became fully submerged. This phenomenon was explained with theoretical interpretations, which exhibited reasonable agreement with experimental results. Further analysis of unsteady flow dynamics revealed that Reynolds stress within the canopy was dominated by ejection events due to the absence of shear layer at the top of emergent canopy. Additionally, streamwise velocity spectra indicated that flow fluctuations inside the canopy were governed by periodic vortex shedding from blade.more » « less
