An official website of the United States government
As the frequency of rocket launches increases, accurately predicting their noise is necessary to assess structural, environmental, and societal impacts. NASA’s Space Launch System (SLS) is a challenging vehicle to model because it has both solid-fuel rocket boosters and liquid-fueled engines that contribute to its thrust at launch. This paper discusses measured aeroacoustic properties of this super heavy-lift rocket in the context of supersonic jet theory and measurements of other rockets. Using four measured aeroacoustic properties: directivity, spectral peak frequency, maximum overall sound pressure level, and overall sound power level, an equivalent rocket based on merged plumes is created for SLS. With the constraint that the effective thrust and mass flow rates should match those of the actual vehicle, a method using weighted averages of the disparate plume parameters successfully reproduces SLS’s desired aeroacoustic properties, yielding a relatively simple model for the complex vehicle.
more »
« less
Sound power of NASA's lunar rockets: Space Launch System versus Saturn V
To improve acoustical models of super heavy-lift launch vehicles, this Letter reports Space Launch System's (SLS's) overall sound power level (OAPWL) and compares it to NASA's past lunar rocket, the Saturn V. Measurements made 1.4–1.8 km from the launchpad indicate that SLS produced an OAPWL of 202.4 (±0.5) dB re 1 pW and acoustic efficiency of about 0.33%. Adjustment of a static-fire sound power spectrum for launch conditions implies Saturn V was at least 2 dB louder than SLS with approximately twice the acoustic efficiency.
more »
« less
- Award ID(s):
- 2109932
- PAR ID:
- 10500729
- Publisher / Repository:
- AIP Publishing
- Date Published:
- Journal Name:
- JASA Express Letters
- Volume:
- 3
- Issue:
- 11
- ISSN:
- 2691-1191
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Whether intentionally generating acoustic waves or attempting to mitigate unwanted noise, sound control is an area of challenge and opportunity. This study investigates traditional fabrics as emitters and suppressors of sound. When attached to a single strand of a piezoelectric fiber actuator, a silk fabric emits up to 70 dB of sound. Despite the complex fabric structure, vibrometer measurements reveal behavior reminiscent of a classical thin plate. Fabric pore size relative to the viscous boundary layer thickness is found—through comparative fabric analysis—to influence acoustic‐emission efficiency. Sound suppression is demonstrated using two distinct mechanisms. In the first, direct acoustic interference is shown to reduce sound by up to 37 dB. The second relies on pacifying the fabric vibrations by the piezoelectric fiber, reducing the amplitude of vibration waves by 95% and attenuating the transmitted sound by up to 75%. Interestingly, this vibration‐mediated suppression in principle reduces sound in an unlimited volume. It also allows the acoustic reflectivity of the fabric to be dynamically controlled, increasing by up to 68%. The sound emission and suppression efficiency of a 130 µm silk fabric presents opportunities for sound control in a variety of applications ranging from apparel to transportation to architecture.more » « less
-
Marine crustaceans produce broadband sounds that are useful for passive acoustic monitoring to support conservation and management efforts. However, the propagation characteristics and detection ranges of their signals are poorly known, limiting our leveraging of these sounds. Here, we used a four-hydrophone linear array to measure source levels (SLs) and sound propagation from Caribbean spiny lobsters (Panulirus argus) of a wide range of sizes within a natural, shallow water habitat (3.3 m depth). Source level in peak-peak (SLpp) varied with body size; larger individuals produced SLpp up to 166 dB re 1 μPa. However, transmission losses (TL) were similar across all sizes, with a global fitted TL of 12.1 dB. Correspondingly, calculated detection ranges varied with body size, ranging between 14 and 364 m for small and large individuals (respectively). This increased up to 1612 m for large spiny lobsters when considering lower ambient noise levels. Despite the potential ease of tank studies, our results highlight the importance of empirical in situ sound propagation studies for marine crustaceans. Given the important ecological and economic role of spiny lobsters, these data are a key step to supporting remote monitoring of this species for fisheries management and efforts to acoustically quantify coral reefs' health.more » « less
-
Acoustic propagation measurements were collected in a seagrass meadow in a shallow lagoon for periods of over 65 h in winter and 93 h in summer. A bottom-deployed sound source transmitted chirps (0.1–100 kHz) every 10 min that were received on a four-receiver horizontal hydrophone array. Oceanographic probes measured various environmental parameters. Daytime broadband acoustic attenuation was 2.4 dB greater in summer than winter, and the median received acoustic energy levels were 8.4 dB lower in summer compared to winter. These differences were attributed in part to seasonal changes in photosynthesis bubble production and above-ground seagrass biomass.more » « less
-
Metals are excellent conductors for phonon transportation such as vibration, sound, and heat. Generally, metal sound insulators require multimaterial structure or defects and unimetal sound insulators are challenging. Therefore, a design of a defect‐free sound insulator made by single alloys with multiple friction stir processes (FSPs) is proposed. Periodic friction stir processing can induce superlattice‐like local mechanical properties’ modifications. By experimental acoustic characterization, it is observed that FSP can introduce clear acoustic–elastic property contrast on an aluminum plate by the presence of stir zone and heat‐affected zones. In numerical simulations, the signature FSP‐induced property profile is periodically and parallelly arranged on a long aluminum plate. The transmission gap frequencies are present on the frequency spectrum with the sound propagation direction perpendicular to the FSP paths. Disorder offsets on FSP periodicity are further introduced. Anderson localization is found on a resonance frequency, which provides −11 dB sound reduction by an exponential decay. Due to the finite design length, the slight disorder can also enhance sound insulation in the periodic transmission gap frequency. With analysis and comparison with different configurations, the best performance in the models can achieve −30 dB sound insulation in the 350 mm‐long aluminum alloy plate with 14 parallel FSPs.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1121/10.0022538
