The robustness of nickelocene’s (NiCp2, Cp = cyclopentadienyl) magnetic anisotropy and addressability of its spin states make this molecular magnet attractive as a spin sensor. However, microscopic understanding of its magnetic anisotropy is still lacking, especially when NiCp2 is deposited on a surface to make quantum sensing devices. Quantum chemical calculations of such molecule/solid-state systems are limited to density functional theory (DFT) or DFT+U (Hubbard correction to DFT). We investigate the magnetic behavior of NiCp2 using the spin-flip variant of the equation-of-motion coupled-cluster (EOM-SF-CC) method and use the EOM-SF-CC results to benchmark SF-TD-DFT. Our first-principle calculations agree well with experimentally derived magnetic anisotropy and susceptibility values. The calculations show that magnetic anisotropy in NiCp2 originates from a large spin–orbit coupling (SOC) between the triplet ground state and the third singlet state, whereas the coupling with lower singlet excited states is negligible. We also considered a set of six ring-substituted NiCp2 derivatives and a model system of the NiCp2/MgO(001) adsorption complex, for which we used SF-TD-DFT method. To gain insight into the electronic structure of these systems, we analyze spinless transition density matrices and their natural transition orbitals (NTOs). The NTO analysis of SOCs explains how spin states and magnetic properties are retained upon modification of the NiCp2 coordination environment and upon its adsorption on a surface. Such resilience of the NiCp2 magnetic behavior supports using NiCp2 as a spin-probe molecule by functionalization of the tip of a scanning tunneling microscope.
more »
« less
Challenges for density functional theory in simulating metal–metal singlet bonding: A case study of dimerized VO2
VO2 is renowned for its electric transition from an insulating monoclinic (M1) phase, characterized by V–V dimerized structures, to a metallic rutile (R) phase above 340 K. This transition is accompanied by a magnetic change: the M1 phase exhibits a non-magnetic spin-singlet state, while the R phase exhibits a state with local magnetic moments. Simultaneous simulation of the structural, electric, and magnetic properties of this compound is of fundamental importance, but the M1 phase alone has posed a significant challenge to the density functional theory (DFT). In this study, we show none of the commonly used DFT functionals, including those combined with on-site Hubbard U to treat 3d electrons better, can accurately predict the V–V dimer length. The spin-restricted method tends to overestimate the strength of the V–V bonds, resulting in a small V–V bond length. Conversely, the spin-symmetry-breaking method exhibits the opposite trends. Each of these two bond-calculation methods underscores one of the two contentious mechanisms, i.e., Peierls lattice distortion or Mott localization due to electron–electron repulsion, involved in the metal–insulator transition in VO2. To elucidate the challenges encountered in DFT, we also employ an effective Hamiltonian that integrates one-dimensional magnetic sites, thereby revealing the inherent difficulties linked with the DFT computations.
more »
« less
- Award ID(s):
- 2344734
- PAR ID:
- 10501606
- Publisher / Repository:
- NSF-PAR
- Date Published:
- Journal Name:
- The Journal of Chemical Physics
- Volume:
- 160
- Issue:
- 13
- ISSN:
- 0021-9606
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
This paper presents an antenna-coupled non-linear vanadium dioxide (VO2) microbolometer operating in the non-linear metal–insulator transition (MIT) region with an ultra-high responsivity of 6.55 × 104 V/W. Sputtered VO2 films used in this device exhibit 104 times change in resistivity between the dielectric and conductive states. The VO2 microbolometer is coupled to a wideband dipole antenna operating at 31–55 GHz and a coplanar waveguide for probed measurement. To enhance the sensitivity, the sensor is suspended in air by micro-electro-mechanical systems process. The large thermal coefficient of resistance of VO2 is utilized by DC biasing the device in the MIT region. Measurements for the fabricated sensor were performed, and a high responsivity was demonstrated, owing to non-linear conductivity change in the transition region. The measured sensitivity is >102 times higher than the state-of-the-art sensors. In addition, the concept of utilizing the proposed VO2 sensor in a mmWave imager was demonstrated by the radiation pattern measurement of a 4 × 4 (16 elements) antenna-coupled VO2 sensor array. The results presented in this work reveal the initial step to employ VO2's MIT for a hyper-sensitive sensor in future mmWave sensing and imaging applications.more » « less
-
The low temperature monoclinic, insulating phase of vanadium dioxide is ordinarily considered nonmagnetic, with dimerized vanadium atoms forming spin singlets, though paramagnetic response is seen at low temperatures. We find a nonlocal spin Seebeck signal in VO2 films that appears below 30 K and that increases with a decrease in temperature. The spin Seebeck response has a nonhysteretic dependence on the in-plane external magnetic field. This paramagnetic spin Seebeck response is discussed in terms of prior findings on paramagnetic spin Seebeck effects and expected magnetic excitations of the monoclinic ground state.more » « less
-
Abstract Thioamides represent highly valuable isosteric in the strictest sense “single‐atom substitution” analogues of amides that have found broad applications in chemistry and biology. A long‐standing challenge is the direct transamidation of thioamides, a process which would convert one thioamide bond (R−C(S)−NR1R2) into another (R−C(S)−NR3N4). Herein, we report the first general method for the direct transamidation of thioamides by highly chemoselective N−C(S) transacylation. The method relies on site‐selective N‐tert‐butoxycarbonyl activation of 2° and 1° thioamides, resulting in ground‐state‐destabilization of thioamides, thus enabling to rationally manipulate nucleophilic addition to the thioamide bond. This method showcases a remarkably broad scope including late‐stage functionalization (>100 examples). We further present extensive DFT studies that provide insight into the chemoselectivity and provide guidelines for the development of transamidation methods of the thioamide bond.more » « less
-
We constructed the magnetic field-temperature phase diagrams of new quasi-two-dimensional isosceles triangular lattice antiferromagnets (TLAF) Ca 3 MNb 2 O 9 (M=Co, Ni) from dc and ac magnetic susceptibilities, specific heat, dielectric constant, and electric polarization measurements on single crystalline samples. Ca 3 CoNb 2 O 9 with effective spin-1/2 Co 2+ ions undergoes a two-step antiferromagnetic phase transition at T N1 = 1.3 K and T N2 = 1.5 K and enters a stripe ordered state at zero magnetic field. With increasing field, successive magnetic phase transitions, reminiscent of the up-up-down ( uud ) and the oblique phases, are observed. The dielectric constant of Ca 3 CoNb 2 O 9 shows anomalies related to the magnetic phase transitions, but clear evidence of ferroelectricity is absent. Meanwhile, Ca 3 NiNb 2 O 9 with spin-1 Ni 2+ ions also shows a two-step antiferromagnetic transition at T N1 = 3.8 K and T N2 = 4.2 K at zero field. For Ca 3 NiNb 2 O 9 , the electric polarization in the magnetic ordered phases was clearly observed from the pyroelectric current measurements, which indicates its coexistence of magnetic ordering and ferroelectricity.more » « less
An official website of the United States government

