An official website of the United States government
Abstract Shape memory alloys (SMAs) absorb and release large amounts of latent heat during martensitic transformation, making them ideal candidates for applications involving thermal energy storage and management. In this study, Cu–Zn–Al SMAs were investigated as lower-cost alternatives to NiTi-based SMAs for solid–solid phase change materials. The alloys were fabricated using an unconventional method of melting and solidification of the constituent elements sealed in quartz tubes under a pressurized Ar atmosphere. The alloys synthesized were found to exhibit superior figure of merit values for thermal energy storage, as compared to conventional solid–liquid phase change materials and NiTi-based SMAs, with thermal conductivity between 59 and 75 W/mK and latent heat values ranging from 3 to 6.5 J/g. Transformation temperature ranges (Af–Mf) less than 20 °C were achieved within a wide operating temperature between − 145 °C and 100 °C. In addition, select CuZnAl compositions yielded excellent cyclic stability with only ± 2 °C shifts in transformation temperatures after 20 thermal cycles. The present study demonstrates the feasibility of CuZnAl SMAs for use in high heat flux thermal energy storage and management applications at a wider range of temperatures.
more »
« less
Design of phase-transition molecular solar thermal energy storage compounds: compact molecules with high energy densities
A series of compact azobenzene derivatives were investigated as phase-transition molecular solar thermal energy storage compounds that exhibit maximum energy storage densities around 300 J g(-1). The relative size and polarity of the functional groups on azobenzene were manifested to significantly influence the phase of isomers and their energy storage capacity.
more »
« less
- Award ID(s):
- 2011846
- PAR ID:
- 10506778
- Publisher / Repository:
- Royal Society of Chemistry
- Date Published:
- Journal Name:
- Chemical Communications
- Volume:
- 57
- Issue:
- 74
- ISSN:
- 1359-7345
- Page Range / eLocation ID:
- 9458 to 9461
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Structurally stabilized composites are promising for using phase change materials in high‐temperature thermal energy storage (TES). However, conventional skeleton materials, which typically comprise 30–50 wt% of the composite, mainly provide sensible heat storage and contribute minimally to overall energy density. This study introduces a new class of redox‐active oxide‐molten salt (ROMS) composites that overcome this limitation by combining sensible, latent, and thermochemical heat storage in a single particle. Specifically, porous, redox‐active Ca2AlMnO5+δ(CAM) complex oxide particles were demonstrated as a suitable support matrix, with the pores filled by eutectic NaCl/CaCl2salt. X‐ray diffraction confirms excellent phase compatibility between CAM and the salt. Scanning electron microscopy/energy dispersive X‐ray spectroscopy and nano X‐ray tomography show good salt infiltration and wettability within the CAM pores. Thermogravimetric analysis reveals that a 60 wt% CAM/40 wt% salt composite achieves an energy density of 267 kJ kg−1over a narrow 150 °C window, with ≈50 kJ kg−1from thermochemical storage. Additionally, the composite shows higher thermal conductivity than salt alone, enabling faster energy storage and release. ROMS composites thus represent a novel and efficient solution for high‐performance TES.more » « less
-
Highly oriented Pb(Zr0.53Ti0.47)0.90Sc0.10O3 (PZTS) thin films were deposited on La0.67Sr0.33MnO3 (LSMO) buffer layer coated on MgO (100) substrates by following two subsequent laser ablation processes in oxygen atmosphere employing pulse laser deposition technique. The PZTS films were found to grow in tetragonal phase with orientation along (100) plane as inferred from x-ray diffractometry analysis. The structural sensitive symmetric E (LO2) Raman band softened at elevated temperature along with its intensity continuously decreased until it disappeared in the cubic phase above 350 K. The existence of broad Raman bands at high temperature (>350 K) is attributed to the symmetry forbidden Raman scattering in relaxor cubic phase due to symmetry breaking in nano length scale. The temperature dependent dielectric measurements were performed on metal-ferroelectric-metal capacitors in the frequencies range of 102–106 Hz was observed to be diffused over a wide range of temperature 300–650 K and exhibits high dielectric constant ~5700 at room temperature. An excellent high energy storage density (Ure) ~54 J/cm3 with efficiency ~70% was estimated at applied voltage 1.82 MV/cm. High DC breakdown strength, larger dielectric constant and high restored energy density values of our PZTS thin films indicate its usage in high energy storage applications.more » « less
-
Abstract Batteries and supercapacitors have emerged as promising candidates for next-generation energy storage technologies. The rapid development of new two-dimensional (2D) electrode materials indicates a new era in energy storage devices. MXenes are a new type of layered 2D transition metal carbides, nitrides, or carbonitrides that have drawn much attention because of their excellent electrical conductivity, electrochemical and hydrophilic properties, large surface area, and attractive topological structure. This review focuses on various synthesis methods to prepare vanadium carbide MXenes with and without etchants like hydrofluoric acid, lithium fluoride, and hydrochloric acid to remove the ‘A’ layers of the MAX phase. The goal is to demonstrate the utilization of a less toxic etching method to achieve MXenes of comparable properties to those prepared by traditional methods. The influence of intercalation on the effect of high interlayer spacing between the MXene layers and the performance of MXenes as supercapacitor and battery electrodes is also addressed in this review. Lastly, the gaps in the current knowledge for vanadium carbide MXenes in synthesis, scalability, and utilization in more energy storage devices were discussed.more » « less
-
null (Ed.)The emergence of high-entropy materials (HEMs) with their excellent mechanical properties, stability at high temperatures, and high chemical stability is poised to yield new advancement in the performance of energy storage and conversion technologies. This review covers the recent developments in catalysis, water splitting, fuel cells, batteries, supercapacitors, and hydrogen storage enabled by HEMs covering metallic, oxide, and non-oxide alloys. Here, first, the primary rules for the proper selection of the elements and the formation of a favorable single solid solution phase in HEMs are defined. Furthermore, recent developments in different fields of energy conversion and storage achieved by HEMs are discussed. Higher electrocatalytic and catalytic activities with longer cycling stability and durability compared to conventional noble metal-based catalysts are reported for high-entropy materials. In electrochemical energy storage systems, high-entropy oxides and alloys have shown superior performance as anode and cathode materials with long cycling stability and high capacity retention. Also, when used as metal hydrides for hydrogen storage, remarkably high hydrogen storage capacity and structural stability are observed for HEMs. In the end, future directions and new energy-related technologies that can be enabled by the application of HEMs are outlined.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1039/d1cc03742k
