An official website of the United States government
Abstract Volcanic eruptions are energetic events driven by the imbalance of magmatic forces. The magnitudes of these forces remain poorly constrained because they operate in regions that are inaccessible, either underground or dangerous to approach. New techniques are needed to quantify the processes that drive eruptions and to probe magma storage conditions. Here we present X‐ray microdiffraction measurements of volcanic stress imparted as lattice distortions to the crystal cargo of magma from Yellowstone and Long Valley eruptions. Elevated residual stresses between 100 and 300 MPa are preserved in erupted quartz. Multiple volcanic forces could be culpable for the deformation so we analyzed crystals from pyroclastic falls, pyroclastic density currents, and effusive lavas. Stresses are preserved in all quartz but cannot be attributed to differences in eruption style. Instead, lattice deformation likely preserves an in situ measurement of the deviatoric stresses required for the brittle failure of viscous, crystal‐bearing glass during ascent.
more »
« less
Stressful crystal histories recorded around melt inclusions in volcanic quartz
Abstract Magma ascent and eruption are driven by a set of internally and externally generated stresses that act upon the magma. We present microstructural maps around melt inclusions in quartz crystals from six large rhyolitic eruptions using synchrotron Laue X-ray microdiffraction to quantify elastic residual strain and stress. We measure plastic strain using average diffraction peak width and lattice misorientation, highlighting dislocations and subgrain boundaries. Quartz crystals across studied magma systems preserve similar and relatively small magnitudes of elastic residual stress (mean 53–135 MPa, median 46–116 MPa) in comparison to the strength of quartz (~ 10 GPa). However, the distribution of strain in the lattice around inclusions varies between samples. We hypothesize that dislocation and twin systems may be established during compaction of crystal-rich magma, which affects the magnitude and distribution of preserved elastic strains. Given the lack of stress-free haloes around faceted inclusions, we conclude that most residual strain and stress was imparted after inclusion faceting. Fragmentation may be one of the final strain events that superimposes stresses of ~ 100 MPa across all studied crystals. Overall, volcanic quartz crystals preserve complex, overprinted deformation textures indicating that quartz crystals have prolonged deformation histories throughout storage, fragmentation, and eruption.
more »
« less
- Award ID(s):
- 2042173
- PAR ID:
- 10509648
- Publisher / Repository:
- Springer Science + Business Media
- Date Published:
- Journal Name:
- Contributions to Mineralogy and Petrology
- Volume:
- 179
- Issue:
- 6
- ISSN:
- 0010-7999
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Quartz deformation fabrics reflect stress and strain conditions in mylonites, and their interpretation has become a mainstay of kinematic and structural analysis. Quantification of grain size and shape and interpretation of textures reflecting deformation mechanisms can provide estimates of flow stress, strain rate, kinematic vorticity, and deformation temperatures. Empirical calibration and determination of quartz flow laws is based on laboratory experiments of pure samples; however, pure quartzite mylonites are relatively uncommon. In particular, phyllosilicates may localize and partition strain that can inhibit or enhance different deformation mechanisms. Experimental results demonstrate that even minor phyllosilicate content (<15 vol%) can dramatically alter the strain behavior of quartz; however, few field studies have demonstrated these effects in a natural setting. To investigate the role of phyllosilicates on quartz strain fabrics, we quantify phyllosilicate content and distribution in quartzite mylonites from the Miocene Raft River detachment shear zone (NW Utah, USA). We use microstructural analysis and electron backscatter diffraction to quantify quartz deformation fabrics and muscovite spatial distribution, and X-ray computed tomography to quantify muscovite content in samples with varying amounts of muscovite collected across the detachment shear zone. Phyllosilicate content has a direct control on quartz deformation mechanisms, and application of piezometers and flow laws based on quartz deformation fabrics yield strain rates and flow stresses that vary by up to two orders of magnitude across our samples. These findings have important implications for the application of flow laws in quartzite mylonites and strain localization mechanisms in mid-crustal shear zones.more » « less
-
Abstract We applied elastic thermobarometry on garnet-bearing migmatites along two transects through the crustal section at Sierra Valle Fértil-La Huerta, Argentina. We performed quartz-in-garnet barometry and zircon-in-garnet thermometry on metapelites from different paleo-depths across the crustal section. Our work recovers entrapment pressures ranging from 240 to 1330 MPa and entrapment temperatures between 691 and 1574 °C. The entrapment conditions are broadly consistent with anticipated pressures and temperatures along the crustal section derived previously using conventional, thermodynamic thermobarometers. The quartz-in-garnet barometer reproduces those conventionally established entrapment conditions when samples only experienced conditions within the alpha-quartz stability field. Raman-derived pressures for samples that experienced beta-quartz reference conditions are commonly much higher than those established by conventional barometry. Samples that preserve compressive (positive) residual pressures best reproduce reference entrapment pressures. Entrapment temperatures show high variability and overestimation of temperature conditions compared to conventional results. These results indicate elastic thermobarometry over- or under-estimates crystallization conditions in rocks crystallized at high temperatures, as is common in the Famatinian Arc deep-crust. We suggest that modeling quartz behavior across the alpha–beta transition may present challenges, as does shape maturation, viscous deformation, and radiation damage in zircon.more » « less
-
Abstract. Inclusion–host elastic thermobarometers are widely used to determine the pressure and temperature (P–T) histories of metamorphic rocks. Complex metamorphic P–T paths can affect the pressures that develop in host–inclusion systems. There are limited experimental studies that investigate how changing P–T conditions may re-equilibrate or “reset” residual pressures of inclusions. To evaluate re-equilibration of the quartz-in-garnet (QuiG) elastic thermobarometer, we performed single-, two-, and three-stage isothermal experiments. In the first stage of the experiments, oxide starting materials hydrothermally crystallised to grow garnet crystals with quartz inclusions between 700 and 800 °C and 1.0 and 3.2 GPa with constant P–T conditions for 48 h. In the second and third stage of the experiments, we isothermally changed pressure by 1.0 to 1.2 GPa for durations up to 38 d. We used Raman spectroscopy to measure strain-induced changes to the 128, 207, and 465 cm−1 Raman bands of quartz inclusions to determine the inclusion pressures (Pinc) and entrapment pressures (Ptrap) at the experimental temperature. The multi-stage experiments show that elasticity primarily controlled changes to Pinc values that occur from Ptrap through quenching to room conditions and that Pinc values measured at room conditions along with elastic modelling can be used to accurately calculate Ptrap. Quartz Pinc values in two-stage experiments re-equilibrated to give Pinc values between P1 and P2. The three-stage isothermal experiments show that the observed changes to inclusion pressures are reversible along different P–T paths to restore the re-equilibrated Pinc values back to their original entrapment isomeke at Ptrap. For rocks that underwent protracted metamorphism along complicated P–T paths, the re-equilibration experiments and viscoelastic calculations show that QuiG may underestimate maximum Ptrap conditions.more » « less
-
Abstract Cerro Machín, a volcano located in the northern segment of the Andes, is considered one of the most dangerous volcanoes in Colombia with an explosive record that involves at least five plinian events. Prior studies focused on the last dome-building eruption have suggested the presence of a water-rich mid-crustal magma reservoir. However, no direct volatile measurements have been published and little work has been completed on the explosive products of the volcano. Here, we study the largest known eruption of Cerro Machín volcano which occurred 3600 years BP producing dacitic pyroclastic fall deposits that can be traced up to 40 km from the vent. Lapilli pumice clasts have a mineral assemblage of plagioclase, amphibole, quartz, and biotite phenocrysts, with accessory olivine, Fe–Ti oxides, and apatite. The occurrence of Fo89–92 olivine rimmed by high Mg# amphibole and the established high-water contents in the magma imply the presence of magma near or at water saturation at pressures > ~ 500 MPa. Measurements of up to 10.7 wt % H2O in melt inclusions hosted in plagioclase and quartz in the 3600 years BP eruption products support the idea that Cerro Machín is a remarkably water-rich volcanic system. Moreover, this is supported by measurements of ~103 to 161 ppm H2O in plagioclase phenocrysts. The application of two parameterizations of water partitioning between plagioclase and silicate melt allows us to use our water in plagioclase measurements to estimate equilibrium melt water contents of 5 ± 1 wt % to 11 ± 2 wt % H2O, which are in good agreement with the water contents we measured in melt inclusions. Results of amphibole geobarometry are consistent with a magma reservoir stored in the mid-to-lower crust at a modal pressure of 700 ± 250 MPa, corresponding to a depth of ~25 km. Minor crystallization in the shallow crust is also recorded by amphibole barometry and calculated entrapment pressures in melt inclusions. Amphibole is present as unzoned and zoned crystals. Two populations of unzoned amphibole crystals are present, the most abundant indicate crystallization conditions of 853 ± 26°C (1 se; standard error), and the less abundant crystallized at an average temperature of 944 ± 24°C (1 se). Approximately 18% of the amphibole crystals are normally or reversely zoned, providing evidence for a minor recharge event that could have been the trigger mechanism for the explosive eruption. Plagioclase crystals also show normal and reverse zoning. The moderate Ni concentrations (<1600 μg/g) in the high-Fo olivine xenocrysts suggest that Cerro Machín primary magmas are generated by inefficient interaction of mantle peridotite with a high-silica melt produced by slab melting of basaltic material. Some sediment input is also suggested by the high Pb/Th (>2.2) and Th/La (0.3–0.4) ratios. Whole rock chemistry reveals heavy rare earth element (HREE) depletion and Sr enrichment that likely formed during the crystallization of garnet and amphibole in the upper part of the mantle or lower portion of the crust, promoting the formation of water-rich dacitic magma that was then injected into the middle-to-lower crust. Textural and compositional differences in the crystal cargo that erupted during dome-building and plinian events support the idea that large volumes of magma recharge lead to effusive eruptions, while only small recharge events are needed to trigger plinian eruptions at Cerro Machín.more » « less
