An official website of the United States government
This research focuses on the efficiency of recommended heavy use area protection (HUAP) pads installed in poultry houses utilizing the Choptank River, a tributary of the Chesapeake Bay. The Chesapeake Bay watershed is severely affected by crop agriculture and poultry feeding operations. Water quality degradation along with scarcity of water is a significant concern in this area, suggesting a need for changes in both environmental and groundwater management practices. Our objective in this study was to compare the efficiency of HUAP in reducing litter spillage and nutrient runoff between two poultry houses, one of which was constructed in 2005 and the other in 2009. The poultry house constructed in 2005 did not have HUAP pads initially; they were built in 2006. The poultry house built in 2009 had the pads from the starting point. We collected soil and water samples each month and analyzed them for pH, electrical conductivity (EC), nitrate, nitrite, total nitrogen, phosphate, and other soil properties throughout the year. The pH of soil and water samples was in the range of 6.8–8.0 and 6.5–7.2, respectively. We collected six water samples in total in the ditch, from points at retention ponds near the farm ditch to sites in wooded areas on the farm. Water sample B (where ditch water meets retention pond water from the poultry farm) had the highest EC value and nitrate, nitrite, and total nitrogen concentrations compared with other water samples. The subsequent water samples downstream had reduced loads of nutrients. The study results suggest that there was a minimum carryover of nutrients from soil into the runoff water, storm ditches, and adjacent stream. There was also a minimal effect of house cleaning and storm events in raising the concentration of nutrients in soil and water samples at our study sites. The older poultry site had higher total nitrogen and phosphorous surrounding the pads, whereas no elevated levels of nutrients were identified at the newer site. The ability of HUAP pads to hold onto contaminates decreases with age and use. This study also shows that the impacts from poultry activities on surface and groundwater can be minimized by using management practices such as HUAP pads. These practices can reduce pollution in the farm, increase productivity, and save farmers and ranchers time and money in the long run.
more »
« less
Qualities and Quantities of Poultry Litter Biochar Characterization and Investigation
Excessive land application of poultry litter (PL) may lead to surface runoff of nitrogen (N) and phosphorus (P), which cause eutrophication, fish death, and water pollution that ultimately have negative effects on humans and animals. Increases in poultry production in the Delmarva Peninsula underscore the need for more efficient, cost-effective, and sustainable disposal technologies for processing PL instead of direct land application. The pyrolysis conversion process can potentially produce nutrient-rich poultry litter biochar (PLB), while the pyrolysis process can change the N and P to a more stable component, thus reducing its runoff. Pyrolysis also kills off any microorganisms that would otherwise trigger negative environmental health effects. This study is to apply an integrated method and investigate the effect of pyrolysis temperature (300 °C, 500 °C), poultry litter source (different feedstock composition), and bedding material mixture (10% pine shavings) on PLB qualities and quantities. Proximate and ultimate analysis showed PL sources and bedding material addition influenced the physicochemical properties of feedstock. The SEM and BET surface results indicate that pyrolysis temperature had a significant effect on changing the PLB morphology and structure, as well as the pH value (7.78 at 300 °C vs. 8.78 at 500 °C), extractable phosphorus (P) (18.73 ppm at 300 °C vs. 11.72 ppm at 500 °C), sulfur (S) (363 ppm at 300 °C vs. 344 ppm at 500 °C), and production yield of PLBs (47.65% at 300 °C vs. 60.62% at 500 °C). The results further suggest that adding a bedding material mixture (10% pine shavings) to PLs improved qualities by reducing the content of extractable P and S, as well as pH values of PLBs. This study also found the increment in both the pore volume and the area of Bethel Farm was higher than that of Sun Farm. Characterization and investigation of qualities and quantities of PLB using the integrated framework suggest that PL from Bethel Farm could produce better-quality PLB at a higher pyrolysis temperature and bedding material mixture to control N and P runoff problems.
more »
« less
- Award ID(s):
- 2200616
- PAR ID:
- 10514261
- Editor(s):
- Rusănescu, C; Ungureanu, N
- Publisher / Repository:
- Energies
- Date Published:
- Journal Name:
- Energies
- Volume:
- 17
- Issue:
- 12
- ISSN:
- 1996-1073
- Page Range / eLocation ID:
- 2885
- Subject(s) / Keyword(s):
- poultry litter biochar poultry litter pyrolysis characterization properties qualities yield
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Biomass burning organic aerosol (BBOA) is one of the largest sources of organics in the atmosphere. Mineral dust and biomass burning smoke frequently co-exist in the same atmospheric environment. Common biomass burning compounds, such as dihydroxybenzenes and their derivatives, are known to produce light-absorbing, water-insoluble polymeric particles upon reaction with soluble Fe( iii ) under conditions characteristic of aerosol liquid water. However, such reactions have not been tested in realistic mixtures of BBOA compounds. In this study, model organic aerosol (OA), meant to replicate BBOA from smoldering fires, was generated through the pyrolysis of Canary Island pine needles in a tube furnace at 300, 400, 500, 600, 700, and 800 °C in nitrogen gas, and the water-soluble fractions were reacted with iron chloride under dark, acidic conditions. We utilized spectrophotometry to monitor the reaction progress. For OA samples produced at lower temperatures (300 and 400 °C), particles (P300 and P400) formed in solution, were syringe filtered, and extracted in organic solvents. Analysis was conducted with ultrahigh pressure liquid chromatography coupled to a photodiode array spectrophotometer and a high-resolution mass spectrometer (UHPLC-PDA-HRMS). For OA samples formed at higher pyrolysis temperatures (500–800 °C), water-insoluble, black particles (P500–800) formed in solution. In contrast to P300 and P400, P500–800 were not soluble in common solvents. Scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDS) and transmission electron microscopy (TEM) were used to image P600 and determine bulk elemental composition. Electron microscopy revealed that P600 had fractal morphology, reminiscent of soot particles, and contained no detectable iron. These results suggest that light-absorbing aerosol particles can be produced from Fe( iii )-catalyzed reactions in aging BBOA plumes produced from smoldering combustion in the absence of any photochemistry. This result has important implications for understanding the direct and indirect effects of aged BBOA on climate.more » « less
-
Denim fabric samples representing current indigo dye sources and fabric structures were biodegraded in feedstock including food waste, manure, and animal bedding, which are typically composted at the Cornell Farm Services Composting Facility and processed under laboratory conditions for 77 days. Indigo types including dry denim, pre-reduced, and natural did not inhibit degradation as compared to undyed 100% cotton fabric. Additionally, fabrics tested as received from the mill and those tested post scouring degraded effectively. As expected, denim containing 24% polyester and 2% spandex retained overall fabric structure despite degradation of the cotton portion of the yarns.more » « less
-
Abstract This study performs techno‐economic analysis and Monte Carlo simulations (MCS) to explore the effects that variations in biomass feedstock quality have on the economic feasibility of fast pyrolysis biorefineries using decentralized preprocessing sites (i.e., depots that produce pellets). Two biomass resources in the Southeastern United States, that is, pine residues and switchgrass, were examined as feedstocks. A scenario analysis was conducted for an array of different combinations, including different pellet ash control levels, feedstock blending ratios, different biorefinery capacities, and different biorefinery on‐stream capacities, followed by a comparison with the traditional centralized system. MCS results show that, with depot preprocessing, variations in the feedstock moisture and feedstock ash content can be significantly reduced compared with a traditional centralized system. For a biorefinery operating at 100% of its designed capacity, the minimum fuel selling price (MFSP) of the decentralized system is $3.97–$4.39 per gallon gasoline equivalent (GGE) based on the mean value across all scenarios, whereas the mean MFSP for the traditional centralized system was $3.79–$4.12/GGE. To understand the potential benefits of highly flowable pellets in decreasing biorefinery downtime due to feedstock handling and plugging problems, this study also compares the MFSP of the decentralized system at 90% of its designed capacity with a traditional system at 80%. The analysis illustrates that using low ash pellets mixed with switchgrass and pine residues generates a more competitive MFSP. Specifically, for a biorefinery designed for 2,000 oven dry metric ton per day, running a blended pellet made from 75% switchgrass and 25% pine residues with 2% ash level, and operating at 90% of designed capacity could make an MFSP between $4.49 and $4.71/GGE. In contrast, a traditional centralized biorefinery operating at 80% of designed capacity marks an MFSP between $4.72 and $5.28.more » « less
-
Fast pyrolysis of pine wood was carried out to yield a liquid bio-oil mixture that was separated into organic and aqueous phases. The organic phase (ORG-bio-oil) was characterized by gas chromatography–mass spectroscopy, 31 P-nuclear magnetic resonance spectroscopy, and Fourier transform infrared (FTIR) spectroscopy. It was further used as a raw material for producing a mixture of biphenolic compounds (ORG-biphenol). ORG-bio-oil, ORG-biphenol, and bisphenol-A were reacted with cyanogen bromide to yield cyanate ester monomers. Cyanate esters were characterized using FTIR spectroscopy and were thermally cross-linked to develop thermoset materials. Thermomechanical properties of cross-linked cyanate esters were assessed using dynamic mechanical analysis and compared with those of cross-linked bisphenol-A-based cyanate ester. ORG-biphenol cyanate ester was observed to have a superior glass transition temperature (350–380°C) as compared to bisphenol-A cyanate ester (190–220°C). Cyanate esters derived from bio-oil have the potential to be a sustainable alternative to the bisphenol-A-derived analog.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- The DOI is not currently available.
