An official website of the United States government
ABSTRACT Without additional heating, radiative cooling of the halo gas of massive galaxies (Milky Way-mass and above) produces cold gas or stars exceeding that observed. Heating from active galactic nucleus (AGN) jets is likely required, but the jet properties remain unclear. This is particularly challenging for galaxy simulations, where the resolution is orders-of-magnitude insufficient to resolve jet formation and evolution. On such scales, the uncertain parameters include the jet energy form [kinetic, thermal, cosmic ray (CR)]; energy, momentum, and mass flux; magnetic fields; opening angle; precession; and duty cycle. We investigate these parameters in a $$10^{14}\, {\rm M}_{\odot }$$ halo using high-resolution non-cosmological magnetohydrodynamic simulations with the FIRE-2 (Feedback In Realistic Environments) stellar feedback model, conduction, and viscosity. We explore which scenarios qualitatively meet observational constraints on the halo gas and show that CR-dominated jets most efficiently quench the galaxy by providing CR pressure support and modifying the thermal instability. Mildly relativistic (∼MeV or ∼1010K) thermal plasma jets work but require ∼10 times larger energy input. For fixed energy flux, jets with higher specific energy (longer cooling times) quench more effectively. For this halo mass, kinetic jets are inefficient at quenching unless they have wide opening or precession angles. Magnetic fields also matter less except when the magnetic energy flux reaches ≳ 1044 erg s−1 in a kinetic jet model, which significantly widens the jet cocoon. The criteria for a successful jet model are an optimal energy flux and a sufficiently wide jet cocoon with a long enough cooling time at the cooling radius.
more »
« less
Unravelling jet quenching criteria across L* galaxies and massive cluster ellipticals
ABSTRACT In the absence of supplementary heat, the radiative cooling of halo gas around massive galaxies (Milky Way mass and above) leads to an excess of cold gas or stars beyond observed levels. Active galactic nucleus jet-induced heating is likely essential, but the specific properties of the jets remain unclear. Our previous work concludes from simulations of a halo with $$10^{14} \,\mathrm{ M}_\odot$$ that a successful jet model should have an energy flux comparable to the free-fall energy flux at the cooling radius and should inflate a sufficiently wide cocoon with a long enough cooling time. In this paper, we investigate three jet modes with constant fluxes satisfying the criteria, including high-temperature thermal jets, cosmic ray (CR)-dominant jets, and widely precessing kinetic jets in $$10^{12}-10^{15}\, {\rm M}_{\odot }$$ haloes using high-resolution, non-cosmological magnetohydrodynamic simulations with the FIRE-2 (Feedback In Realistic Environments) stellar feedback model, conduction, and viscosity. We find that scaling the jet energy according to the free-fall energy at the cooling radius can successfully suppress the cooling flows and quench galaxies without violating observational constraints. On the contrary, if we scale the energy flux based on the total cooling rate within the cooling radius, strong interstellar medium cooling dominates this scaling, resulting in a jet flux exceeding what is needed. Among the three jet types, the CR-dominant jet is most effective in suppressing cooling flows across all surveyed halo masses due to enhanced CR pressure support. We confirm that the criteria for a successful jet model work across a wider range, encompassing halo masses of $$10^{12}-10^{15} {\rm M_\odot }$$.
more »
« less
- PAR ID:
- 10524331
- Publisher / Repository:
- Oxford University Press
- Date Published:
- Journal Name:
- Monthly Notices of the Royal Astronomical Society
- Volume:
- 532
- Issue:
- 2
- ISSN:
- 0035-8711
- Format(s):
- Medium: X Size: p. 2724-2740
- Size(s):
- p. 2724-2740
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
ABSTRACT The early growth of black holes (BHs) in atomic-cooling haloes is likely influenced by feedback on the surrounding gas. While the effects of radiative feedback are well-documented, mechanical feedback, particularly from active galactic nucleus (AGN) jets, has been comparatively less explored. Building on our previous work that examined the growth of a 100 $${\rm M_\odot }$$ BH in a constant density environment regulated by AGN jets, we expand the initial BH mass range from 1 to $$10^4\, {\rm M_\odot }$$ and adopt a more realistic density profile for atomic-cooling haloes. We reaffirm the validity of our analytic models for jet cocoon propagation and feedback regulation. We identify several critical radii – namely, the terminal radius of jet cocoon propagation, the isotropization radius of the jet cocoon, and the core radius of the atomic-cooling halo – that are crucial in determining BH growth given specific gas properties and jet feedback parameters. In a significant portion of the parameter space, our findings show that jet feedback substantially disrupts the halo’s core during the initial feedback episode, preventing BH growth beyond $$10^4 \, {\rm M_\odot }$$. Conversely, conditions characterized by low jet velocities and high gas densities enable sustained BH growth over extended periods. We provide a prediction for the BH mass growth as a function of time and feedback parameters. We found that, to form a supermassive BH ($$\gt 10^6 \, {\rm M_\odot }$$) within 1 Gyr entirely by accreting gas from an atomic-cooling halo, the jet energy feedback efficiency must be $$\lesssim 10^{-4} \dot{M}_{\rm BH} c^2$$ even if the seed BH mass is $$10^4 \, {\rm M_\odot }$$.more » « less
-
ABSTRACT We revisit the question of ‘hot mode’ versus ‘cold mode’ accretion on to galaxies using steady-state cooling flow solutions and idealized 3D hydrodynamic simulations. We demonstrate that for the hot accretion mode to exist, the cooling time is required to be longer than the free-fall time near the radius where the gas is rotationally supported, Rcirc, i.e. the existence of the hot mode depends on physical conditions at the galaxy scale rather than on physical conditions at the halo scale. When allowing for the depletion of the halo baryon fraction relative to the cosmic mean, the longer cooling times imply that a virialized gaseous halo may form in halo masses below the threshold of $$\sim 10^{12}\, {\rm M_{\odot }}$$ derived for baryon-complete haloes. We show that for any halo mass there is a maximum accretion rate for which the gas is virialized throughout the halo and can accrete via the hot mode of $${\dot{M}}_{\rm crit}\approx 0.7(v_{\rm c}/100\, \rm km\ s^{-1})^{5.4}(R_{\rm circ}/10\, {\rm kpc})(Z/\, {\rm Z_{\odot }})^{-0.9}\, {\rm M_{\odot }}\, {\rm yr}^{-1}$$, where Z and vc are the metallicity and circular velocity measured at Rcirc. For accretion rates $$\gtrsim {\dot{M}}_{\rm crit}$$ the volume-filling gas phase can in principle be ‘transonic’ – virialized in the outer halo but cool and free-falling near the galaxy. We compare $${\dot{M}}_{\rm crit}$$ to the average star formation rate (SFR) in haloes at 0 < z < 10 implied by the stellar-mass–halo-mass relation. For a plausible metallicity evolution with redshift, we find that $${\rm SFR}\lesssim {\dot{M}}_{\rm crit}$$ at most masses and redshifts, suggesting that the SFR of galaxies could be primarily sustained by the hot mode in halo masses well below the classic threshold of $$\sim 10^{12}\, {\rm M_{\odot }}$$.more » « less
-
ABSTRACT We present and study a large suite of high-resolution cosmological zoom-in simulations, using the FIRE-2 treatment of mechanical and radiative feedback from massive stars, together with explicit treatment of magnetic fields, anisotropic conduction and viscosity (accounting for saturation and limitation by plasma instabilities at high β), and cosmic rays (CRs) injected in supernovae shocks (including anisotropic diffusion, streaming, adiabatic, hadronic and Coulomb losses). We survey systems from ultrafaint dwarf ($$M_{\ast }\sim 10^{4}\, \mathrm{M}_{\odot }$$, $$M_{\rm halo}\sim 10^{9}\, \mathrm{M}_{\odot }$$) through Milky Way/Local Group (MW/LG) masses, systematically vary uncertain CR parameters (e.g. the diffusion coefficient κ and streaming velocity), and study a broad ensemble of galaxy properties [masses, star formation (SF) histories, mass profiles, phase structure, morphologies, etc.]. We confirm previous conclusions that magnetic fields, conduction, and viscosity on resolved ($$\gtrsim 1\,$$ pc) scales have only small effects on bulk galaxy properties. CRs have relatively weak effects on all galaxy properties studied in dwarfs ($$M_{\ast } \ll 10^{10}\, \mathrm{M}_{\odot }$$, $$M_{\rm halo} \lesssim 10^{11}\, \mathrm{M}_{\odot }$$), or at high redshifts (z ≳ 1–2), for any physically reasonable parameters. However, at higher masses ($$M_{\rm halo} \gtrsim 10^{11}\, \mathrm{M}_{\odot }$$) and z ≲ 1–2, CRs can suppress SF and stellar masses by factors ∼2–4, given reasonable injection efficiencies and relatively high effective diffusion coefficients $$\kappa \gtrsim 3\times 10^{29}\, {\rm cm^{2}\, s^{-1}}$$. At lower κ, CRs take too long to escape dense star-forming gas and lose their energy to collisional hadronic losses, producing negligible effects on galaxies and violating empirical constraints from spallation and γ-ray emission. At much higher κ CRs escape too efficiently to have appreciable effects even in the CGM. But around $$\kappa \sim 3\times 10^{29}\, {\rm cm^{2}\, s^{-1}}$$, CRs escape the galaxy and build up a CR-pressure-dominated halo which maintains approximate virial equilibrium and supports relatively dense, cool (T ≪ 106 K) gas that would otherwise rain on to the galaxy. CR ‘heating’ (from collisional and streaming losses) is never dominant.more » « less
-
ABSTRACT Feedback driven by jets from active galactic nuclei is believed to be responsible for reducing cooling flows in cool-core galaxy clusters. We use simulations to model feedback from hydrodynamic jets in isolated haloes. While the jet propagation converges only after the diameter of the jet is well resolved, reliable predictions about the effects these jets have on the cooling time distribution function only require resolutions sufficient to keep the jet-inflated cavities stable. Comparing different model variations, as well as an independent jet model using a different hydrodynamics code, we show that the dominant uncertainties are the choices of jet properties within a given model. Independent of implementation, we find that light, thermal jets with low momentum flux tend to delay the onset of a cooling flow more efficiently on a 50 Myr time-scale than heavy, kinetic jets. The delay of the cooling flow originates from a displacement and boost in entropy of the central gas. If the jet kinetic luminosity depends on accretion rate, collimated, light, hydrodynamic jets are able to reduce cooling flows in haloes, without a need for jet precession or wide opening angles. Comparing the jet feedback with a ‘kinetic wind’ implementation shows that equal amounts of star formation rate reduction can be achieved by different interactions with the halo gas: the jet has a larger effect on the hot halo gas while leaving the denser, star-forming phase in place, while the wind acts more locally on the star-forming phase, which manifests itself in different time-variability properties.more » « less
