Conjugated polymer‐based block copolymers (CP‐BCPs) are an unexplored class of materials for organic thermoelectrics. Herein, the authors report on the electronic conductivity (σ) and Seebeck coefficient (α) of a newly synthesized CP‐BCP, poly(3‐hexylthiophene)‐
Doping can alter certain electronics, including the thermoelectric properties of an organic semiconductor. These alterations may enable viable tunable devices that could be useful in temperature sensing for autonomous controls. Here, we demonstrate a dual-modulation organic field-effect transistor (OFET) where temperature can modulate the current-voltage characteristics of the OFET and gate voltage can modulate the thermoelectric properties of the active layer in the same device. Specifically, Poly(3-hexylthiophene-2,5-diyl) (P3HT) was utilized as the host p-type semiconducting polymer, and iodine was utilized as the thermoelectric minority dopant. The finished devices were characterized with a semiconductor analyzer system with temperature controlled using two thermoelectric cooling plates. The FETs with iodine doping levels in the range of 0.25% to 0.5% mole ratio with respect to the P3HT exhibit the greatest on/off ratios. This study also observed that P3HT thin film samples with an intermediate iodine doping concentration of 0.25% mole ratio exhibit an optimal thermoelectric power factor (PF).
more » « less- Award ID(s):
- 2112595
- PAR ID:
- 10526024
- Publisher / Repository:
- MDPI
- Date Published:
- Journal Name:
- Micromachines
- Volume:
- 15
- Issue:
- 2
- ISSN:
- 2072-666X
- Page Range / eLocation ID:
- 172
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
more » « less
Abstract block ‐poly (oligo‐oxyethylene methacrylate) (P3HT‐b ‐POEM), upon solution co‐processing with lithium bis(trifluoromethanesulfonyl)imide (LiTFSI), and subsequently vapor‐doping with a molecular dopant, 2,3,5,6‐tetrafluoro‐7,7,8,8‐tetracyanoquinodimethane (F4TCNQ). It is found that the addition of the hydrophilic block POEM greatly enhances the processability of P3HT, enabling homogeneous solution‐mixing with LiTFSI. Notably, interactions between P3HT‐b ‐POEM with ionic species significantly improve molecular order and unexpectedly cause electrical oxidizing doping of P3HT block both in solution and solid‐states, a phenomenon that has not been previously observed in Li‐salt containing P3HT. Vapor doping of P3HT‐b ‐POEM‐LiTFSI thin films with F4TCNQ further enhances σ and yields a thermoelectric power factorPF = α2σ of 13.0µ W m−1 K−2, which is more than 20 times higher than salt‐free P3HT‐b ‐POEM sample. Through modeling thermoelectric behaviors of P3HT‐b‐ POEM with the Kang‐Snyder transport model, the improvement inPF is attributed to higher electronic charge mobility originating from the enhanced molecular ordering of P3HT. The results demonstrate that solution co‐processing CP‐BCPs with a salt is a powerful method to control structure and performance of organic thermoelectric materials. -
more » « less
Abstract Organic doping is widely used for defining the majority charge carriers of organic thin films, tuning the Fermi level, and improving and stabilizing the performance of organic light‐emitting diodes and organic solar cells. However, in contrast to inorganic semiconductors, the doping concentrations commonly used are quite high (in the wt% range). Such high concentrations not only limit the scope of doping in organic field‐effect transistors (OFETs), but also limit the doping process itself resulting in a low doping efficiency. Here, the mechanism of doping at ultralow doping concentrations is studied. Doped C60metal‐oxide‐semiconductor (MOS) junctions are used to study doping at the 100 ppm level. With the help of a small‐signal drift‐diffusion model, it is possible to disentangle effects of traps at the gate dielectric/organic semiconductor interface from effects of doping and to determine the doping efficiency and activation energy of the doping process. Doped C60OFETs with an ultralow operation voltage of 800 mV and an excellent on/off ratio of up to 107are realized. The devices have low subthreshold swing in the range of 80 mV dec−1and a large transconductance of up to 8 mS mm−1.
-
more » « less
Abstract Materials for simultaneous photoelectric and thermo‐electric dual conversions and modulations, where photon can modulate the thermoelectric conversion, and temperature can modulate the photoelectric conversion, may find potential applications where light (including a laser) can remotely turn on, turn off, or modulate a thermoelectric generator, a cooler, or a temperature sensor, and vice versa, temperature (heating/cooling) can turn on, turn off, or modulate a photoelectric device such as a photo detector or a solar cell. Here, it is demonstrated that such simultaneous dual conversion or modulation can be achieved via a ternary composite, e.g., a poly‐3‐hexyl‐thiophene thin‐film doped with both phenyl‐C61‐butyric acid methyl ester and iodine. This finding may result in the development of lightweight, flexible shape, cost‐effective, renewable, environmentally friendly, biocompatible, and scalable materials, devices, and systems for clean energy harvestings (such as solar and waste heat dual energy harvesting) as well as light/heat dual‐sensing sensors, modulators, and controllers.
-
more » « less
Doping in an organic photovoltaic (OPV) device can largely impact its performance. In this work, it is discovered that n‐type electrical doping in the poly(3‐hexylthiophene):[6,6]‐phenyl‐C61‐butyric acid methyl ester active layer can be induced by a certain electron transport layer (ETL), particularly branched polyethylenimine (PEI). Consequently, OPV devices with different ETLs exhibit dramatically different current density–voltage behaviors and external quantum efficiency (EQE) spectra. Using drift‐diffusion modeling, Hall effect, and capacitance–voltage measurements, it is shown that the difference in EQE spectra originates from the different background carrier type and concentration in the OPV active layer, dictated by the specific properties of ETL. Factors that influence electrical doping and device behaviors, such as difference between PEI and another polymeric ETL, polyethylenimine ethoxylated, and the active layer thickness and energy of negative integer charge‐transfer state are elucidated. These findings provide insight into material selection and device design for organic electronic devices.
-
more » « less
Abstract Precise control of carrier concentration in both bulk and thin‐film materials is crucial for many solid‐state devices, including photovoltaic cells, superconductors, and high mobility transistors. For applications that span a wide temperature range (thermoelectric power generation being a prime example) the optimal carrier concentration varies as a function of temperature. This work presents a modified modulation doping method to engineer the temperature dependence of the carrier concentration by incorporating a nanosize secondary phase that controls the temperature‐dependent doping in the bulk matrix. This study demonstrates this technique by de‐doping the heavily defect‐doped degenerate semiconductor GeTe, thereby enhancing its average power factor by 100% at low temperatures, with no deterioration at high temperatures. This can be a general method to improve the average thermoelectric performance of many other materials.
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.3390/mi15020172
