Surface-enhanced Raman spectroscopy (SERS) has great potential as an analytical technique for environmental analyses. In this study, we fabricated highly porous gold (Au) supraparticles ( i.e. , ∼100 μm diameter agglomerates of primary nano-sized particles) and evaluated their applicability as SERS substrates for the sensitive detection of environmental contaminants. Facile supraparticle fabrication was achieved by evaporating a droplet containing an Au and polystyrene (PS) nanoparticle mixture on a superamphiphobic nanofilament substrate. Porous Au supraparticles were obtained through the removal of the PS phase by calcination at 500 °C. The porosity of the Au supraparticles was readily adjusted by varying the volumetric ratios of Au and PS nanoparticles. Six environmental contaminants (malachite green isothiocyanate, rhodamine B, benzenethiol, atrazine, adenine, and gene segment) were successfully adsorbed to the porous Au supraparticles, and their distinct SERS spectra were obtained. The observed linear dependence of the characteristic Raman peak intensity for each environmental contaminant on its aqueous concentration reveals the quantitative SERS detection capability by porous Au supraparticles. The limit of detection (LOD) for the six environmental contaminants ranged from ∼10 nM to ∼10 μM, which depends on analyte affinity to the porous Au supraparticles and analyte intrinsic Raman cross-sections. The porous Au supraparticles enabled multiplex SERS detection and maintained comparable SERS detection sensitivity in wastewater influent. Overall, we envision that the Au supraparticles can potentially serve as practical and sensitive SERS devices for environmental analysis applications.
more »
« less
This content will become publicly available on January 9, 2025
Structure Formation in Supraparticles Composed of Spherical and Elongated Particles
We studied the evaporation-induced formation of supraparticles from dispersions of elongated colloidal particles using experiments and computer simulations. Aqueous droplets containing a dispersion of ellipsoidal and spherical polystyrene particles were dried on superamphiphobic surfaces at different humidity values that led to varying evaporation rates. Supraparticles made from only ellipsoidal particles showed short-range lateral ordering at the supraparticle surface and random orientations in the interior regardless of the evaporation rate. Particle-based simulations corroborated the experimental observations in the evaporation-limited regime and showed an increase in the local nematic ordering as the diffusion-limited regime was reached. A thin shell of ellipsoids was observed at the surface when supraparticles were made from binary mixtures of ellipsoids and spheres. Image analysis revealed that the supraparticle porosity increased with an increasing aspect ratio of the ellipsoids.
more »
« less
- Award ID(s):
- 2223084
- NSF-PAR ID:
- 10530560
- Publisher / Repository:
- American Chemical Society
- Date Published:
- Journal Name:
- Langmuir
- Volume:
- 40
- Issue:
- 1
- ISSN:
- 0743-7463
- Page Range / eLocation ID:
- 1096-1108
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
more » « less
Abstract The preparation of fumed silica‐based anisometric supraparticles with well‐defined catalytically active patches suitable for self‐propulsion is presented here. These sub‐millimeter‐sized particles can self‐propel as they contain Pt‐covered magnetite (Fe3O4) nanoparticles, where the Pt can decompose catalytically a “fuel” like H2O2and thereby propel the supraparticles. By their magnetic properties, the catalytically active nanoparticles can be concentrated in patches on the supraparticle surface. The goal is to obtain robust supraparticles with well‐defined patchiness and long‐time stability during self‐propulsion through evaporation‐induced self‐assembly (EISA) on a superhydrophobic surface. The latter is a major issue as oxygen evolution can lead to the disintegration of the supraparticles. Therefore, enhanced mechanical stability is sought using a number of different additives, where the best results are obtained by incorporating polystyrene microspheres followed by heat treatment or reinforcement with microfibrillated cellulose (MFC) and sodium trisilicate (Na2SiO3). The detailed internal structure of the different types of particles is investigated by confocal micro‐X‐ray fluorescence spectroscopy (CMXRF), which allows for precisely locating the catalytic Fe3O4@Pt nanoparticles within the supraparticles with a resolution in the µm range. The insights on the supraparticle structure, together with their long‐time stability, allow fabricating optimized patchy supraparticles for potential applications in propulsion‐enhanced catalysis.
-
more » « less
We model near-field thermal emission from metasurfaces structured as two-dimensional arrays of ellipsoidal SiC particles. The modeling approach is developed from fluctuational electrodynamics and is applicable to systems of ellipsoidal particles within the dipole limit. In all simulations, the radial lengths of particles are restricted to the range of 10–100 nm, and interparticle spacing is constrained to at least three times the particle characteristic length. The orientation and dimensions of constituent ellipsoidal particles are varied to tune localized surface phonon resonances and control the near-field energy density above metasurfaces. Results show that particle orientation can be used to regulate the relative magnitude of resonances in the energy density, and particle dimensions may be changed to adjust the frequency of these resonances within the Reststrahlen band. Metasurfaces constructed from particles with randomized dimensions display comparatively broadband thermal emission rather than the three distinct resonances seen in metasurfaces made with ellipsoidal particles of equivalent dimensions. When the interparticle spacing in a metasurface exceeds about three times the particle characteristic length, the spectral energy density above the metasurface is dominated by individual particle self-interaction and can be approximated as a linear combination of single-particle spectra. When interparticle spacing is at the lower limit of three times the characteristic length, however, multiparticle interaction effects increase and the spectral energy density above a metasurface deviates from that of single particles. This work provides guidance for designing all-dielectric, particle-based metasurfaces with desired near-field thermal emission spectra, such as thermal switches.
-
Observations of nanoparticle superlattice formation over minutes during colloidal nanoparticle synthesis elude description by conventional understanding of self-assembly, which theorizes superlattices require extended formation times to allow for diffusively driven annealing of packing defects. It remains unclear how nanoparticle position annealing occurs on such short time scales despite the rapid superlattice growth kinetics. Here we utilize liquid phase transmission electron microscopy to directly image the self-assembly of platinum nanoparticles into close packed supraparticles over tens of seconds during nanoparticle synthesis. Electron-beam induced reduction of an aqueous platinum precursor formed monodisperse 2–3 nm platinum nanoparticles that simultaneously self-assembled over tens of seconds into 3D supraparticles, some of which showed crystalline ordered domains. Experimentally varying the interparticle interactions ( e.g. , electrostatic, steric interactions) by changing precursor chemistry revealed that supraparticle formation was driven by weak attractive van der Waals forces balanced by short ranged repulsive steric interactions. Growth kinetic measurements and an interparticle interaction model demonstrated that nanoparticle surface diffusion rates on the supraparticles were orders of magnitude faster than nanoparticle attachment, enabling nanoparticles to find high coordination binding sites unimpeded by incoming particles. These results reconcile rapid self-assembly of supraparticles with the conventional self-assembly paradigm in which nanocrystal position annealing by surface diffusion occurs on a significantly shorter time scale than nanocrystal attachment.more » « less
-
The phase transition from subcritical to supercritical conditions, referred to as transcritical behavior, significantly impacts the evaporation and fuel–air mixing in high-pressure liquid-fuel propulsion systems. Transcritical behavior is characterized as a transition from classical two-phase evaporation to a single-phase gas-like diffusion regime as surface tension and latent heat of vaporization reduce. However, the interfacial behavior represented by the surface tension coefficient and evaporation rate during this transition which are crucial inputs for Computational Fluid Dynamics (CFD) simulations of practical transcritical fuel spray is still missing. This study aims at developing new evaporation rate and surface tension models for transcritical n-dodecane droplets using molecular dynamics (MD) simulations irrespective of the droplet size. As MD simulations are primarily limited to the nanoscale, the new models can bridge the gap between MD and continuum simulations and enable the direct application of these findings to microscopic droplets. A new characteristic timescale, i.e., “undroplet time,” is defined which marks the transition from classical two-phase evaporation to single-phase gas-like diffusion behavior. The undroplet time indicates the onset of droplet core disintegration and penetration of nitrogen molecules into the droplet, which occurs after the vanishment of the surface tension. By normalizing the time with respect to the undroplet time, the rate of surface tension decay, evaporation rate, and the rate of droplet mass depletion become independent of the droplet size. Calculation of pairwise correlation coefficients for the entire MD results shows that both surface tension coefficient and evaporation rate are strongly correlated with the background temperature, while pressure and droplet size play a less significant role past the critical point. Therefore, new models for surface tension coefficient and evaporation rate spanning from sub- to supercritical conditions are developed as a function of background pressure and temperature, which can be used in continuum simulations. The identified phase change behavior based on the undroplet time shows a good agreement with the phase change regime maps obtained using microscale experiments and nanoscale MD predictions.more » « less
