We present a petrologic study of the post-collapse rhyolites from Valles Caldera (New Mexico, USA) to evaluate changes in magmatic storage conditions following the eruption of the Upper Bandelier Tuff (UBT). We assess likely phenocrysts through textures, comparison with experiments, and rhyolite-MELTS outputs, and apply thermobarometers, oxygen barometers, and hygrometers to these minerals. The post-collapse rhyolites have average pre-eruptive temperatures ranging from 742–824 °C, average pre-eruptive oxygen fugacities ranging from –0.1 to +1.3 ΔNNO, and average pre-eruptive H2O contents ranging from 4.4–6.0 wt% H2O. Average storage pressures range from 130–196 MPa for all rhyolites except the youngest, which has a range of 157–376 MPa. The post-collapse rhyolites are more oxidizing than the UBT and have similar pre-eruptive pressures. The change in oxidation state between the rhyolites and UBT, despite similar storage pressures, can be explained if the UBT is generated from a unique, reduced source but accumulated at depths similar to the post-collapse rhyolites.
more »
« less
Temporal variations in storage conditions of the post-collapse rhyolites, Valles Caldera, New Mexico (USA)
We present a petrologic study of the post-collapse rhyolites from Valles Caldera (New Mexico, USA) to evaluate changes in magmatic storage conditions following the eruption of the Upper Bandelier Tuff (UBT). We assess likely phenocrysts through textures, comparison with experiments, and rhyolite-MELTS outputs, and apply thermobarometers, oxygen barometers, andhygrometers to these minerals. The post-collapse rhyolites have average pre-eruptive temperatures ranging from 742–824°C, average pre-eruptive oxygen fugacities ranging from –0.1 to +1.3ΔNNO, and average pre-eruptive H2O contents ranging from4.4–6.0 wt% H2O. Average storage pressures range from 130–196 MPa for all rhyolites except the youngest, which has a range of157–376 MPa. The post-collapse rhyolites are more oxidizing than the UBT and have similar pre-eruptive pressures. The change in oxidation state between the rhyolites and UBT, despite similar storage pressures, can be explained if the UBT is generated from a unique, reduced source but accumulated at depths similar to the post-collapse rhyolites.
more »
« less
- Award ID(s):
- 2022465
- PAR ID:
- 10532072
- Editor(s):
- Iacovino, K
- Publisher / Repository:
- Volcanica
- Date Published:
- Journal Name:
- Volcanica
- Volume:
- 7
- Issue:
- 1
- ISSN:
- 2610-3540
- Page Range / eLocation ID:
- 303-333
- Subject(s) / Keyword(s):
- Valles Caldera High-silica rhyolite Petrology Thermobarometry Oxygen barometry
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract We present230Th‐238U crystallization ages and trace element compositions for zircons spanning the late Pleistocene to Holocene rhyolite eruptive record at South Sister volcano in the central Oregon Cascade Range. Most zircon ages are between 100 and 20 ka, with very few in secular equilibrium (>350 ka). The weighted mean of zircon ages for the two oldest South Sister rhyolites, 31.5 ± 2.1 and 39.1 ± 2.4 ka, are significantly younger than the associated40Ar/39Ar ages, 47.4 ± 9.7 and 51.4 ± 9.7 ka. We propose that these40Ar/39Ar dates, performed on plagioclase separates, are compromised by a subtle amount of excess Ar and therefore the younger weighted mean zircon ages yield more reliable eruption ages. These results imply that the interval of rhyolite eruption at South Sister during the late Pleistocene was both shorter and more productive than previously thought and that eruption at South Sister initiated after Middle Sister. Compositionally, zircons from the Pleistocene rhyolites are broadly similar and show down‐temperature zircon and plagioclase crystallization trends. However, we argue that destabilized amphibole and titanite in a common mush also exert leverage on the Pleistocene zircon trace element compositions. Divergence in the Eu/Eu* ratio between the Pleistocene and Holocene lavas implies chemically distinct magma reservoirs originating from the Pleistocene rhyolite eruptive sequence and the Holocene eruptive sequence. This work suggests a higher flux of rhyolite volcanism than previously thought and characterizes magmatic storage distinctions between the Pleistocene and Holocene rhyolites, aiding in the assessment of future eruptive hazards at South Sister volcano.more » « less
-
Volcanic eruptions of rhyolitic magma often show shifts from powerful (Vulcanian to Plinian) explosive episodes to a more gentle effusion of viscous lava forming obsidian flows. Another prevailing characteris-tic of these eruptions is the presence of pyroclastic obsidians intermingled with the explosive tephra. This dense, juvenile product is similar to the tephra and obsidian flow in composition, but is generally less degassed than its flow counterpart. The formation mechanism(s) of pyroclastic obsidians and the information they can provide concerning the extent to which magma degassing modulates the eruptive style of rhyolitic eruptions are currently subject to active research. Porous tephra and pyroclastic and flow obsidians from the 1060CE Glass Mountain rhyolitic eruption at Medicine Lake Volcano (California) were analyzed for their porosity, φ, water content, H2O, and hydrogen isotopic composition, δD. H2O in porous pyroclasts is correlated negatively with δD and positively with φ, indicating that the samples were affected by post-eruptive rehydration. Numerical modeling suggests that this rehydration occurred at an average rate of 10−23.5±0.5m2s−1during the ∼960 years since the eruption, causing some pyroclasts to gain up to 1 wt%of meteoric water. Pyroclastic and flow obsidians were not affected by rehydration due to their very low porosity. Comparison between modeled δD-H2O relationships in degassing magma and values measured in the Glass Mountain samples supports the idea that rhyolitic magma degasses in closed-system until its porosity reaches a value of about 65±5%, beyond which degassing occurs in open-system until quench. During the explosive phase, rapidly ascending magma fragments soon after it becomes permeable, creating porous lapilli and ash that continue to degas in open-system within an expanding gas phase. As suggested by recent studies, some ash may aggregate and sinter on the conduit sides at different depths above the fragmentation level, partly equilibrating with the continuously fluxing heavier magmatic vapor, explaining the wide range of H2O contents and high variability in δD measured in the pyroclastic obsidians. Using only H2O and δD, it is impossible to rule out the possibility that pyroclastic obsidians may also form by permeable foam collapse, either syn-explosively near the conduit sides below the fragmentation level or during more effusive periods interspersed in the explosive phase. During the final effusive phase of the eruption, slowly ascending magma degasses in open-system until it reaches the surface, creating flows with low H2O and δD. This study shows that H2O measured in highly porous pyroclasts of a few hundred years or more cannot be used to infer syn-eruptive magma degassing pathways, unless careful assessment of post-eruptive rehydration is first carried out. If their mechanism of formation can be better understood, detailed analysis of the variations in texture and volatile content of pyroclastic obsidians throughout the explosive phase may help decipher the reasons why rhyolitic eruptions commonly shift from explosive to effusive phases.more » « less
-
Abstract The conditions under which halogens partition in favor of an exsolved fluid relative to the coexisting melt are key for understanding many magmatic processes, including volcanic degassing, evolution of crustal melt bodies, and ore formation. We report new F, Cl, and Br fluid/melt partition coefficients for intermediate to silicic melts, for which F and Br data are particularly lacking; and for varying CO2-H2O contents to assess the effects of changing fluid composition (XH2O) on Br fluid/melt partitioning for the first time. The experiments were conducted at pressures 50–120 MPa, temperatures 800–1100 °C, and volatile compositions [molar XH2O = H2O/(H2O +CO2)] of 0.55 to 1, with redox conditions around the Nickel-Nickel Oxygen buffer (fO2 ≈ NNO). Experiments were not doped with Cl, Br, or F and were conducted on natural crystal-bearing volcanic products at conditions close to their respective pre-eruptive state. The experiments therefore provide realistic constraints on halogen partitioning at naturally occurring, brine-undersaturated conditions. Measurements of Br, Cl, and F were made by Secondary Ion Mass Spectrometry (SIMS) on 13 experimental glass products spanning andesite to rhyolitic compositions, together with their natural starting materials from Kelud volcano, Indonesia, and Quizapu volcano, Chile. Fluid compositions were constrained by mass balance. Average bulk halogen fluid/melt partition coefficients and standard deviations are: DClfluid/melt = 3.4 (±3.7 1 s.d.), DFfluid/melt = 1.7 (±1.7), and DBrfluid/melt = 7.1 (±6.4) for the Kelud starting material (bulk basaltic andesite), and DClfluid/melt = 11.1 (±3.5), DFfluid/melt = 0.8 (±0.8), and DBrfluid/melt = 31.3 (±20.9) for Quizapu starting material (bulk dacite). The large range in average partition coefficients is a product of changing XH2O, pressure and temperature. In agreement with studies on synthetic melts, our data show an exponential increase of halogen Dfluid/melt with increasing ionic radius, with partitioning behavior controlled by melt composition according to the nature of the complexes forming in the melt (e.g., SiF4, NaCl, KBr). The fundamental chemistry of the different halogens (differing ionic size and electronegativities) controls the way in which partitioning responds to changes in melt composition and other variables. Experimental results confirm that more Cl partitions into the fluid at higher bulk Cl contents, higher melt Na, higher fluid XH2O ratios, and lower temperatures. Bromine shows similar behavior, though it seems to be more sensitive to temperature and less sensitive to Na content and XH2O. In contrast, F partitioning into the fluid increases as the melt silica content decreases (from 72 to 56 wt% SiO2), which we attribute to the lower abundance of Si available to form F complexes in the melt. These new data provide more insights into the conditions and processes that control halogen degassing from magmas and may help to inform the collection and interpretation of melt inclusions and volcano gas data.more » « less
-
null (Ed.)Abstract Volcán Quizapu, Chile, is an under-monitored volcano that was the site of two historical eruptions: an effusive eruption in 1846–1847 and a Plinian eruption in 1932, both of which discharged ∼5 km3 (dense rock equivalent) of lava and/or tephra. The majority of material erupted in both cases is trachydacite, nearly identical for each event. We present H2O-saturated, phase equilibrium experiments on this end-member dacite magma, using a pumice sample from the 1932 eruption as the main starting material. At an oxygen fugacity (fO2) of ∼NNO + 0·2 (where NNO is the nickel–nickel oxide buffer), the phase assemblage of An25–30 plagioclase + amphibole + orthopyroxene, without biotite, is stable at 865 ± 10 °C and 110 ± 20 MPa H2O pressure (PH2O), corresponding to ∼4 km depth. At these conditions, experiments also reproduce the quenched glass composition of the starting pumice. At slightly higher PH2O and below 860 °C, biotite joins the equilibrium assemblage. Because biotite is not part of the observed Quizapu phase assemblage, its presence places an upper limit on PH2O. At the determined storage PH2O of ∼110 MPa, H2O undersaturation of the magma with XH2Ofluid = 0·87 would align Ptotal to mineral-based geobarometry estimates of ∼130 MPa. However, XH2Ofluid < 1 is not required to reproduce the Quizapu dacite phase assemblage and compositions. A second suite of experiments at lower fO2 shows that the stability fields of the hydrous silicates (amphibole and biotite) are significantly restricted at NNO – 2 relative to NNO + 0·2. Additional observations of Quizapu lava and pumice samples support the existing hypothesis that rapid pre-eruptive heating drove the effusive 1846–1847 eruption, with important refinements. We demonstrate that microlites in the end-member dacite lavas are consistent with in situ crystallization (during ascent), rather than transfer from an andesite. In one end-member dacite lava, newly identified reverse zoning in orthopyroxene and incipient destabilization of amphibole are consistent with small degrees of heating. Our work articulates a clear direction for future Quizapu studies, which are warranted given the active nature of the Cerro Azul–Descabezado Grande volcanic axis.more » « less
An official website of the United States government

