An official website of the United States government
Metal surfaces can alter the luminescence emitted by nanoparticles through a variety of effects including quenching, plasmonic enhancement, and optical interference-, reflection-, and absorption-related phenomena. While many of these effects are well-established, multiple such effects typically occur in parallel in realistic measurement scenarios, making the relative importance of each effect difficult to discern. As imaging and sensing applications in which luminescent nanoparticles are placed on metal surfaces continue to grow, a detailed understanding of how metal surfaces modify nanoparticle luminescence is increasingly important for optimizing and ensuring correct interpretation of the measurement results. Here, we systematically investigate how metal surfaces affect the luminescence emitted by individual NaYF4:Yb3+,Er3+ upconverting nanoparticles (UCNPs) ∼27 nm in diameter using a judiciously selected set of five different metal coatings with varying optical and thermal properties. We find that the average single-UCNP emission intensity is determined by an interplay between quenching and reflection effects. Consequently, the average single-UCNP emission intensity is correlated with the reflectance of the underlying metal coating, but non-radiative decay rate changes also play an important role, leading to different average single-UCNP emission intensities for metal coatings with near-identical reflectances. We also evaluate metal surface effects on the common ratiometric thermometry signal of NaYF4:Yb3+,Er3+ UCNPs and find that the intrinsic temperature dependence of the luminescence intensity ratio is unaffected by the underlying material. The only differences observed are the result of laser-induced heating for sufficiently absorbing metal coatings on low thermal conductivity substrates, in accordance with the predictions of an analytical heat transfer model.
more »
« less
Enhancement of Er luminescence from bridge-type photonic crystal nanocavities with Er, O-co-doped GaAs
A bridge-type photonic crystal (PhC) nanocavity based on Er,O-codoped GaAs is employed to realize enhancement of Er luminescence. By adjusting the structural design and measurement temperature, the cavity mode's wavelength can be coupled to Er luminescence. The peak emission intensity from an Er-2O defect center was enhanced 7.3 times at 40 nW pump power and 77 K. The experimental Q-factor is estimated to be over 1.2 × 104, and the luminescence intensity shows superlinearity with excitation power, suggesting Er luminescence amplification. This result would pave the way towards the realization of highly efficient single-photon emitters based on rare-earth elements.
more »
« less
- Award ID(s):
- 2129183
- PAR ID:
- 10535776
- Publisher / Repository:
- OSA
- Date Published:
- Journal Name:
- Optics Continuum
- Volume:
- 2
- Issue:
- 10
- ISSN:
- 2770-0208
- Page Range / eLocation ID:
- 2178
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Lanthanide-doped upconversion nanoparticles (UCNPs) have attracted widespread interest in bioimaging and sensing due to their photostability, low excitation energy, and good tissue penetration. Plasmonic nanostructures, on the other hand, can enhance the luminescence of UCNPs by concentrating electric fields into a nanoscale volume. While the enhanced luminescence intensity is in principle beneficial to sensing, intensity-based sensing has limitations in absolute measurements. This deficiency can be overcome by employing ratiometric sensing in which intensity ratio, rather than intensity itself, is used to quantitatively determine the presence of analytes. The ratiometric sensing is advantageous because the intensity ratio is much less sensitive to the variations in the environment and the number of probe materials in the sensing volume. Here, we demonstrate a plasmonic nanostructure with upconversion nanoparticles for an enhanced ratiometric sensing platform. The plasmonic nanostructure is composed of UCNPs, an indium tin oxide (ITO) spacer layer and an Au nanodisk. The nanostructure is designed such that the plasmon resonance selectively enhances the red luminescence of NaYGdF 4 :Yb 3+ , Er 3+ UCNPs while leaving the green luminescence unaffected, thereby increasing the dynamic range and achievable sensitivity of the red-to-green (R/G) intensity ratio. We observed a 4-fold enhancement in the R/G ratio and also a drastic reduction in the signal uncertainty. This work advances our knowledge of the optical interaction between UCNPs and plasmonic nanostructures and also provides a foundation for improved ratiometric sensing in biomedical applications.more » « less
-
Abstract The synthesis of a fluorescent covalent organic framework (COF) using perylene and pyrene building blocks (PEPy‐COF), via a one‐pot condensation reaction is reported. PEPy‐COF is crystallized into 2D nanosheets with a cubic and prismatic crystalline morphology and demonstrates structural stability at temperatures up to 500 °C. The structural morphology is confirmed using X‐ray diffraction and atomic‐level simulations. These 2D porous polymer sheets form a tetragonal framework that is found to have a high specific surface area of 772 m2g−1. Based on the definition of porous materials, the network is mesoporous with an observed pore size of 3.03 nm, which is in good agreement with the material's calculated pore size. The experimentally obtained HOMO‐LUMO band gap is 2.62 eV, confirming the semiconducting nature of PEPy‐COF. PEPy‐COF emits a shiny blue luminescence under UV and visible light. This luminescence intensity is temperature‐dependent in solvents with different polarities and dielectric constants demonstrating that the PEPy‐COF has potential use in a wide range of temperature‐sensing devices. The fluorescence intensity ratio is similar for different temperatures under ultra‐sound conditions and varying solvents.more » « less
-
Abstract The mechanism surrounding chromosome inheritance during cell division has been well documented, however, organelle inheritance during mitosis is less understood. Recently, the endoplasmic reticulum (ER) has been shown to reorganize during mitosis, dividing asymmetrically in proneuronal cells prior to cell fate selection, indicating a programmed mechanism of inheritance. ER asymmetric partitioning in proneural cells relies on the highly conserved ER integral membrane protein, Jagunal (Jagn). Knockdown of Jagn in the compound Drosophila eye displays a pleotropic rough eye phenotype in 48% of the progeny. To identify genes involved in Jagn dependent ER partitioning pathway, we performed a dominant modifier screen of the 3rd chromosome for enhancers and suppressors of this Jagn-RNAi-induced rough eye phenotype. We screened through 181 deficiency lines covering the 3L and 3R chromosomes and identified 12 suppressors and 10 enhancers of the Jagn-RNAi phenotype. Based on the functions of the genes covered by the deficiencies, we identified genes that displayed a suppression or enhancement of the Jagn-RNAi phenotype. These include Division Abnormally Delayed (Dally), a heparan sulfate proteoglycan, the γ-secretase subunit Presenilin, and the ER resident protein Sec63. Based on our understanding of the function of these targets, there is a connection between Jagn and the Notch signaling pathway. Further studies will elucidate the role of Jagn and identified interactors within the mechanisms of ER partitioning during mitosis.more » « less
-
Abstract Unveiling the underlying mechanisms of properties of functional materials, including the luminescence differences among similar pyrochlores A2B2O7, opens new gateways to select proper hosts for various optoelectronic applications by scientists and engineers. For example, although La2Zr2O7(LZO) and La2Hf2O7(LHO) pyrochlores have similar chemical compositional and crystallographic structural features, they demonstrate different luminescence properties both before and after doped with Eu3+ions. Based on our earlier work, LHO‐based nanophosphors display higher photo‐ and radioluminescence intensity, higher quantum efficiency, and longer excited state lifetime compared to LZO‐based nanophosphors. Moreover, under electronic O2−→Zr4+/Hf4+transition excitation at 306 nm, undoped LHO nanoparticles (NPs) have only violet blue emission, whereas LZO NPs show violet blue and red emissions. In this study, we have combined experimental and density functional theory (DFT) based theoretical calculation to explain the observed results. First, we calculated the density of state (DOS) based on DFT and studied the energetics of ionized oxygen vacancies in the band gaps of LZO and LHO theoretically, which explain their underlying luminescence difference. For Eu3+‐doped NPs, we performed emission intensity and lifetime calculations and found that the LHOE NPs have higher host to dopant energy transfer efficiency than the LZOE NPs (59.3% vs 24.6%), which accounts for the optical performance superiority of the former over the latter. Moreover, by corroborating our experimental data with the DFT calculations, we suggest that the Eu3+doping states in LHO present at exact energy position (both in majority and minority spin components) where oxygen defect states are located unlike those in LZO. Lastly, both the NPs show negligible photobleaching highlighting their potential for bioimaging applications. This current report provides a deeper understanding of the advantages of LHO over LZO as an advanced host for phosphors, scintillators, and fluoroimmunoassays.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1364/OPTCON.501666
