This content will become publicly available on May 16, 2025
- Award ID(s):
- 1904042
- PAR ID:
- 10543277
- Publisher / Repository:
- Royal Society of Chemistry
- Date Published:
- Journal Name:
- Nanoscale
- Volume:
- 16
- Issue:
- 19
- ISSN:
- 2040-3364
- Page Range / eLocation ID:
- 9455 to 9461
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
Inorganic lead-halide perovskite, cesium lead bromide (CsPbBr3), shows outstanding optoelectronic properties. Both solution- and melt-based methods have been proposed for CsPbBr3 crystal growth. The solution-based growth was done at low-temperature, whereas the melt-based growth was done at high-temperature. However, the comparison of optical, physical, and defect states using these two different growth conditions has been scarcely studied. Here, we have compared the thermal and optical properties of solution-grown and melt-grown single crystals of CsPbBr3. Positron Annihilation Lifetime Spectroscopy (PALS) analysis showed that melt-grown crystal has a relatively smaller number of defects than the chemical synthesis method. In addition, crystals grown using the chemical method showed a higher fluorescence lifetime than melt-grown CsPbBr3.more » « less
-
Recently, there has been considerable interest in x-ray and gamma ray detectors with large volume and high energy resolution that operate at room temperature. To improve detector energy resolution, the carrier mobility-lifetime product needs to be increased, and the electronic trap state concentration needs to be minimized. Defect concentrations in the part per billion range can alter the charge transport and carrier recombination lifetime. In this work, thermally stimulated current spectroscopy measurements were systematically carried out in bulk halide perovskite single crystals of CsPbBr3 over a temperature range of 80–320 K. The origins and trap parameters of CsPbBr3 crystals from the solution growth and melt growth procedures were determined and compared. Trap concentrations were ranged from 1 × 1011 to 1 × 1016 cm−3. Appreciable detector performance was observed for CsPbBr3 crystals with trap concentrations less than 1 × 1014 cm−3. The comparison of spectral responses of crystal samples grown using two different methods shows that, after purification, solution-grown crystals are comparable to melt-grown crystals in terms of low defect concentration and improved detector performance. For an improved mobility-lifetime product and enhanced spectral response to high energy radiation from fissile materials, trap states in either type of a crystal ingot must be reduced closer to 1011 cm−3.
-
This paper investigates the optoelectronic properties of CsPbBr3, a lead-based perovskite, and Cs2AgBiBr6, a lead-free double perovskite, in composite thick films synthesized using mechanochemical and hot press methods, with poly(butyl methacrylate) as the matrix. Comprehensive characterization was conducted, including X-ray diffraction (XRD), Raman spectroscopy, scanning electron microscopy (SEM), UV–visible spectroscopy (UV–Vis), and photoluminescence (PL). Results indicate that the polymer matrix does not significantly impact the crystalline structure of the perovskites but has a direct impact on the grain size and surface area, enhancing the interfacial charge transfer of the composites. Optical characterization indicates minimal changes in bandgap energies across all different phases, with CsPbBr3 exhibiting higher photocurrent than Cs2AgBiBr6. This is attributed to the CsPbBr3 superior charge carrier mobility. Both composites showed photoconductive behavior, with Cs2AgBiBr6 also demonstrating higher-energy (X-ray) photon detection. These findings highlight the potential of both materials for advanced photodetector applications, with Cs2AgBiBr6 offering an environmentally Pb-free alternative.
-
Anion exchange is a facile, post-synthetic method to tune the emission wavelength of colloidal cesium lead halide (CsPbX3, X = Cl, Br, I) perovskite nanocrystals. While colloidal nanocrystals can exhibit size-dependent phase stability and chemical reactivity, the role of size in the mechanism of anion exchange in CsPbX3 nanocrystals has not been elucidated. We used single-particle fluorescence microscopy to monitor the transformation of individual CsPbBr3 nanocrystals to CsPbI3. By systematically varying the size of the nanocrystals and the concentration of substitutional iodide, we observed that smaller nanocrystals exhibit longer transition times in their fluorescence trajectories, while larger nanocrystals undergo a more abrupt transition during anion exchange. Monte Carlo simulations were used to rationalize the size-dependent reactivity, in which we varied how each exchange event affects the probability for further exchange. Greater cooperativity for simulated ion exchange leads to shorter transition times to complete the exchange. We propose that size-dependent miscibility between CsPbBr3 and CsPbI3 at the nanoscale controls the reaction kinetics. Smaller nanocrystals maintain a homogeneous composition during anion exchange. As the nanocrystal size increases, variations in the octahedral tilting patterns of the perovskite crystals lead to different structures for CsPbBr3 and CsPbI3. Thus, an iodide-rich region must first nucleate within larger CsPbBr3 nanocrystals, which is followed by rapid transformation to CsPbI3. While higher concentrations of substitutional anions can suppress this size-dependent reactivity, the inherent differences in reactivity between nanocrystals of different sizes are important to consider when scaling up this reaction for applications in solid-state lighting and biological imaging.more » « less
-
Abstract Materials with tunable infrared refractive index changes have enabled active metasurfaces for novel control of optical circuits, thermal radiation, and more. Ion‐gel‐gated epitaxial films of the perovskite cobaltite La1−
x Srx CoO3−δ (LSCO) with 0.00 ≤x ≤ 0.70 offer a new route to significant, voltage‐tuned, nonvolatile refractive index modulation for infrared active metasurfaces, shown here through Kramers–Kronig‐consistent dispersion models, structural and electronic transport characterization, and electromagnetic simulations before and after electrochemical reduction. As‐grown perovskite films are high‐index insulators forx < 0.18 but lossy metals forx > 0.18, due to a percolation insulator‐metal transition. Positive‐voltage gating of LSCO transistors withx > 0.18 reveals a metal‐insulator transition from the metallic perovskite phase to a high‐index (n > 2.5), low‐loss insulating phase, accompanied by a perovskite to oxygen‐vacancy‐ordered brownmillerite transformation at highx . Atx < 0.18, despite nominally insulating character, the LSCO films undergo remarkable refractive index changes to another lower‐index, lower‐loss insulating perovskite state with Δn > 0.6. In simulations of plasmonic metasurfaces, these metal‐insulator and insulator‐insulator transitions support significant, varied mid‐infrared reflectance modulation, thus framing electrochemically gated LSCO as a diverse library of room‐temperature phase‐change materials for applications including dynamic thermal imaging, camouflage, and optical memories.