An official website of the United States government
In recent years, great advances in understanding the opportunities for nonlinear vibration energy harvesting systems have been achieved giving attention to either the structural or electrical subsystems. Yet, a notable disconnect appears in the knowledge on optimal means to integrate nonlinear energy harvesting structures with effective nonlinear rectifying and power management circuits for practical applications. Motivated to fill this knowledge gap, this research employs impedance principles to investigate power optimization strategies for a nonlinear vibration energy harvester interfaced with a bridge rectifier and a buck-boost converter. The frequency and amplitude dependence of the internal impedance of the harvester structure challenges the conventional impedance matching concepts. Instead, a system-level optimization strategy is established and validated through simulations and experiments. Through careful studies, the means to optimize the electrical power with partial information of the electrical load is revealed and verified in comparison to the full analysis. These results suggest that future study and implementation of optimal nonlinear energy harvesting systems may find effective guidance through power flow concepts built on linear theories despite the presence of nonlinearities in structures and circuits.
more »
« less
Impulsive energy conversion with magnetically coupled nonlinear energy harvesting systems
Magnets have received broad attention for vibration energy harvesting due to noncontact, nonlinear forces that may be leveraged among harvesting system elements. Yet, opportunities to integrate multi-directional coupling among a nonlinear energy harvesting system subjected to impulsive excitations have not been scrutinized, despite widespread prevalence of such excitations. To characterize these potentials, this research investigates an energy harvesting system with magnetically induced nonlinearities and coupling effects under impulsive excitations. A system model is formulated and validated with experimental efforts to reconstruct static and dynamic properties of the system via simulations. Then, the model is harnessed to scrutinize dynamic response of the system when subjected to impulse conditions. This research reveals the clear impulse strength dependence and influence of asymmetries on total electrical energy capture and energy conversion efficiency that are tailored by magnetic force coupling. Asymmetry is found to promote greater impulse-to-electrical energy conversion when compared to the symmetric counterpart system and a benchmark nonlinear energy harvester. The roles of initial conditions exemplify how stored energy in an asymmetric energy harvesting system may be released during nonlinear impulsive response. These results provide insights about opportunities and challenges to incorporate magnetic coupling effects in nonlinear energy harvesting systems subjected to impulses.
more »
« less
- Award ID(s):
- 1661572
- PAR ID:
- 10547316
- Publisher / Repository:
- SAGE Publications
- Date Published:
- Journal Name:
- Journal of Intelligent Material Systems and Structures
- Volume:
- 29
- Issue:
- 11
- ISSN:
- 1045-389X
- Format(s):
- Medium: X Size: p. 2374-2391
- Size(s):
- p. 2374-2391
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
In this article we propose a theoretical investigation of the nonlinear dynamical response of a class of planar resonators dubbed the V-Shaped resonator. The resonators are intended for energy harvesting purpose and are designed to exhibit two-to-one internal resonance. In particular, we navigate the design space for the generalized V-shaped resonator to investigate the influence of shape parameters on the performance of the Vibration Energy Harvester. Notably, we introduce two metrics that help elucidating the role of the shape parameter in dictating the behavior of the system in terms of peak voltage and operational bandwidth width. For simplicity, we consider that the system is subjected to harmonic excitations near its primary resonances.more » « less
-
The need for efficient energy utilization is driving research into ways to harvest ubiquitous waste heat. Here, we explore pyroelectric energy conversion from low-grade thermal sources that exploits strong field- and temperature-induced polarization susceptibilities in the relaxor ferroelectric 0.68Pb(Mg1/3Nb2/3)O3–0.32PbTiO3. Electric-field-driven enhancement of the pyroelectric response (as large as − 550 μC m−2 K−1) and suppression of the dielectric response (by 72%) yield substantial figures of merit for pyroelectric energy conversion. Field- and temperature-dependent pyroelectric measurements highlight the role of polarization rotation and field-induced polarization in mediating these effects. Solid-state, thin-film devices that convert lowgrade heat into electrical energy are demonstrated using pyroelectric Ericsson cycles, and optimized to yield maximum energy density, power density and efficiency of 1.06 J cm−3, 526 W cm−3 and 19% of Carnot, respectively; the highest values reported to date and equivalent to the performance of a thermoelectric with an effective ZT ≈ 1.16 for a temperature change of 10 K. Our findings suggest that pyroelectric devices may be competitive with thermoelectric devices for low-grade thermal harvesting.more » « less
-
Abstract The inerter pendulum vibration absorber (IPVA) is integrated between a spar and an annulus floater using a ball-screw mechanism to study its wave energy conversion potential. Hydrodynamic stiffness, added mass, and radiation damping effects on the spar-floater system are characterized using the boundary element method. It is found that a 1:2 internal resonance via a period-doubling bifurcation in the system is responsible for nonlinear energy transfer between the spar-floater system and the pendulum vibration absorber. This nonlinear energy transfer occurs when the primary harmonic solution of the system becomes unstable due to the 1:2 internal resonance phenomenon. The focus of this paper is to analyze this 1:2 internal resonance phenomenon near the first natural frequency of the system. The IPVA system when integrated with the spar-floater system is shown to outperform a linear coupling between the spar and the floater both in terms of the response amplitude operator (RAO) of the spar and one measure of the energy conversion potential of the system. Finally, experiments are performed on the IPVA system integrated with single-degree-of-freedom system (without any hydrodynamic effects) to observe the 1:2 internal resonance phenomenon and the nonlinear energy transfer between the primary mass and the pendulum vibration absorber. It is shown experimentally that the IPVA system outperforms a linear benchmark in terms of vibration suppression due to the energy transfer phenomenon.more » « less
-
Abstract When and where the magnetic field energy is released and converted in eruptive solar flares remains an outstanding topic in solar physics. To shed light on this question, here we report multiwavelength observations of a C9.4-class eruptive limb flare that occurred on 2017 August 20. The flare, accompanied by a magnetic flux rope eruption and a white light coronal mass ejection, features three post-impulsive X-ray and microwave bursts immediately following its main impulsive phase. For each burst, both microwave and X-ray imaging suggest that the nonthermal electrons are located in the above-the-loop-top region. Interestingly, contrary to many other flares, the peak flux of the three post-impulsive microwave and X-ray bursts shows an increase for later bursts. Spectral analysis reveals that the sources have a hardening spectral index, suggesting a more efficient electron acceleration into the later post-impulsive bursts. We observe a positive correlation between the acceleration of the magnetic flux rope and the nonthermal energy release during the post-impulsive bursts in the same event. Intriguingly, different from some other eruptive events, this correlation does not hold for the main impulse phase of this event, which we interpret as energy release due to the tether-cutting reconnection before the primary flux rope acceleration occurs. In addition, using footpoint brightenings at conjugate flare ribbons, a weakening reconnection guide field is inferred, which may also contribute to the hardening of the nonthermal electrons during the post-impulsive phase.more » « less
