An official website of the United States government
S trange-metal behavior has been observed in materials ranging from high-temperature superconductors to heavy fermion metals. In conventional metals, current is carried by quasiparticles; although it has been suggested that quasiparticles are absent in strange metals, direct experimental evidence is lacking. We measured shot noise to probe the granularity of the current-carrying excitations in nanowires of the heavy fermion strange metal YbRh2Si2. When compared with conventional metals, shot noise in these nanowires is strongly suppressed. This suppression cannot be attributed to either electron-phonon or electron-electron interactions in a Fermi liquid, which suggests that the current is not carried by well-defined quasiparticles in the strange-metal regime that we probed. Our work sets the stage for similar studies of other strange metals.
more »
« less
This content will become publicly available on February 1, 2026
Anomalous shot noise in a bad metal β-tantalum
We investigate the electronic shot noise produced by nanowires of β-Ta, an archetypal “bad” metal with resistivity near the Ioffe–Regel localization limit. The Fano factor characterizing the shot noise exhibits a strong dependence on temperature and is suppressed compared to the expectations for quasiparticle diffusion, but hopping transport is ruled out by the analysis of scaling with the nanowire length. These anomalous behaviors closely resemble those of strange metal nanowires, suggesting that β-Ta may host a correlated electron liquid. This material provides an accessible platform for exploring exotic electronic states of matter.
more »
« less
- Award ID(s):
- 2005786
- PAR ID:
- 10574287
- Publisher / Repository:
- American Institute of Physics
- Date Published:
- Journal Name:
- Applied Physics Letters
- Volume:
- 126
- Issue:
- 8
- ISSN:
- 0003-6951
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
null (Ed.)Gallium oxide (Ga 2 O 3 ) and its most stable modification, monoclinic β-Ga 2 O 3 , is emerging as a primary material for power electronic devices, gas sensors and optical devices due to a high breakdown voltage, large bandgap, and optical transparency combined with electrical conductivity. Growth of β-Ga 2 O 3 is challenging and most methods require very high temperatures. Nanowires of β-Ga 2 O 3 have been investigated extensively as they might be advantageous for devices such as nanowire field effect transistors, and gas sensors benefiting from a large surface to volume ratio, among others. Here, we report a synthesis approach using a sulfide precursor (Ga 2 S 3 ), which requires relatively low substrate temperatures and short growth times to produce high-quality single crystalline β-Ga 2 O 3 nanowires in high yields. Even though Au- or Ag-rich nanoparticles are invariably observed at the nanowire tips, they merely serve as nucleation seeds while the nanowire growth proceeds via supply and local oxidation of gallium at the substrate interface. Absorption and cathodoluminescence spectroscopy on individual nanowires confirms a wide bandgap of 4.63 eV and strong luminescence with a maximum ∼2.7 eV. Determining the growth process, morphology, composition and optoelectronic properties on the single nanowire level is key to further application of the β-Ga 2 O 3 nanowires in electronic devices.more » « less
-
Single electron transistors (SET) featuring metal (Ni) electrodes and silicon nitride dielectric barriers prepared by atomic layer deposition are fabricated and tested. Electrical characterization of the devices reveals electrostatic energy parameters consistent with the parameters of the designed tunnel junctions. In addition, an analysis of temperature dependence of conductance confirms the formation of metal-insulator-metal (MIM) junctions with negligible in-series contribution of any surface native metal oxide. However, the fabricated devices exhibit a very high level of electrical noise, far exceeding the commonly observed shot noise. Experimental investigation reveals the random telegraph signal (RTS) nature of the observed excess noise. The RTS noise in electronic devices is commonly associated with charging of external traps that are electrostatically coupled to the SET island. In the devices under study, however, the defects that result in the observed RTS noise are demonstrated to reside within the tunnel junctions. Our results also indicate the critical importance of interface states and surface preparation for achieving good performance of the SETs fabricated using ALD to form the tunnel barrier.more » « less
-
Layered metal-halide perovskites, or two-dimensional perovskites, can be synthesized in solution, and their optical and electronic properties can be tuned by changing their composition. We report a molecular templating method that restricted crystal growth along all crystallographic directions except for [110] and promoted one-dimensional growth. Our approach is widely applicable to synthesize a range of high-quality layered perovskite nanowires with large aspect ratios and tunable organic-inorganic chemical compositions. These nanowires form exceptionally well-defined and flexible cavities that exhibited a wide range of unusual optical properties beyond those of conventional perovskite nanowires. We observed anisotropic emission polarization, low-loss waveguiding (below 3 decibels per millimeter), and efficient low-threshold light amplification (below 20 microjoules per square centimeter).more » « less
-
Abstract Detection of long wave infrared (LWIR) light at room temperature is a long‐standing challenge due to the low energy of photons. A low‐cost, high‐performance LWIR detector or camera that operates under such conditions is pursued for decades. Currently, all available detectors operate based on amplitude modulation (AM) and are limited in performance by AM noises, including Johnson noise, shot noise, and background fluctuation noise. To address this challenge, a frequency modulation (FM)‐based detection technique is introduced, which offers inherent robustness against different types of AM noises. The FM‐based approach yields an outstanding room temperature noise equivalent power (NEP), response time, and detectivity (D*). This result promises a novel uncooled LWIR detection scheme that is highly sensitive, low‐cost, and can be easily integrated with electronic readout circuitry, without the need for complex hybridization.more » « less
