An official website of the United States government
Abstract. We used mapping of bedrock lithology, bedrock fractures, and lake density in Inglefield Land, northwestern Greenland, combined with cosmogenic nuclide (10Be and 26Al) measurements in bedrock surfaces, to investigate glacial erosion and the ice sheet history of the northwestern Greenland Ice Sheet. The pattern of eroded versus weathered bedrock surfaces and other glacial erosion indicators reveal temporally and spatially varying erosion under cold- and warm-based ice. All of the bedrock surfaces that we measured in Inglefield Land contain cosmogenic nuclide inheritance with apparent 10Be ages ranging from 24.9 ± 0.5 to 215.8 ± 7.4 ka. The 26Al/10Be ratios require minimum combined surface burial and exposure histories of ∼ 150 to 2000 kyr. Because our sample sites span a relatively small area that experienced a similar ice sheet history, we attribute differences in nuclide concentrations and ratios to varying erosion during the Quaternary. We show that an ice sheet history with ∼ 900 kyr of exposure and ∼ 1800 kyr of ice cover throughout the Quaternary is consistent with the measured nuclide concentrations in most samples when sample-specific subaerial erosion rates are between 0 and 2 × 10−2 mm yr−1 and subglacial erosion rates are between 0 and 2 × 10−3 mm yr−1. These erosion rates help to characterize Arctic landscape evolution in crystalline bedrock terrains in areas away from focused ice flow.
more »
« less
A Model Framework for Scaling Pre‐Quaternary Cosmogenic Nuclide Production Rates
Abstract Cosmogenic nuclide dating is an essential component of studying Earth surface processes, but it requires knowledge of how nuclide production rates vary in time and space. Typically, production rates are calibrated at sites with independently well‐constrained exposure histories and then scaled to other sites of interest using scaling frameworks that account for spatial and temporal variations in the secondary cosmic‐ray flux at Earth's surface. To date, scaling schemes for terrestrial cosmogenic nuclide production rates have been developed for the Quaternary, yet cosmogenic nuclide applications that extend beyond the Quaternary are becoming more prevalent. For these deeper time applications, production rate calculations using scaling models optimized for the latest Quaternary neglect longer term spatiotemporal variations in geomagnetic field intensity, paleogeography, and paleoatmospheric depth. We present a production rate scaling scheme for the past 70 million years, SPRITE (Scaling Production Rates In deep TimE). This framework extends existing scaling schemes into deeper time by (a) accounting for site‐specific changes in paleolatitude, (b) integrating a geomagnetic field intensity model rooted in data from a global paleomagnetic database, and (c) incorporating climate‐driven, time‐varying atmospheric depths. We evaluate the efficacy of our model by applying it to existing data sets from paleoexposure sites, and from sites with apparent continuous million‐year exposure histories. This scaling model can be applied with measurements of stable cosmogenic nuclides to research questions such as constraining hiatus durations between ancient lava flows and calculating the formation timescales of stable landforms in arid environments over millions of years.
more »
« less
- Award ID(s):
- 2300559
- PAR ID:
- 10581337
- Publisher / Repository:
- DOI PREFIX: 10.1029
- Date Published:
- Journal Name:
- Geochemistry, Geophysics, Geosystems
- Volume:
- 26
- Issue:
- 1
- ISSN:
- 1525-2027
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
We assess if variations in the in situ cosmogenic 26Al/10Be production ratio expected from nuclear physics are consistent with empirical data, knowledge critical for two-isotope studies. We do this using 313 samples from glacially transported boulders or scoured bedrock with presumed simple exposure histories in the Informal Cosmogenic-nuclide Exposure-age Database (ICE-D) from latitudes between 53°S to 70°N and altitudes up to 5000 m above sea level. Although there were small systematic differences in Al/Be ratios measured in different laboratories, these were not significant and are in part explained by differences in elevation distribution of samples analyzed by each laboratory. We observe a negative correlation between the 26Al/10Be production ratio and elevation (p = 0.0005), consistent with predictions based on the measured energy dependence of nuclear reaction cross-sections and the spatial variability in cosmic-ray energy spectra. We detect an increase in the production ratio with increasing latitude, but this correlation is significant only in a single variate model, and we attribute at least some of the correlation to sample elevation bias because lower latitude samples are typically from higher elevations (and vice versa). Using 6.75 as the 26Al/10Be production ratio globally will bias two-isotope results at higher elevations and perhaps higher latitudes. Data reported here support using production rate scaling that incorporates such ratio changes, such as the LSDn scheme, to minimize such biases.more » « less
-
Abstract. Galactic cosmic rays (GCRs) interact with matter in the atmosphere and at the surface of the Earth to produce a range of cosmogenic nuclides. Measurements of cosmogenic nuclides produced in surface rocks have been used to study past land ice extent as well as to estimate erosion rates. Because the GCR flux reaching the Earth is modulated by magnetic fields (solar and Earth's), records of cosmogenic nuclides produced in the atmosphere have also been used for studies of past solar activity. Studies utilizing cosmogenic nuclides assume that the GCR flux is constant in time, but this assumption may be uncertain by 30 % or more. Here we propose that measurements of 14C of carbon monoxide (14CO) in ice cores at low-accumulation sites can be used as a proxy for variations in GCR flux on timescales of several thousand years. At low-accumulation ice core sites, 14CO in ice below the firn zone originates almost entirely from in situ cosmogenic production by deep-penetrating secondary cosmic ray muons. The flux of such muons is almost insensitive to solar and geomagnetic variations and depends only on the primary GCR flux intensity. We use an empirically constrained model of in situ cosmogenic 14CO production in ice in combination with a statistical analysis to explore the sensitivity of ice core 14CO measurements at Dome C, Antarctica, to variations in the GCR flux over the past ≈ 7000 years. We find that Dome C 14CO measurements would be able to detect a linear change of 6 % over 7 ka, a step increase of 6 % at 3.5 ka or a transient 100-year spike of 190 % at 3.5 ka at the 3σ significance level. The ice core 14CO proxy therefore appears promising for the purpose of providing a high-precision test of the assumption of GCR flux constancy over the Holocene.more » « less
-
Abstract. Cosmogenic nuclide production rates depend on the excitation functions of the underlying nuclear reactions and the intensity and energy spectrum of the cosmic-ray flux. The cosmic-ray energy spectrum shifts towards lower average energies with decreasing altitude (increasing atmospheric depth), so production rate scaling will differ for production reactions that have different energy sensitivities. Here, we assess the possibility of the unique scaling of 36Cl production from Fe by modeling changes in the 36ClFe/36ClK and 36ClFe/10Beqtz production ratios with altitude. We evaluate model predictions against measured 36Cl concentrations in magnetite and K-feldspar and 10Be concentrations in quartz from granitic rocks exposed across an elevation transect (ca. 1700–4300 ma.s.l.) in western North America. The data are broadly consistent with model predictions. The null hypothesis that 36ClFe/10Beqtz and 36ClFe/36ClK production ratios are invariant with altitude can be rejected at the 90 % confidence level. Thus, reaction-specific scaling factors will likely yield more accurate results than non-reaction-specific scaling factors when scaling 36Cl production in Fe-rich rocks and minerals.more » « less
-
Abstract. Measurements of multiple cosmogenic nuclides in a single sample are valuable for various applications of cosmogenic nuclide exposure dating and allow for correcting exposure ages for surface weathering and erosion and establishing exposure–burial history. Here we provide advances in the measurement of cosmogenic 10Be in pyroxene and constraints on the production rate that provide new opportunities for measurements of multi-nuclide systems, such as 10Be/3He, in pyroxene-bearing samples. We extracted and measured cosmogenic 10Be in pyroxene from two sets of Ferrar Dolerite samples collected from the Transantarctic Mountains in Antarctica. One set of samples has 10Be concentrations close to saturation, which allows for the production rate calibration of 10Be in pyroxene by assuming production–decay equilibrium. The other set of samples, which has a more recent exposure history, is used to determine if a rapid fusion method can be successfully applied to samples with Holocene to Last Glacial Maximum exposure ages. From measured 10Be concentrations in the near-saturation sample set we find the production rate of 10Be in pyroxene to be 3.74 ± 0.10 atoms g−1 yr−1, which is consistent with 10Be/3He paired nuclide ratios from samples assumed to have simple exposure. Given the high 10Be concentration measured in this sample set, a sample mass of ∼ 0.5 g of pyroxene is sufficient for the extraction of cosmogenic 10Be from pyroxene using a rapid fusion method. However, for the set of samples that have low 10Be concentrations, measured concentrations were higher than expected. We attribute spuriously high 10Be concentrations to failure in removing all meteoric 10Be and/or a highly variable and poorly quantified procedural blank background correction.more » « less
