An official website of the United States government
Abstract Levees are built to safeguard human lives, essential infrastructure, and farmland. However, failure of levees can have catastrophic impacts due to a fast rate of inundation in areas protected by levees. Earthen levees are prone to failure due to excessive moisture content that reduces the shear strength of the soil. The use of levee monitoring systems has demonstrated the ability to reduce the likelihood of failure by creating maps that depict the saturation levels of the surface of the levee, both in terms of space and time. By utilizing extensive sensor networks to continuously monitor these geo-infrastructure systems, the structural deterioration attributed to changing climate can be studied. Measuring environmental parameters surrounding such structures provides insight into the potential stressors that cause structural failure. Steps can then be taken to mitigate those effects on the levees and maintain structural integrity. However, the massive scale of levees makes it difficult to monitor with conventional wired sensors. This paper presents a preliminary investigation into the development and validation of UAV-deployable smart sensing spikes for soil conductivity levels in levees, which is a measurement modality for determining soil saturation levels. For this work, Gaussian process regression (also known as kriging) is used to model the soil saturation levels between sensing spikes obtaining a continuous moisture map of the levees. The expanded data is then categorized using a clustering-based machine learning approach with conductivity data from sensing spikes as model inputs. The machine learning model output is sorted into three categories: dry, partially saturated, and saturated soil. The findings of a laboratory study are presented, and the implications of the raw and expanded data are discussed. This work will aid in predicting potential levee failure risks and maintenance requirements based on the analysis of the soil conditions using a network of smart sensing spikes.
more »
« less
This content will become publicly available on November 17, 2025
Distributed Real-Time Soil Saturation Assessment in Levees Using a Network of Wireless Sensor Packages With Conductivity Probes
Abstract Levees play a critical role in safeguarding communities and assets from flooding, acting as essential defenses against the devastating impacts of inundation. Yet, earthen levees are prone to breaches, especially in the face of swift floodwaters. Distributed low-cost sensor networks offer the potential to generate spatial maps illustrating soil moisture levels. Long-term monitoring of these spatial maps could identify vulnerable zones in the levee while providing an understanding of how climate change affects levee stability. This study presents an investigation into spatial monitoring of soil saturation in levees using a wireless network of UAV-deployable sensing spike packages. The goal of this paper is to demonstrate the use of these sensors for assessing soil conductivity levels in sand-filled embankments. The obtained soil conductivity levels are crucial for determining soil saturation. The developed sensing spikes consist of a spike that penetrates the ground and measures conductivity between two electrically conductive contacts. The sensing spike consists of microprocessors for edge computing, and wireless data communication systems that report data to a way station in real-time. To validate the efficacy of the developed sensors, a flume test is developed as a replica of a levee and monitored under controlled water flow conditions. The analysis of data at different times revealed the progression of moisture throughout the earthen embankment. Initially, the soil is almost dry. As the controlled water flow proceeds, the soil becomes partially saturated, with the final stage showing a dominant presence of saturated soil. The collected data sampled at the measurement points is expanded to a continuous moisture profile using kriging. Gaussian kriging, also known as ordinary kriging, is one of the commonly used variants of the kriging method. In Gaussian kriging, the estimation of values at unsampled locations is based on a linear combination of nearby data points, with weights determined by their spatial relationships. The Gaussian assumption implies that the errors in the estimation process follow a normal distribution. The extended knowledge about saturation levels obtained through kriging can lead to insights for predicting vulnerable areas and preempting potential failures. Overall, this study paves the way for further development of a wireless network of sensing spike packages as a UAV-deployable system for levee health assessment and improved infrastructure management.
more »
« less
- PAR ID:
- 10583626
- Publisher / Repository:
- American Society of Mechanical Engineers
- Date Published:
- ISBN:
- 978-0-7918-8869-8
- Format(s):
- Medium: X
- Location:
- Portland, Oregon, USA
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Research in different agricultural sectors, including in crop loss estimation during flood and yield estimation, substantially rely on inundation information. Spaceborne remote sensing has widely been used in the mapping and monitoring of floods. However, the inability of optical remote sensing to cloud penetration and the scarcity of fine temporal resolution SAR data hinder the application of flood mapping in many cases. Soil Moisture Active Passive (SMAP) level 4 products, which are model-driven soil moisture data derived from SMAP observations and are available at 3-h intervals, can offer an intermediate but effective solution. This study maps flood progress in croplands by incorporating SMAP surface soil moisture, soil physical properties, and national floodplain information. Soil moisture above the effective soil porosity is a direct indication of soil saturation. Soil moisture also increases considerably during a flood event. Therefore, this approach took into account three conditions to map the flooded pixels: a minimum of 0.05 m3m−3 increment in soil moisture from pre-flood to post-flood condition, soil moisture above the effective soil porosity, and the holding of saturation condition for the 72 consecutive hours. Results indicated that the SMAP-derived maps were able to successfully map most of the flooded areas in the reference maps in the majority of the cases, though with some degree of overestimation (due to the coarse spatial resolution of SMAP). Finally, the inundated croplands are extracted from saturated areas by Spatial Hazard Zone areas (SHFA) of Federal Emergency Management Agency (FEMA) and cropland data layer (CDL). The flood maps extracted from SMAP data are validated with FEMA-declared affected counties as well as with flood maps from other sources.more » « less
-
There are growing concerns regarding the increase in flood risk due to climate change and land use/land cover changes. In light of these changes, levees play an increasingly critical role in safeguarding communities, infrastructure, and the natural environment. However, the average age of levees in the United States is 60 years, with the majority operating under marginal conditions. The most common failure mode of earthen levees is breach due to overtopping. Existing methodologies evaluate the site-specific probability of levee overtopping and do not provide a holistic view of flood risk across a wider area. Here we present a regional-scale overtopping model for levees using a data-driven overtopping model that uses five variables: (1) levee construction classification, (2) overtopping depth, (3) overtopping duration, (4) erosion resistance classification, and (5) duration of levee loading before overtopping. The overtopping model is applied to levee systems in Wilton, California. The probability of breach due to overtopping is presented for three distinct scenarios (overtopping duration) during a 50-year flood event. The results show the probability of breach for the Wilton Levee ranges from 0.32 to 0.91 for overtopping durations of 6 hours and between 6 to 24 hours. For durations exceeding 24 hours, the probability of breach increases to a range of 0.73 to 0.98. The proposed framework offers a viable tool for performing regional-scale levee risk assessment, offering broader implications for enhancing preparedness, response, and recovery strategies in the face of escalating flood risks.more » « less
-
Bioinspired slope improvements can achieve outcomes similar to traditional slope improvements for shallow slope failures, while incorporating plant material as a structural component and using a minimum of heavy equipment. Vetiver grass can mitigate the rain-induced slope instability of earthen infrastructure, such as levees, constructed using loess and clay soils. Vetiver grassroots can extend to depths greater than 3 m (10 ft), creating a new composite material with the grassroots and soil, thereby increasing shear strength to combat shallow slope failures. The objective of this study is to determine the feasibility of vetiver as a climate-resilient bioinspired slope stability improvement on a test levee constructed of loess in Vicksburg, Mississippi (MS). Vetiver was planted at 1 ft center-to-center intervals on a 9.1 m wide (30 ft) section of an approximately 12.2 m long (40 ft) downstream slope of a test levee and observed for 2.5 years. To consider the effect of extreme precipitation events, a finite element analysis was completed for a comparable clay slope using 500 year precipitation intensity–duration– frequency curves of Jackson, MS. Precipitation negatively impacts the collapsible and expansive nature of the local loess and clay, respectively. The results demonstrate that vetiver grass is a viable method to increase slope stability for earthen levees constructed with loess and clay, which are prevalent in Vicksburg and Jackson, respectively. Vetiver also holds promise as a climate resilient solution to combat raininduced shallow slope failures.more » « less
-
Climate change is expected to alter the statistics of extreme events including rainfall storms, floods, droughts, and heatwaves. Climate-adaptive geotechnical structures warrant a quantitative assessment of the impacts of emerging and projected extreme patterns on the short and long-term behaviors of earthen structures. Furthermore, long-term changes to soil carbon and moisture due to non-extreme climate events should also be considered. While several large-scale studies have been conducted to evaluate various aspects of climate change, there is a clear gap in the state of knowledge in terms of assessing the resilience of geotechnical structures to changes in climatic trends (e.g., warmer climate, protracted droughts, intensified extreme precipitations, and sea level rise). The majority of the aforementioned climatic trends pose multi-physics problems involving thermo-hydro-mechanical (THM) processes in partially saturated soils and earthen structures. This review paper discusses how soil-atmospheric interactions and extreme event patterns in a changing climate can alter soil properties and loading conditions, affecting the performance of partially saturated geotechnical structures. We speculate how changes in climatic trends may weaken partially saturated earthen structures through strength reduction, drying, soil desiccation cracking, shrinkage, microbial oxidation of soil organic matter, fluctuation in the ground water table, land and surface erosion, and highly dynamic pore pressure changes. Each of these weakening processes is primarily induced by variations in the soil moisture and temperature. Finally, we discuss potential modes of failure imposed on partially saturated earthen structures by climatic trends.more » « less
