An official website of the United States government
We present a transient response study of a semiconductor based plasmonic switch. The proposed device operates through active control and modulation of localized electron density waves, i.e., surface plasmon polaritons (SPPs) at degenerately doped In0.53Ga0.47As based PN++junctions. A set of devices is designed and fabricated, and its optical and electronic behaviors are studied both experimentally and theoretically. Optical characterization shows far-field reflectivity modulation, a result of electrical tuning of the SPPs at the PN++junctions for mid-IR wavelengths, with significant 3 dB bandwidths. Numerical studies using a self-consistent electro-optic multi-physics model are performed to uncover the temporal response of the devices’ electromagnetic and kinetic mechanisms facilitating the SPP switching at the PN++junctions. Numerical simulations show strong synergy with the experimental results, validating the claim of potential optoelectronic switching with a 3 dB bandwidth as high as 2 GHz. Thus, this study confirms that the presented SPP diode architecture can be implemented for high-speed control of SPPs through electrical means, providing a pathway toward fast all-semiconductor plasmonic devices.
more »
« less
Optoelectronic control of surface plasmon polaritons at metal-doped semiconductor interfaces
Abstract We present a metal–semiconductor (M–S) based electro-optic modulator designed for functional plasmonic circuits, utilizing the active control of surface plasmon polaritons (SPPs) at M–S junction interfaces. Through self-consistent multiphysics simulations, including electromagnetic, thermal, and current–voltage (IV) characteristics, we estimate bias- and doping concentration-dependent SPP modulation and switching times. This study focuses on germanium-based Schottky contacts and can be extended to other semiconducting materials. We performed parametric analysis using the developed thermo-electro-optic model to identify device parameters and dimensions for enhanced optical confinement and faster operation. The studied device exhibits signal modulation exceeding −28 dB, responsivity greater than −1800 dB V−1, and switching rates of 8 GHz, suggesting potential data rates above 16 Gbit s−1. Additionally, frequency response analysis using the numerical model confirms the device’s electrical tunability and predicts a 3 dB bandwidth of up to 4 GHz. These findings highlight the significant potential of Schottky junctions as active components in the development of plasmonic-based integrated circuits.
more »
« less
- Award ID(s):
- 2138198
- PAR ID:
- 10588244
- Publisher / Repository:
- IOP Publishing
- Date Published:
- Journal Name:
- Journal of Physics: Photonics
- Volume:
- 7
- Issue:
- 3
- ISSN:
- 2515-7647
- Format(s):
- Medium: X Size: Article No. 035001
- Size(s):
- Article No. 035001
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract With success of silicon photonics having mature to foundry-readiness, the intrinsic limitations of the weak electro-optic effects in Silicon limit further device development. To overcome this, heterogeneous integration of emerging electrooptic materials into Si or SiN platforms are a promising path to deliver <1fJ/bit device-level efficiency, 50+Ghz fast switching, and <10's um^2 compact footprints. Graphene's Pauli blocking enables intriguing opportunities for device performance to include broadband absorption, unity-strong index modulation, low contact resistance. Similarly, ITO has shown ENZ behavior, and tunability for EOMs or EAMs. Here we review recent modulator advances all heterogeneously integrated on Si or SiN such as a) a DBR-enabled photonic 60 GHz graphene EAM, b) a hybrid plasmon graphene EAM of 100aJ/bit efficiency, d) the first ITO- based MZI showing a VpL = 0.52 V-mm, and e) a plasmonic ITO MZI with a record low VpL = 11 V- um. We conclude by discussing modulator scaling laws for a roadmap to achieve 10's aJ/bit devices.more » « less
-
We demonstrate telecommunication-wavelength Pockels electro-optic modulators in thin-film lithium tantalate (TFLT) with superior DC stability compared to equivalent thin-film lithium niobate (TFLN) modulators. Less than 1 dB output power fluctuation for quadrature-biased TFLT is measured compared to 5 dB with TFLN over 46 hours with 12.1 dBm input power. Our TFLT modulators maintain properties similar to those in TFLN: 3.4 Vcm half-wave voltage length product, 39 dB extinction ratio, flat RF electro-optic response from 3-50 GHz, and 0.35 dB on-chip loss. We also show low error-rate data modulation over 0-70°C with TFLT modulators and optical loss of 9 dB/m.more » « less
-
Abstract We report a novel approach for dynamically tuning and reconfiguring microwave bandpass filters (BPFs) based on optically controlled switching elements using photoconductivity modulation in semiconductors. For a prototype demonstration, a BPF circuit featuring a second‐order design using two closely coupled split‐ring resonators embedded with multiple silicon chips (as switching elements) was designed, fabricated, and characterized. The silicon chips were optically linked to fiber‐coupled laser diodes (808 nm light) for switching/modulation, enabling dynamic tuning and reconfiguring of the BPF without any complex biasing circuits. By turning on and off the two laser diodes simultaneously, the BPF response can be dynamically reconfigured between bandpass and broadband suppression. Moreover, the attenuation level of the passband can be continuously adjusted (from 0.7 to 22 dB at the center frequency of 3.03 GHz) by varying the light intensity from 0 to 40 W/cm2. The tuning/reconfiguring 3‐dB bandwidth is estimated to be ~200 kHz. In addition, the potential and limitations of the proposed approach using photoconductivity modulation are discussed. With the strong tuning/reconfiguring capability demonstrated and the great potential for high‐frequency operation, this approach holds promise for the development of more advanced tunable filters and other adaptive circuits for next‐generation sensing, imaging, and communication systems.more » « less
-
Congreve, Daniel; Nielsen, Christian; Musser, Andrew J.; Baran, Derya (Ed.)Hybrid organic electro-optic (OEO) devices consist of a layer of ordered organic chromophores confined between layers of metals or semiconductors, enabling optical fields to be tightly confined within the OEO material. The combination of tight confinement with the high electro-optic (EO) performance of state-of-the art OEO materials enables exceptional electro-optic switching performance in silicon-organic hybrid (SOH) and plasmonic-organic hybrid (POH) device architectures. Recent records in POH devices include bandwidths > 500 GHz and energy efficiency < 100 aJ/bit. However, optimization of device performance requires both understanding and improving the degree to which chromophores can be acentrically ordered near a metal or semiconductor interface. Applying bulk and/or isotropic models of OEO materials to nanophotonic device architectures often lead to overly optimistic translation of materials performance to device performance. Prior work has identified influences of high centrosymmetric order (birefringence), altered relations between acentric and centrosymmetric order (dimensionality), and surface electrostatics on chromophore ordering. We combine these models into a representation that can be used to understand the influences of these phenomena on device performance, how some prior OEO materials exhibited unusually high performance under confinement, how ordering close to surfaces may be improved, and implications for future electro-optic device design.more » « less
