An official website of the United States government
High critical current (Ic) in high magnetic fields (B) with minimal variations with respect to the orientation of the B field is demanded by many applications such as high-field magnets for fusion systems. Motivated by this, this work studies 6 vol. % BaZrO3/YBa2Cu3O7 (BZO/YBCO) multilayer nanocomposite films by stacking two 10 nm thick Ca0.3Y0.7Ba2Cu3O7 (CaY-123) spacers with three BZO/YBCO layers of thickness varied from 50 to 330 nm to make the total film thickness of 150–1000 nm. The Ca diffusion from the spacers into BZO/YBCO was shown to dramatically enhance pinning efficiency of c-axis aligned BZO nanorods, which yields high and almost thickness independent critical current density (Jc) in the BZO/YBCO multilayer nanocomposite films. Remarkably, enhanced Jc was observed in these multilayer samples at a wide temperature range of 20–80 K and magnetic fields up to 9.0 T. In particular, the thicker BZO/YBCO multilayer films outperform their thinner counterparts in both higher value and less anisotropy of Jc at lower temperatures and higher fields. At 20 K and 9.0 T, Ic is up to 654 A/cm-width at B//c in the 6% multilayer (1000 nm) sample, which is close to 753 A/cm-width at B//ab due to the intrinsic pinning. This result illustrates the critical role of the Ca cation diffusion into the YBCO lattice in achieving high and isotropic pinning in thick BZO/YBCO multilayer films.
more »
« less
a -axis YBa2Cu3O7− x /PrBa2Cu3O7− x /YBa2Cu3O7− x trilayers with subnanometer rms roughness
We demonstrate a-axis YBa2Cu3O7−x/PrBa2Cu3O7−x/YBa2Cu3O7−x trilayers grown on (100) LaAlO3 substrates with improved interface smoothness. The trilayers are synthesized by ozone-assisted molecular-beam epitaxy. The thickness of the PrBa2Cu3O7−x layer is held constant at 8 nm, and the thickness of the YBa2Cu3O7−x layers is varied from 24 nm to 100 nm. X-ray diffraction measurements show all trilayers to have >97% a-axis content. The rms roughness of the thinnest trilayer is <0.7 nm, and this roughness increases with the thickness of the YBa2Cu3O7−x layers. The thickness of the YBa2Cu3O7−x layers also affects the transport properties: while all samples exhibit an onset of the superconducting transition at and above 85 K, the thinner samples show wider transition widths, ΔTc. High-resolution scanning transmission electron microscopy reveals coherent and chemically sharp interfaces and that growth begins with a cubic (Y,Ba)CuO3−x perovskite phase that transforms into a-axis oriented YBa2Cu3O7−x as the substrate temperature is ramped up.
more »
« less
- Award ID(s):
- 1719875
- PAR ID:
- 10595009
- Publisher / Repository:
- American Institute of Physics
- Date Published:
- Journal Name:
- APL Materials
- Volume:
- 9
- Issue:
- 2
- ISSN:
- 2166-532X
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Nanoscale c-axis-aligned one dimensional artificial pinning centers (1D-APC) in superconducting YBa2Cu3O7-x (YBCO) films have been shown to provide strong correlated pining to magnetic vortices at magnetic field H//c-axis. A question arises on how the pinning effectiveness is sustained as the H-orientation (θ) deviates from the c-axis and how such an angular range is correlated to the pinning efficiency of an individual 1D-APC. To shed lights on this question, this work investigates the angular range of pinning effectiveness of the BaZrO3 (BZO) 1D-APCs in BZO/YBa2Cu3O7-x nanocomposites as the strain field overlap is systematically varied by increasing the BZO doping level in the range of 2-6 vol.% and by the introduction of the secondary Y2O3 nanoparticles (3D APCs). By evaluating the maximum pinning force density (Fp, max), its location Hmax, and the α values of the nanocomposites normalized to that of the reference YBa2Cu3O7-x film as functions of θ at temperatures of 65–77 K, a quantitative correlation between the pinning efficiency of the BZO 1D-APCs and their effective angular range was obtained. In most samples, the 1D-APCs can provide enhanced Hmax in the range of θ ∼0°-60°. However, the Fp, max values only in nanocomposites with high pinning efficiency 1D-APCs exceed that of the YBa2Cu3O7-x over a smaller range up to θ ∼ 37°. Finally, the introduction of 3D APCs results in reduction of the α values over nearly the entire angular range. This study reveals the importance in improving individual 1D-APC’s pinning efficiency and hence extending its angular range of effective pinning.more » « less
-
In this work, we extract the temperature-dependent bilinear J1 and biquadratic J2 exchange energy densities in permalloy–ruthenium-based synthetic antiferromagnet bilayers, trilayers, and tetralayers. In our samples, the ruthenium interlayer thickness is fixed to be 1 nm across all structures, but we consider permalloy layers that are 3 and 9 nm thick. To the best of our knowledge, this work represents the first time that the influence of both the ferromagnetic layer thickness as well as the total number of ferromagnetic layers on biquadratic exchange interactions has been examined together. Across all samples, we observe a significant increase in the strength of J2 relative to J1 as the temperature is lowered. We also observe trends indicating that J2 is sensitive to both the thickness and the total number of permalloy layers. Our analysis suggests that in structures with thicker and more numerous ferromagnetic layers, J2 originates from interfacial roughness effects between the magnetic layer and the spacer layer. In samples with thinner and less numerous permalloy layers, multiple mechanisms must contribute to J2. These findings provide new insights into the complexity of interlayer exchange interactions in synthetic antiferromagnets, which will aid in interpreting ongoing magnonic and spintronic experimental studies of synthetic antiferromagnets.more » « less
-
The growth of monoclinic phase‐pure gallium oxide (β‐Ga2O3) layers by metal–organic chemical vapor deposition on c‐plane sapphire and aluminum nitride (AlN) templates using silicon‐oxygen bonding (SiOx) as a phase stabilizer is reported. The β‐Ga2O3layers are grown using triethylgallium, oxygen, and silane for gallium, oxygen, and silicon precursors, respectively, at 700 °C, with and without silane flow in the process. The samples grown on sapphire with SiOxphase stabilization show a notable change from samples without phase stabilization in the roughness and resistivity, from 16.2 to 4.2 nm and from 85.82 to 135.64 Ω cm, respectively. X‐ray diffraction reveals a pure‐monoclinic phase, and Raman spatial mapping exhibits higher tensile strain in the films in the presence of SiOx. The β‐Ga2O3layers grown on an AlN template, using the same processes as for sapphire, show an excellent epitaxial relationship between β‐Ga2O3and AlN and have a significant change in β‐Ga2O3surface morphology.more » « less
-
Epitaxial ScxAl1−xN thin films of ∼100 nm thickness grown on metal polar GaN substrates are found to exhibit significantly enhanced relative dielectric permittivity (εr) values relative to AlN. εrvalues of ∼17–21 for Sc mole fractions of 17%–25% ( x = 0.17–0.25) measured electrically by capacitance–voltage measurements indicate that ScxAl1−xN has the largest relative dielectric permittivity of any existing nitride material. Since epitaxial ScxAl1−xN layers deposited on GaN also exhibit large polarization discontinuity, the heterojunction can exploit the in situ high-K dielectric property to extend transistor operation for power electronics and high-speed microwave applications.more » « less
