An official website of the United States government
Epitaxial growth of κ-phase Ga 2 O 3 thin films is investigated on c-plane sapphire, GaN- and AlN-on-sapphire, and (100) oriented yttria stabilized zirconia (YSZ) substrates via metalorganic chemical vapor deposition. The structural and surface morphological properties are investigated by comprehensive material characterization. Phase pure κ-Ga 2 O 3 films are successfully grown on GaN-, AlN-on-sapphire, and YSZ substrates through a systematical tuning of growth parameters including the precursor molar flow rates, chamber pressure, and growth temperature, whereas the growth on c-sapphire substrates leads to a mixture of β- and κ-polymorphs of Ga 2 O 3 under the investigated growth conditions. The influence of the crystalline structure, surface morphology, and roughness of κ-Ga 2 O 3 films grown on different substrates are investigated as a function of precursor flow rate. High-resolution scanning transmission electron microscopy imaging of κ-Ga 2 O 3 films reveals abrupt interfaces between the epitaxial film and the sapphire, GaN, and YSZ substrates. The growth of single crystal orthorhombic κ-Ga 2 O 3 films is confirmed by analyzing the scanning transmission electron microscopy nanodiffraction pattern. The chemical composition, surface stoichiometry, and bandgap energies of κ-Ga 2 O 3 thin films grown on different substrates are studied by high-resolution x-ray photoelectron spectroscopy (XPS) measurements. The type-II (staggered) band alignments at three interfaces between κ-Ga 2 O 3 and c-sapphire, AlN, and YSZ substrates are determined by XPS, with an exception of κ-Ga 2 O 3 /GaN interface, which shows type-I (straddling) band alignment.
more »
« less
Magnetic properties of MBE grown Mn4N on MgO, SiC, GaN and Al2O3 substrates
Mn4N is a compound magnetic material that can be grown using MBE while exhibiting several desirable magnetic properties such as strong perpendicular magnetic anisotropy, low saturation magnetization, large domain size, and record high domain wall velocities. In addition to its potential for spintronic applications exploiting spin orbit torque with epitaxial topological insulator/ferromagnet bilayers, the possibility of integrating Mn4N seamlessly with the wide bandgap semiconductors GaN and SiC provides a pathway to merge logic, memory and communication components. We report a comparative study of MBE grown Mn4N thin films on four crystalline substrates: cubic MgO, and hexagonal GaN, SiC and sapphire. Under similar growth conditions, the Mn4N film is found to grow single crystalline on MgO and SiC, polycrystalline on GaN, and amorphous on sapphire. The magnetic properties vary on the substrates and correlate to the structural properties. Interestingly, the field dependent anomalous Hall resistance of Mn4N on GaN shows different behavior from other substrates such as a flipped sign of the anomalous Hall resistance.
more »
« less
- PAR ID:
- 10597517
- Publisher / Repository:
- American Institute of Physics
- Date Published:
- Journal Name:
- AIP Advances
- Volume:
- 10
- Issue:
- 1
- ISSN:
- 2158-3226
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Abstract Quantum anomalous Hall phases arising from the inverted band topology in magnetically doped topological insulators have emerged as an important subject of research for quantization at zero magnetic fields. Though necessary for practical implementation, sophisticated electrical control of molecular beam epitaxy (MBE)‐grown quantum anomalous Hall matter have been stymied by growth and fabrication challenges. Here, a novel procedure is demonstrated, employing a combination of thin‐film deposition and 2D material stacking techniques, to create dual‐gated devices of the MBE‐grown quantum anomalous Hall insulator, Cr‐doped (Bi,Sb)2Te3. In these devices, orthogonal control over the field‐induced charge density and the electric displacement field is demonstrated. A thorough examination of material responses to tuning along each control axis is presented, realizing magnetic property control along the former and a novel capability to manipulate the surface exchange gap along the latter. Through electrically addressing the exchange gap, the capabilities to either strengthen the quantum anomalous Hall state or suppress it entirely and drive a topological phase transition to a trivial state are demonstrated. The experimental result is explained using first principle theoretical calculations, and establishes a practical route for in situ control of quantum anomalous Hall states and topology.more » « less
-
null (Ed.)Recently there has been renewed interest in resonant tunnel diodes (RTD) owing to the demonstration of repeatable room temperature negative differential resistance (RT-NDR) [1], [2] and high peak current densities [3] in GaN-based RTDs. While most of the successful demonstrations of RT-NDR have been from device structures grown on low dislocation-density, freestanding (FS) GaN substrates, there have been a few reports of repeatable RT-NDR from GaN-based RTDs grown on GaN templates on sapphire [4], [5], which have significantly higher densities of threading dislocations (TDs) than FS GaN substrates, but much lower cost. Furthermore, due to the large spontaneous and piezoelectric charge found at the heterointerfaces in III-nitrides, GaN-based RTDs, such as the one illustrated in Fig. 1(a), have highly unusual energy band diagrams, even at 0V bias [Fig. 1(b)]. However, observations of RT-NDR in GaN RTDs on GaN templated sapphire substrates have been restricted to devices of very small active area, typically less than 10 μm 2 [4], [5].more » « less
-
Hexagonal boron nitride (hBN) has been grown on sapphire substrates by ultrahigh-temperature molecular beam epitaxy (MBE). A wide range of substrate temperatures and boron fluxes have been explored, revealing that high crystalline quality hBN layers are grown at high substrate temperatures, >1600℃ , and low boron fluxes, ∼1 × 10%& Torr beam equivalent pressure. In situ reflection high-energy electron diffraction revealed the growth of hBN layers with 60° rotational symmetry and the [112+ 0] axis of hBN parallel to the [11+ 00] axis of the sapphire substrate. Unlike the rough, polycrystalline films previously reported, atomic force microscopy and transmission electron microscopy characterization of these films demonstrate smooth, layered, few-nanometer hBN films on a nitridated sapphire substrate. This demonstration of high-quality hBN growth by MBE is a step toward its integration into existing epitaxial growth platforms, applications, and technologies.more » « less
-
Gallium nitride (GaN)-based high electron mobility transistors (HEMTs) are essential components in modern radio frequency power amplifiers. In order to improve both the device electrical and thermal performance (e.g., higher current density operation and better heat dissipation), researchers are introducing AlN into the GaN HEMT structure. The knowledge of thermal properties of the constituent layers, substrates, and interfaces is crucial for designing and optimizing GaN HEMTs that incorporate AlN into the device structure as the barrier layer, buffer layer, and/or the substrate material. This study employs a multi-frequency/spot-size time-domain thermoreflectance approach to measure the anisotropic thermal conductivity of (i) AlN and GaN epitaxial films, (ii) AlN and SiC substrates, and (iii) the thermal boundary conductance for GaN/AlN, AlN/SiC, and GaN/SiC interfaces (as a function of temperature) by characterizing GaN-on-SiC, GaN-on-AlN, and AlN-on-SiC epitaxial wafers. The thermal conductivity of both AlN and GaN films exhibits an anisotropy ratio of ∼1.3, where the in-plane thermal conductivity of a ∼1.35 μm thick high quality GaN layer (∼223 W m−1 K−1) is comparable to that of bulk GaN. A ∼1 μm thick AlN film grown by metalorganic chemical vapor deposition possesses a higher thermal conductivity than a thicker (∼1.4 μm) GaN film. The thermal boundary conductance values for a GaN/AlN interface (∼490 MW m-2 K−1) and AlN/SiC interface (∼470 MW m−2 K−1) are found to be higher than that of a GaN/SiC interface (∼305 MW m−2 K−1). This work provides thermophysical property data that are essential for optimizing the thermal design of AlN-incorporated GaN HEMT devices.more » « less
